Sicherheitslücken in linux-nvidia-tegra · Seite 120

ocfs2: avoid moving extents to occupied clusters

In the Linux kernel, the following vulnerability has been resolved: ocfs2: avoid moving extents to occupied clusters For non-auto OCFS2_IOC_MOVE_EXT operations, userspace supplies a physical me_goal. ocfs2_move_extent() initializes new_phys_cpos from that goal and expects ocfs2_probe_alloc_group() to replace it with a free run in the target block group. The probe currently leaves *phys_cpos unchanged if the scan reaches the end of the group without finding a free run. An occupied goal at the last bit can therefore survive the probe and be passed to __ocfs2_move_extent(), which copies file data into a cluster still owned by another inode

• Auf 5.15.0-1070.72 aktualisieren

ocfs2: fix NULL h_transaction deref in ocfs2_assure_trans_credits

In the Linux kernel, the following vulnerability has been resolved: ocfs2: fix NULL h_transaction deref in ocfs2_assure_trans_credits [BUG] A direct write over unwritten extents can panic the kernel in ocfs2_assure_trans_credits() when the journal aborts during DIO completion. The crash is a general protection fault from a NULL pointer dereference. [CAUSE] ocfs2_dio_end_io_write() loops over a direct write's unwritten extents, marking each written under a single journal handle. If the journal aborts (for example after an I/O error) while the extent tree is being updated, the handle is left aborted with its transaction pointer cleared. The

• Auf 5.15.0-1070.72 aktualisieren

ocfs2: fix UBSAN array-index-out-of-bounds in ocfs2_sum_rightmost_rec

In the Linux kernel, the following vulnerability has been resolved: ocfs2: fix UBSAN array-index-out-of-bounds in ocfs2_sum_rightmost_rec [BUG] On-disk corruption setting l_next_free_rec to 0 in an inode's embedded extent list triggers a UBSAN panic on the next write to that file. [CAUSE] ocfs2_sum_rightmost_rec() computes i = le16_to_cpu(el->l_next_free_rec) - 1 and accesses el->l_recs[i] without validating i. When l_next_free_rec is 0, i becomes -1; when l_next_free_rec exceeds l_count, i falls past the end of the array. Either case violates the __counted_by_le(l_count) annotation on l_recs[] and triggers UBSAN. [FIX] Validate the inode

ocfs2: reject dinodes with non-canonical i_mode type

In the Linux kernel, the following vulnerability has been resolved: ocfs2: reject dinodes with non-canonical i_mode type Patch series "ocfs2: harden inode validators against forged metadata", v2. This series adds three structural checks to OCFS2 dinode validation so malformed on-disk fields are rejected before ocfs2_populate_inode() copies them into the in-core inode. The checks cover: - i_mode values whose type bits do not name a canonical POSIX file type; - non-device dinodes whose id1.dev1.i_rdev field is non-zero; and - non-inline dinodes that claim non-zero i_size while i_clusters is zero, covering directories uncondit

• Auf 5.15.0-1070.72 aktualisieren

ocfs2: reject non-inline dinodes with i_size and zero i_clusters

In the Linux kernel, the following vulnerability has been resolved: ocfs2: reject non-inline dinodes with i_size and zero i_clusters On a volume mounted without OCFS2_FEATURE_INCOMPAT_SPARSE_ALLOC, a non-inline regular file with non-zero i_size and zero i_clusters is structurally malformed: the extent map declares no allocated clusters yet the size header claims content exists. Keep rejecting that shape, but express it through a shared predicate so the same invariant is available to normal inode reads and online filecheck. The same zero-cluster shape is also malformed for non-inline directories. ocfs2 directory growth allocates backing s

• Auf 5.15.0-1070.72 aktualisieren

net: thunderbolt: Fix frags[] overflow by bounding frame_count

In the Linux kernel, the following vulnerability has been resolved: net: thunderbolt: Fix frags[] overflow by bounding frame_count tbnet_poll() assembles a multi-frame ThunderboltIP packet into one skb. The first frame goes into the skb linear area and every further frame is added as a page fragment. skb_add_rx_frag(skb, skb_shinfo(skb)->nr_frags, page, hdr_size, frame_size, TBNET_RX_PAGE_SIZE - hdr_size); A packet of frame_count frames therefore ends up with frame_count - 1 fragments. tbnet_check_frame() only bounds the peer supplied frame_count to TBNET_RING_SIZE / 4 (64), which is far above MAX_SKB_FRAGS (17 by default). A peer

• Auf 5.15.0-1070.72 aktualisieren

mtd: spi-nor: swp: Improve locking user experience

In the Linux kernel, the following vulnerability has been resolved: mtd: spi-nor: swp: Improve locking user experience In the case of the first block being locked (or the few first blocks), if the user want to fully unlock the device it has two possibilities: - either it asks to unlock the entire device, and this works; - or it asks to unlock just the block(s) that are currently locked, which fails. It fails because the conditions "can_be_top" and "can_be_bottom" are true. Indeed, in this case, we unlock everything, so the TB bit does not matter. However in the current implementation, use_top would be true (as this is the favourite optio

• Auf 5.15.0-1070.72 aktualisieren

irqchip/crossbar: Use correct index in crossbar_domain_free()

In the Linux kernel, the following vulnerability has been resolved: irqchip/crossbar: Use correct index in crossbar_domain_free() crossbar_domain_free() resets the domain data and then uses the nulled out irq_data->hwirq member as index to reset the irq_map[] entry and to write the relevant crossbar register with a safe entry. That means it never frees the correct index and keeps the crossbar register connection to the source interrupt active. If it would not reset the domain data, then this would be even worse as irq_data->hwirq holds the source interrupt number, but both the map and register index need the corresponding GIC SPI number an

• Auf 5.15.0-1070.72 aktualisieren

tpm: tpm_tis_spi: Use wait_woken() in wait_for_tmp_stat()

In the Linux kernel, the following vulnerability has been resolved: tpm: tpm_tis_spi: Use wait_woken() in wait_for_tmp_stat() wait_event_interruptible_timeout() evaluates its condition after setting the current task state to TASK_INTERRUPTIBLE. With CONFIG_DEBUG_ATOMIC_SLEEP this triggers a warning when the IRQ wait path is used: tpm_tis_status() tpm_tis_spi_read_bytes() tpm_tis_spi_transfer_full() spi_bus_lock() mutex_lock() Address this with the following measures: 1. Call wait_tpm_stat_cond() only while tasking is running. 2. Use wait_woken() to wait for changes.

• Auf 5.15.0-1070.72 aktualisieren

dmaengine: tegra: Fix burst size calculation

In the Linux kernel, the following vulnerability has been resolved: dmaengine: tegra: Fix burst size calculation Currently, the Tegra GPC DMA hardware requires the transfer length to be a multiple of the max burst size configured for the channel. When a client requests a transfer where the length is not evenly divisible by the configured max burst size, the DMA hangs with partial burst at the end. Fix this by reducing the burst size to the largest power-of-2 value that evenly divides the transfer length. For example, a 40-byte transfer with a 16-byte max burst will now use an 8-byte burst (40 / 8 = 5 complete bursts) instead of causing a h

dmaengine: dw-edma: Add spinlock to protect DONE_INT_MASK and ABORT_INT_MASK

In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma: Add spinlock to protect DONE_INT_MASK and ABORT_INT_MASK The DONE_INT_MASK and ABORT_INT_MASK registers are shared by all DMA channels, and modifying them requires a read-modify-write sequence. Because this operation is not atomic, concurrent calls to dw_edma_v0_core_start() can introduce race conditions if two channels update these registers simultaneously. Add a spinlock to serialize access to these registers and prevent race conditions. [den: update dw_edma.lock comment]

• Auf 5.15.0-1070.72 aktualisieren

dmaengine: dw-edma-pcie: Reject devices without driver data

In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma-pcie: Reject devices without driver data dw_edma_pcie_probe() treats the PCI device ID driver_data as the template for the controller layout and copies it unconditionally. A device bound dynamically via sysfs can match the driver without that data, which leads to a NULL pointer dereference. Reject such matches before enabling the device.

dmaengine: sh: rz-dmac: Move interrupt request after everything is set up

In the Linux kernel, the following vulnerability has been resolved: dmaengine: sh: rz-dmac: Move interrupt request after everything is set up Once the interrupt is requested, the interrupt handler may run immediately. Since the IRQ handler can access channel->ch_base, which is initialized only after requesting the IRQ, this may lead to invalid memory access. Likewise, the IRQ thread may access uninitialized data (the ld_free, ld_queue, and ld_active lists), which may also lead to issues. Request the interrupts only after everything is set up. To keep the error path simpler, use dmam_alloc_coherent() instead of dma_alloc_coherent().

• Auf 5.15.0-1070.72 aktualisieren

platform/x86: dell-laptop: fix missing cleanups in init error path

In the Linux kernel, the following vulnerability has been resolved: platform/x86: dell-laptop: fix missing cleanups in init error path dell_init() initializes several resources after dell_setup_rfkill(), including the optional touchpad LED, keyboard backlight LED, battery hook, debugfs directory and dell-laptop notifier. If a later LED or backlight registration fails, the error path only tears down the battery hook and rfkill resources. This leaves the notifier, debugfs directory, keyboard backlight LED and optional touchpad LED registered after dell_init() returns an error. Add the missing cleanup calls before tearing down rfkill.

i2c: imx: fix locked bus on SMBus block-read of 0 (atomic)

In the Linux kernel, the following vulnerability has been resolved: i2c: imx: fix locked bus on SMBus block-read of 0 (atomic) SMBus 3.1 6.5.7 allows a Block Read byte count of 0, but the atomic (polling) path rejects it as -EPROTO. Worse, it returns without a NACK+STOP: the next receive cycle has already started, so the target keeps holding SDA and the bus stays stuck until a power cycle for this i2c controller. Reading I2DR to obtain the count likewise arms the next byte on the count > I2C_SMBUS_BLOCK_MAX path, which also returned -EPROTO directly and left the bus held. Handle both: NACK the in-flight dummy byte (TXAK) and extend msgs->

• Auf 5.15.0-1070.72 aktualisieren

i2c: mlxbf: Fix use-after-free in mlxbf_i2c_init_resource()

In the Linux kernel, the following vulnerability has been resolved: i2c: mlxbf: Fix use-after-free in mlxbf_i2c_init_resource() If devm_platform_get_and_ioremap_resource() returns an error, mlxbf_i2c_init_resource() frees tmp_res before reading tmp_res->io to get the error code. This results in a use-after-free. Save the error code before freeing tmp_res.

• Auf 5.15.0-1070.72 aktualisieren

xen/gntdev: fix error handling in ioctl

In the Linux kernel, the following vulnerability has been resolved: xen/gntdev: fix error handling in ioctl When gntdev_ioctl_map_grant_ref() fails to copy the operation result back to userspace after successfully adding the mapping to the list, the error path returns -EFAULT without releasing the reference acquired by gntdev_alloc_map(). The mapping remains in priv->maps with a refcount of 1, causing a memory leak and a dangling list entry. Additionally, gntdev_add_map() may modify map->index to avoid overlap with existing mappings. Therefore, the index returned to userspace must be obtained after gntdev_add_map() completes. Fix this by

• Auf 5.15.0-1070.72 aktualisieren

xfrm: xfrm_interface: require CAP_NET_ADMIN in the device netns for changelink

In the Linux kernel, the following vulnerability has been resolved: xfrm: xfrm_interface: require CAP_NET_ADMIN in the device netns for changelink xfrmi_changelink() operates on at most two netns, dev_net(dev) and the interface link netns xi->net. They differ once the device is created in or moved to a netns other than the one the request runs in. The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev), so a caller privileged there but not in xi->net can rewrite an interface that lives in xi->net. Gate xfrmi_changelink() on rtnl_dev_link_net_capable() at its top, before any attribute is parsed.

• Auf 5.15.0-1070.72 aktualisieren

tpm: Make the TPM character devices non-seekable

In the Linux kernel, the following vulnerability has been resolved: tpm: Make the TPM character devices non-seekable The TPM character devices expose a sequential command/response interface, but their open handlers leave FMODE_PREAD and FMODE_PWRITE enabled. After a command leaves a response pending, pread(fd, buf, 16, 0x1400) passes 0x1400 as *off to tpm_common_read(). The transfer length is bounded by response_length, but the offset is used unchecked when forming data_buffer + *off. A sufficiently large offset therefore causes an out-of-bounds heap read through copy_to_user() and, if the copy succeeds, an out-of-bounds zero-write through

• Auf 5.15.0-1070.72 aktualisieren

spi: uniphier: Fix completion initialization order before devm_request_irq()

In the Linux kernel, the following vulnerability has been resolved: spi: uniphier: Fix completion initialization order before devm_request_irq() The driver calls devm_request_irq() before initializing the completion used by the interrupt handler. Because the interrupt may occur immediately after devm_request_irq(), the handler may execute before init_completion(). This may result in calling complete() on an uninitialized completion, causing undefined behavior. This has been observed with KASAN. Fix this by initializing the completion before registering the IRQ.

• Auf 5.15.0-1070.72 aktualisieren