Sicherheitslücken in linux-gcp · Seite 181

power: supply: bq256xx: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: bq256xx: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler ha

• Auf 5.15.0-1112.122 aktualisieren

ext4: drop extent cache when splitting extent fails

In the Linux kernel, the following vulnerability has been resolved: ext4: drop extent cache when splitting extent fails When the split extent fails, we might leave some extents still being processed and return an error directly, which will result in stale extent entries remaining in the extent status tree. So drop all of the remaining potentially stale extents if the splitting fails.

• Auf 5.15.0-1112.122 aktualisieren

iommu/vt-d: Clear Present bit before tearing down PASID entry

In the Linux kernel, the following vulnerability has been resolved: iommu/vt-d: Clear Present bit before tearing down PASID entry The Intel VT-d Scalable Mode PASID table entry consists of 512 bits (64 bytes). When tearing down an entry, the current implementation zeros the entire 64-byte structure immediately using multiple 64-bit writes. Since the IOMMU hardware may fetch these 64 bytes using multiple internal transactions (e.g., four 128-bit bursts), updating or zeroing the entire entry while it is active (P=1) risks a "torn" read. If a hardware fetch occurs simultaneously with the CPU zeroing the entry, the hardware could observe an in

apparmor: Fix & Optimize table creation from possibly unaligned memory

In the Linux kernel, the following vulnerability has been resolved: apparmor: Fix & Optimize table creation from possibly unaligned memory Source blob may come from userspace and might be unaligned. Try to optize the copying process by avoiding unaligned memory accesses. - Added Fixes tag - Added "Fix &" to description as this doesn't just optimize but fixes a potential unaligned memory access [jj: remove duplicate word "convert" in comment trigger checkpatch warning]

net: hns3: fix double free issue for tx spare buffer

In the Linux kernel, the following vulnerability has been resolved: net: hns3: fix double free issue for tx spare buffer In hns3_set_ringparam(), a temporary copy (tmp_rings) of the ring structure is created for rollback. However, the tx_spare pointer in the original ring handle is incorrectly left pointing to the old backup memory. Later, if memory allocation fails in hns3_init_all_ring() during the setup, the error path attempts to free all newly allocated rings. Since tx_spare contains a stale (non-NULL) pointer from the backup, it is mistaken for a newly allocated buffer and is erroneously freed, leading to a double-free of the backup

• Auf 5.15.0-1112.122 aktualisieren

xen-netback: reject zero-queue configuration from guest

In the Linux kernel, the following vulnerability has been resolved: xen-netback: reject zero-queue configuration from guest A malicious or buggy Xen guest can write "0" to the xenbus key "multi-queue-num-queues". The connect() function in the backend only validates the upper bound (requested_num_queues > xenvif_max_queues) but not zero, allowing requested_num_queues=0 to reach vzalloc(array_size(0, sizeof(struct xenvif_queue))), which triggers WARN_ON_ONCE(!size) in __vmalloc_node_range(). On systems with panic_on_warn=1, this allows a guest-to-host denial of service. The Xen network interface specification requires the queue count to be

• Auf 5.15.0-1112.122 aktualisieren

power: supply: cpcap-battery: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: cpcap-battery: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ hand

• Auf 5.15.0-1112.122 aktualisieren

iio: sca3000: Fix a resource leak in sca3000_probe()

In the Linux kernel, the following vulnerability has been resolved: iio: sca3000: Fix a resource leak in sca3000_probe() spi->irq from request_threaded_irq() not released when iio_device_register() fails. Add an return value check and jump to a common error handler when iio_device_register() fails.

• Auf 5.15.0-1112.122 aktualisieren

power: supply: bq25980: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: bq25980: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler ha

• Auf 5.15.0-1112.122 aktualisieren

HID: intel-ish-hid: fix NULL-ptr-deref in ishtp_bus_remove_all_clients

In the Linux kernel, the following vulnerability has been resolved: HID: intel-ish-hid: fix NULL-ptr-deref in ishtp_bus_remove_all_clients During a warm reset flow, the cl->device pointer may be NULL if the reset occurs while clients are still being enumerated. Accessing cl->device->reference_count without a NULL check leads to a kernel panic. This issue was identified during multi-unit warm reboot stress clycles. Add a defensive NULL check for cl->device to ensure stability under such intensive testing conditions. KASAN: null-ptr-deref in range [0000000000000000-0000000000000007] Workqueue: ish_fw_update_wq fw_reset_work_fn Call Trace:

mfd: arizona: Fix regulator resource leak on wm5102_clear_write_sequencer() failure

In the Linux kernel, the following vulnerability has been resolved: mfd: arizona: Fix regulator resource leak on wm5102_clear_write_sequencer() failure The wm5102_clear_write_sequencer() helper may return an error and just return, bypassing the cleanup sequence and causing regulators to remain enabled, leading to a resource leak. Change the direct return to jump to the err_reset label to properly free the resources.

• Auf 5.15.0-1112.122 aktualisieren

netfilter: nft_set_rbtree: check for partial overlaps in anonymous sets

In the Linux kernel, the following vulnerability has been resolved: netfilter: nft_set_rbtree: check for partial overlaps in anonymous sets Userspace provides an optimized representation in case intervals are adjacent, where the end element is omitted. The existing partial overlap detection logic skips anonymous set checks on start elements for this reason. However, it is possible to add intervals that overlap to this anonymous where two start elements with the same, eg. A-B, A-C where C < B. start end A B start end A C Restore the check on overlapping start elements to report an overlap.

• Auf 5.15.0-1112.122 aktualisieren

scsi: smartpqi: Fix memory leak in pqi_report_phys_luns()

In the Linux kernel, the following vulnerability has been resolved: scsi: smartpqi: Fix memory leak in pqi_report_phys_luns() pqi_report_phys_luns() fails to release the rpl_list buffer when encountering an unsupported data format or when the allocation for rpl_16byte_wwid_list fails. These early returns bypass the cleanup logic, leading to memory leaks. Consolidate the error handling by adding an out_free_rpl_list label and use goto statements to ensure rpl_list is consistently freed on failure. Compile tested only. Issue found using a prototype static analysis tool and code review.

tpm: st33zp24: Fix missing cleanup on get_burstcount() error

In the Linux kernel, the following vulnerability has been resolved: tpm: st33zp24: Fix missing cleanup on get_burstcount() error get_burstcount() can return -EBUSY on timeout. When this happens, st33zp24_send() returns directly without releasing the locality acquired earlier. Use goto out_err to ensure proper cleanup when get_burstcount() fails.

• Auf 5.15.0-1112.122 aktualisieren

SUNRPC: auth_gss: fix memory leaks in XDR decoding error paths

In the Linux kernel, the following vulnerability has been resolved: SUNRPC: auth_gss: fix memory leaks in XDR decoding error paths The gssx_dec_ctx(), gssx_dec_status(), and gssx_dec_name() functions allocate memory via gssx_dec_buffer(), which calls kmemdup(). When a subsequent decode operation fails, these functions return immediately without freeing previously allocated buffers, causing memory leaks. The leak in gssx_dec_ctx() is particularly relevant because the caller (gssp_accept_sec_context_upcall) initializes several buffer length fields to non-zero values, resulting in memory allocation: struct gssx_ctx rctxh = { .exp

• Auf 5.15.0-1112.122 aktualisieren

power: supply: wm97xx: Fix NULL pointer dereference in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: wm97xx: Fix NULL pointer dereference in power_supply_changed() In `probe()`, `request_irq()` is called before allocating/registering a `power_supply` handle. If an interrupt is fired between the call to `request_irq()` and `power_supply_register()`, the `power_supply` handle will be used uninitialized in `power_supply_changed()` in `wm97xx_bat_update()` (triggered from the interrupt handler). This will lead to a `NULL` pointer dereference since Fix this racy `NULL` pointer dereference by making sure the IRQ is requested _after_ the registration of the `power

• Auf 5.15.0-1112.122 aktualisieren

pinctrl: single: fix refcount leak in pcs_add_gpio_func()

In the Linux kernel, the following vulnerability has been resolved: pinctrl: single: fix refcount leak in pcs_add_gpio_func() of_parse_phandle_with_args() returns a device_node pointer with refcount incremented in gpiospec.np. The loop iterates through all phandles but never releases the reference, causing a refcount leak on each iteration. Add of_node_put() calls to release the reference after extracting the needed arguments and on the error path when devm_kzalloc() fails. This bug was detected by our static analysis tool and verified by my code review.

• Auf 5.15.0-1112.122 aktualisieren

power: supply: act8945a: Fix use-after-free in power_supply_changed()

In the Linux kernel, the following vulnerability has been resolved: power: supply: act8945a: Fix use-after-free in power_supply_changed() Using the `devm_` variant for requesting IRQ _before_ the `devm_` variant for allocating/registering the `power_supply` handle, means that the `power_supply` handle will be deallocated/unregistered _before_ the interrupt handler (since `devm_` naturally deallocates in reverse allocation order). This means that during removal, there is a race condition where an interrupt can fire just _after_ the `power_supply` handle has been freed, *but* just _before_ the corresponding unregistration of the IRQ handler h

• Auf 5.15.0-1112.122 aktualisieren

serial: caif: fix use-after-free in caif_serial ldisc_close()

In the Linux kernel, the following vulnerability has been resolved: serial: caif: fix use-after-free in caif_serial ldisc_close() There is a use-after-free bug in caif_serial where handle_tx() may access ser->tty after the tty has been freed. The race condition occurs between ldisc_close() and packet transmission: CPU 0 (close) CPU 1 (xmit) ------------- ------------ ldisc_close() tty_kref_put(ser->tty) [tty may be freed here] <-- race window --> caif_xmit() handle_tx()

• Auf 5.15.0-1112.122 aktualisieren

fs/ntfs3: prevent infinite loops caused by the next valid being the same

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: prevent infinite loops caused by the next valid being the same When processing valid within the range [valid : pos), if valid cannot be retrieved correctly, for example, if the retrieved valid value is always the same, this can trigger a potential infinite loop, similar to the hung problem reported by syzbot [1]. Adding a check for the valid value within the loop body, and terminating the loop and returning -EINVAL if the value is the same as the current value, can prevent this. [1] INFO: task syz.4.21:6056 blocked for more than 143 seconds. Call Trace: rwbase_

• Auf 5.15.0-1112.122 aktualisieren