In the Linux kernel, the following vulnerability has been resolved:
serial: msm: Disable DMA for kernel console UART
At the moment, concurrent writes from userspace and the kernel to the
console can trigger a race condition that results in an infinite loop of
the same messages printed over and over again. This is most likely to
happen during system startup or shutdown when the init system starts/stops
a large number of system services that interact with various kernel code.
When userspace writes to the TTY device, the driver initiates an
asynchronous DMA transfer and releases the port lock. At the same moment,
the kernel printk path might
drm/tegra: gr2d/gr3d: Initialize address register map before HOST1X client is registered
In the Linux kernel, the following vulnerability has been resolved:
drm/tegra: gr2d/gr3d: Initialize address register map before HOST1X client is registered
The host1x_client_register() function is called just prior to register map
initialization loop, making the device available to userspace. This may
result in userspace attempting to submits a job before the register map is
initialized. Address this by moving register initialization before host1x
client registration.
ocfs2: fix circular locking dependency in ocfs2_dio_end_io_write
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix circular locking dependency in ocfs2_dio_end_io_write
A circular locking dependency involves INODE_ALLOC_SYSTEM_INODE,
EXTENT_ALLOC_SYSTEM_INODE, and ORPHAN_DIR_SYSTEM_INODE.
1. ocfs2_mknod() acquires INODE_ALLOC then EXTENT_ALLOC.
2. ocfs2_dio_end_io_write() acquires EXTENT_ALLOC for unwritten
extents, then ORPHAN_DIR via ocfs2_del_inode_from_orphan() while still
holding EXTENT_ALLOC.
3. ocfs2_wipe_inode() acquires ORPHAN_DIR then INODE_ALLOC via
ocfs2_remove_inode.
Break the cycle in ocfs2_dio_end_io_write() by freeing the allocation
contexts (rele
ring-buffer: Fix event length with forced 8-byte alignment
In the Linux kernel, the following vulnerability has been resolved:
ring-buffer: Fix event length with forced 8-byte alignment
When RB_FORCE_8BYTE_ALIGNMENT is true, rb_calculate_event_length()
reserves the space of event->array[0] for placing the data length and
rb_update_event() stores the data length in event->array[0]
accordingly. As a result the whole event length will add extra 4 bytes
for sizeof(event.array[0]) unconditionally.
But ring_buffer_event_length() only subtracts the
sizeof(event->array[0]) for events larger than RB_MAX_SMALL_DATA +
sizeof(event->array[0]). As a result, small events on architectures
with RB_FORCE_8BYTE_ALI
ipvs: use parsed transport offset in TCP state lookup
In the Linux kernel, the following vulnerability has been resolved:
ipvs: use parsed transport offset in TCP state lookup
TCP state handling reparses the skb to find the TCP header. For IPv6 it
uses sizeof(struct ipv6hdr), while the surrounding IPVS code already
parsed the packet with ip_vs_fill_iph_skb() and has the real
transport-header offset in iph.len.
This makes TCP state handling look at the wrong bytes when an IPv6
packet carries extension headers. Use the parsed transport offset passed
down from ip_vs_set_state() when reading the TCP header.
For IPv4 and for IPv6 packets without extension headers, the passed
offset matches the pr
usb: xhci: bail out of setup if the controller is inaccessible
In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: bail out of setup if the controller is inaccessible
xhci_gen_setup() locates the operational registers using the capability
length read from the very first register:
xhci->op_regs = hcd->regs +
HC_LENGTH(readl(&xhci->cap_regs->hc_capbase));
If the controller is dead or has dropped off the bus, that read returns
~0, HC_LENGTH() truncates it to 0xff, and op_regs ends up 0xff bytes
past the page-aligned MMIO base, i.e. unaligned. The first access
through it, xhci_halt() -> xhci_handshake() reading op_regs->status, is
then an unaligned readl() on device memory.
usb: gadget: f_tcm: keep port count until LUN teardown completes
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_tcm: keep port count until LUN teardown completes
tcm_usbg_drop_nexus() permits session removal once tpg_port_count
reaches zero. However, usbg_port_unlink() currently decrements that
count from the fabric_pre_unlink() callback, before core_dev_del_lun()
waits for active se_lun references to drain.
If removal of the last LUN races a nexus removal, the latter can observe
a zero port count and call target_remove_session(). This frees
sess_cmd_map while an in-flight struct usbg_cmd, including its work item,
can still be accessed.
Overlapping the last-LUN unlin
In the Linux kernel, the following vulnerability has been resolved:
tcp: clamp route advmss to TCP_MIN_MSS
tcp_select_initial_window() assumes that callers never pass an MSS
smaller than 1, but route-derived advmss values can violate that
assumption.
A too-small explicit RTAX_ADVMSS is one way to get there, but it is not
the only one. The same divide-by-zero can also be reached through the
"default advmss" path when RTAX_ADVMSS is left at 0 and the effective
advmss is later driven down by route MTU and min_adv_mss.
Introduce a tcp_dst_advmss() helper that clamps route advmss to
TCP_MIN_MSS before TCP consumes it, and use it in the TCP pat
Non évaluéeEPSS 0,43%Code d’exploitation publicAucun correctif publié
xfrm: ah6: validate routing header segments_left
In the Linux kernel, the following vulnerability has been resolved:
xfrm: ah6: validate routing header segments_left
AH6 rearranges routing-header addresses before computing or verifying the
ICV. ipv6_rearrange_rthdr() assumes that segments_left is not larger than
the number of addresses described by the routing header's hdrlen field.
That assumption does not hold for raw IPv6 HDRINCL packets. A packet with
hdrlen equal to 2 describes one address, but can carry an arbitrary
segments_left value. With segments_left equal to 255, the function moves
its address pointer 4,064 bytes backwards and passes a 4,064-byte length to
memmove(), resultin
In the Linux kernel, the following vulnerability has been resolved:
xfrm: fix xfrm_state_construct() auth-trunc leak
attach_auth_trunc() can allocate x->aalg while leaving
x->props.aalgo at zero when the selected auth algorithm has no
sadb_alg_id. One real case is cmac(aes).
xfrm_state_construct() then treats !x->props.aalgo as "no auth
algorithm attached yet" and calls attach_auth(). That overwrites
x->aalg and loses the first allocation. Any later failure or teardown
only frees the replacement pointer.
Check whether x->aalg is already attached instead of inferring that
state from x->props.aalgo.
net/packet: defer vmalloc TX_RING free until skbs finish
In the Linux kernel, the following vulnerability has been resolved:
net/packet: defer vmalloc TX_RING free until skbs finish
AF_PACKET TX_RING skbs keep a raw pointer to their ring frame. The skb
page references preserve page-backed ring blocks after pg_vec is freed,
but they do not preserve a vmalloc mapping.
tpacket_destruct_skb() currently drops the pending reference before
writing the timestamp and TP_STATUS_AVAILABLE to the frame. Move the
decrement after those stores. The smp_wmb() in __packet_set_status()
orders the frame stores before the decrement.
Also recheck pending TX frames under pg_vec_lock before non-closing
ring replaceme
In the Linux kernel, the following vulnerability has been resolved:
crypto: mxs-dcp - fix source scatterlist length access
mxs_dcp_aes_block_crypt() uses sg_dma_len() without mapping the source
scatterlist with dma_map_sg() first. Therefore, sg_dma_len() is invalid
and could return zero or a stale DMA length, causing encryption and
decryption to process the wrong number of bytes when
CONFIG_NEED_SG_DMA_LENGTH=y.
Use the original scatterlist length instead.
In the Linux kernel, the following vulnerability has been resolved:
usb: core: Add lock to usb_wakeup_notification()
Add a spin lock to usb_wakeup notification to prevent a race condition
with dereferencing freed memory. This could be hit by the xHCI driver as
it calls this function from an IRQ and could race with the
hub_disconnect() function, which properly grabs this lock to protect the
state of the device.
ALSA: usb-audio: fix OOB write in snd_usbmidi_novation_output()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_novation_output()
snd_usbmidi_novation_output() lays out a two-byte header at
transfer_buffer[0..1] and passes &transfer_buffer[2] together with a
length of ep->max_transfer - 2 to snd_rawmidi_transmit():
count = snd_rawmidi_transmit(ep->ports[0].substream,
&transfer_buffer[2],
ep->max_transfer - 2);
ep->max_transfer comes from the output endpoint's wMaxPacketSize via
usb_maxpacket(). A malformed or malicious device can advertise a bulk
OUT endpoint with a wMaxPacketSize of 1 - the USB core only clamps this
ALSA: usb-audio: Complete cleanup after system-resume errors
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Complete cleanup after system-resume errors
A failed system resume can leave the card unusable until reboot.
usb_audio_resume() jumps to err_out when snd_usb_pcm_resume() or
snd_usb_mixer_resume() fails. The error path skips the out: block, which
restores D0 and decrements chip->num_suspended_intf.
The card stays in SNDRV_CTL_POWER_D3hot, so later control access blocks in
snd_power_ref_and_wait(). USB core logs an interface resume callback error.
It does not retry that callback, so a later callback cannot complete the
skipped cleanup.
usb_audio_suspend()
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: option: fix slab OOB read in interrupt URB callback
The interrupt URB buffer is allocated in setup_port_interrupt_in() based
on the endpoint's wMaxPacketSize:
buffer_size = usb_endpoint_maxp(epd);
port->interrupt_in_buffer = kmalloc(buffer_size, GFP_KERNEL);
When a USB device declares wMaxPacketSize = 8 on its interrupt IN
endpoint, the buffer is allocated from kmalloc-8 cache (exactly
8 bytes).
If the device sends a short packet (actual_length < wMaxPacketSize),
the URB completes with status == 0 and the callback proceeds to read:
data[sizeof(s
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
In the Linux kernel, the following vulnerability has been resolved:
USB: c67x00: fix use-after-free in c67x00_add_iso_urb()
When TD creation fails for the last packet of an isochronous URB,
c67x00_add_iso_urb() gives the URB back before updating the endpoint
scheduling state.
c67x00_giveback_urb() frees the URB private data, and the completion
callback may release the final URB reference. The following accesses to
urbp->ep_data, urb->interval, and urbp->cnt can therefore use freed
memory.
Update next_frame and cnt before giving back the failed final packet,
making the giveback the last operation that uses the URB and its private
data.
nfc: st21nfca: validate ATR_REQ length against the received frame
In the Linux kernel, the following vulnerability has been resolved:
nfc: st21nfca: validate ATR_REQ length against the received frame
st21nfca_tm_recv_atr_req() checks that the received ATR_REQ frame is at
least ST21NFCA_ATR_REQ_MIN_SIZE and that the self-declared atr_req->length
is at least sizeof(struct st21nfca_atr_req), but never checks that
atr_req->length does not exceed the actual received length (skb->len).
st21nfca_tm_send_atr_res() then trusts the declared length:
gb_len = atr_req->length - sizeof(struct st21nfca_atr_req);
...
memcpy(atr_res->gbi, atr_req->gbi, gb_len);
so an RF peer that sends a short frame but sets atr_req
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: take rfcomm_mutex for the deferred setup accept
rfcomm_sock_recvmsg() completes a deferred setup by calling
rfcomm_dlc_accept() without holding any RFCOMM lock:
if (test_and_clear_bit(RFCOMM_DEFER_SETUP, &d->flags)) {
rfcomm_dlc_accept(d);
return 0;
}
and rfcomm_dlc_accept() dereferences the session on its first line:
struct sock *sk = d->session->sock->sk;
Every other path that touches d->session runs under rfcomm_mutex:
rfcomm_dlc_open(), rfcomm_dlc_close(), rfcomm_dlc_exists(),
rfcomm_dlc_send_rpn(), and the RFCOMM thread through
rfcomm_proc
rndis_host: add overflow check in rndis_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
rndis_host: add overflow check in rndis_rx_fixup()
Add an overflow check to ensure that data_offset + data_len + 8 does not
wrap, which would enable an OOB read of the USB data buffer.