smb: client: restore the data_offset bound in is_valid_oplock_break()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: restore the data_offset bound in is_valid_oplock_break()
Commit 83bfbd0bb902 ("cifs: Remove the RFC1002 header from smb_hdr")
changed the quantity this bound is measured against. It used to be
srv->total_read minus the 4-byte RFC1002 preamble that total_read then
included, so it was the SMB message length. The same commit stopped
counting the preamble, and the mechanical substitution to
srv->total_read - srv->pdu_size left an expression that is identically
zero: standard_receive3() reads MID_HEADER_SIZE() bytes and then exactly
pdu_length - MID_HEADER_SIZE()
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
HID: corsair-void: Check size of status and firmware events before reading them
In the Linux kernel, the following vulnerability has been resolved:
HID: corsair-void: Check size of status and firmware events before reading them
Malformed status and firmware events could cause an out-of-bounds read since
the size wasn't being checked. Check the size and warn on unexpected values to
avoid this.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
HID: picolcd: clamp eeprom debugfs read to bytes actually received
In the Linux kernel, the following vulnerability has been resolved:
HID: picolcd: clamp eeprom debugfs read to bytes actually received
picolcd_debug_eeprom_read() trusts resp->raw_data[2] -- a length byte
supplied by the device in its REPORT_EE_DATA reply -- clamped only to
the caller's read() count:
ret = resp->raw_data[2];
if (ret > s)
ret = s;
if (copy_to_user(u, resp->raw_data+3, ret))
It never checks resp->raw_size, the number of bytes picolcd_raw_event()
actually copied into the 64-byte raw_data[] of the kmalloc'd struct
picolcd_pending. A device (or a spoofed picoLCD) returning a length byte
of 0xff, read with a count >= 255,
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
HID: roccat: free buffered reports when destroying device
In the Linux kernel, the following vulnerability has been resolved:
HID: roccat: free buffered reports when destroying device
roccat_report_event() duplicates each report with kmemdup() and stores
the allocation in a circular-buffer slot. The allocation is released only
when that slot is reused.
The device destruction paths free struct roccat_device without releasing
reports still stored in cbuf[]. This makes those allocations unreachable
and leaks up to ROCCAT_CBUF_SIZE report buffers per device.
Add a small destructor that frees every buffered report before freeing the
device, and use it in both paths that can destroy a registered devic
HID: sensor: custom: Fix field sysfs group cleanup on failure
In the Linux kernel, the following vulnerability has been resolved:
HID: sensor: custom: Fix field sysfs group cleanup on failure
hid_sensor_custom_add_attributes() creates one sysfs group for each
custom sensor field. If sysfs_create_group() fails after some groups
have already been created, the function returns the error without
removing the previously created groups.
Add a local unwind path to remove the groups that were already created.
With enable_sensor exposed only after the field attributes are ready,
this path can free sensor_inst->fields without leaving enable_sensor
able to access pointers into that array.
HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind
In the Linux kernel, the following vulnerability has been resolved:
HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind
For GHL (Guitar Hero Live) dongles, sony_probe() arms a periodic timer:
ghl_magic_poke() (the timer callback) submits sc->ghl_urb, and the URB
completion ghl_magic_poke_cb() re-arms the timer with mod_timer().
sony_remove() drained the timer with timer_delete_sync() and then freed
the URB with usb_free_urb():
timer_delete_sync(&sc->ghl_poke_timer);
usb_free_urb(sc->ghl_urb);
timer_delete_sync() does not block re-arming, and while the URB is in
flight the timer is not pending, so the sync delete is a no-op.
HID: universal-pidff: stop the device when force-feedback init fails
In the Linux kernel, the following vulnerability has been resolved:
HID: universal-pidff: stop the device when force-feedback init fails
universal_pidff_probe() starts the device with hid_hw_start() and then, if
force-feedback initialisation fails, returns the error through a label that
only does "return error". The device is left started.
The HID core does not unwind on the driver's behalf. __hid_device_probe()
releases the devres group, closes the report and clears hdev->driver:
if (ret) {
devres_release_group(&hdev->dev, hdev->devres_group_id);
hid_close_report(hdev);
hdev->driver = NULL;
}
The hidraw character device that h
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: stop device IO before hid_hw_stop
Quiesce device IO at the start of the devm cleanup callback
mcp2221_hid_unregister() so that incoming HID reports cannot race with
hardware teardown during probe failure or device removal, addressing a
potential use-after-free.
Guard the call to hid_device_io_stop() with io_started. On normal
removal hid_device_remove() has already cleared io_started before the
devres group is released, so an unconditional call would otherwise hit
the !io_started path and emit a spurious "io already stopped" warning
on every removal. The guar
HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes
mcp_i2c_smbus_read() stores the caller-supplied buffer pointer in
mcp->rxbuf for the duration of a transfer but never clears it when the
transfer finishes or times out. Once the caller frees or reuses the
buffer, mcp->rxbuf becomes a dangling pointer. A delayed or spurious
MCP2221_I2C_GET_DATA report can then drive mcp2221_raw_event() to
memcpy device data into the freed memory, causing a write
use-after-free.
Route all return paths through a single exit point that clears
mcp->rxbuf and mcp->rxbuf_size, so that t
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
HID: mcp2221: validate report size in mcp2221_raw_event()
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: validate report size in mcp2221_raw_event()
mcp2221_raw_event() never validates the size of incoming HID reports.
In the MCP2221_I2C_GET_DATA path it trusts the device-supplied data[3]
as the copy length without checking that 4 + data[3] bytes actually
exist in the received report. A malicious or misbehaving USB device can
send a short report with a large data[3], causing the memcpy to read
past the valid report data in the HID transfer buffer and leak
uninitialized kernel memory back to userspace through the I2C/SMBus
read path.
Add a minimum size check at e
HID: intel-thc-hid: intel-quickspi: validate report size before copy
In the Linux kernel, the following vulnerability has been resolved:
HID: intel-thc-hid: intel-quickspi: validate report size before copy
write_cmd_to_txdma() builds an output report in qsdev->report_buf, a heap
buffer allocated in quickspi_alloc_report_buf() to the device-descriptor
derived max_report_len (a few hundred bytes for a touch controller). It
copies the caller-supplied report into that buffer:
memcpy(write_buf->content, report_buf, report_buf_len);
The HID core caps a report at HID_MAX_BUFFER_SIZE (16384) by default, and
quickspi_hid_ll_driver does not set max_buffer_size, so the length reaches
the driver unbounded. A hid
HID: intel-thc-hid: intel-quickspi: bound GET_REPORT response to the caller buffer
In the Linux kernel, the following vulnerability has been resolved:
HID: intel-thc-hid: intel-quickspi: bound GET_REPORT response to the caller buffer
quickspi_hid_raw_request() receives the caller's buffer length in len, but
quickspi_get_report() never sees it and copies the whole device-supplied
response into buf regardless:
memcpy(buf, qsdev->report_buf, qsdev->report_len);
qsdev->report_len comes from the input report the touch controller returns,
while buf is sized to whatever the caller asked hidraw for through
HIDIOCGFEATURE or HIDIOCGINPUT. A response larger than that overflows buf
with device-controlled content.
The intel-q
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
eventfs: Initialize ei->children and ei->list in init_ei()
In the Linux kernel, the following vulnerability has been resolved:
eventfs: Initialize ei->children and ei->list in init_ei()
eventfs_create_dir() allocates the eventfs_inode and initializes it with
init_ei(). But this does not initialize the eventfs_inode list_heads. If
the eventfs_create_dir() fails due to memory pressure, it will call
free_ei() before it initialized the lists, and that checks to make sure
the eventfs_inode has no children. But because the list wasn't
initialized, it will give a false warning.
Fix it by moving the list initialization into init_ei().
[ Rewrote change log ]
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: validate dirty page table on log replay
Each DIR_PAGE_ENTRY ends in a page_lcns[] array whose length is the on-disk
lcns_follow field. check_rstbl() validates the table bookkeeping but never
checks that this array fits in the entry, so a crafted lcns_follow lets the
v0->v1 conversion memmove and later replay passes run off the entry.
Add check_dp_table() to reject, right after check_rstbl(), any entry larger
than its size claims via struct_size() (the same expression used to allocate
these entries, so the check is overflow-safe by construction). All consumers
can
fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()
ni_read_frame() decompresses an LZNT $DATA frame into the vmapped target
pages and then trusts decompress_lznt()'s return value:
unc_size = decompress_lznt(frame_ondisk, ondisk_size, frame_mem,
frame_size);
if ((ssize_t)unc_size < 0) err = unc_size;
else if (!unc_size || unc_size > frame_size) err = -EINVAL;
decompress_lznt() stops as soon as the compressed stream is exhausted
(e.g. a zero chunk header) and returns the number of bytes it actually
wrote, which m
fs/ntfs3: bound page_lcns[] index by the log record
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: bound page_lcns[] index by the log record
The copy_lcns loop and the redo shorten loop index page_lcns[] at j + i,
where i runs up to the log record's lcns_follow. That count is checked only
against the record's own length, not the target entry, so check_dp_table()
(which validates the entry's lcns_follow) does not cover it: the copy_lcns
entry may even be freshly allocated after that check, and find_dp() bounds j
but not i. A crafted record thus overflows page_lcns[] of an otherwise valid
entry.
Add dp_range_ok() and reject, before each loop, any record whose ru
ntfs: bound the free-cluster bitmap scan to the volume
In the Linux kernel, the following vulnerability has been resolved:
ntfs: bound the free-cluster bitmap scan to the volume
vol->lcn_empty_bits_per_page is sized from vol->nr_clusters at mount, but
ntfs_cluster_alloc() bounds its scan of that array by the size of $Bitmap.
Those are independent on-disk quantities and the mount-time check only
rejects a $Bitmap that is too small, so an image whose $Bitmap covers more
clusters than the volume has lets the scan index past the array. A run
whose LCN lies in that gap takes the allocator straight there, since the
caller passes the file's own last LCN as its locality hint. KASAN reports
a slab out
In the Linux kernel, the following vulnerability has been resolved:
ntfs: reject invalid empty mapping pairs
Reject an attribute with empty mapping pairs if it has inconsistent
highest VCN and size.
In the Linux kernel, the following vulnerability has been resolved:
ntfs: reject invalid MFT LCNs from boot sector
The NTFS boot sector stores the MFT and MFTMirr locations as unsigned
64-bit LCNs, but parse_ntfs_boot_sector() decoded them into an s64.
A crafted high-bit value could therefore become negative and pass
the existing upper-bound check. The invalid value then propagated into
the MFT zone allocator and could result in an out-of-bounds access to
lcn_empty_bits_per_page.
In the Linux kernel, the following vulnerability has been resolved:
ntfs: validate non-resident attribute offsets
ntfs_attr_update_meta() shifts the attribute name when converting between
non-sparse and sparse attributes. Converting to sparse also adds the
compressed_size field before the name and mapping pairs, requiring eight
additional bytes in the attribute record.
However, the validator does not check that name_offset is within safe
boundaries for these operations or that the additional space is available.
A malicious MFT record could set name_offset such that:
1. The name is positioned at the very end of a non-sparse attribute.
C