usb: typec: altmodes/displayport: validate count before reading Status Update VDO
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: altmodes/displayport: validate count before reading Status Update VDO
A broken/malicious device can send the incorrect count for a status
update VDO, which will cause the kernel to read uninitialized stack data
and send it off elsewhere.
Fix this up by correctly verifying the count for the update object.
usb: typec: wcove: don't write past struct pd_message in wcove_read_rx_buffer()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: wcove: don't write past struct pd_message in wcove_read_rx_buffer()
wcove_read_rx_buffer() copies the PD RX FIFO into the caller's
struct pd_message with
for (i = 0; i < USBC_RXINFO_RXBYTES(info); i++)
regmap_read(wcove->regmap, USBC_RX_DATA + i, msg + i);
which has two problems:
USBC_RXINFO_RXBYTES() is a 5-bit field (max 31) while struct pd_message
is 30 bytes (__le16 header + __le32 payload[PD_MAX_PAYLOAD], packed).
The byte count latched in RXINFO is the number of bytes the port partner
put on the wire, so a malicious partner that transmits a 31-byte f
usb: typec: tcpm/tcpci_maxim: validate header NDO against RX_BYTE_CNT
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm/tcpci_maxim: validate header NDO against RX_BYTE_CNT
A broken/malicious port can transmit a CRC-valid frame whose header
advertises up to seven data objects but whose body carries fewer than
that. Check for this, and rightfully reject the message, instead of
reading from uninitialized stack memory.
usb: typec: ucsi: validate connector number in ucsi_connector_change()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: ucsi: validate connector number in ucsi_connector_change()
The connector number in a UCSI CCI notification is a 7-bit field
supplied by the PPM. ucsi_connector_change() uses it to index the
ucsi->connector[] array without checking it against the number of
connectors the PPM reported at init time, so a buggy or malicious PPM
(EC firmware, or an I2C-attached UCSI controller on the ccg / stm32g0 /
glink transports) can drive schedule_work() on memory past the end of
the array.
Reject connector numbers that are zero or exceed cap.num_connectors
before dereferencin
USB: serial: safe_serial: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: safe_serial: fix memory corruption with small endpoint
Make sure that the bulk-out buffer size is at least eight bytes to avoid
user-controlled slab corruption in "safe" mode should a malicious device
report a smaller size.
USB: serial: cypress_m8: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: cypress_m8: fix memory corruption with small endpoint
Make sure that the interrupt-out endpoint max packet size is at least
eight bytes to avoid user-controlled slab corruption or NULL-pointer
dereference should a malicious device report a smaller size.
In the Linux kernel, the following vulnerability has been resolved:
hpfs: fix a crash if hpfs_map_dnode_bitmap fails
If hpfs_map_dnode_bitmap fails, the code would call hpfs_brelse4 on
uninitialized quad buffer head, causing a crash.
Bluetooth: L2CAP: fix chan ref leak in l2cap_chan_timeout() on !conn
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: fix chan ref leak in l2cap_chan_timeout() on !conn
__set_chan_timer() takes a l2cap_chan reference via l2cap_chan_hold()
before scheduling the delayed work. The normal path in
l2cap_chan_timeout() drops this reference with l2cap_chan_put() at the
end, but the early return when chan->conn is NULL skips the put,
leaking the reference.
Add the missing l2cap_chan_put() before the early return.
Bluetooth: HIDP: fix missing length checks in hidp_input_report()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: fix missing length checks in hidp_input_report()
hidp_input_report() reads keyboard and mouse payload data from an skb
without first verifying that skb->len contains enough data.
hidp_recv_intr_frame() pulls the 1-byte HIDP header before dispatching
to hidp_input_report(). If a paired device sends a truncated packet,
the handler reads beyond the valid skb data, resulting in an
out-of-bounds read of skb data. The OOB bytes may be interpreted as
phantom key presses or spurious mouse movement.
Replace the open-coded length tracking and pointer arithmetic wit
parport: Fix race between port and client registration
In the Linux kernel, the following vulnerability has been resolved:
parport: Fix race between port and client registration
The parport subsystem registers port devices before they are fully
initialised, resulting in a race condition where client drivers such
as lp can attach to ports that are not completely initialised or even
being torn down.
When the port and client drivers are built as modules and loaded
around the same time during boot, this occasionally results in a
crash. I was able to make this happen reliably in a VM with a
PC-style parallel port by patching parport_pc to fail probing:
> --- a/drivers/parport/parport_pc.c
> +++ b
In the Linux kernel, the following vulnerability has been resolved:
KVM: SEV: Ignore Port I/O requests of length '0'
Explicitly ignore Port I/O requests of length '0' (or count '0'), so that
setting up the software scratch area (and other code) doesn't have to
worry about underflowing the length, and to allow for WARNing on trying
to configure the scratch area with len==0.
iio: gyro: itg3200: fix i2c read into the wrong stack location
In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: itg3200: fix i2c read into the wrong stack location
itg3200_read_all_channels() takes `__be16 *buf' as a parameter and
fills the i2c_msg destination as `(char *)&buf'. Since `buf' is the
parameter (a pointer), `&buf' is the address of the local pointer
slot on the stack of itg3200_read_all_channels(), not the address
of the caller's scan buffer. The (char *) cast hides the type
mismatch.
i2c_transfer() therefore writes ITG3200_SCAN_ELEMENTS * sizeof(s16)
= 8 bytes into the parameter's stack slot, which is discarded when
the function returns. The caller's scan bu
iio: gyro: adis16260: fix division by zero in write_raw
In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: adis16260: fix division by zero in write_raw
Add a validation check for the sampling frequency value before using it
as a divisor. A user writing zero to the sampling_frequency sysfs
attribute triggers a division by zero in the kernel.
iio: chemical: scd30: fix division by zero in write_raw
In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: scd30: fix division by zero in write_raw
Add a zero check for val2 before using it as a divisor when setting the
sampling frequency. A user writing a zero fractional part to the
sampling_frequency sysfs attribute triggers a division by zero in the
kernel.
iio: buffer: hw-consumer: fix use-after-free in error path
In the Linux kernel, the following vulnerability has been resolved:
iio: buffer: hw-consumer: fix use-after-free in error path
In the err_put_buffers cleanup path of iio_hw_consumer_alloc(), the code
was using list_for_each_entry() to iterate through buffers while calling
iio_buffer_put() which can free the current buffer if refcount drops to 0.
The list_for_each_entry() loop macro then evaluates buf->head.next to
continue iteration, accessing the freed buffer.
Fix this by using list_for_each_entry_safe().
USB: serial: omninet: fix memory corruption with small endpoint
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: omninet: fix memory corruption with small endpoint
Make sure that the bulk-out buffers are at least as large as the
hardcoded transfer size to avoid user-controlled slab corruption should
a malicious device report a smaller endpoint max packet size than
expected.
In the Linux kernel, the following vulnerability has been resolved:
usb: dwc2: Fix use after free in debug code
We're not allowed to dereference "urb" after calling
usb_hcd_giveback_urb() so save the urb->status ahead of time.
bpf: sockmap: fix tail fragment offset in bpf_msg_push_data
In the Linux kernel, the following vulnerability has been resolved:
bpf: sockmap: fix tail fragment offset in bpf_msg_push_data
When bpf_msg_push_data() inserts data in the middle of a scatterlist
entry, it splits the original entry into a left fragment and a right
fragment.
The right fragment offset is page-local, but the code advances it with
`start`, which is the message-global insertion point. For inserts into a
non-first SG entry, this over-advances the offset and leaves the split
layout inconsistent.
Advance the right fragment offset by the fragment-local delta,
`start - offset`, which matches the length removed from the front of th
macsec: fix replay protection at XPN lower-PN wrap
In the Linux kernel, the following vulnerability has been resolved:
macsec: fix replay protection at XPN lower-PN wrap
In macsec_post_decrypt(), when pn is U32_MAX, pn + 1 overflows u32 to 0
and the first branch never fires. If next_pn_halves.lower is also in the
upper half, pn_same_half(pn, lower) is true and the XPN else-if does not
fire either, leaving next_pn_halves unchanged. An attacker that captures
the legitimate frame carrying pn == 0xFFFFFFFF on an XPN association
can then replay it indefinitely, since lowest_pn never rises above
the captured pn and macsec_decrypt() reconstructs the same IV.
Extend the XPN else-if to also fire wh
ipv6: exthdrs: refresh nh pointer after ipv6_hop_jumbo()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: exthdrs: refresh nh pointer after ipv6_hop_jumbo()
ipv6_hop_jumbo() calls pskb_trim_rcsum(), which can change skb pointers.
Let's recompute nh pointer to make sure any change won't mess things up.