Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
vt: selection: Fix unsigned underflow and slab-out-of-bounds read in paste_selection()
In the Linux kernel, the following vulnerability has been resolved:
vt: selection: Fix unsigned underflow and slab-out-of-bounds read in paste_selection()
In paste_selection(), the loop copies min_t(unsigned int,
vc_sel.buf_len - pasted,tty->receive_room) bytes per iteration into
tty_ldisc_receive_buf() and increments pasted += count.
Because the selection mutex (vc_sel.lock) is dropped inside the loop
Whenever the line discipline buffer fills up and paste_selection()
sleeps on tty->write_wait, a concurrent TIOCLINUX (TIOCL_SETSEL) ioctl
can replace vc_sel.buffer with a shorter selection and reduce
vc_sel.buf_len below pasted.
When paste_
vt: skip screen update for DEC alignment test on backgroup consoles
In the Linux kernel, the following vulnerability has been resolved:
vt: skip screen update for DEC alignment test on backgroup consoles
[BUG]
Recently, we encountered a KASAN warning as follows:
BUG: KASAN: slab-out-of-bounds in fb_pad_aligned_buffer+0x11f/0x140
Read of size 1 at addr ff1100015fd9f6a4 by task tty_fbcon_oob/1239
CPU: 7 UID: 0 PID: 1239 Comm: tty_fbcon_oob Not tainted 7.3.0-rc1 #100 PREEMPT(full)
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.17.0-4.fc41 04/01/2014
Call Trace:
<TASK>
...
kasan_report+0xf0/0x120
fb_pad_aligned_buffer+0x11f/0x140
ccw_putcs+0x86c/0xa80
fbcon_putcs+0x338/0x410
do_update_reg
ALSA: caiaq: unregister the input device when probe fails
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: unregister the input device when probe fails
setup_card() registers the input device, whose name and phys point into
struct snd_usb_caiaqdev, and then goes on to snd_card_register() and
snd_usb_caiaq_control_init(). If either fails, snd_probe() calls
snd_card_free(), which frees the device state but leaves the input
device registered: card_free() only clears the pointer, and the input
device is unregistered from snd_disconnect() alone. Reading its "uevent"
attribute afterwards dereferences freed memory:
BUG: KASAN: slab-use-after-free in string+0x4a9/0x4f0
In the Linux kernel, the following vulnerability has been resolved:
ALSA: line6: reject oversized playback packets
Each playback URB is handed a slice of out.buffer that is exactly
LINE6_ISO_PACKETS * max_packet_size_out bytes, sized from the OUT
endpoint, but the number of bytes written into that slice is never
compared against it.
submit_audio_out_urb() takes the frame count from prev_fsize, which
audio_in_callback() derived from the *IN* endpoint's received packet
length, and rescales it with the playback frame size; when prev_fsize is
still zero it synthesizes a length from the sample rate instead. On a
device declaring a large IN wMa
Nicht bewertetEPSS 0,15%Keine Korrektur veröffentlicht
mtd: core: avoid double-free of OTP NVMEM device
In the Linux kernel, the following vulnerability has been resolved:
mtd: core: avoid double-free of OTP NVMEM device
If factory OTP setup fails after the user OTP NVMEM device has been
registered, mtd_otp_nvmem_add() unregisters the user device but leaves
mtd->otp_user_nvmem set. On an error, the caller unregisters it again.
For -EOPNOTSUPP, registration continues and normal teardown unregisters
it again.
Clear mtd->otp_user_nvmem after unregistering it.
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
mtd: core: call _get_device() with the master MTD
In the Linux kernel, the following vulnerability has been resolved:
mtd: core: call _get_device() with the master MTD
__get_mtd_device() calls the master's _get_device() callback with mtd,
which may be a partition. __put_mtd_device() passes the master.
This breaks gluebi partitions because gluebi_get_device() uses
container_of() and therefore requires the master MTD. Pass the master
to _get_device(), matching _put_device().
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
of/overlay: don't leak fragment references when changeset init fails
In the Linux kernel, the following vulnerability has been resolved:
of/overlay: don't leak fragment references when changeset init fails
init_overlay_changeset() stores the number of initialized fragments
in ovcs->count only on full success. When find_target() or the
__symbols__ lookup fails partway through, the target and overlay
references taken for the fragments initialized so far are never
dropped: free_overlay_changeset() bounds its cleanup loop by
ovcs->count, which is still 0.
Store the running count on the error path so free_overlay_changeset()
puts whatever was set up. The store is guarded by ovcs->fragments
because on the allocat
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
wifi: wfx: validate MIB read length before copying to caller
In the Linux kernel, the following vulnerability has been resolved:
wifi: wfx: validate MIB read length before copying to caller
wfx_hif_read_mib() copies reply->length bytes from the firmware
response into the caller-provided buffer without checking that
reply->length does not exceed val_len. A firmware response with
a length field larger than expected overruns the caller buffer and
reads past the end of the reply allocation.
Replace the dead -ENOMEM check with an active validation that
reply->length fits within val_len before the memcpy.
wifi: mac80211: drop oversized fragments to avoid extra_len overflow
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: drop oversized fragments to avoid extra_len overflow
In ieee80211_rx_h_defragment(), fragment payloads are accumulated into
entry->extra_len as subsequent fragments arrive:
entry->extra_len += rx->skb->len;
When the final fragment arrives, the head fragment is dequeued, and
pskb_expand_head() is called with entry->extra_len to ensure sufficient
tailroom for all queued fragments before copying:
if (skb_tailroom(rx->skb) < entry->extra_len) {
if (unlikely(pskb_expand_head(rx->skb, 0, entry->extra_len,
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: reject short WMI command responses
ath9k_wmi_rsp_callback() removes the validated WMI header and copies
the number of bytes expected by the waiting command into its response
buffer. A device response shorter than that expectation can therefore
be read beyond the skb payload.
Record -EMSGSIZE for a short response, complete the waiter, and return
the stored status from the command path. This also prevents callers from
consuming stale response bytes as a successful reply.
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
__hif_usb_tx() dequeues up to MAX_TX_AGGR_NUM (20) frames into a
single tx_buf of MAX_TX_BUF_SIZE (32768) bytes, limiting the batch
by record count but never by cumulative byte length.
With large frames (MTU 2304), 20 aggregated frames of 2292 bytes
each exceed the allocation (20 * 2296 = 45920 bytes), so the
memcpy() in the loop writes up to 13152 bytes past tx_buf->buf
before usb_submit_urb().
Peek the queue head and stop before copying any record that would
cross MAX_TX_BUF_SIZE, then dispatch the current batch.
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
rtc: ac100: Fix clock provider use-after-free on probe failure
In the Linux kernel, the following vulnerability has been resolved:
rtc: ac100: Fix clock provider use-after-free on probe failure
ac100_rtc_register_clks() registers the RTC-32k clock with
clk_hw_register_fixed_rate() and the clock provider with
of_clk_add_hw_provider(). Neither is device managed, and both are
released only from ac100_rtc_remove(). The driver core does not call
remove() when probe() fails: really_probe() reaches probe_failed below
the device_remove() call and goes straight to releasing the device's
managed resources.
ac100_rtc_probe() ends with
return devm_rtc_register_device(chip->rtc);
so if that fails after the cloc
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
rtc: mpfs: fix unchecked devm_clk_get() error pointer in probe()
In the Linux kernel, the following vulnerability has been resolved:
rtc: mpfs: fix unchecked devm_clk_get() error pointer in probe()
devm_clk_get(&pdev->dev, "rtcref")'s return value was passed straight
into clk_get_rate() without checking it for an error first, unlike the
"rtc" clock a few lines above which is correctly checked with
IS_ERR(). clk_get_rate() only guards against a NULL clk, not an error
pointer:
if (!clk)
return 0;
...
rate = clk_core_get_rate_recalc(clk->core);
so if devm_clk_get() ever returns an error pointer here (for example
ERR_PTR(-EPROBE_DEFER), which is the normal, expected outcome if the
clkcfg clock-provide
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate TX status rate metadata
minstrel_ht_tx_status() converts the HT/VHT rate reported in a TX status
into a group and rate index and uses those to index the minstrel_ht rate
tables. The existing validation only checked that an entry was present
and had tries recorded; it did not check that the reported MCS, spatial
stream count and bandwidth are representable by the tables, so malformed
metadata passed to minstrel_ht_get_stats() or
minstrel_ht_ri_get_stats() could be used as an out-of-bounds index.
Validate the rate metadata in the common TX status pa
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: preserve hidden-group beacon IE ownership
A hidden-group probe-response entry borrows its beacon IEs from the
group's beacon entry. cfg80211_update_assoc_bss_entry() can pass such
an entry to cfg80211_update_known_bss() when merging scan entries
after a channel switch.
Copying the borrowed beacon_ies into the associated entry gives the
same allocation two owners. Releasing the group's beacon entry can
then leave the associated entry pointing to freed IEs, which are
freed again when that entry is released.
Skip beacon IE replacement when the source entry be
wifi: mac80211: prevent AP VLAN tx from other interfaces
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: prevent AP VLAN tx from other interfaces
Since the station lookup was factored out of ieee80211_build_hdr(),
ieee80211_lookup_ra_sta() uses sta_info_get_bss() for all AP and AP VLAN
frames, not only for control port frames. A unicast frame sent on one
interface thus matches a station of a different VLAN of the same BSS and
is transmitted to it.
Only match stations of the interface the frame is sent on, except for
control port frames, since those may be sent for VLAN stations directly
on the BSS interface.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
blk-mq: set RQF_USE_SCHED when the operation is known
In the Linux kernel, the following vulnerability has been resolved:
blk-mq: set RQF_USE_SCHED when the operation is known
The cached requests are allocated for one operation but can be handed
out for another. A passthrough command has RQF_USE_SCHED cleared, so
using those flags for a subsequent read/write bio will insert it into
the scheduler without ->prepare_request() and frees it without
->finish_request(). For kyber, this leaks the domain token acquired at
dispatch and stalls the queue.
Don't set RQF_USE_SCHED based on the first operation the batch happened
to be allocated for. Instead, set it after the request is claimed by an
operati
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
Bluetooth: btintel: validate DDC record lengths
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: validate DDC record lengths
Parse DDC record lengths in unsigned storage so 0xFF does not wrap.
Reject records smaller than the mandatory three-byte header, records
exceeding U8_MAX, and records exceeding remaining firmware bytes before
issuing Intel_Write_DDC.
This issue was reported by Claude Mythos.
bpf: Fix overflow of jump offset in constant blinding
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix overflow of jump offset in constant blinding
bpf_jit_blind_insn() rewrites 'if rX op imm goto off' into:
AX = imm ^ rnd
AX ^= rnd
if rX op AX goto off
and subtracts 2 from off when the jump is backward. off is s16, so
-32767 and -32768 wrap and the jump goes 32767 insns forward, past the
end of the prog. The jump is inside the patch, hence bpf_adj_branches()
doesn't check it. The kernel crashes when such prog runs with
bpf_jit_harden=2.
Return -ERANGE in such case. bpf_jit_blind_constants() fails the same
way when blinding of other insns moves a jump out o
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
nvme: fix cdev lifetime
In the Linux kernel, the following vulnerability has been resolved:
nvme: fix cdev lifetime
Sashiko bot reported a potential problem for the cdev lifetime in [0]
- the code there is heavily based on the NVMe code.
Currently the NS head .open and .release file_operations methods take and
put a reference to the nvme_ns_head to ensure that this structure does not
disappear while we open fds for that cdev.
In multipath mode, when we teardown the NS head, we call nvme_cdev_del() ->
cdev_device_del() -> cdev_del(). However after cdev_del() returns, cdevs
already open will remain and their fops will still be callable. As such,
we can still refer