wifi: mt76: mt7915: unlink TWT flow if the MCU rejects the agreement
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: unlink TWT flow if the MCU rejects the agreement
The flow is added to dev->twt_list before sending the agreement to the
firmware, but the error path leaves it linked while flowid_mask is
never set. The flow slot can then be reused and memset while still on
the list, corrupting twt_list, and station removal leaves a dangling
entry behind that mt7915_mac_twt_sched_list_add() later walks.
wifi: mt76: mt7915: fix double hif2 init on the non-WED path
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: fix double hif2 init on the non-WED path
mt7915_pci_init_hif2() was called unconditionally and again inside the
WED-inactive branch. The helper increments the global hif_idx, writes the
PCIe RECOG_ID register and takes a get_device() reference via
mt7915_pci_get_hif2(), while removal only drops one reference. On non-WED
dual-hif hardware this double-incremented hif_idx, wrote RECOG_ID twice and
leaked a device reference. Only the call inside the WED-inactive branch is
correct; drop the unconditional one. hif2 is already initialised to NULL.
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: fix ext PHY use-after-free on register error path
After mt7915_register_ext_phy() succeeded, a failure of the main PHY
mt7915_init_debugfs() or mt7915_coredump_register() unwound through
free_phy2, which called ieee80211_free_hw() on the ext PHY hw while it
was still registered with mac80211, since mt76_unregister_device() only
unregisters the main hw. Unregister the ext PHY (thermal + phy + hw)
first and skip the redundant free.
wifi: mt76: mt7915: release hif2 reference on probe IRQ failure
In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7915: release hif2 reference on probe IRQ failure
The hif2 reference obtained by mt7915_pci_init_hif2() is only released on
error paths that key off dev->hif2, which is not assigned until after the
IRQ setup. If pci_alloc_irq_vectors() or the primary devm_request_irq()
fails, the reference leaks. Drop it explicitly on those paths via
mt7915_put_hif2().
wifi: ath10k: snoc: use memcpy_fromio() for MSA ramdump
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath10k: snoc: use memcpy_fromio() for MSA ramdump
On WCN3990/SNOC the MSA region is mapped with devm_memremap(MEMREMAP_WT).
On arm64 such a mapping is not Normal-cacheable, so unaligned accesses to
it are not permitted. ath10k_msa_dump_memory() copies the region with a
plain memcpy(), whose optimized __pi_memcpy_generic implementation issues
wide/unaligned loads. This triggers an alignment fault (FSC=0x21) Oops in
ath10k_snoc_fw_crashed_dump() while collecting the devcoredump:
Unable to handle kernel paging request ... FSC=0x21: alignment fault
pc : __pi_memcpy_g
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: disconnect on CSA to channel 0
The refactor for the CSA parsing erroneously equates channel
zero and no information present, leading it to ignore a CSA
on an AP that advertises a switch to that (invalid) channel.
This leads to not disconnecting, which we should. For Intel
devices, this can lead to a firmware crash.
Fix this by using an int type for the channel number as well
as the opclass, and using a (negative) value that cannot be
encoded in the element to indicate it's not present.
In the Linux kernel, the following vulnerability has been resolved:
firmware: coreboot: Validate table bounds
The existing coreboot_table_populate() bounds checks limit individual
entries to the mapped length. However, coreboot_table_probe() replaces
the platform resource length with header and table sizes supplied by
firmware before mapping the full table.
A malformed table can overflow the 32-bit size addition or advertise an
extent beyond the resource, causing the driver to map and parse memory
outside the resource. A resource shorter than the fixed header is also
mapped as though it contained a complete header.
Reject resources shor
In the Linux kernel, the following vulnerability has been resolved:
tty: clear cdev pointer after cdev_add() failure
tty_cdev_add() drops the cdev reference when cdev_add() fails, but
leaves driver->cdevs[index] pointing to freed memory.
tty_unregister_device() later passes that stale pointer to cdev_del(),
causing a use-after-free.
Clear the slot after dropping the reference.
HID: synchronize input before cleaning up a failed probe
In the Linux kernel, the following vulnerability has been resolved:
HID: synchronize input before cleaning up a failed probe
hid_device_io_start() allows reports to run concurrently with probe. If
the probe subsequently fails, __hid_device_probe() releases driver
resources and clears hdev->driver without first excluding those report
callbacks.
For example, a report may enter hidraw_report_event() while the failure
path frees the associated hidraw object, leading to a use-after-free when
the report takes the object's list lock.
Stop input before performing failed-probe cleanup. This reacquires
driver_input_lock and waits for any report cal
phonet: pep: do not write beyond optlen in getsockopt
In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: do not write beyond optlen in getsockopt
pep_getsockopt() clamps the reported length to the caller's buffer with
min_t(), but then stores the value with put_user(val, (int __user *)
optval), which always writes sizeof(int) bytes. A getsockopt() call with
an optlen smaller than sizeof(int) thus reports the clamped length yet
writes a full int, one to three bytes past the user buffer.
Write the value with copy_to_user() bounded by len, so at most optlen
bytes are copied, matching the length reported back to userspace.
blk-cgroup: skip dying blkg in blkcg_activate_policy()
In the Linux kernel, the following vulnerability has been resolved:
blk-cgroup: skip dying blkg in blkcg_activate_policy()
When switching IO schedulers on a block device, blkcg_activate_policy()
can race with concurrent blkcg deletion, leading to a use-after-free in
rcu_accelerate_cbs.
T1: T2:
blkg_destroy
kill(&blkg->refcnt) // blkg->refcnt=1->0
blkg_release // call_rcu(__blkg_release)
...
blkg_free_workfn
->
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/cluster: keep heartbeat local node stable
o2nm_node_local_store() handles local=0 by stopping o2net and setting
cl_local_node to O2NM_INVALID_NODE_NUM, but it leaves cl_has_local set.
That stale state makes o2nm_this_node() return 255, blocks a later local=1
attempt with -EBUSY, and can feed 255 to heartbeat users that call
o2nm_this_node() dynamically.
Clearing cl_has_local is required when the local node is reset. But
heartbeat threads can still be running at that point. They pin the local
node config item at startup, yet o2hb_do_disk_heartbeat() and thread
tear
rapidio: clear mport->net when rio_add_net() fails
In the Linux kernel, the following vulnerability has been resolved:
rapidio: clear mport->net when rio_add_net() fails
rio_alloc_net() stores the newly allocated rio_net in mport->net before
rio_scan_alloc_net() registers the device.
If rio_add_net() fails, rio_scan_alloc_net() drops the device reference
with put_device(), which releases the rio_net through the device release
callback. However, mport->net is left pointing at the freed object.
A later mport unregister path can then dereference the dangling mport->net
pointer and may try to free the same rio_net again.
Clear mport->net in the rio_add_net() failure path, matching the clean
In the Linux kernel, the following vulnerability has been resolved:
fat: release buffer head after rebuilding parent
fat_scan_logstart() leaves the matching directory entry's buffer head in
sinfo.bh for the caller to release, just like fat_scan().
fat_rebuild_parent() uses the directory entry to rebuild the parent inode
for the nostale_ro NFS export path, but does not release sinfo.bh after a
successful scan. Release it once fat_build_inode() has consumed the
directory entry data.
In the Linux kernel, the following vulnerability has been resolved:
drm/omap: dsi: Do not copy isr table
To be able to unregister stuff from isrs, the corresponding table was
copied. Nobody seems to unregister stuff that way, so it does not help.
But there are stack-allocated objects passed to these isrs giving chances
of UAF of these objects if irqs are unregistered while they are handled,
so better do not copy that table.
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
In the Linux kernel, the following vulnerability has been resolved:
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
table->offset[i] is a u32 from firmware, but was stored into a signed
int. A crafted offset like 0xFFFFFFF0 becomes -16, placing hdr 16 bytes
before the table buffer. The subsequent avail check was bypassed
because the negative int was promoted to a large size_t in the
expression "table_sz - offset - sizeof(*hdr)", yielding a large positive
avail and letting the out-of-bounds hdr->type read proceed undetected.
Store the offset as u32 and validate it with unsigned comparisons before
any pointer arith
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
In the Linux kernel, the following vulnerability has been resolved:
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
A potential invalid storage access issue can occur after replacing a
cgroup bpf prog.
This occurs in the following scenario:
1. prog1 with storage is attached to a cgroup in multi-attach mode.
2. prog1 is replaced with prog2 using BPF_F_REPLACE in multi-attach
mode, but fails midway (e.g. in bpf_trampoline_link_cgroup_shim or
update_effective_progs).
3. A new prog3 is attached to the cgroup in multi-attach mode.
The reason is that __cgroup_bpf_attach overwrites pl->storage with the
new storage
RDMA/erdma: Hold CQ references when processing EQ events
In the Linux kernel, the following vulnerability has been resolved:
RDMA/erdma: Hold CQ references when processing EQ events
EQ handlers look up CQs from dev->cq_xa and invoke CQ completion or
error callbacks outside the xarray lock. erdma_destroy_cq() can erase the
CQ from the xarray and free its queue buffer and doorbell record while a
previously scheduled EQ handler is still using the CQ.
Add a CQ refcount and take a reference under the xarray lock with
refcount_inc_not_zero(). Remove the CQ from the xarray before dropping
the destroy-path reference, then wait for in-flight EQ users before
releasing CQ resources.
RDMA/erdma: Hold QP references for AE and CM processing
In the Linux kernel, the following vulnerability has been resolved:
RDMA/erdma: Hold QP references for AE and CM processing
AE QP fatal events and iWARP CM paths load QPs from dev->qp_xa
and then use or reference them outside the xarray lock.
erdma_destroy_qp() can drop the destroy-path reference and free QP
resources while such a lookup is in flight.
Add erdma_qp_get_by_qpn() to acquire a kref under the xarray
lock with kref_get_unless_zero(). Remove the QP from the xarray
before dropping the destroy-path reference so no new lookup can acquire
it while destruction waits for existing users.
RDMA/srp: fix heap information leak on a truncated SRP_CRED_REQ
In the Linux kernel, the following vulnerability has been resolved:
RDMA/srp: fix heap information leak on a truncated SRP_CRED_REQ
srp_recv_done() passes wc->byte_len to srp_process_rsp(). It passes
nothing to srp_process_cred_req() and srp_process_aer_req(), which read
fixed-size fields from the receive buffer without checking that those
fields were received.
The buffer size is max_ti_iu_len, which comes from the login response
and is not validated. A target that advertises 8 and then sends an
8-byte SRP_CRED_REQ makes the initiator read req->tag from beyond the
end of the buffer. req->tag is copied into the SRP_CRED_RSP and sent
back, s