Bluetooth: HIDP: reject frames without a transaction header
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: reject frames without a transaction header
hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0]
before checking that the L2CAP SDU contains a transaction header. A
connected HIDP peer can send an empty basic-mode SDU and make both paths
use an uninitialized byte from skb tailroom.
KMSAN reports the use in hidp_session_run(), with the uninitialized value
originating in __alloc_skb() through vhci_write(). The control path
produces two reports and the interrupt path produces one.
The byte can also be controlled by a malformed lower-layer packe
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: validate numbered report payloads
When hidp_get_raw_report() waits for a numbered report,
hidp_process_data() compares the expected report number with skb->data[0].
A connected HIDP peer can reply with only a DATA transaction header,
leaving the skb empty after the header is removed.
KMSAN reports an uninitialized-value use in hidp_session_run(), with the
value originating in __alloc_skb() through vhci_write(). The transaction
header checks remove the empty-frame reports, but this report remains until
the payload check is added.
The comparison can also co
ALSA: 6fire: Fix UAF at error handling during probe
In the Linux kernel, the following vulnerability has been resolved:
ALSA: 6fire: Fix UAF at error handling during probe
Although 6fire driver had a few fixes for dealing with the early error
handling during the probe phase, it forgot a pending URB before
freeing the resources, which may lead to a UAF.
This patch addresses it by doing the almost same cleanup procedure
like the normal disconnect phase at the error path.
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
snd_usbmidi_akai_output() computes its fill-loop bound
buf_end = ep->max_transfer - MAX_AKAI_SYSEX_LEN - 1;
as a signed int, so a small device-advertised bulk-OUT max_transfer
makes buf_end negative. The loop guard then compares the u32
urb->transfer_buffer_length against that negative int: the usual
arithmetic conversion turns buf_end into a large unsigned value, so the
guard stays true and each iteration keeps appending SysEx framing and
payload bytes past the end of the URB transfer buffer, which is only
max
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
When a USB audio endpoint requests full packet transfers via the fill_max
descriptor flag, data_ep_set_params() promotes ep->curpacksize to
ep->maxpacksize. However, maxsize is left at the original sample-rate
derived value.
Since u->buffer_size is allocated as maxsize * packets, the resulting
DMA buffer is far too small for the requested transfer length. When the
USB host controller streams up to curpacksize bytes per packet, it writes
past the end of the buffer via DMA, corrupting kernel heap memory
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
snd_usb_handle_sync_urb() scales received sync packet sizes by the sender's
stride and stores the result directly in out_packet->packet_size[i]. If a
connected USB device sends an oversized sync packet, this frame count can
exceed ep->maxframesize.
The un-clamped frame count then propagates to the playback endpoint queue,
potentially driving packet transfers beyond the endpoint's hardware frame
limits.
Cap the calculated frame count against ep->maxframesize in
snd_usb_handle_sync_urb() to prevent oversized packet
In the Linux kernel, the following vulnerability has been resolved:
fou: Fix use-after-free in fou_create()
fou_create() publishes struct fou through sk_user_data before adding the
new FOU port to the per-netns list. If fou_add_to_port_list() fails,
the error path frees fou while it is still reachable through
sk_user_data. A concurrent receive can then dereference the freed
object in fou_from_sock().
This ordering issue was previously noted in the linked discussion.
The failure is reachable when local port 0 is requested. Each socket
binds to a different ephemeral port, but fou_cfg_cmp() compares the
requested port 0 and reports -EALRE
In the Linux kernel, the following vulnerability has been resolved:
igbvf: Fix leak in TX DMA error cleanup
If an error is encountered while mapping TX buffers, the driver should
unmap any buffers already mapped for that skb.
Because count is incremented before each frag mapping, it will always
match the correct number of unmappings needed when dma_error is reached.
Decrementing count before the while loop in dma_error causes an
off-by-one error. If any mapping was successful before an unsuccessful
mapping, exactly one DMA mapping (the head) would leak.
This bug was introduced by a 2010 fix for an endless loop in dma_error.
All other affe
binfmt_misc: reject a flag character as the field delimiter
In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: reject a flag character as the field delimiter
The registration string starts with a user chosen delimiter that
separates the individual fields. So that the field parsers terminate
even on a truncated string create_entry() pads the buffer with that
same delimiter:
memset(buf + count, del, 8);
Most fields are scanned for the delimiter with strchr()/scanarg() and
happily stop on the padding. The flags field is different: instead of
scanning for the delimiter check_special_flags() consumes the flag
characters 'P', 'O', 'C' and 'F' and stops at the first byte th
In the Linux kernel, the following vulnerability has been resolved:
net: pktgen: fix proc entry use-after-free
pktgen_change_name() replaces pkt_dev->entry while holding t->if_lock.
pktgen_remove_device() removes the same entry before
_rem_dev_from_if_list() takes that lock.
This allows the following interleaving:
CPU 0 (NETDEV_CHANGENAME) CPU 1 (kpktgend)
if_lock(t)
proc_remove(pkt_dev->entry)
proc_remove(pkt_dev->entry)
pkt_dev->entry = proc_create_data(...)
if_unlock(t)
The kthread can pass the stale proc_dir_entry to proc_remove() after the
rename path has freed it. A reproducer with
vxlan: use neigh_ha_snapshot() in route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use neigh_ha_snapshot() in route_shortcircuit()
The neighbour hardware address n->ha can be updated asynchronously by the
neighbour subsystem, protected by n->ha_lock seqlock. Reading n->ha without
holding the seqlock loop can lead to torn reads or reading a partially updated
MAC address.
Use neigh_ha_snapshot() in route_shortcircuit() to safely copy n->ha under
read_seqbegin()/read_seqretry() lock protection before using it.
Note that arp_reduce() and neigh_reduce() seem to have the same issue
left for future patches.
vxlan: use pskb_network_may_pull() for transmit path header pulls
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use pskb_network_may_pull() for transmit path header pulls
In vxlan_xmit(), arp_reduce(), and vxlan_mdb_entry_skb_get(), pskb_may_pull() was
being called to verify the availability of network layer headers (ARP, IPv6/ND,
IP/IPv6 MDB keys).
However, during transmit skb->data points to the MAC header, so skb_network_offset(skb)
is ETH_HLEN (14 bytes). Using pskb_may_pull(skb, len) only checks len bytes from skb->data
rather than skb_network_offset(skb) + len, which can leave part of the network header
in non-linear frags.
Replace these remaining pskb_may_pull() calls
vxlan: use pskb_network_may_pull() in route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: use pskb_network_may_pull() in route_shortcircuit()
route_shortcircuit() currently calls pskb_may_pull(skb, sizeof(struct iphdr))
(or ipv6hdr), which checks if bytes are available starting from skb->data.
However, in vxlan_xmit(), skb->data points to the MAC header, so
skb_network_offset(skb) is ETH_HLEN (14 bytes). Using pskb_may_pull(skb, 20)
only checks 20 bytes from skb->data (which is 14 bytes MAC header + 6 bytes of
IP header), leaving the rest of the IP header potentially un-pulled in non-linear
frags. Subsequent dereferences of ip_hdr(skb)->daddr can read be
tracing: Check return value of __register_event() in trace_module_add_events()
In the Linux kernel, the following vulnerability has been resolved:
tracing: Check return value of __register_event() in trace_module_add_events()
trace_module_add_events() ignores the return value of __register_event()
and unconditionally calls __add_event_to_tracers() for each event.
If __register_event() fails (for example, if event_init() fails), the
trace_event_call is not added to ftrace_events list, but
__add_event_to_tracers() still creates a trace_event_file pointing to it.
If module loading subsequently fails and module memory is freed, tracing
state retains a stale trace_event_call pointer in trace_event_file,
leading to a use-a
gpio: pch: use raw_spinlock_t for the register lock
In the Linux kernel, the following vulnerability has been resolved:
gpio: pch: use raw_spinlock_t for the register lock
pch_irq_type() is registered as the irq_chip .irq_set_type callback and
takes chip->spinlock with spin_lock_irqsave(). This callback is reached
from __setup_irq() -> __irq_set_trigger() -> chip->irq_set_type() while
the caller holds desc->lock, a raw_spinlock_t, with hardirqs disabled.
That context is not sleepable, but on PREEMPT_RT a regular spinlock_t is
an rtmutex-backed sleeping lock, so acquiring it there is invalid.
This was confirmed on a PREEMPT_RT kernel with lockdep
(PROVE_RAW_LOCK_NESTING and DEBUG_ATOMIC_SLE
net: openvswitch: fix skb leak on flow key update failure during ct
In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix skb leak on flow key update failure during ct
ovs_ct_execute() always steals or frees the skb on failure while
ovs_flow_key_update() does not. So, if it fails and we return right
away, the skb ends up leaked.
Fix that by breaking instead and letting the common error handling
code at the bottom of the loop to free the skb properly.
This is a very unlikely scenario as it requires the packet to become
unparseable by applying a set of actions on a previously parseable skb,
but should be fixed nevertheless.
Reported by Sashiko.
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
In the Linux kernel, the following vulnerability has been resolved:
i2c: jz4780: Cache host clock rate at probe to prevent CCF prepare_lock deadlock
Fix a severe AB/BA deadlock between the Common Clock Framework (CCF)
and the I2C adapter lock, which triggers when an I2C-controlled clock
generator client (like the Si5351) is registered or modified under the CCF.
During an i2c client clock (generator) frequency change, the CCF acquires its global
'prepare_lock' mutex and the driver calls i2c_transfer() to update the client's
chip registers, stalling for the adapter's I2C bus lock.
Concurrently, an independent, parallel transfer on the same
In the Linux kernel, the following vulnerability has been resolved:
can: ems_usb: validate CPC message lengths
ems_usb_read_bulk_callback() walks CPC messages packed in one USB
receive buffer.
Check that each declared message fits in the URB payload. Also require the
type-specific payload to cover the fields used by the CAN, state, error and
overrun handlers.
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
In the Linux kernel, the following vulnerability has been resolved:
can: kvaser_usb_leaf: kvaser_usb_leaf_wait_cmd(): validate received command extents
The wait and bulk receive paths walk variable-length commands from a
USB buffer. A nonzero command shorter than CMD_HEADER_LEN can still be
dispatched, and the wait path copies a matching command into a fixed
caller-owned struct kvaser_cmd using the device-provided length.
Reject nonzero commands that do not contain the fixed header or that
extend beyond the current USB buffer item. In the wait path, also reject
a matching command that exceeds the destination before copying it.
can: peak_usb: add bounds check for USB channel index
In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: add bounds check for USB channel index
The channel control index ctrl_idx is derived from rx->len which comes
directly from a device USB payload. The mask 0x0f allows values 0-15, but
the array size of usb_if->dev[] is only 2. Values 2-15 cause heap
out-of-bounds read, eventually causing kernel panic in the IRQ context.
Add bounds checking for ctrl_idx before the array access in both
pcan_usb_pro_handle_canmsg() and pcan_usb_pro_handle_error().