In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btusb: validate Realtek vendor event length
btusb_recv_event_realtek() reads the event code at data[0] and the Realtek
subevent code at data[2] before deciding whether to consume a vendor event
as a coredump.
For example, the two-byte event ff 00 contains a complete vendor-event
header declaring zero parameters. The old classifier still reads a
nonexistent third byte and can misclassify the event as a coredump if the
adjacent byte is 0x34.
Require the HCI event header and first parameter to be present before
inspecting the Realtek subevent code. Short events co
net/packet: avoid fanout hook re-registration after unregister
In the Linux kernel, the following vulnerability has been resolved:
net/packet: avoid fanout hook re-registration after unregister
packet_set_ring() temporarily detaches a socket from packet delivery while
reconfiguring its ring. It records the previous running state, clears
po->num, unregisters the protocol hook when needed, drops po->bind_lock,
and later restores po->num and re-registers the hook from the saved
was_running value.
That unlocked window can race with NETDEV_UNREGISTER. The notifier can
observe the socket as not running, skip __unregister_prot_hook(), and
invalidate the per-socket binding by setting po->ifindex to -1 and cle
bpf: Reject redirect helpers without a bpf_net_context
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject redirect helpers without a bpf_net_context
The bpf_redirect*() helpers and skb_do_redirect() obtain the per-task
bpf_redirect_info via bpf_net_ctx_get_ri(), which dereferences the
current->bpf_net_context unconditionally. That context is established
on the paths that run tc BPF such as sch_handle_{ingress,egress}(),
*except* for the case where {cls,act}_bpf was attached to a proper
qdisc. A program running from there reaches the NULL deref in two ways:
* It calls bpf_redirect() directly, which dereferences the context at
the top of the helper:
tc qdisc
bonding: fix devconf_all NULL dereference when IPv6 is disabled
In the Linux kernel, the following vulnerability has been resolved:
bonding: fix devconf_all NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, the devconf_all is
never initialized because inet6_init() exits before addrconf_init() is
called which initializes it. bond_send_validate(), however, will still
call bond_ns_send_all() even ipv6 is indeed disabled. It will lead to
NULL derefence of net->ipv6.devconf_all in ip6_pol_route().
BUG: kernel NULL pointer dereference, address: 000000000000000c
[...]
Workqueue: bond0 bond_arp_monitor [bonding]
RIP: 0010:ip6_pol_route+0x69/0x480
[...]
Call Trace:
rds: drop incoming messages that cross network namespace boundaries
In the Linux kernel, the following vulnerability has been resolved:
rds: drop incoming messages that cross network namespace boundaries
rds_find_bound() looks up the destination socket using a global
rhashtable keyed solely on (addr, port, scope_id). Network namespaces
are not part of the key, so a sender in netns A can deliver an incoming
message (inc) to a socket that lives in a different netns B.
When this happens, inc->i_conn points to an rds_connection whose c_net
is netns A, but the receiving rs lives in netns B. Once the child
process that created netns A exits, cleanup_net() calls
rds_loop_exit_net() -> rds_loop_kill_conns() -> r
dpaa2-switch: put MAC endpoint device on disconnect
In the Linux kernel, the following vulnerability has been resolved:
dpaa2-switch: put MAC endpoint device on disconnect
fsl_mc_get_endpoint() returns the MAC endpoint device with a reference
taken through device_find_child(). The switch port connect path stores
that device in mac->mc_dev and keeps it for the lifetime of the connected
MAC object.
However, the disconnect path only closes the MAC and frees the dpaa2_mac
object. It does not drop the endpoint device reference stored in
mac->mc_dev, so every successful connect leaks that device reference when
the MAC is later disconnected.
Drop the endpoint device reference before freeing the d
In the Linux kernel, the following vulnerability has been resolved:
dpaa2-eth: put MAC endpoint device on disconnect
fsl_mc_get_endpoint() returns the MAC endpoint device with a reference
taken through device_find_child(). The Ethernet connect path stores that
device in mac->mc_dev and keeps it for the lifetime of the connected MAC
object.
However, the disconnect path only disconnects and closes the MAC before
freeing the dpaa2_mac object. It does not drop the endpoint device
reference stored in mac->mc_dev, so every successful connect leaks that
device reference when the MAC is later disconnected.
Drop the endpoint device reference after
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Wait for completion instead of returning early in iommu_completion_wait()
need_sync is a per-IOMMU flag shared by all domains and devices behind
that IOMMU. It is set whenever a command is queued with sync == true and
cleared when a completion-wait (CWAIT) command is queued. However, a
cleared need_sync only means that a covering CWAIT has been queued, not
that all previously queued commands have actually completed in hardware.
iommu_completion_wait() read need_sync locklessly and returned early
when it was false. This breaks the "block until all previously queu
In the Linux kernel, the following vulnerability has been resolved:
nfp: Check resource mutex allocation
nfp_cpp_resource_find() allocates a CPP mutex handle for the matching
resource-table entry and then reports success. nfp_resource_try_acquire()
immediately passes that handle to nfp_cpp_mutex_trylock().
However, nfp_cpp_mutex_alloc() returns NULL on failure. If that happens
for a matching table entry, the resource lookup still returns success and
the following trylock dereferences a NULL mutex pointer while opening the
resource.
nfp_resource_acquire() already treats failure to allocate the table mutex
as -ENOMEM. Do the same for the
In the Linux kernel, the following vulnerability has been resolved:
wan: wanxl: Only reset hardware after BAR mapping
wanxl_pci_init_one() stores the freshly allocated card in driver data
before the PLX BAR is mapped. Several early probe failures then unwind
through wanxl_pci_remove_one(), including failure to allocate the coherent
status area or to restore the DMA mask.
wanxl_pci_remove_one() unconditionally calls wanxl_reset(), and
wanxl_reset() dereferences card->plx. On those early failures card->plx
is still NULL, so the error path can dereference a NULL MMIO pointer.
Only issue the hardware reset once the BAR mapping exists. The
wifi: mwifiex: bound uAP association event IEs to the event buffer
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound uAP association event IEs to the event buffer
mwifiex_process_uap_event() handles EVENT_UAP_STA_ASSOC by exposing the
(re)association request IEs that the firmware copies into the event:
sinfo->assoc_req_ies = &event->data[len];
len = (u8 *)sinfo->assoc_req_ies - (u8 *)&event->frame_control;
sinfo->assoc_req_ies_len = le16_to_cpu(event->len) - (u16)len;
event->len is supplied by the device firmware and is never validated,
and the subtraction is unchecked. assoc_req_ies points into
adapter->event_body[MAX_EVENT_SIZE], a fixed-size array embedded in
In the Linux kernel, the following vulnerability has been resolved:
iommu/amd: Bound the early ACPI HID map
The ivrs_acpihid command-line parser appends entries to a fixed
four-element early_acpihid_map array. Unlike the sibling IOAPIC and HPET
parsers, it does not reject a fifth entry before incrementing the map size.
Check the capacity at the common found label before parsing the HID and
UID or writing the entry.
iommu/intel: Fix out-of-bounds memset in dmar_latency_disable()
In the Linux kernel, the following vulnerability has been resolved:
iommu/intel: Fix out-of-bounds memset in dmar_latency_disable()
dmar_latency_disable() intends to zero out only the single
latency_statistic entry for the given type, but the memset size was
computed as sizeof(*lstat) * DMAR_LATENCY_NUM, which clears the entire
array starting from &lstat[type].
When type > 0, this writes beyond the end of the allocated array,
corrupting adjacent memory.
Fix by using sizeof(*lstat) to clear only the target entry.
In the Linux kernel, the following vulnerability has been resolved:
tipc: serialize udp bearer replicast list updates
tipc_udp_rcast_add() and cleanup_bearer() both update ub->rcast.list with
list_add_rcu() / list_del_rcu(), but nothing serializes them. The add runs
from the encap receive softirq (via tipc_udp_rcast_disc()) without
rtnl_lock(), so it can race the cleanup delete and corrupt the list:
list_del corruption. prev->next should be ffff8880298d7ab8,
but was ffff88802449ad38. (prev=ffff888027e3ec98)
kernel BUG at lib/list_debug.c:62!
RIP: __list_del_entry_valid_or_report+0x17a/0x200
Workqueue: events cleanup_bearer
Ca
rds: Fix inet6_addr_lst NULL dereference when IPv6 is disabled
In the Linux kernel, the following vulnerability has been resolved:
rds: Fix inet6_addr_lst NULL dereference when IPv6 is disabled
When booting with the 'ipv6.disable=1' parameter, inet6_addr_lst
is never initialized because inet6_init() exits before addrconf_init()
is called to initialize it. An attempt to bind an RDS socket to
an ipv6 address results in a crash in __ipv6_chk_addr_and_flags()
KASAN: null-ptr-deref in range [0x0000000000000008-0x000000000000000f]
RIP: 0010:__ipv6_chk_addr_and_flags+0x1df/0x7e0
Call Trace:
<TASK>
ipv6_chk_addr+0x3b/0x50
rds_tcp_laddr_check+0x155/0x3b0 [rds_tcp]
rds_trans_get_preferred+0x15d/0x2d0 [rds]
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
In the Linux kernel, the following vulnerability has been resolved:
sctp: fix auth_chunk_list capacity check in sctp_auth_ep_add_chunkid
sctp_auth_ep_add_chunkid() uses SCTP_NUM_CHUNK_TYPES (20) as the
capacity limit for ep->auth_chunk_list, allowing it to hold up to
20 chunk entries (param_hdr.length up to 24). However, the copy
destination asoc->c.auth_chunks in struct sctp_cookie is only
SCTP_AUTH_MAX_CHUNKS (16) entries (20 bytes). When more than 16
chunks are added, sctp_association_init() memcpy overflows the
destination by up to 4 bytes.
Fix by using SCTP_AUTH_MAX_CHUNKS as the capacity limit, matching
the destination capacity.
pds_core: fix deadlock between reset thread and remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix deadlock between reset thread and remove
pci_reset_function() acquires device_lock before performing the reset.
pdsc_remove() is called by the PCI core with device_lock already held.
If pdsc_pci_reset_thread() is running when pdsc_remove() is called,
destroy_workqueue() will block waiting for the work to complete, while
the work is blocked waiting for device_lock - deadlock.
Use pci_try_reset_function() which uses pci_dev_trylock() internally.
This acquires both the device lock and the PCI config access lock
without blocking - if either lock is contended, it
pds_core: fix use-after-free on workqueue during remove
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix use-after-free on workqueue during remove
In pdsc_remove(), the workqueue is destroyed before pdsc_teardown()
is called. This ordering allows two paths to queue work on the
destroyed workqueue:
1. If pdsc_teardown() -> pdsc_devcmd_reset() times out, the error
path in pdsc_devcmd_locked() queues health_work.
2. A NotifyQ event can trigger the ISR and queue work before free_irq()
is called in pdsc_teardown().
Fix by moving destroy_workqueue() after pdsc_teardown() so the
workqueue outlives every queuer; destroy_workqueue() then flushes any
work still pe
In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix auxiliary device add/del races
Two paths add or delete the same slot (pf->vfs[vf_id].padev): a VF's
pdsc_reset_done() and the PF's devlink enable_vnet/disable_vnet handler.
They serialize on config_lock, but neither guards the slot under it
correctly.
add() registers and stores a new auxiliary device without first checking
the slot, so a second add of an already-populated slot leaks the first
device. del() makes that check outside config_lock, so two concurrent
dels can both pass it; the first clears the slot, and the second
dereferences a NULL pointer.
Chec
sctp: validate stream count in sctp_process_strreset_inreq()
In the Linux kernel, the following vulnerability has been resolved:
sctp: validate stream count in sctp_process_strreset_inreq()
When processing a RESET_IN_REQUEST from a peer,
sctp_process_strreset_inreq() derives the stream count from the
parameter length but does not check whether the resulting
RESET_OUT_REQUEST would exceed SCTP_MAX_CHUNK_LEN.
The OUT request header (sctp_strreset_outreq, 16 bytes) is 8 bytes
larger than the IN request header (sctp_strreset_inreq, 8 bytes).
Generally, the IP payload is bounded to 65535 bytes, so the stream
list cannot be large enough to trigger the overflow. However, on
interfaces with MTU > 65535 (e.g