net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: bound RX frame length in kalmia_rx_fixup()
kalmia_rx_fixup() computes usb_packet_length = skb->len - (2 *
KALMIA_HEADER_LENGTH) as a u16, guarded only by a pre-loop check that
skb->len is at least KALMIA_HEADER_LENGTH, which is 6. A device can
deliver a short bulk-IN frame with skb->len in the 6 to 11 range, or
leave a short trailing remainder on a later loop iteration. Either case
underflows usb_packet_length to about 65530.
That bypasses the usb_packet_length < ether_packet_length truncation path.
The device-supplied ether_packet_length, a le16 up to 65
In the Linux kernel, the following vulnerability has been resolved:
usb: free iso schedules on failed submit
EHCI and FOTG210 isochronous submits build an ehci_iso_sched before
linking the URB to the endpoint queue, and keep the staged schedule in
urb->hcpriv until iso_stream_schedule() and the link helpers consume it.
If the controller is no longer accessible, or usb_hcd_link_urb_to_ep()
fails, submit jumps to done_not_linked before that handoff happens and
leaks the staged schedule still attached to urb->hcpriv.
Free the staged schedule from done_not_linked when submit fails before
the URB is linked and clear urb->hcpriv after the free.
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: composite: fix dead empty check in the USB_DT_OTG handler
The OTG branch of composite_setup() falls back to the first
configuration when none is selected:
if (cdev->config)
config = cdev->config;
else
config = list_first_entry(&cdev->configs,
struct usb_configuration, list);
if (!config)
goto done;
...
memcpy(req->buf, config->descriptors[0], value);
list_first_entry() never returns NULL. On an empty list it returns
container_of() of the list head. So the "if (!config)" check is dead.
When cdev->configs is empty, config points at the head i
usb: gadget: udc: Fix use-after-free in gadget_match_driver
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: udc: Fix use-after-free in gadget_match_driver
The udc structure acts as the management structure for the gadget,
but their lifecycles are decoupled. A race condition exists where
usb_del_gadget() frees the udc memory (e.g., via mode-switch work)
while gadget_match_driver() concurrently accesses the freed udc memory
(e.g., via configfs), causing a Use-After-Free (UAF) that triggers a
NULL pointer dereference when the freed memory is zeroed:
[39430.908615][ T1171] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
[39430.911397
USB: idmouse: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: idmouse: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use t
In the Linux kernel, the following vulnerability has been resolved:
USB: ldusb: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect
Submitted write URBs are not stopped on close() and therefore need to be
stopped unconditionally on disconnect() to avoid use-after-free in the
completion handler.
USB: iowarrior: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: iowarrior: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still use the lock object
USB: legousbtower: fix use-after-free on disconnect race
In the Linux kernel, the following vulnerability has been resolved:
USB: legousbtower: fix use-after-free on disconnect race
mutex_unlock() may access the mutex structure after releasing the lock
and therefore cannot be used to manage lifetime of objects directly
(unlike spinlocks and refcounts). [1][2]
Use a kref to release the driver data to avoid use-after-free in
mutex_unlock() when release() races with disconnect().
[1] a51749ab34d9 ("locking/mutex: Document that mutex_unlock() is
non-atomic")
[2] 2b9d9e0a9ba0 ("locking/mutex: Clarify that mutex_unlock(), and most
other sleeping locks, can still
In the Linux kernel, the following vulnerability has been resolved:
usb: mtu3: unmap request DMA on queue failure
mtu3_gadget_queue() maps the request before checking whether
the QMU GPD ring can accept another transfer. the request is
returned with -EAGAIN before it is linked on the endpoint
request list if mtu3_prepare_transfer() fails.
Normal completion and dequeue paths unmap requests from
mtu3_req_complete(), but this error path never reaches that
helper, so the DMA mapping is left active. Unmap the request
before returning from the failed queue path.
USB: serial: digi_acceleport: fix broken rx after throttle
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix broken rx after throttle
If the port is closed while throttled, the read urb is never resubmitted
and the port will not receive any further data until the device is
reconnected (or the driver is rebound).
Clear the throttle flags and submit the urb if needed when opening the
port.
USB: serial: digi_acceleport: fix hard lockup on disconnect
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix hard lockup on disconnect
If submitting the OOB write urb fails persistently (e.g if the device is
being disconnected) the driver would loop indefinitely with interrupts
disabled.
Check for urb submission errors when sending OOB commands to avoid
hanging if, for example, open(), set_termios() or close() races with a
physical disconnect.
This is issue was flagged by Sashiko when reviewing an unrelated change
to the driver.
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix write buffer corruption
The digi_write_inb_command() is supposed to wait for the write urb to
become available or return an error, but instead it updates the transfer
buffer and tries to resubmit the urb on timeout.
To make things worse, for commands like break control where no timeout
is used, the driver would corrupt the urb immediately due to a broken
jiffies comparison (on 32-bit machines this takes five minutes of uptime
to trigger due to INITIAL_JIFFIES).
Fix this by adding the missing return on timeout and waiting
indefinitely when
USB: ulpi: fix memory leak on registration failure
In the Linux kernel, the following vulnerability has been resolved:
USB: ulpi: fix memory leak on registration failure
The allocated device name is never freed on early ULPI device
registration failures.
Fix this by initialising the device structure earlier and releasing the
initial reference whenever registration fails.
In the Linux kernel, the following vulnerability has been resolved:
usbip: vudc: fix NULL deref in vep_dequeue()
vep_alloc_request() wasn't initializing vrequest->udc, so cancellations
on the FunctionFS AIO path were arriving in vep_dequeue without a valid
UDC reference.
Since vrequest->udc is never actually properly used anywhere, we opt to
remove it, and update vep_dequeue to obtain a reference to the udc with
ep_to_vudc(), consistent with the other vep_ ops.
AFAICT this bug has existed for ~10 years. Seems that nobody has really
stressed the FunctionFS AIO path on usbip's vudc.
I tested this fix in a QEMU aarch64 guest driving Functio
udf: validate VAT header length against the VAT inode size
In the Linux kernel, the following vulnerability has been resolved:
udf: validate VAT header length against the VAT inode size
udf_load_vat() takes the virtual partition's start offset straight from
the on-disk VAT 2.0 header without checking it against the VAT inode
size:
map->s_type_specific.s_virtual.s_start_offset =
le16_to_cpu(vat20->lengthHeader);
map->s_type_specific.s_virtual.s_num_entries =
(sbi->s_vat_inode->i_size -
map->s_type_specific.s_virtual.s_start_offset) >> 2;
lengthHeader is a fully attacker-controlled 16-bit value. If it exceeds
the VAT inode size, the s_num_entries subtraction underflows to a huge
count, wh
udf: validate sparing table length as an entry count, not a byte count
In the Linux kernel, the following vulnerability has been resolved:
udf: validate sparing table length as an entry count, not a byte count
udf_load_sparable_map() accepts a sparing table when
sizeof(*st) + le16_to_cpu(st->reallocationTableLen) > sb->s_blocksize
is false, i.e. it treats reallocationTableLen as a number of BYTES that
must fit in the block. But the table is walked as an array of 8-byte
sparingEntry elements:
for (i = 0; i < le16_to_cpu(st->reallocationTableLen); i++) {
struct sparingEntry *entry = &st->mapEntry[i];
... entry->origLocation ...
}
in udf_get_pblock_spar15() and udf_relocate_blocks(). A
reallocationTa
nvmet: fix pre-auth out-of-bounds heap read in Discovery Get Log Page
In the Linux kernel, the following vulnerability has been resolved:
nvmet: fix pre-auth out-of-bounds heap read in Discovery Get Log Page
nvmet_execute_disc_get_log_page() validates only the dword alignment
of the host-supplied Log Page Offset (lpo). The 64-bit offset is then
added to a small kzalloc'd buffer that holds the discovery log page
and the result is passed straight to nvmet_copy_to_sgl(), which
memcpy()s data_len bytes out to the host with no source-side bound
check:
u64 offset = nvmet_get_log_page_offset(req->cmd); /* 64-bit host */
size_t data_len = nvmet_get_log_page_len(req->cmd); /* 32-bit host */
...
partitions: aix: bound the pp_count scan to the ppe array
In the Linux kernel, the following vulnerability has been resolved:
partitions: aix: bound the pp_count scan to the ppe array
aix_partition() reads the physical volume descriptor into a fixed-size
struct pvd and then scans its physical-partition-extent array:
int numpps = be16_to_cpu(pvd->pp_count);
...
for (i = 0; i < numpps; i += 1) {
struct ppe *p = pvd->ppe + i;
...
lp_ix = be16_to_cpu(p->lp_ix);
pvd points at a single kmalloc()'d struct pvd whose ppe[] member holds a
fixed ARRAY_SIZE(pvd->ppe) (1016) entries, but the loop runs up to the
on-disk pp_count. pp_count is an unvalidated __be16 read straight from
the descriptor, s
isofs: bound Rock Ridge symlink components to the SL record
In the Linux kernel, the following vulnerability has been resolved:
isofs: bound Rock Ridge symlink components to the SL record
get_symlink_chunk() and the SL handling in
parse_rock_ridge_inode_internal() walk the variable-length components of
a Rock Ridge "SL" (symbolic link) record. Each component is a two-byte
header (flags, len) followed by len bytes of text, so it occupies
slp->len + 2 bytes. Both loops read slp->len and advance to the next
component, and get_symlink_chunk() additionally does
memcpy(rpnt, slp->text, slp->len), but neither checks that the component
lies within the SL record before dereferencing it.
A crafted SL recor