In the Linux kernel, the following vulnerability has been resolved:
octeontx2-af: npc: Fix size of entry2cntr_map
KASAN prints below splat. This is caused by allocating counter for
reserved mcam entry for cpt 2nd pass entry. But mcam->entry2cntr_map
is not allocated for reserved entries.
BUG: KASAN: slab-out-of-bounds in npc_map_mcam_entry_and_cntr+0xb0/0x1a0
Write of size 2 at addr ffff0001033e7ffe by task kworker/0:1/14
CPU: 0 PID: 14 Comm: kworker/0:1 Not tainted 6.1.67 #1
Hardware name: Marvell CN106XX board (DT)
Workqueue: events work_for_cpu_fn
Call trace:
dump_backtrace.part.0+0xe4/0xf0
show_stack+0x18/0x30
dump_stack_lvl+0x88/0
ALSA: seq: oss: Serialize readq reset state with q->lock
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Serialize readq reset state with q->lock
snd_seq_oss_readq_clear() resets qlen, head, and tail without
q->lock even though the normal reader and producer paths serialize the
same ring state under that spinlock. A reset can therefore race
snd_seq_oss_readq_free() or snd_seq_oss_readq_put_event() and leave
stale records in the queue, drop freshly queued ones, or report the
wrong readiness after wakeup. KCSAN reports a data race between
snd_seq_oss_readq_clear() and snd_seq_oss_readq_free().
Take q->lock while clearing the ring and resetting input_time. Factor
MIPS: mm: Fix out-of-bounds write in maar_res_walk()
In the Linux kernel, the following vulnerability has been resolved:
MIPS: mm: Fix out-of-bounds write in maar_res_walk()
maar_res_walk() uses wi->num_cfg as the index into the fixed-size
wi->cfg array, but checks whether the array is full only after it has
filled the selected entry. If walk_system_ram_range() reports more than
16 memory ranges, the overflow call writes one struct maar_config past
the end of the array before WARN_ON() prevents num_cfg from advancing.
Move the full-array check before taking the array slot and return non-zero
when the scratch array is full, so walk_system_ram_range() terminates the
walk instead of invoking th
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
In the Linux kernel, the following vulnerability has been resolved:
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
fsl_emb_pmu_del() unconditionally calls put_cpu_var(cpu_hw_events) at
the 'out:' label, but only calls the matching get_cpu_var() after the
'i < 0' early-return check. When event->hw.idx is negative the
function jumps to 'out:' without having taken get_cpu_var(), and the
trailing put_cpu_var() then issues an unmatched preempt_enable(),
underflowing preempt_count.
On a CONFIG_PREEMPT=y kernel preempt_count would underflow and
eventually present as a 'scheduling while atomic' BUG.
Move put_cpu_var() to pair with g
In the Linux kernel, the following vulnerability has been resolved:
mfd: cs42l43: Sanity check firmware size
Currently the code checks if a firmware was received, however it does
not verify that the firmware size is larger than the firmware header. As
the firmware pointer is dereferenced as a pointer to the header
structure this could lead to an out of bounds memory access. Add the
missing check.
In the Linux kernel, the following vulnerability has been resolved:
coresight: ete: Always save state on power down
System register ETMs and ETE are unlikely to be preserved on CPU power
down. The ETE DT binding also never documented
"arm,coresight-loses-context-with-cpu" so nobody would have legitimately
been able to use that binding to fix it and ACPI has no such binding at
all.
Fix it by hard coding the setting for sysreg ETMs (ETE is always sysreg)
or ACPI boots. Use a local variable when setting up save_state so that
it's immune to concurrent probing when devices have different
configurations which is an issue with modifying the globa
char: tlclk: fix use-after-free in tlclk_cleanup()
In the Linux kernel, the following vulnerability has been resolved:
char: tlclk: fix use-after-free in tlclk_cleanup()
This patch improves the module cleanup process in the tlclk driver to
prevent potential use-after-free and race conditions.
Currently, the file_operations structure does not specify the .owner
field, which could allow the module to be unloaded while user-space
processes are still interacting with the device. Additionally, the
tlclk_cleanup() function frees the alarm_events memory before ensuring
that blocked processes in the waitqueue are fully awakened and that the
switchover_timer has completed.
To address these cases,
In the Linux kernel, the following vulnerability has been resolved:
Revert "PCI/MSI: Unmap MSI-X region on error"
This reverts commit 1a8d4c6ecb4c81261bcdf13556abd4a958eca202.
Commit 1a8d4c6ecb4c ("PCI/MSI: Unmap MSI-X region on error") added an
iounmap(dev->msix_base) on the error path of msix_capability_init() to
release the MSI-X region when msix_setup_interrupts() fails.
When msix_setup_interrupts() fails, the call chain is:
msix_setup_interrupts()
-> __msix_setup_interrupts()
struct pci_dev *dev __free(free_msi_irqs) = __dev;
...
return ret; // __free cleanup fires on error
The __free(free_msi_irqs
apparmor: fix potential UAF in aa_replace_profiles
In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix potential UAF in aa_replace_profiles
The function aa_replace_profiles was accessing udata->size after calling
aa_put_loaddata(udata), causing a potential UAF.
Fixed this by saving the size to a local variable before dropping the
reference.
drm/amdkfd: Avoid double-unpin of DOORBELL/MMIO BOs on free
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Avoid double-unpin of DOORBELL/MMIO BOs on free
amdgpu_amdkfd_gpuvm_free_memory_of_gpu() unpinned DOORBELL and MMIO
remap BOs (which are pinned at allocation time) before checking whether
the BO is still mapped to the GPU. When the BO is still mapped, the
function returns -EBUSY and leaves the BO alive, but it has already
been unpinned. The BO is then unpinned again when it is finally freed
during process teardown, triggering a ttm_bo_unpin() underflow warning:
WARNING: CPU: 18 PID: 15066 at ttm/ttm_bo.c:650 amdttm_bo_unpin+0x6d/0x80 [amdttm]
Workqueue: kfd
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
In the Linux kernel, the following vulnerability has been resolved:
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
It's pointless to call WARN_ON() in case of an allocation failure in
dev_change_net_namespace() and device_rename(), since it only leads to
useless splats caused by deliberate fault injections, so avoid it.
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
In the Linux kernel, the following vulnerability has been resolved:
veth: fix NAPI leak in XDP enable error path
During XDP enablement in veth, if xdp_rxq_info_reg() or
xdp_rxq_info_reg_mem_model() fails, the driver rolls back the changes.
However, the rollback loop:
for (i--; i >= start; i--) {
decrements the loop index 'i' before the first iteration. This
correctly skips unregistering the rxq for the failed index 'i' (as
registration failed or was already cleaned up), but it also
erroneously skips calling netif_napi_deli() for rq[i].xdp_napi.
Since netif_napi_add() was already called for index 'i', this leaves
a dangling napi_struct i
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
In the Linux kernel, the following vulnerability has been resolved:
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
When function tracing or Kprobes is enabled, entering an ACPI Low
Power Idle (LPI) state triggers the following RCU splat:
RCU not on for: acpi_idle_lpi_enter+0x4/0xd8
WARNING: CPU: 8 PID: 0 at include/linux/trace_recursion.h:162 function_trace_call+0x1e8/0x228
The acpi_idle_lpi_enter() function is invoked within the cpuidle
path after RCU has already been disabled for the current local CPU.
Consequently, ftrace's function_trace_call() expects RCU to be
actively watching before recording trace data, emitting
In the Linux kernel, the following vulnerability has been resolved:
qede: fix out-of-bounds check for cqe->len_list[]
Move index check before element access.
tracing/probes: Remove WARN_ON_ONCE from parse_btf_arg
In the Linux kernel, the following vulnerability has been resolved:
tracing/probes: Remove WARN_ON_ONCE from parse_btf_arg
Sashiko found that user can cause this WARN_ON_ONCE() easily
with adding a kprobe event based on a raw address with BTF
parameter.
Since this is not an unexpected condition, remove the
WARN_ON_ONCE().
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In the Linux kernel, the following vulnerability has been resolved:
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In picolcd_send_and_wait(), an integer overflow of the signed loop counter
'k' can theoretically lead to a NULL pointer dereference of 'raw_data'.
If the loop executes more than INT_MAX times, 'k' becomes negative,
making the condition 'k < size' true even when 'size' is 0.
Change the type of 'k' to 'unsigned int' to prevent the overflow and
eliminate the out-of-bounds access.
Found by Linux Verification Center (linuxtesting.org) with the Svace static
analysis tool.
[[email protected]: extended hash
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_irc: fix parse_dcc() off-by-one OOB read
parse_dcc() treats data_end as an inclusive end pointer, but its only
caller passes data_limit = ib_ptr + datalen, which points one past the
last valid byte.
The newline search loop iterates while tmp <= data_end, so when no
newline is present, *tmp is read at tmp == data_end, one byte beyond
the region filled by skb_header_pointer().
irc_buffer is kmalloc'd as MAX_SEARCH_SIZE + 1 bytes and datalen is
capped at MAX_SEARCH_SIZE, so the stray read does not fault. The byte
is uninitialized or stale; if it cont
In the Linux kernel, the following vulnerability has been resolved:
perf/x86/amd/lbr: Fix kernel address leakage
A user-only branch stack can contain branches that originate from
the kernel. As a result, kernel addresses are exposed to user space
even when PERF_SAMPLE_BRANCH_USER is requested. On AMD processors
supporting X86_FEATURE_AMD_LBR_V2, perf can still report SYSRET/ERET
entries for which the branch-from addresses are in the kernel.
E.g.
$ perf record -e cycles -o - -j any,save_type,u -- \
perf bench syscall basic --loop 1000 | \
perf script -i - -F brstack|tr ' ' '\n'| \
grep -E '0x[89a-f][0-9a-f]{15}'
batman-adv: gw: acquire ethernet header only after skb realloc
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: gw: acquire ethernet header only after skb realloc
The pskb_may_pull() called by batadv_get_vid() could reallocate the buffer
behind the skb. Variables which were pointing to the old buffer need to be
reassigned to avoid an use-after-free.
batman-adv: dat: acquire ARP hw source only after skb realloc
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: dat: acquire ARP hw source only after skb realloc
The pskb_may_pull() called by batadv_get_vid() could reallocate the buffer
behind the skb. Variables which were pointing to the old buffer need to be
reassigned to avoid an use-after-free.