Vulnérabilités de linux-azure-fips · Page n° 181

ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths

In the Linux kernel, the following vulnerability has been resolved: ksmbd: call ksmbd_vfs_kern_path_end_removing() on some error paths There are two places where ksmbd_vfs_kern_path_end_removing() needs to be called in order to balance what the corresponding successful call to ksmbd_vfs_kern_path_start_removing() has done, i.e. drop inode locks and put the taken references. Otherwise there might be potential deadlocks and unbalanced locks which are caught like: BUG: workqueue leaked lock or atomic: kworker/5:21/0x00000000/7596 last function: handle_ksmbd_work 2 locks held by kworker/5:21/7596: #0: ffff8881051ae448 (sb_writers#3){.+.

• Mettez à jour vers 5.15.0-1117.126+fips1

net: usb: catc: enable basic endpoint checking

In the Linux kernel, the following vulnerability has been resolved: net: usb: catc: enable basic endpoint checking catc_probe() fills three URBs with hardcoded endpoint pipes without verifying the endpoint descriptors: - usb_sndbulkpipe(usbdev, 1) and usb_rcvbulkpipe(usbdev, 1) for TX/RX - usb_rcvintpipe(usbdev, 2) for interrupt status A malformed USB device can present these endpoints with transfer types that differ from what the driver assumes. Add a catc_usb_ep enum for endpoint numbers, replacing magic constants throughout. Add usb_check_bulk_endpoints() and usb_check_int_endpoints() calls after usb_set_interface() to verify endp

ext4: fix dirtyclusters double decrement on fs shutdown

In the Linux kernel, the following vulnerability has been resolved: ext4: fix dirtyclusters double decrement on fs shutdown fstests test generic/388 occasionally reproduces a warning in ext4_put_super() associated with the dirty clusters count: WARNING: CPU: 7 PID: 76064 at fs/ext4/super.c:1324 ext4_put_super+0x48c/0x590 [ext4] Tracing the failure shows that the warning fires due to an s_dirtyclusters_counter value of -1. IOW, this appears to be a spurious decrement as opposed to some sort of leak. Further tracing of the dirty cluster count deltas and an LLM scan of the resulting output identified the cause as a double decrement in the

• Mettez à jour vers 5.15.0-1117.126+fips1

sched/rt: Skip currently executing CPU in rto_next_cpu()

In the Linux kernel, the following vulnerability has been resolved: sched/rt: Skip currently executing CPU in rto_next_cpu() CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound RT task, and a CFS task stuck in kernel space. When other CPUs switch from RT to non-RT tasks, RT load balancing (LB) is triggered; with HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution of rto_push_irq_work_func. During push_rt_task on CPU0, if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED and after the push operation completes, CPU0 calls rto_next_cpu(). Since only CPU0 is overloaded in this scenario

• Mettez à jour vers 5.15.0-1117.126+fips1

ipvs: do not keep dest_dst if dev is going down

In the Linux kernel, the following vulnerability has been resolved: ipvs: do not keep dest_dst if dev is going down There is race between the netdev notifier ip_vs_dst_event() and the code that caches dst with dev that is going down. As the FIB can be notified for the closed device after our handler finishes, it is possible valid route to be returned and cached resuling in a leaked dev reference until the dest is not removed. To prevent new dest_dst to be attached to dest just after the handler dropped the old one, add a netif_running() check to make sure the notifier handler is not currently running for device that is closing.

power: supply: sbs-battery: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: sbs-battery: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handle

• Mettez à jour vers 5.15.0-1117.126+fips1

fat: avoid parent link count underflow in rmdir

In the Linux kernel, the following vulnerability has been resolved: fat: avoid parent link count underflow in rmdir Corrupted FAT images can leave a directory inode with an incorrect i_nlink (e.g. 2 even though subdirectories exist). rmdir then unconditionally calls drop_nlink(dir) and can drive i_nlink to 0, triggering the WARN_ON in drop_nlink(). Add a sanity check in vfat_rmdir() and msdos_rmdir(): only drop the parent link count when it is at least 3, otherwise report a filesystem error.

• Mettez à jour vers 5.15.0-1117.126+fips1

ext4: don't cache extent during splitting extent

In the Linux kernel, the following vulnerability has been resolved: ext4: don't cache extent during splitting extent Caching extents during the splitting process is risky, as it may result in stale extents remaining in the status tree. Moreover, in most cases, the corresponding extent block entries are likely already cached before the split happens, making caching here not particularly useful. Assume we have an unwritten extent, and then DIO writes the first half. [UUUUUUUUUUUUUUUU] on-disk extent U: unwritten extent [UUUUUUUUUUUUUUUU] extent status tree |<- ->| ----> dio write this range First, when ext4_split_extent_at()

• Mettez à jour vers 5.15.0-1117.126+fips1

usb: cdns3: fix role switching during resume

In the Linux kernel, the following vulnerability has been resolved: usb: cdns3: fix role switching during resume If the role change while we are suspended, the cdns3 driver switches to the new mode during resume. However, switching to host mode in this context causes a NULL pointer dereference. The host role's start() operation registers a xhci-hcd device, but its probe is deferred while we are in the resume path. The host role's resume() operation assumes the xhci-hcd device is already probed, which is not the case, leading to the dereference. Since the start() operation of the new role is already called, the resume operation can be skipp

• Mettez à jour vers 5.15.0-1117.126+fips1

xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path

In the Linux kernel, the following vulnerability has been resolved: xfrm: fix ip_rt_bug race in icmp_route_lookup reverse path icmp_route_lookup() performs multiple route lookups to find a suitable route for sending ICMP error messages, with special handling for XFRM (IPsec) policies. The lookup sequence is: 1. First, lookup output route for ICMP reply (dst = original src) 2. Pass through xfrm_lookup() for policy check 3. If blocked (-EPERM) or dst is not local, enter "reverse path" 4. In reverse path, call xfrm_decode_session_reverse() to get fl4_dec which reverses the original packet's flow (saddr<->daddr swapped) 5. If fl4_dec.saddr

powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling

In the Linux kernel, the following vulnerability has been resolved: powerpc/eeh: fix recursive pci_lock_rescan_remove locking in EEH event handling The recent commit 1010b4c012b0 ("powerpc/eeh: Make EEH driver device hotplug safe") restructured the EEH driver to improve synchronization with the PCI hotplug layer. However, it inadvertently moved pci_lock_rescan_remove() outside its intended scope in eeh_handle_normal_event(), leading to broken PCI error reporting and improper EEH event triggering. Specifically, eeh_handle_normal_event() acquired pci_lock_rescan_remove() before calling eeh_pe_bus_get(), but eeh_pe_bus_get() itself attempts t

• Mettez à jour vers 5.15.0-1117.126+fips1

power: supply: bq256xx: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: bq256xx: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler ha

• Mettez à jour vers 5.15.0-1117.126+fips1

ext4: drop extent cache when splitting extent fails

In the Linux kernel, the following vulnerability has been resolved: ext4: drop extent cache when splitting extent fails When the split extent fails, we might leave some extents still being processed and return an error directly, which will result in stale extent entries remaining in the extent status tree. So drop all of the remaining potentially stale extents if the splitting fails.

• Mettez à jour vers 5.15.0-1117.126+fips1

iommu/vt-d: Clear Present bit before tearing down PASID entry

In the Linux kernel, the following vulnerability has been resolved: iommu/vt-d: Clear Present bit before tearing down PASID entry The Intel VT-d Scalable Mode PASID table entry consists of 512 bits (64 bytes). When tearing down an entry, the current implementation zeros the entire 64-byte structure immediately using multiple 64-bit writes. Since the IOMMU hardware may fetch these 64 bytes using multiple internal transactions (e.g., four 128-bit bursts), updating or zeroing the entire entry while it is active (P=1) risks a "torn" read. If a hardware fetch occurs simultaneously with the CPU zeroing the entry, the hardware could observe an in

apparmor: Fix & Optimize table creation from possibly unaligned memory

In the Linux kernel, the following vulnerability has been resolved: apparmor: Fix & Optimize table creation from possibly unaligned memory Source blob may come from userspace and might be unaligned. Try to optize the copying process by avoiding unaligned memory accesses. - Added Fixes tag - Added "Fix &" to description as this doesn't just optimize but fixes a potential unaligned memory access [jj: remove duplicate word "convert" in comment trigger checkpatch warning]

net: hns3: fix double free issue for tx spare buffer

In the Linux kernel, the following vulnerability has been resolved: net: hns3: fix double free issue for tx spare buffer In hns3_set_ringparam(), a temporary copy (tmp_rings) of the ring structure is created for rollback. However, the tx_spare pointer in the original ring handle is incorrectly left pointing to the old backup memory. Later, if memory allocation fails in hns3_init_all_ring() during the setup, the error path attempts to free all newly allocated rings. Since tx_spare contains a stale (non-NULL) pointer from the backup, it is mistaken for a newly allocated buffer and is erroneously freed, leading to a double-free of the backup

• Mettez à jour vers 5.15.0-1117.126+fips1

xen-netback: reject zero-queue configuration from guest

In the Linux kernel, the following vulnerability has been resolved: xen-netback: reject zero-queue configuration from guest A malicious or buggy Xen guest can write "0" to the xenbus key "multi-queue-num-queues". The connect() function in the backend only validates the upper bound (requested_num_queues > xenvif_max_queues) but not zero, allowing requested_num_queues=0 to reach vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers WARN_ON_ONCE(!size) in __vmalloc_node_range(). On systems with panic_on_warn=1, this allows a guest-to-host denial of service. The Xen network interface specification requires the queue count to be

• Mettez à jour vers 5.15.0-1117.126+fips1

power: supply: cpcap-battery: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: cpcap-battery: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ hand

• Mettez à jour vers 5.15.0-1117.126+fips1

iio: sca3000: Fix a resource leak in sca3000_probe()

In the Linux kernel, the following vulnerability has been resolved: iio: sca3000: Fix a resource leak in sca3000_probe() spi->irq from request_threaded_irq() not released when iio_device_register() fails. Add an return value check and jump to a common error handler when iio_device_register() fails.

• Mettez à jour vers 5.15.0-1117.126+fips1

power: supply: bq25980: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: bq25980: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler ha

• Mettez à jour vers 5.15.0-1117.126+fips1