In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: Handle probe errors properly
The probe procedure of setup_card() in caiaq driver doesn't treat the
error cases gracefully, e.g. the error from snd_card_register() calls
snd_card_free() but continues. This would lead to a UAF for the
further calls like snd_usb_caiaq_control_init(), as Berk suggested in
another patch in the link below.
However, the problem is not only that; in general, this function drops
the all error handlings (as it's a void function) although its caller
can propagate an error to snd_probe(), which eventually calls
snd_card_free() as a prope
ext2: reject inodes with zero i_nlink and valid mode in ext2_iget()
In the Linux kernel, the following vulnerability has been resolved:
ext2: reject inodes with zero i_nlink and valid mode in ext2_iget()
ext2_iget() already rejects inodes with i_nlink == 0 when i_mode is
zero or i_dtime is set, treating them as deleted. However, the case of
i_nlink == 0 with a non-zero mode and zero dtime slips through. Since
ext2 has no orphan list, such a combination can only result from
filesystem corruption - a legitimate inode deletion always sets either
i_dtime or clears i_mode before freeing the inode.
A crafted image can exploit this gap to present such an inode to the
VFS, which then triggers WARN_ON inside drop_n
rxrpc: Fix conn-level packet handling to unshare RESPONSE packets
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix conn-level packet handling to unshare RESPONSE packets
The security operations that verify the RESPONSE packets decrypt bits of it
in place - however, the sk_buff may be shared with a packet sniffer, which
would lead to the sniffer seeing an apparently corrupt packet (actually
decrypted).
Fix this by handing a copy of the packet off to the specific security
handler if the packet was cloned.
scsi: sd: fix missing put_disk() when device_add(&disk_dev) fails
In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: fix missing put_disk() when device_add(&disk_dev) fails
If device_add(&sdkp->disk_dev) fails, put_device() runs
scsi_disk_release(), which frees the scsi_disk but leaves the gendisk
referenced. The device_add_disk() error path in sd_probe() calls
put_disk(gd); call put_disk(gd) here to mirror that cleanup.
ibmasm: fix OOB reads in command_file_write due to missing size checks
In the Linux kernel, the following vulnerability has been resolved:
ibmasm: fix OOB reads in command_file_write due to missing size checks
The command_file_write() handler allocates a kernel buffer of exactly
count bytes and copies user data into it, but does not validate the
buffer against the dot command protocol before passing it to
get_dot_command_size() and get_dot_command_timeout().
Since both the allocation size (count) and the header fields (command_size,
data_size) are independently user-controlled, an attacker can cause
get_dot_command_size() to return a value exceeding the allocation,
triggering OOB reads in get_dot_command_time
In the Linux kernel, the following vulnerability has been resolved:
udf: fix partition descriptor append bookkeeping
Mounting a crafted UDF image with repeated partition descriptors can
trigger a heap out-of-bounds write in part_descs_loc[].
handle_partition_descriptor() deduplicates entries by partition number,
but appended slots never record partnum. As a result duplicate
Partition Descriptors are appended repeatedly and num_part_descs keeps
growing.
Once the table is full, the growth path still sizes the allocation from
partnum even though inserts are indexed by num_part_descs. If partnum is
already aligned to PART_DESC_ALLOC_STEP, ALI
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix re-decryption of RESPONSE packets
If a RESPONSE packet gets a temporary failure during processing, it may end
up in a partially decrypted state - and then get requeued for a retry.
Fix this by just discarding the packet; we will send another CHALLENGE
packet and thereby elicit a further response. Similarly, discard an
incoming CHALLENGE packet if we get an error whilst generating a RESPONSE;
the server will send another CHALLENGE.
crypto: ccree - fix a memory leak in cc_mac_digest()
In the Linux kernel, the following vulnerability has been resolved:
crypto: ccree - fix a memory leak in cc_mac_digest()
Add cc_unmap_result() if cc_map_hash_request_final()
fails to prevent potential memory leak.
ext4: don't set EXT4_GET_BLOCKS_CONVERT when splitting before submitting I/O
In the Linux kernel, the following vulnerability has been resolved:
ext4: don't set EXT4_GET_BLOCKS_CONVERT when splitting before submitting I/O
When allocating blocks during within-EOF DIO and writeback with
dioread_nolock enabled, EXT4_GET_BLOCKS_PRE_IO was set to split an
existing large unwritten extent. However, EXT4_GET_BLOCKS_CONVERT was
set when calling ext4_split_convert_extents(), which may potentially
result in stale data issues.
Assume we have an unwritten extent, and then DIO writes the second half.
[UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent
[UUUUUUUUUUUUUUUU] extent status tree
|<- ->| --
gfs2: Fix use-after-free in iomap inline data write path
In the Linux kernel, the following vulnerability has been resolved:
gfs2: Fix use-after-free in iomap inline data write path
The inline data buffer head (dibh) is being released prematurely in
gfs2_iomap_begin() via release_metapath() while iomap->inline_data
still points to dibh->b_data. This causes a use-after-free when
iomap_write_end_inline() later attempts to write to the inline data
area.
The bug sequence:
1. gfs2_iomap_begin() calls gfs2_meta_inode_buffer() to read inode
metadata into dibh
2. Sets iomap->inline_data = dibh->b_data + sizeof(struct gfs2_dinode)
3. Calls release_metapath() which calls brelse(dibh), dropping refcount
In the Linux kernel, the following vulnerability has been resolved:
nfsd: never defer requests during idmap lookup
During v4 request compound arg decoding, some ops (e.g. SETATTR)
can trigger idmap lookup upcalls. When those upcall responses get
delayed beyond the allowed time limit, cache_check() will mark the
request for deferral and cause it to be dropped.
This prevents nfs4svc_encode_compoundres from being executed, and
thus the session slot flag NFSD4_SLOT_INUSE never gets cleared.
Subsequent client requests will fail with NFSERR_JUKEBOX, given
that the slot will be marked as in-use, making the SEQUENCE op
fail.
Fix this by making su
s390/cio: Fix device lifecycle handling in css_alloc_subchannel()
In the Linux kernel, the following vulnerability has been resolved:
s390/cio: Fix device lifecycle handling in css_alloc_subchannel()
`css_alloc_subchannel()` calls `device_initialize()` before setting up
the DMA masks. If `dma_set_coherent_mask()` or `dma_set_mask()` fails,
the error path frees the subchannel structure directly, bypassing
the device model reference counting.
Once `device_initialize()` has been called, the embedded struct device
must be released via `put_device()`, allowing the release callback to
free the container structure.
Fix the error path by dropping the initial device reference with
`put_device()` instead of calli
In the Linux kernel, the following vulnerability has been resolved:
staging: greybus: lights: avoid NULL deref
gb_lights_light_config() stores channel_count before allocating the
channels array. If kcalloc() fails, gb_lights_release() iterates the
non-zero count and dereferences light->channels, which is NULL.
Allocate channels first and only then publish channels_count so the
cleanup path can't walk a NULL pointer.
bonding: alb: fix UAF in rlb_arp_recv during bond up/down
In the Linux kernel, the following vulnerability has been resolved:
bonding: alb: fix UAF in rlb_arp_recv during bond up/down
The ALB RX path may access rx_hashtbl concurrently with bond
teardown. During rapid bond up/down cycles, rlb_deinitialize()
frees rx_hashtbl while RX handlers are still running, leading
to a null pointer dereference detected by KASAN.
However, the root cause is that rlb_arp_recv() can still be accessed
after setting recv_probe to NULL, which is actually a use-after-free
(UAF) issue. That is the reason for using the referenced commit in the
Fixes tag.
[ 214.174138] Oops: general protection fault, probably for non-c
cpuidle: Skip governor when only one idle state is available
In the Linux kernel, the following vulnerability has been resolved:
cpuidle: Skip governor when only one idle state is available
On certain platforms (PowerNV systems without a power-mgt DT node),
cpuidle may register only a single idle state. In cases where that
single state is a polling state (state 0), the ladder governor may
incorrectly treat state 1 as the first usable state and pass an
out-of-bounds index. This can lead to a NULL enter callback being
invoked, ultimately resulting in a system crash.
[ 13.342636] cpuidle-powernv : Only Snooze is available
[ 13.351854] Faulting instruction address: 0x00000000
[ 13.376489] NIP [000
apparmor: fix invalid deref of rawdata when export_binary is unset
In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix invalid deref of rawdata when export_binary is unset
If the export_binary parameter is disabled on runtime, profiles that
were loaded before that will still have their rawdata stored in
apparmorfs, with a symbolic link to the rawdata on the policy
directory. When one of those profiles are replaced, the rawdata is set
to NULL, but when trying to resolve the symbolic links to rawdata for
that profile, it will try to dereference profile->rawdata->name when
profile->rawdata is now NULL causing an oops. Fix it by checking if
rawdata is set.
[ 168.653080] BUG: ker
SUNRPC: fix gss_auth kref leak in gss_alloc_msg error path
In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: fix gss_auth kref leak in gss_alloc_msg error path
Commit 5940d1cf9f42 ("SUNRPC: Rebalance a kref in auth_gss.c") added
a kref_get(&gss_auth->kref) call to balance the gss_put_auth() done
in gss_release_msg(), but forgot to add a corresponding kref_put()
on the error path when kstrdup_const() fails.
If service_name is non-NULL and kstrdup_const() fails, the function
jumps to err_put_pipe_version which calls put_pipe_version() and
kfree(gss_msg), but never releases the gss_auth reference. This leads
to a kref leak where the gss_auth structure is never freed.
Add a
hfsplus: return error when node already exists in hfs_bnode_create
In the Linux kernel, the following vulnerability has been resolved:
hfsplus: return error when node already exists in hfs_bnode_create
When hfs_bnode_create() finds that a node is already hashed (which should
not happen in normal operation), it currently returns the existing node
without incrementing its reference count. This causes a reference count
inconsistency that leads to a kernel panic when the node is later freed
in hfs_bnode_put():
kernel BUG at fs/hfsplus/bnode.c:676!
BUG_ON(!atomic_read(&node->refcnt))
This scenario can occur when hfs_bmap_alloc() attempts to allocate a node
that is already in use (e.g., when node 0's b
drm/exynos: vidi: fix to avoid directly dereferencing user pointer
In the Linux kernel, the following vulnerability has been resolved:
drm/exynos: vidi: fix to avoid directly dereferencing user pointer
In vidi_connection_ioctl(), vidi->edid(user pointer) is directly
dereferenced in the kernel.
This allows arbitrary kernel memory access from the user space, so instead
of directly accessing the user pointer in the kernel, we should modify it
to copy edid to kernel memory using copy_from_user() and use it.
drm/exynos: vidi: use priv->vidi_dev for ctx lookup in vidi_connection_ioctl()
In the Linux kernel, the following vulnerability has been resolved:
drm/exynos: vidi: use priv->vidi_dev for ctx lookup in vidi_connection_ioctl()
vidi_connection_ioctl() retrieves the driver_data from drm_dev->dev to
obtain a struct vidi_context pointer. However, drm_dev->dev is the
exynos-drm master device, and the driver_data contained therein is not
the vidi component device, but a completely different device.
This can lead to various bugs, ranging from null pointer dereferences and
garbage value accesses to, in unlucky cases, out-of-bounds errors,
use-after-free errors, and more.
To resolve this issue, we need to store/delete the vid