wifi: rt2x00: avoid full teardown before work setup in probe
In the Linux kernel, the following vulnerability has been resolved:
wifi: rt2x00: avoid full teardown before work setup in probe
rt2x00lib_probe_dev() uses the full rt2x00lib_remove_dev() teardown for
all probe failures. However, drv_data allocation and workqueue allocation
can fail before intf_work, autowakeup_work and sleep_work have been
initialized.
Do not enter the full remove path until the probe has reached the point
where those work items are set up. Return directly for drv_data allocation
failure, and use a small early cleanup path for workqueue allocation
failure.
This issue was found by our static analysis tool and then confirm
wifi: mac80211: fix memory leak in ieee80211_register_hw()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix memory leak in ieee80211_register_hw()
If kmemdup() fails while copying supported band structures, the error
path jumps to fail_rate. This skips rate_control_deinitialize() and
leaks the initialized local->rate_ctrl.
Fix this by adding a fail_band label that shares the rate-control cleanup
path before falling through to the remaining teardown.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Man
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btrtl: validate firmware patch bounds
rtlbt_parse_firmware() copies patch_length - 4 bytes before appending the
firmware version. A malformed firmware patch shorter than the version field
can make this subtraction underflow and turn the copy into an oversized
read and write during Bluetooth setup.
The existing patch_offset + patch_length check can also wrap on 32-bit
architectures. Validate the patch length and range without arithmetic
overflow before allocating or copying the patch.
memstick: ms_block: reject a card that reports too many blocks
In the Linux kernel, the following vulnerability has been resolved:
memstick: ms_block: reject a card that reports too many blocks
msb_ftl_initialize() computes the zone count from the card block count
with no bound:
msb->zone_count = msb->block_count / MS_BLOCKS_IN_ZONE;
...
for (i = 0; i < msb->zone_count; i++)
msb->free_block_count[i] = MS_BLOCKS_IN_ZONE;
msb->block_count is a card value. msb_read_boot_blocks() reads
number_of_blocks from the card boot page and byte swaps it.
free_block_count is a fixed int[MS_MAX_ZONES]. MS_MAX_ZONES is 16, so the
valid indices are 0 to 15. The init loop above indexes it by zone_count.
msb_mark_b
ipvs: fix more places with wrong ipv6 transport offsets
In the Linux kernel, the following vulnerability has been resolved:
ipvs: fix more places with wrong ipv6 transport offsets
Sashiko reports for more incorrect IPv6 transport offsets.
The app code for TCP was assuming IPv4 network header
even after the ipvsh argument was provided. This can
cause problems with apps over IPv6. As for the only
official app in the kernel tree (FTP) this problem is
harmless because we use Netfilter to mangle the FTP
ports and we do not adjust the TCP seq numbers.
Also, provide correct offset of the ICMPV6 header in
ip_vs_out_icmp_v6() for correct checksum checks when
the IPv6 packet has extension headers.
In the Linux kernel, the following vulnerability has been resolved:
ipvs: reload ip header after head reallocation
__ip_vs_get_out_rt() calls skb_ensure_writable() which may
reallocate skb->head.
reset: sunxi: fix memory region leak on ioremap failure
In the Linux kernel, the following vulnerability has been resolved:
reset: sunxi: fix memory region leak on ioremap failure
In sunxi_reset_init(), when ioremap() fails, the memory region obtained
via request_mem_region() is not released, leading to a resource leak.
Add an err_mem_region label to properly release the memory region before
freeing the data structure.
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
In the Linux kernel, the following vulnerability has been resolved:
powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()
spufs_mem_mmap_access() computes the local store offset as
address - vma->vm_start, but bounds-checks it against vma->vm_end
instead of the local store size. On 64-bit, offset is always well
below vma->vm_end, so the clamp never fires and len stays unbounded
against the LS_SIZE buffer returned by ctx->ops->get_ls().
Reject offsets at or beyond LS_SIZE and clamp len to the remaining
space, mirroring the guard already used by spufs_mem_mmap_fault() and
spufs_ps_fault().
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: fix permanently busy scans after multiple roam iterations
In order for the firmware to sleep, the driver has to confirm a
previously received sleep request. The normal sequence of evets goes
like this:
EVENT_SLEEP -> adapter->ps_state = PS_STATE_PRE_SLEEP -> sleep-confirm
-> SLEEP -> EVENT_AWAKE -> AWAKE.
Before sending the sleep-confirm command, the driver must make sure
there are no commands either running or waiting to be completed.
mwifiex_ret_802_11_associate() unconditionally sets
ps_state = PS_STATE_AWAKE when it processes the association command
resp
In the Linux kernel, the following vulnerability has been resolved:
mtd: mchp23k256: use SPI match data for chip caps
The driver stores chip capacity information in both the OF match table
and the SPI id table. Probe currently uses of_device_get_match_data(),
so a non-OF SPI modalias match falls back to mchp23k256_caps even when
the SPI id table selected a different part.
Use spi_get_device_match_data() so SPI id-table driver_data is consumed
when OF match data is absent. This keeps the existing default fallback
while avoiding the wrong MTD geometry for id-table-only matches.
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout
lpc32xx_xmit_dma() waits for the DMA completion callback but ignores
wait_for_completion_timeout(). A timed out DMA transfer is therefore
unmapped and reported as successful to the NAND read/write path.
Return -ETIMEDOUT when the completion wait expires. Terminate the DMA
channel before unmapping the scatterlist so the timed out transfer cannot
continue to access the buffer after the error is returned.
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix potential deadlock in f2fs_balance_fs()
When the f2fs filesystem space is nearly exhausted, we encounter deadlock
issues as below:
INFO: task A:1890 blocked for more than 120 seconds.
Tainted: G O 6.12.41-g3fe07ddf05ab #1
"echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
task:A state:D stack:0 pid:1890 tgid:1626 ppid:1153 flags:0x00000204
Call trace:
__switch_to+0xf4/0x158
__schedule+0x27c/0x908
schedule+0x3c/0x118
io_schedule+0x44/0x68
folio_wait_bit_common+0x174/0x370
folio_wait_bit+0x20/0x38
folio
f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs()
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs()
When we mount device w/ gc_merge mount option, we may suffer below
potential deadlock:
Kworker GC trehad Truncator
- f2fs_write_cache_pages
- f2fs_write_single_data_page
- f2fs_do_write_data_page
- folio_start_writeback --- set writeback flag on folio
- f2fs_outplace_write_data
: cached folio in internal bio cache
- f2fs_balance_fs
- wake_up(gc_thread)
: wake up gc thread to run foreground GC
- finish_wait(fggc_wq)
: wait on the waitqueue --- wait on GC thread to finish the
usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect()
In the Linux kernel, the following vulnerability has been resolved:
usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect()
ueagle-atm uses the asynchronous request_firmware_nowait() in .probe(),
but does not wait for its completion, not even in .disconnect(); so, if the
device is unplugged meanwhile, its teardown runs concurrently with that.
Even though this inconsistency is worth addressing on its own, it has also
triggered several bug reports in syzbot over the years (some auto-closed)
where the firmware sysfs fallback mechanism (CONFIG_FW_LOADER_USER_HELPER)
creates a firmware subdirectory in the device directory during its r
s390/zcrypt: Fix buffer over-read in cca_cipher2protkey
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix buffer over-read in cca_cipher2protkey
Add validation of both the actual key buffer size and token length
fields in all the cca_check_sec*token() functions. Additionally check
in cca_gencipherkey() for possible underflow with returned key size.
The CCA token structures contain user-controlled len fields that
were used in operations without proper validation against both the
actual buffer size and minimum token structure size. An attacker
could set this field larger than the actual buffer size, leading to
reading beyond buffer boundaries. This may result in
s390/zcrypt: Validate length for CCA AES cipher key requests
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Validate length for CCA AES cipher key requests
cca_cipher2protkey() derives the copy length for the CPRB parameter
block directly from the length field in the key token. Reject the
request early if the token length exceeds the available space in the
parameter block.
ata: sata_dwc_460ex: fix infinite loop in NCQ tag completion bit-scanning
In the Linux kernel, the following vulnerability has been resolved:
ata: sata_dwc_460ex: fix infinite loop in NCQ tag completion bit-scanning
The hand-rolled bit-scanning loop in the NCQ completion path has an
infinite loop bug. When tag_mask has only high bits set (e.g.
0x80000000), the inner while loop left-shifts tag_mask until it
overflows to 0. At that point !(0 & 1) is always true and 0 <<= 1
stays 0, causing an infinite loop in hardirq context with a spinlock
held.
Replace the open-coded bit-scanning with __ffs() which correctly
finds the least significant set bit and is bounded by the width of
the argument.
ovl: check access to copy_file_range source with src mounter creds
In the Linux kernel, the following vulnerability has been resolved:
ovl: check access to copy_file_range source with src mounter creds
Commit 5dae222a5ff0c ("vfs: allow copy_file_range to copy across devices")
allowed filesystems that implement the copy_file_range() f_op to decide
if they want to access cross-sb copy from/to the same fs type.
The same commit added checks to verify same sb copy for filesystems that
implement ->copy_file_range() and do not support cross-sb copy at the
time, namely, to ceph, fuse and nfs.
The two remaining fs which implement ->copy_file_range(), cifs and
overlayfs started to support cross-sb copy from this t
drm/amdkfd: clamp v9 CRIU control stack checkpoint copy to BO size
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: clamp v9 CRIU control stack checkpoint copy to BO size
CRIU checkpoint copies the MQD control stack using cp_hqd_cntl_stack_size
from hardware without bounding it to the allocated BO region. If the HW
field is larger than the queue's control stack allocation, memcpy reads
past the BO into adjacent GTT memory and can leak kernel data to userspace.
Store the page-aligned control stack BO size in mqd_manager and clamp
checkpoint copies and reported checkpoint sizes to
min(cp_hqd_cntl_stack_size, mm->ctl_stack_size). Apply the same bound
for multi-XCC v9.4.3 checkp
drm/vc4: Prevent shader BO mappings from becoming writable
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: Prevent shader BO mappings from becoming writable
vc4_gem_object_mmap() rejects a writable mapping of a validated shader
BO, but leaves VM_MAYWRITE set. Userspace can map the BO read-only and
then turn it writable with mprotect().
Validated shader BOs must stay read-only: the validator checks the
instructions once and the GPU trusts them afterwards. A writable
mapping lets userspace rewrite the code after validation, bypassing the
validator.
Clear VM_MAYWRITE on the read-only path so the mapping cannot be
upgraded, as i915 already does for its read-only objects