netfilter: nf_tables: honor table dormant flag from netdev release event path
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_tables: honor table dormant flag from netdev release event path
Check for table dormant flag otherwise netdev release event path tries
to unregister an already unregistered hook.
[524854.857999] ------------[ cut here ]------------
[524854.858010] WARNING: CPU: 0 PID: 3386599 at net/netfilter/core.c:501 __nf_unregister_net_hook+0x21a/0x260
[...]
[524854.858848] CPU: 0 PID: 3386599 Comm: kworker/u32:2 Not tainted 6.9.0-rc3+ #365
[524854.858869] Workqueue: netns cleanup_net
[524854.858886] RIP: 0010:__nf_unregister_net_hook+0x21a/0x260
[524854.858903] Code: 24
i40e: Do not use WQ_MEM_RECLAIM flag for workqueue
In the Linux kernel, the following vulnerability has been resolved:
i40e: Do not use WQ_MEM_RECLAIM flag for workqueue
Issue reported by customer during SRIOV testing, call trace:
When both i40e and the i40iw driver are loaded, a warning
in check_flush_dependency is being triggered. This seems
to be because of the i40e driver workqueue is allocated with
the WQ_MEM_RECLAIM flag, and the i40iw one is not.
Similar error was encountered on ice too and it was fixed by
removing the flag. Do the same for i40e too.
[Feb 9 09:08] ------------[ cut here ]------------
[ +0.000004] workqueue: WQ_MEM_RECLAIM i40e:i40e_service_task [i40e] is
flushing
HID: i2c-hid: remove I2C_HID_READ_PENDING flag to prevent lock-up
In the Linux kernel, the following vulnerability has been resolved:
HID: i2c-hid: remove I2C_HID_READ_PENDING flag to prevent lock-up
The flag I2C_HID_READ_PENDING is used to serialize I2C operations.
However, this is not necessary, because I2C core already has its own
locking for that.
More importantly, this flag can cause a lock-up: if the flag is set in
i2c_hid_xfer() and an interrupt happens, the interrupt handler
(i2c_hid_irq) will check this flag and return immediately without doing
anything, then the interrupt handler will be invoked again in an
infinite loop.
Since interrupt handler is an RT task, it takes over the CPU and the
fla
In the Linux kernel, the following vulnerability has been resolved:
dma: xilinx_dpdma: Fix locking
There are several places where either chan->lock or chan->vchan.lock was
not held. Add appropriate locking. This fixes lockdep warnings like
[ 31.077578] ------------[ cut here ]------------
[ 31.077831] WARNING: CPU: 2 PID: 40 at drivers/dma/xilinx/xilinx_dpdma.c:834 xilinx_dpdma_chan_queue_transfer+0x274/0x5e0
[ 31.077953] Modules linked in:
[ 31.078019] CPU: 2 PID: 40 Comm: kworker/u12:1 Not tainted 6.6.20+ #98
[ 31.078102] Hardware name: xlnx,zynqmp (DT)
[ 31.078169] Workqueue: events_unbound deferred_probe_work_func
[ 31.07
dmaengine: idxd: Fix oops during rmmod on single-CPU platforms
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Fix oops during rmmod on single-CPU platforms
During the removal of the idxd driver, registered offline callback is
invoked as part of the clean up process. However, on systems with only
one CPU online, no valid target is available to migrate the
perf context, resulting in a kernel oops:
BUG: unable to handle page fault for address: 000000000002a2b8
#PF: supervisor write access in kernel mode
#PF: error_code(0x0002) - not-present page
PGD 1470e1067 P4D 0
Oops: 0002 [#1] PREEMPT SMP NOPTI
CPU: 0 PID: 20 Comm: cpuhp/0 Not tainted 6.8.
In the Linux kernel, the following vulnerability has been resolved:
riscv: Fix TASK_SIZE on 64-bit NOMMU
On NOMMU, userspace memory can come from anywhere in physical RAM. The
current definition of TASK_SIZE is wrong if any RAM exists above 4G,
causing spurious failures in the userspace access routines.
In the Linux kernel, the following vulnerability has been resolved:
i2c: smbus: fix NULL function pointer dereference
Baruch reported an OOPS when using the designware controller as target
only. Target-only modes break the assumption of one transfer function
always being available. Fix this by always checking the pointer in
__i2c_transfer.
[wsa: dropped the simplification in core-smbus to avoid theoretical regressions]
batman-adv: Avoid infinite loop trying to resize local TT
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: Avoid infinite loop trying to resize local TT
If the MTU of one of an attached interface becomes too small to transmit
the local translation table then it must be resized to fit inside all
fragments (when enabled) or a single packet.
But if the MTU becomes too low to transmit even the header + the VLAN
specific part then the resizing of the local TT will never succeed. This
can for example happen when the usable space is 110 bytes and 11 VLANs are
on top of batman-adv. In this case, at least 116 byte would be needed.
There will just be an endless spam of
ba
Bluetooth: Fix memory leak in hci_req_sync_complete()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Fix memory leak in hci_req_sync_complete()
In 'hci_req_sync_complete()', always free the previous sync
request state before assigning reference to a new one.
xsk: validate user input for XDP_{UMEM|COMPLETION}_FILL_RING
In the Linux kernel, the following vulnerability has been resolved:
xsk: validate user input for XDP_{UMEM|COMPLETION}_FILL_RING
syzbot reported an illegal copy in xsk_setsockopt() [1]
Make sure to validate setsockopt() @optlen parameter.
[1]
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr_offset include/linux/sockptr.h:49 [inline]
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr include/linux/sockptr.h:55 [inline]
BUG: KASAN: slab-out-of-bounds in xsk_setsockopt+0x909/0xa40 net/xdp/xsk.c:1420
Read of size 4 at addr ffff888028c6cde3 by task syz-executor.0/7549
CPU: 0 PID: 7549 Comm: syz-executor.0 Not tainted 6.8.0-syzkaller-0
geneve: fix header validation in geneve[6]_xmit_skb
In the Linux kernel, the following vulnerability has been resolved:
geneve: fix header validation in geneve[6]_xmit_skb
syzbot is able to trigger an uninit-value in geneve_xmit() [1]
Problem : While most ip tunnel helpers (like ip_tunnel_get_dsfield())
uses skb_protocol(skb, true), pskb_inet_may_pull() is only using
skb->protocol.
If anything else than ETH_P_IPV6 or ETH_P_IP is found in skb->protocol,
pskb_inet_may_pull() does nothing at all.
If a vlan tag was provided by the caller (af_packet in the syzbot case),
the network header might not point to the correct location, and skb
linear part could be smaller than expected.
Add skb_vlan
In the Linux kernel, the following vulnerability has been resolved:
af_unix: Clear stale u->oob_skb.
syzkaller started to report deadlock of unix_gc_lock after commit
4090fa373f0e ("af_unix: Replace garbage collection algorithm."), but
it just uncovers the bug that has been there since commit 314001f0bf92
("af_unix: Add OOB support").
The repro basically does the following.
from socket import *
from array import array
c1, c2 = socketpair(AF_UNIX, SOCK_STREAM)
c1.sendmsg([b'a'], [(SOL_SOCKET, SCM_RIGHTS, array("i", [c2.fileno()]))], MSG_OOB)
c2.recv(1) # blocked as no normal data in recv queue
c2.close() # done async and un
ipv6: fix race condition between ipv6_get_ifaddr and ipv6_del_addr
In the Linux kernel, the following vulnerability has been resolved:
ipv6: fix race condition between ipv6_get_ifaddr and ipv6_del_addr
Although ipv6_get_ifaddr walks inet6_addr_lst under the RCU lock, it
still means hlist_for_each_entry_rcu can return an item that got removed
from the list. The memory itself of such item is not freed thanks to RCU
but nothing guarantees the actual content of the memory is sane.
In particular, the reference count can be zero. This can happen if
ipv6_del_addr is called in parallel. ipv6_del_addr removes the entry
from inet6_addr_lst (hlist_del_init_rcu(&ifp->addr_lst)) and drops all
references (__in6_ifa_put
Bluetooth: SCO: Fix not validating setsockopt user input
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: SCO: Fix not validating setsockopt user input
syzbot reported sco_sock_setsockopt() is copying data without
checking user input length.
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr_offset
include/linux/sockptr.h:49 [inline]
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr
include/linux/sockptr.h:55 [inline]
BUG: KASAN: slab-out-of-bounds in sco_sock_setsockopt+0xc0b/0xf90
net/bluetooth/sco.c:893
Read of size 4 at addr ffff88805f7b15a3 by task syz-executor.5/12578
Bluetooth: RFCOMM: Fix not validating setsockopt user input
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix not validating setsockopt user input
syzbot reported rfcomm_sock_setsockopt_old() is copying data without
checking user input length.
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr_offset
include/linux/sockptr.h:49 [inline]
BUG: KASAN: slab-out-of-bounds in copy_from_sockptr
include/linux/sockptr.h:55 [inline]
BUG: KASAN: slab-out-of-bounds in rfcomm_sock_setsockopt_old
net/bluetooth/rfcomm/sock.c:632 [inline]
BUG: KASAN: slab-out-of-bounds in rfcomm_sock_setsockopt+0x893/0xa70
net/bluetooth/rfcomm/sock.c:673
Read of size 4 at addr ffff8880209a8
Bluetooth: L2CAP: Fix not validating setsockopt user input
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix not validating setsockopt user input
Check user input length before copying data.
Bluetooth: hci_sock: Fix not validating setsockopt user input
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: Fix not validating setsockopt user input
Check user input length before copying data.
net/mlx5: Properly link new fs rules into the tree
In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: Properly link new fs rules into the tree
Previously, add_rule_fg would only add newly created rules from the
handle into the tree when they had a refcount of 1. On the other hand,
create_flow_handle tries hard to find and reference already existing
identical rules instead of creating new ones.
These two behaviors can result in a situation where create_flow_handle
1) creates a new rule and references it, then
2) in a subsequent step during the same handle creation references it
again,
resulting in a rule with a refcount of 2 that is not linked into the
tree, wi
In the Linux kernel, the following vulnerability has been resolved:
net: ena: Fix incorrect descriptor free behavior
ENA has two types of TX queues:
- queues which only process TX packets arriving from the network stack
- queues which only process TX packets forwarded to it by XDP_REDIRECT
or XDP_TX instructions
The ena_free_tx_bufs() cycles through all descriptors in a TX queue
and unmaps + frees every descriptor that hasn't been acknowledged yet
by the device (uncompleted TX transactions).
The function assumes that the processed TX queue is necessarily from
the first category listed above and ends up using napi_consume_skb()
for descri
kprobes: Fix possible use-after-free issue on kprobe registration
In the Linux kernel, the following vulnerability has been resolved:
kprobes: Fix possible use-after-free issue on kprobe registration
When unloading a module, its state is changing MODULE_STATE_LIVE ->
MODULE_STATE_GOING -> MODULE_STATE_UNFORMED. Each change will take
a time. `is_module_text_address()` and `__module_text_address()`
works with MODULE_STATE_LIVE and MODULE_STATE_GOING.
If we use `is_module_text_address()` and `__module_text_address()`
separately, there is a chance that the first one is succeeded but the
next one is failed because module->state becomes MODULE_STATE_UNFORMED
between those operations.
In `check_kprobe_address_