kprobes: Skip disarmed probes when checking optkprobe overlap
In the Linux kernel, the following vulnerability has been resolved:
kprobes: Skip disarmed probes when checking optkprobe overlap
On x86, an optkprobe at A replaces five bytes with a jump. If a disabled
probe B is at A+2, get_optimized_kprobe() stops at B when arming a new
probe C at A+4. It leaves A optimized:
A A+1 A+2 A+3 A+4
A's jump | e9 | d0 | d1 | d2 | d3 |
after C | e9 | d0 | d1 | d2 | cc |
The INT3 for C overwrites the last byte of A's jump displacement, so
execution can jump to the wrong address. B can have prepared optinsns
while disarmed, but has no jump to unoptimize.
Continue past disarmed and unp
of/overlay: only treat a positive changeset id as registered
In the Linux kernel, the following vulnerability has been resolved:
of/overlay: only treat a positive changeset id as registered
of_overlay_fdt_apply() stores the idr_alloc() return value in
ovcs->id before checking it. On failure the stored id is negative,
free_overlay_changeset()'s "if (ovcs->id)" check passes, idr_remove()
is called with a negative id and list_del() runs on ovcs->ovcs_list,
which is not initialized until after the id allocation. An allocation
failure at that point dereferences NULL.
Make free_overlay_changeset() treat only a strict-positive id as
registered. The rest of the function already copes with a
partially-initia
In the Linux kernel, the following vulnerability has been resolved:
net: gso: limit recursive IP-in-IP segmentation
IP-in-IP GSO can re-enter inet_gso_segment() or ipv6_gso_segment()
for each nested IP header. encap_level tracks header bytes, not callback
depth, so a deep chain can exhaust the kernel stack. Making
inet_gso_segment() stackable introduced unbounded IPv4 nesting; IPIP
GSO/TSO later made the path reachable. The IPv6 stackable path was
introduced separately and uses the same guard.
Count IPv4 and IPv6 GSO handler entries in skb_gso_cb, initialized once
per top-level GSO operation and preserved across GRE/UDP context changes.
Us
In the Linux kernel, the following vulnerability has been resolved:
net/packet: prevent TX_RING byte count overflow
tpacket_snd() drains every SEND_REQUEST frame in a TX ring and adds
each valid packet length to the signed int len_sum. Userspace can
recycle completed frames concurrently, so a single blocking send call
is not bounded by the ring size.
After enough successful transmissions len_sum wraps into the negative
range. In particular, 65536 65535-byte frames followed by a 65007-byte
frame produce 0xfffffdef, or -EIOCBQUEUED. sock_sendmsg_nosec() treats
that as an impossible return and triggers a BUG. On systems configured
to panic on
rtc: spear: initialize IRQ state before requesting alarm IRQ
In the Linux kernel, the following vulnerability has been resolved:
rtc: spear: initialize IRQ state before requesting alarm IRQ
devm_request_irq() enables the interrupt before it returns, so the handler
may run while probe is still initializing the device. Initialize the MMIO
address and spinlock before requesting the alarm IRQ.
vt: skip screen update for DEC alignment test on backgroup consoles
In the Linux kernel, the following vulnerability has been resolved:
vt: skip screen update for DEC alignment test on backgroup consoles
[BUG]
Recently, we encountered a KASAN warning as follows:
BUG: KASAN: slab-out-of-bounds in fb_pad_aligned_buffer+0x11f/0x140
Read of size 1 at addr ff1100015fd9f6a4 by task tty_fbcon_oob/1239
CPU: 7 UID: 0 PID: 1239 Comm: tty_fbcon_oob Not tainted 7.3.0-rc1 #100 PREEMPT(full)
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.17.0-4.fc41 04/01/2014
Call Trace:
<TASK>
...
kasan_report+0xf0/0x120
fb_pad_aligned_buffer+0x11f/0x140
ccw_putcs+0x86c/0xa80
fbcon_putcs+0x338/0x410
do_update_reg
In the Linux kernel, the following vulnerability has been resolved:
ALSA: line6: reject oversized playback packets
Each playback URB is handed a slice of out.buffer that is exactly
LINE6_ISO_PACKETS * max_packet_size_out bytes, sized from the OUT
endpoint, but the number of bytes written into that slice is never
compared against it.
submit_audio_out_urb() takes the frame count from prev_fsize, which
audio_in_callback() derived from the *IN* endpoint's received packet
length, and rescales it with the playback frame size; when prev_fsize is
still zero it synthesizes a length from the sample rate instead. On a
device declaring a large IN wMa
of/overlay: don't leak fragment references when changeset init fails
In the Linux kernel, the following vulnerability has been resolved:
of/overlay: don't leak fragment references when changeset init fails
init_overlay_changeset() stores the number of initialized fragments
in ovcs->count only on full success. When find_target() or the
__symbols__ lookup fails partway through, the target and overlay
references taken for the fragments initialized so far are never
dropped: free_overlay_changeset() bounds its cleanup loop by
ovcs->count, which is still 0.
Store the running count on the error path so free_overlay_changeset()
puts whatever was set up. The store is guarded by ovcs->fragments
because on the allocat
wifi: mac80211: drop oversized fragments to avoid extra_len overflow
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: drop oversized fragments to avoid extra_len overflow
In ieee80211_rx_h_defragment(), fragment payloads are accumulated into
entry->extra_len as subsequent fragments arrive:
entry->extra_len += rx->skb->len;
When the final fragment arrives, the head fragment is dequeued, and
pskb_expand_head() is called with entry->extra_len to ensure sufficient
tailroom for all queued fragments before copying:
if (skb_tailroom(rx->skb) < entry->extra_len) {
if (unlikely(pskb_expand_head(rx->skb, 0, entry->extra_len,
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: reject short WMI command responses
ath9k_wmi_rsp_callback() removes the validated WMI header and copies
the number of bytes expected by the waiting command into its response
buffer. A device response shorter than that expectation can therefore
be read beyond the skb payload.
Record -EMSGSIZE for a short response, complete the waiter, and return
the stored status from the command path. This also prevents callers from
consuming stale response bytes as a successful reply.
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
__hif_usb_tx() dequeues up to MAX_TX_AGGR_NUM (20) frames into a
single tx_buf of MAX_TX_BUF_SIZE (32768) bytes, limiting the batch
by record count but never by cumulative byte length.
With large frames (MTU 2304), 20 aggregated frames of 2292 bytes
each exceed the allocation (20 * 2296 = 45920 bytes), so the
memcpy() in the loop writes up to 13152 bytes past tx_buf->buf
before usb_submit_urb().
Peek the queue head and stop before copying any record that would
cross MAX_TX_BUF_SIZE, then dispatch the current batch.
rtc: ac100: Fix clock provider use-after-free on probe failure
In the Linux kernel, the following vulnerability has been resolved:
rtc: ac100: Fix clock provider use-after-free on probe failure
ac100_rtc_register_clks() registers the RTC-32k clock with
clk_hw_register_fixed_rate() and the clock provider with
of_clk_add_hw_provider(). Neither is device managed, and both are
released only from ac100_rtc_remove(). The driver core does not call
remove() when probe() fails: really_probe() reaches probe_failed below
the device_remove() call and goes straight to releasing the device's
managed resources.
ac100_rtc_probe() ends with
return devm_rtc_register_device(chip->rtc);
so if that fails after the cloc
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate TX status rate metadata
minstrel_ht_tx_status() converts the HT/VHT rate reported in a TX status
into a group and rate index and uses those to index the minstrel_ht rate
tables. The existing validation only checked that an entry was present
and had tries recorded; it did not check that the reported MCS, spatial
stream count and bandwidth are representable by the tables, so malformed
metadata passed to minstrel_ht_get_stats() or
minstrel_ht_ri_get_stats() could be used as an out-of-bounds index.
Validate the rate metadata in the common TX status pa
wifi: mac80211: prevent AP VLAN tx from other interfaces
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: prevent AP VLAN tx from other interfaces
Since the station lookup was factored out of ieee80211_build_hdr(),
ieee80211_lookup_ra_sta() uses sta_info_get_bss() for all AP and AP VLAN
frames, not only for control port frames. A unicast frame sent on one
interface thus matches a station of a different VLAN of the same BSS and
is transmitted to it.
Only match stations of the interface the frame is sent on, except for
control port frames, since those may be sent for VLAN stations directly
on the BSS interface.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: validate DDC record lengths
Parse DDC record lengths in unsigned storage so 0xFF does not wrap.
Reject records smaller than the mandatory three-byte header, records
exceeding U8_MAX, and records exceeding remaining firmware bytes before
issuing Intel_Write_DDC.
This issue was reported by Claude Mythos.
bpf: Fix overflow of jump offset in constant blinding
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix overflow of jump offset in constant blinding
bpf_jit_blind_insn() rewrites 'if rX op imm goto off' into:
AX = imm ^ rnd
AX ^= rnd
if rX op AX goto off
and subtracts 2 from off when the jump is backward. off is s16, so
-32767 and -32768 wrap and the jump goes 32767 insns forward, past the
end of the prog. The jump is inside the patch, hence bpf_adj_branches()
doesn't check it. The kernel crashes when such prog runs with
bpf_jit_harden=2.
Return -ERANGE in such case. bpf_jit_blind_constants() fails the same
way when blinding of other insns moves a jump out o
In the Linux kernel, the following vulnerability has been resolved:
nvme: fix cdev lifetime
Sashiko bot reported a potential problem for the cdev lifetime in [0]
- the code there is heavily based on the NVMe code.
Currently the NS head .open and .release file_operations methods take and
put a reference to the nvme_ns_head to ensure that this structure does not
disappear while we open fds for that cdev.
In multipath mode, when we teardown the NS head, we call nvme_cdev_del() ->
cdev_device_del() -> cdev_del(). However after cdev_del() returns, cdevs
already open will remain and their fops will still be callable. As such,
we can still refer
wifi: mac80211: fix slab-out-of-bounds read in ieee80211_monitor_select_queue()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix slab-out-of-bounds read in ieee80211_monitor_select_queue()
ieee80211_monitor_select_queue() validates the skb length using skb->len
before dereferencing pointers into skb->data to access the 802.11 header.
However, skb->len includes data in both the linear head buffer and
non-linear fragments/pages. When AF_PACKET sends a packet large enough to
become non-linear, the 802.11 header at skb->data + len_rthdr may extend
past the linear head buffer even though skb->len appears sufficient.
This leads to a slab-out-of-bounds read when accessing hdr->frame_con
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
In the Linux kernel, the following vulnerability has been resolved:
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
When running on SYSTEMPORT Lite, certain statistics are unsupported and
skipped during bcm_sysport_get_stats(). The variable 'j' tracks the
compacted index into the destination data buffer, whereas 'i' iterates
over all elements in bcm_sysport_gstrings_stats.
Because the buffer allocated by ethtool is sized only according to
bcm_sysport_get_sset_count(), storing values at data[i] instead of
data[j] writes past the allocated array bounds, leading to memory
corruption.
Fix this by writing to data[j] instead of
seg6: ensure packet data is writable before modifying SRH and IPv6 DA
In the Linux kernel, the following vulnerability has been resolved:
seg6: ensure packet data is writable before modifying SRH and IPv6 DA
advance_nextseg() modifies the SRH Segments Left field and the IPv6
destination address without ensuring the packet data is writable.
seg6_next_csid_advance_arg() has the same problem when it advances the
NEXT-C-SID argument in the destination address.
The skb may be cloned, for example by an AF_PACKET socket receiving on
the ingress device. advance_nextseg() and seg6_next_csid_advance_arg()
then write into the packet data shared with the clone. A read from that
socket can return the modified packet inst