nvdimm/btt: reject an arena whose nfree is below the lane count
In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: reject an arena whose nfree is below the lane count
The BTT info block's nfree field, the number of reserve free blocks, is
read from the medium without validation. btt_freelist_init() and
btt_rtt_init() size the per-lane freelist[] and rtt[] arrays by nfree,
but the I/O path indexes them by the lane from nd_region_acquire_lane(),
which is bounded by nd_region->num_lanes (ND_MAX_LANES), not by nfree.
A crafted or foreign arena whose nfree is below the lane count makes
freelist[lane]/rtt[lane] run past the allocation: an out-of-bounds write.
btt.rst documents t
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
In the Linux kernel, the following vulnerability has been resolved:
parisc: eisa: Fix infinite loop when parsing invalid IRQ value
When an invalid value is passed via the "eisa_irq_edge=" kernel
command line parameter (e.g. "eisa_irq_edge=16,5"), eisa_irq_setup()
prints an error message and continues without advancing the current
position. As a result the same invalid value is parsed again and
again, causing an infinite loop while the kernel boots.
Advance to the next comma-separated entry, or stop parsing when there
is no next entry, before continuing so that the remaining entries are
processed normally.
In the Linux kernel, the following vulnerability has been resolved:
mtd: afs: validate v2 image info bounds
The AFS v2 parser uses footer[8] to locate the image information block
inside the current erase block, then uses the image information
region_count to walk entries from a fixed local array. The footer offset
and region count come from flash contents and are not checked against the
erase block or the local image-info array before use.
Reject v2 entries whose image information offset would underflow the
erase block calculation, and reject region counts that cannot fit in the
local image-info array before walking region entries.
mtd: mtdoops: free page bitmap when the backing MTD is removed
In the Linux kernel, the following vulnerability has been resolved:
mtd: mtdoops: free page bitmap when the backing MTD is removed
mtdoops_notify_add() allocates oops_page_used when the configured MTD
device is registered. mtdoops_notify_remove() detaches from that device
but leaves the bitmap allocated. If the same MTD device is later
registered again, the add path allocates a new bitmap and overwrites the
old pointer, leaking one vmalloc allocation per remove/add cycle.
This is only visible when the backing MTD device can disappear and be
registered again while mtdoops remains loaded, so the usual static MTD
case does not expose it.
F
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: validate ONFI extended parameter page sections
nand_flash_detect_ext_param_page() allocates the length declared by the
ONFI parameter page, then treats the data as a fixed header followed by
variable-length sections. It reads that header and advances over sections
without first proving that the fixed page and each current section fit in
the allocation.
Reject pages shorter than the fixed header, track the remaining variable
area while walking sections, and require the ECC section to contain every
field read from struct onfi_ext_ecc_info. Use device-scoped dia
batman-adv: fix stale receive device on merged fragments
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: fix stale receive device on merged fragments
Fragment reassembly reuses the skb from the highest-numbered buffered
fragment as the merged packet. When that fragment was received on a hard
interface which is deleted before the chain completes, the merged skb can
re-enter the receive path with a stale skb->dev and skb_iif.
batadv_batman_skb_recv() passes such merged packets through the normal
receive handlers again. DAT and bridge loop avoidance both derive the ARP
header length from skb->dev, so they can dereference the freed net_device
before the packet reaches
batman-adv: dat: avoid unaligned fault in IP extraction
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: dat: avoid unaligned fault in IP extraction
Independent of the alignment of the ARP packet in the SKB, either the
batadv_arp_ip_src or the batadv_arp_ip_dst will have an unaligned access
(on HW without native unaligned read support).
Use get_unaligned() to handle this properly on all architectures.
batman-adv: bla: fix freeing of claims on meshif deletion
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: bla: fix freeing of claims on meshif deletion
When the mesh interface is getting deleted, then
batadv_bla_del_backbone_claims() (via batadv_bla_purge_backbone_gw()) could
make sure that all claims gets removed. But this function is only executed
when bat_priv->bla.claim_hash is not NULL. And since batadv_bla_free() is
always setting it to NULL before it is (indirectly) called, it was never
actually executed.
But the batadv_bla_purge_claims() -> batadv_handle_unclaim() is at the
moment too fragile because the BLA code is not handling the rehashing in
batadv_bla_
ASoC: cs35l33: drain threaded IRQ before runtime suspend
In the Linux kernel, the following vulnerability has been resolved:
ASoC: cs35l33: drain threaded IRQ before runtime suspend
cs35l33_runtime_suspend() currently switches the codec into
regcache_cache_only(true) and powers it down without first quiescing the
threaded IRQ registered by devm_request_threaded_irq(). That leaves a
window where cs35l33_irq_thread() can still run after suspend has closed
off live register access.
A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1/2 after cache_only has been
enabled,
ASoC: cs35l34: drain threaded IRQ before runtime suspend
In the Linux kernel, the following vulnerability has been resolved:
ASoC: cs35l34: drain threaded IRQ before runtime suspend
cs35l34_runtime_suspend() currently switches the codec into
regcache_cache_only(true), asserts reset low, and powers the device off
without first quiescing the threaded IRQ registered by
devm_request_threaded_irq(). That leaves a window where
cs35l34_irq_thread() can still run after suspend has removed live
hardware access.
A running system can reach this during runtime PM while the driver still
has critical fault IRQs unmasked. If the threaded handler runs in that
window, it reads volatile INT_STATUS_1..4 after cach
ASoC: hdac_hda: Fix hlink refcount leak on component registration failure
In the Linux kernel, the following vulnerability has been resolved:
ASoC: hdac_hda: Fix hlink refcount leak on component registration failure
hdac_hda_dev_probe() gets the HDA link with snd_hdac_ext_bus_link_get()
before registering the ASoC component. If component registration fails,
the function returns without dropping the link reference.
Always call snd_hdac_ext_bus_link_put() after the registration attempt so
the reference taken during probe is balanced on both success and failure.
iio: chemical: atlas-sensor: use iio_trigger_poll_nested() to fix remove UAF
In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: atlas-sensor: use iio_trigger_poll_nested() to fix remove UAF
The atlas driver requests its hardware data-ready IRQ with
devm_request_threaded_irq(); its threaded handler queues an irq_work,
atlas_work_handler(), that calls iio_trigger_poll(data->trig).
The IRQ is devm-managed, so free_irq() runs from the devres unwind after
atlas_remove() returns without flushing that irq_work. Once a buffer is
enabled, conversion-complete IRQs keep firing and queueing it; a pending
irq_work can therefore run after the unwind has freed atlas_data/indio_dev
and the trigger,
In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: sgp30: Handle IAQ thread creation failure
kthread_run() can fail and return an error pointer, but sgp_probe() stores
it and returns success, so the device is registered without its IAQ thread
and sgp_remove() later passes the error pointer to kthread_stop(). Return
the error from probe instead.
In the Linux kernel, the following vulnerability has been resolved:
iio: dac: m62332: Fix regulator reference count imbalance
m62332_set_value() enables the Vcc regulator on every write of a
non-zero value and disables it on every write of zero, without tracking
the channel's current state. Because the regulator is reference counted,
changing a channel directly from one non-zero value to another enables
it more than once, while a later write of zero disables it only once.
The reference count never returns to zero and the regulator is left
enabled indefinitely.
Only enable the regulator on the transition from zero to non-zero, and
only disa
In the Linux kernel, the following vulnerability has been resolved:
KVM: nVMX: Always flush vpid02 on first use
Make sure vpid02 is always flushed on first use by setting last_vpid=0
when allocating vpid02. nested_vmx_transition_tlb_flush() will always
detect a VPID change on first VM-Enter after VMXON, because VPID=0 in
vmcs12 is not allowed if L1 enables VPID.
This avoids using stale TLB entries from a previous lifetime of the
VPID, that might have been associated with a different vCPU (or a
completely different VM).
Note that last_vpid is already being initialized as 0 when the vCPU is
created, but it is not reset when vpid02 is freed
KVM: nVMX: Service local TLB flushes on failed nested VM-Enter
In the Linux kernel, the following vulnerability has been resolved:
KVM: nVMX: Service local TLB flushes on failed nested VM-Enter
KVM services local TLB flushes on "full" nested VM-Exits (through
__nested_vmx_vmexit()), but not if a nested VM-Enter fails (e.g. due to
failed VMCS checks in nested_vmx_enter_non_root_mode()).
However, it is possible that KVM had queued TLB flushes that need to be
performed, even if the nested VM-Enter was not successful. For example,
if VPID is disabled for L2 (via nested_vmx_transition_tlb_flush(), or if
via the MSR load lists, as the SDM says:
If any MSR is being loaded in such a way that would architec
KVM: nVM: Ensure INVVPID is emulated on the correct physical CPU
In the Linux kernel, the following vulnerability has been resolved:
KVM: nVM: Ensure INVVPID is emulated on the correct physical CPU
When emulating INVVPID, KVM executes INVVPID on the physical CPU using
vpid02 (instead of the L1 assigned VPID), after doing some validations
on the operands. However, it is possible that the physical CPU KVM
executes INVVPID on is different from the CPU L2 is running on.
For example, in the following scenario:
- L2 runs on CPU #1 and exits to L1 (vmx->nested.vmcs02.cpu=1)
- L1 migrates to CPU #2 and executes INVVPID
- KVM executes INVVPID on CPU #2
- L1 migrates back to CPU #1 and runs L2 (vmx->nested.vmcs02
KVM: x86: hyper-v: Clamp stimer deadline to avoid livelock
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: hyper-v: Clamp stimer deadline to avoid livelock
Fix an issue where userspace or the guest can program an Hyper-V
synthetic timer to have a deadline in the past via integer overflow,
preventing the CPU from making progress and triggering an RCU stall.
Hyper-V's SynIC exposes 4 per-vCPU synthetic timers to the
guest, which are emulated by KVM. Each is programmed through the
HV_X64_MSR_STIMERi_CONFIG and HV_X64_MSR_STIMERi_COUNT MSRs. Depending
on CONFIG, COUNT represents either the absolute expiration time or the
period of a periodic timer, both expressed in 100ns
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Fix length check __import_wp_info()
struct kvm_hw_breakpoint::len is a __u64 that is fully controlled by user
space. This is then assigned to wp_info->len, which is an int. The bounds
check is done on the truncated value while the allocation uses the
untruncated one:
wp_info->len = bp_data->len;
[...]
if (wp_info->len < 0 || wp_info->len > MAX_WP_SIZE)
return -EINVAL;
wp_info->old_data = kmalloc(bp_data->len, GFP_KERNEL_ACCOUNT);
Use the validated value for the allocation as intended. Without this
fix userspace can trigger >4GB allocations which will fai
KVM: s390: Fix memory leak in guest debug handling
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: Fix memory leak in guest debug handling
bp_data is freed only for the error case by kfree(bp_data).
Every successful KVM_SET_GUEST_DEBUG will leak bp_data.