md/raid5: round bitmap stripes with sector division
In the Linux kernel, the following vulnerability has been resolved:
md/raid5: round bitmap stripes with sector division
raid5_bitmap_sector_map() aligns the array range to full RAID5 stripe
widths before converting it to component sectors. That width is
chunk_sectors multiplied by the number of data disks, and it is not
always a power of two.
Reproduce with a 4-disk RAID5, 1024-sector chunks, and three data disks.
The full-stripe width is 3072 sectors. For a one-sector write at array
sector 3072, correct rounding gives array range [3072, 6144), which maps
to component range [1024, 2048). The old round_down()/round_up() logic
instead gives
md: wait for behind writes before destroying bitmap
In the Linux kernel, the following vulnerability has been resolved:
md: wait for behind writes before destroying bitmap
__md_stop() destroyed the bitmap before calling mddev_detach(). That made
mddev_detach() skip bitmap_ops->wait_behind_writes(), because the bitmap
was already disconnected from mddev.
This was still safe for the legacy bitmap because bitmap_destroy() waits
for behind writes itself. llbitmap keeps that wait in its
->wait_behind_writes() operation instead, while ->destroy() tears down the
llbitmap storage. With the old ordering, RAID1 behind-write completions
could still run after llbitmap storage had been freed.
Call mdde
In the Linux kernel, the following vulnerability has been resolved:
md/md-llbitmap: prevent create failure bitmap UAF
llbitmap_create() publishes mddev->bitmap before reading the bitmap
superblock. This is needed because llbitmap_read_sb() can initialize a
new bitmap and flush it through helpers that use mddev->bitmap.
If llbitmap_read_sb() fails, the old cleanup dropped bitmap_info.mutex
and freed llbitmap before clearing mddev->bitmap. Readers such as
/proc/mdstat rely on bitmap_info.mutex to keep the bitmap pointer stable
while collecting bitmap stats, so they could observe the stale pointer
after the failed create path released the mut
md/md-llbitmap: stop daemon timer rearm on destroy
In the Linux kernel, the following vulnerability has been resolved:
md/md-llbitmap: stop daemon timer rearm on destroy
llbitmap_destroy() deletes pending_timer before flushing
md_llbitmap_io_wq. However, daemon_work can still be queued or running
after the timer has been deleted, and the daemon path can arm
pending_timer again when it finds dirty chunks that are not ready to
flush yet.
If that happens during teardown, pending_timer can remain armed after
llbitmap is freed and later dereference freed memory.
Add a BITMAP_SHUTDOWN bit to llbitmap->flags, set it before deleting
the timer, and make the timer and daemon paths stop queueing or
md/raid1: don't set array_frozen in raid1_takeover()
In the Linux kernel, the following vulnerability has been resolved:
md/raid1: don't set array_frozen in raid1_takeover()
raid1_takeover() sets conf->array_frozen = 1 on the newly-allocated
r1conf and nothing ever clears it, so every I/O to the array stalls
permanently once _wait_barrier() sees it stuck at 1.
This used to be harmless: level_store() called mddev_resume() right
after pers->run(), which called raid1_quiesce(mddev, 0) and cleared
array_frozen back to 0 regardless of what raid1_takeover() set. Commit
b39f35ebe86d ("md: don't quiesce in mddev_suspend()") removed that
quiesce(mddev, 0) call, so the pre-set now sticks.
setup_conf(
coresight: etm4x: fix underflow for usage of (nrseqstate - 1)
In the Linux kernel, the following vulnerability has been resolved:
coresight: etm4x: fix underflow for usage of (nrseqstate - 1)
According to IHI006H Embedded Trace Macrocell Architecture
Specification[0], TRCSEQEVR<n> is implemented only when
TRCIDR5.NUMSEQSTATE is 0b100, in which case n ranges from 0 to 2;
otherwise, TRCIDR5.NUMSEQSTATE is 0b000.
IOW, the number of usage in the initialisation or setting
TRCSEQEVR<n> with drvdata->nrseqstate - 1 in the loop could make
underflow issue when TRCIDR5.NUMSEQSTATE is 0b000.
Therefore, introduce nr_seq_ctrls field and untie it from nrseqstate.
As part of this introduce ETM_MAX_SEQ_TRANSITIONS
coresight: etm4x: missing cscfg_csdev_disable_active_config() in perf enable
In the Linux kernel, the following vulnerability has been resolved:
coresight: etm4x: missing cscfg_csdev_disable_active_config() in perf enable
In the perf enable path, there are missing cases where
cscfg_csdev_disable_active_config() is not called:
- Branch broadcast is selected but not supported by the hardware
- etm4_enable_hw() fails
This can lead to a leak of config_desc->active_cnt.
Fix this by properly calling cscfg_csdev_disable_active_config()
in these error paths.
perf: arm_pmuv3: Zero initialize hw_id branch stack field
In the Linux kernel, the following vulnerability has been resolved:
perf: arm_pmuv3: Zero initialize hw_id branch stack field
PERF_SAMPLE_BRANCH_HW_INDEX is supported by BRBE so hw_id is passed to
userspace, but it's never set by the BRBE driver. Zero initialize it as
it should be according to the docs:
* For the architectures whose raw branch records are
* already stored in age order, the hw_idx should be 0.
It's probably too risky to remove PERF_SAMPLE_BRANCH_HW_INDEX from BRBE
now in case anyone is setting it and reading the value, but zero
initializing the whole struct also protects against the same issue with
new fields that ar
arm_mpam: Fix a NULL pointer dereference on unbinding after an error interrupt
In the Linux kernel, the following vulnerability has been resolved:
arm_mpam: Fix a NULL pointer dereference on unbinding after an error interrupt
If a user unbinds an MSC after mpam_disable() has been run in response
to an error interrupt then a dereference of a NULL pointer occurs as
mpam_disable() sets the drvdata to NULL. Add an early return to the driver
remove callback to avoid this.
In the Linux kernel, the following vulnerability has been resolved:
arm_mpam: Disable driver unbind to avoid UAF
When a user unbinds an MSC and that MSC is the only MSC left for a
component then the corresponding mpam_component will be freed. If the user
then goes on to read the schemata file in the resctrl filesystem then the
mpam_component will be accessed from resctrl_arch_get_config() leading to a
use after free.
As the MPAM driver is not a module the unbind sysfs interface is the only
way to trigger the remove. Instead of dealing with the complexity of
allowing some unused MSC to unbind just remove the unbind sysfs interface.
bpf: Reject load-acquire from pointers requiring fault protection
In the Linux kernel, the following vulnerability has been resolved:
bpf: Reject load-acquire from pointers requiring fault protection
A BPF_LOAD_ACQ is not rewritten to a BPF_PROBE_MEM load by the verifier,
unlike a regular BPF_LDX, so the JIT emits a plain load with no exception
table entry and a fault panics the kernel instead of being handled.
Reject the source pointer types that a BPF_LDX would have had that fault
protection applied to, i.e. the ones bpf_convert_ctx_accesses() turns
into BPF_PROBE_MEM: a bare PTR_TO_BTF_ID, PTR_TO_BTF_ID | PTR_UNTRUSTED,
PTR_TO_BTF_ID | MEM_ALLOC | PTR_UNTRUSTED and PTR_TO_MEM | MEM_RDONLY |
PTR_UNTRUS
scsi: sd: Fix error handling in sd_probe() after large pool creation failure
In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: Fix error handling in sd_probe() after large pool creation failure
After device_add(&sdkp->disk_dev) succeeds, sd_large_pool_create()
failure must unregister disk_dev and let scsi_disk_release() free
sdkp. Going through out_free_index kfree()s an already registered device
and leaks the sysfs entry.
scsi: sd: Fix special_vec mempool leak when scsi_alloc_sgtables() fails
In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: Fix special_vec mempool leak when scsi_alloc_sgtables() fails
sd_set_special_bvec() allocates a special payload page for UNMAP and
WRITE SAME commands. If scsi_alloc_sgtables() fails afterward in
sd_setup_unmap_cmnd() or sd_setup_write_same{10,16}_cmnd(), the SCSI
midlayer does not call uninit_command() because RQF_DONTPREP is not set
yet, leaking the page.
Call sd_uninit_command() on error, and clear RQF_SPECIAL_PAYLOAD after
freeing the page.
btrfs: zoned: don't force read-only on transient -EAGAIN from reloc merge
In the Linux kernel, the following vulnerability has been resolved:
btrfs: zoned: don't force read-only on transient -EAGAIN from reloc merge
On a zoned FS, btrfs_delayed_refs_rsv_refill() returns -EAGAIN whenever
the over-committed metadata plus the zone_unusable bytes exceeds the
usable size in a metadata block-group to avoid heavy over-commit of
metadata and early ENOSPC in one transaction.
If this happens while doing reclaim, the transaction is getting aborted.
Treat -EAGAIN as a soft, retryable condition in case of block-group
reclaim.
btrfs: defrag: fix deadlock between defrag and delalloc space reservation
In the Linux kernel, the following vulnerability has been resolved:
btrfs: defrag: fix deadlock between defrag and delalloc space reservation
While running fsstress with autodefrag and flushoncommit, hit a deadlock
due to the fact that defrag reserves delalloc space while it's holding
dirty and locked folios, besides the extent range lock. The stack traces
are the following:
[958.624] task:kworker/u50:3 state:D stack:0 pid:20365 tgid:20365 ppid:2 task_flags:0x4208060 flags:0x00080000
[958.626] Workqueue: events_unbound btrfs_async_reclaim_metadata_space [btrfs]
[958.627] Call Trace:
[958.628] <TASK>
[958.628] __
btrfs: always wait for ordered extents to avoid OE races
In the Linux kernel, the following vulnerability has been resolved:
btrfs: always wait for ordered extents to avoid OE races
[BUG]
Syzbot reported a bug that there can be conflicting OEs for the same
range:
BTRFS critical (device loop4): panic in insert_ordered_extent:264: overlapping ordered extents, existing oe file_offset 16384 num_bytes 430080 flags 0x1089, new oe file_offset 16384 num_bytes 430080 flags 0x80 (errno=-17 Object alrea[ 179.162726][ T6897] BTRFS critical (device loop4): panic in insert_ordered_extent:264: overlapping ordered extents, existing oe file_offset 16384 num_bytes 430080 flags 0x1089, new oe file_offset 16384
btrfs: check if root is readonly when setting posix acl
In the Linux kernel, the following vulnerability has been resolved:
btrfs: check if root is readonly when setting posix acl
For a filesystem which has btrfs read-only property set to true, all
write operations including acl and xattr should be denied. However, acl
can still be set even if btrfs ro property is true.
This happens because no function on the set_acl code path checks the root
is readonly or not. It was checked in btrfs_setxattr_trans() but got
removed in commit 353c2ea735e4 ("btrfs: remove redundant readonly root
check in btrfs_setxattr_trans")
That commit didn't check if all the callers properly check the root's
read-only fla
btrfs: retry verity reads for not-uptodate Merkle folios
In the Linux kernel, the following vulnerability has been resolved:
btrfs: retry verity reads for not-uptodate Merkle folios
btrfs_read_merkle_tree_page() can find a folio in the mapping that is not
uptodate. After taking the folio lock, the current code treats that state
as a read error and returns -EIO.
That can make a previous transient read failure sticky. If the failed read
left a not-uptodate folio in the mapping, later callers find that folio and
fail instead of retrying the read.
Keep the existing page-cache insertion and locking order, but retry the
Merkle item read when a not-uptodate folio is found in the mapping. Also
unloc
btrfs: zoned: flush active metadata block group at btree_writepages() start
In the Linux kernel, the following vulnerability has been resolved:
btrfs: zoned: flush active metadata block group at btree_writepages() start
btree_writepages() writes the btree inode's dirty metadata in ascending
logical address order. On a zoned filesystem only one metadata and one
system block group is active for writing at a time, and
check_bg_is_active() (via btrfs_check_meta_write_pointer()) pivots the
active block group as writeback moves from one block group to the next.
If the active block group sits at a higher logical address than another
block group that also holds dirty metadata, the ascending walk reaches
the lower one firs
btrfs: zoned: don't clobber the extent buffer when zeroing it out
In the Linux kernel, the following vulnerability has been resolved:
btrfs: zoned: don't clobber the extent buffer when zeroing it out
On a zoned filesystem a freed-but-still-dirty tree block is written out
as zeros (EXTENT_BUFFER_ZONED_ZEROOUT) only to keep the zone write
pointer advancing. btree_csum_one_bio() implemented this by memzeroing
the extent buffer's own folios before submission.
That destroys the in-memory buffer while it may still be referenced. In
particular btrfs_free_tree_block() can run on it afterwards and reads
the header to add a delayed reference; once the header has been zeroed
it frees bytenr 0 and corrupts the exten