Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
drm/amdgpu: fix ACP MFD device leak on init failure
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix ACP MFD device leak on init failure
acp_hw_init() registers ACP child devices with mfd_add_devices() before
attaching them to the ACP power domain and initializing the hardware.
If attaching a child to the power domain fails, or if the ACP reset or
clock enable operation times out, the failure path frees only the
source cell, resource, and platform-data allocations. The child
platform devices already registered by mfd_add_devices() remain
registered and are never released.
Remove the children from the power domain and unregister the MFD
devices on failures
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
nitro_enclaves: fix use-after-free on SLOT_ALLOC failure
In the Linux kernel, the following vulnerability has been resolved:
nitro_enclaves: fix use-after-free on SLOT_ALLOC failure
When ne_create_vm_ioctl() fails the SLOT_ALLOC request after
anon_inode_getfile() has succeeded, the error path calls
fput(enclave_file) and then frees ne_enclave.
In normal userspace context, fput() defers the final __fput() via
task_work. ne_enclave_release() therefore runs after ne_enclave has
already been freed and dereferences ne_enclave->slot_uid, causing a
use-after-free: KASAN: slab-use-after-free in ne_enclave_release.
The enclave has no slot allocated and is not yet linked into the
enclaves list on this er
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix port tear down use-after-free
Some drivers for multiport devices access port driver data from
completion handlers of shared URBs submitted at attach() or first open()
and stopped at disconnect() or last close(), respectively.
A simple NULL check before accessing the driver data makes sure that a
port state container has at least been allocated, but a completion
handler can still race with port tear down.
Reorder the disconnect handling so that ports are not deregistered (and
their driver data freed) until after all ports have been hung up and the
driver d
usb: storage: sierra_ms: reject short SWoC info transfers
In the Linux kernel, the following vulnerability has been resolved:
usb: storage: sierra_ms: reject short SWoC info transfers
sierra_get_swoc_info() requests sizeof(struct swoc_info) (60) bytes
from the device via usb_control_msg(), but its callers only treat a
negative return value as failure. A device that answers the
vendor-specific GetSwocInfo request with a short IN transfer is
therefore accepted, leaving the tail of the freshly allocated
(kmalloc(), non-zeroing) swoc_info buffer uninitialized.
truinst_show() subsequently prints swocInfo->rev, swocInfo->LinuxSKU
and swocInfo->LinuxVer from that buffer into the world-readable
(0444) "t
usb: gadget: f_uac1_legacy: validate bRequest index in generic_{set,get}_cmd
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_uac1_legacy: validate bRequest index in generic_{set,get}_cmd
generic_set_cmd() and generic_get_cmd() use the low nibble of
ctrl->bRequest as an index into con->data[]:
u8 cmd = (ctrl->bRequest & 0x0F); /* 0 .. 15 */
...
con->data[cmd] = value; /* OOB when cmd >= 5 */
struct usb_audio_control (include/linux/usb/audio.h) declares data as
a 5-element array, so indices 5 through 15 write (or read) up to 44
bytes past the end of the array on the heap.
A malicious USB host can craft a class-specific SET_CUR / GET_CUR
request with an arbi
In the Linux kernel, the following vulnerability has been resolved:
usb: dwc3: gadget: fix IRQ storm on invalid event buffer count
When dwc3_check_event_buf() reads a GEVNTCOUNT value exceeding the
event buffer length, commit 63ccd26cd1f6 ("usb: dwc3: gadget: check
that event count does not exceed event buffer length") returns IRQ_NONE
without writing back GEVNTCOUNT. Since the DWC3 interrupt is
level-triggered, the uncleared IRQ source keeps the line asserted,
causing a tight IRQ storm that accumulates 99,900 unhandled interrupts
and triggers spurious.c:184 BUG -> kernel panic.
The resulting call stack:
__report_bad_irq+0xac/0xc8
note
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
usb: gadget: aspeed-vhub: cancel wake work on device removal
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: aspeed-vhub: cancel wake work on device removal
wake_work is armed from the gadget .wakeup callback to resume suspended
downstream ports, and it is never cancelled in ast_vhub_remove(), so a
work item queued before or during removal can run after devm has freed
vhub and its ports, a use-after-free.
Cancelling the work alone is not sufficient: usb_gadget_wakeup() takes
no lock and the unbind path never clears wakeup_en, so a remote-wakeup
request in flight on another CPU can re-arm the work after the cancel
and before vhub is freed.
ast_vhub_del_dev() already
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
USB: gadget: dummy-hcd: Fix wait for outstanding request completions
In the Linux kernel, the following vulnerability has been resolved:
USB: gadget: dummy-hcd: Fix wait for outstanding request completions
The dummy-hcd driver emulates synchronize_irq() by waiting until its
private callback_usage counter drops to 0 (with the private lock not
held). This counter is incremented whenever a gadget driver callback
occurs (which requires the private lock to be dropped), but not when a
request completion handler is called.
This is an oversight. Request completion is triggered by timer
interrupts (emulating device IRQs in a real UDC), and the interrupt
handlers are supposed to have completed when the synchronize_
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
usb: gadget: f_fs: Fix NULL pointer dereference in FUNCTIONFS_ENDPOINT_DESC
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_fs: Fix NULL pointer dereference in FUNCTIONFS_ENDPOINT_DESC
When user space sets up FunctionFS with only full-speed descriptors
(e.g., flags = FUNCTIONFS_HAS_FS_DESC) and the gadget operates at a
higher speed (such as USB_SPEED_HIGH or USB_SPEED_SUPER),
config_ep_by_speed() detects that the function lacks descriptors for
the current speed, logs a warning, and falls back to full-speed
descriptors. The endpoint is then successfully enabled via
usb_ep_enable(), and epfile->ep becomes valid.
However, when user space subsequently issues the FUNCTIONFS_ENDPOINT_D
usb: core: clear both ep_in and ep_out for non-ep0 control endpoints
In the Linux kernel, the following vulnerability has been resolved:
usb: core: clear both ep_in and ep_out for non-ep0 control endpoints
In usb_enable_endpoint(), non-zero control endpoints (where
usb_endpoint_xfer_control(&ep->desc) is true) populate both
dev->ep_in[epnum] and dev->ep_out[epnum] with the same struct
usb_host_endpoint pointer.
However, usb_disable_endpoint() only clears either dev->ep_out[epnum] or
dev->ep_in[epnum] depending on the direction bit of epaddr when
reset_hardware is set, leaving the opposite direction's array slot
pointing to the disabled/freed endpoint.
Clear both dev->ep_out[epnum] and dev->ep_in[epnum] whe
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
USB: dwc2: shut down wakeup timer before freeing HCD state
In the Linux kernel, the following vulnerability has been resolved:
USB: dwc2: shut down wakeup timer before freeing HCD state
dwc2_wakeup_detected() accesses the DWC2 host state and can rearm the
wakeup timer. dwc2_hcd_free() currently deletes the timer only after
freeing host-owned state, and timer_delete() does not synchronize a
callback or prevent it from being queued again.
Stop and shut down the timer in dwc2_hcd_release(), before the HCD
resources are freed. This covers both the HCD initialization error path
and normal HCD removal.
usb: typec: tcpm: recover after failure to start the frs ams
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm: recover after failure to start the frs ams
Reset the port if the tcpm fails to start the FAST_ROLE_SWAP AMS by
initiating error recovery on it.
This helps in cases where some cables (incorrectly) signal an FRS to
an FRS capable port during disconnection. The TCPC autonomously starts
sourcing VBUS on detecting the FRS signal. However, the VBUS sourcing is
left on when the FAST_ROLE_SWAP AMS fails to start (as tcpm_sink_tx_ok
is 0 as CC is open due to the cable disconnect). This is because the
code sets the state to INVALID_STATE without resetting the port
usb: typec: tipd: fix uninitialized typec_partner_desc in tps6598x_connect()
In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tipd: fix uninitialized typec_partner_desc in tps6598x_connect()
tps6598x_connect() passes a stack-allocated typec_partner_desc to
typec_register_partner() after initializing only usb_pd, accessory and
identity.
typec_register_partner() copies attach and deattach from the descriptor
into the partner. With those fields left unset, garbage function pointers
may be stored and later invoked from typec_partner_link_device() when a USB
device is linked to the port. Uninitialized pd_revision and usb_capability
similarly leak stack data through partner sysfs.
Zero-ini
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
usb: cdns3: fix use-after-free in cdns3_gadget_exit()
In the Linux kernel, the following vulnerability has been resolved:
usb: cdns3: fix use-after-free in cdns3_gadget_exit()
cdns3_gadget_start() arms two works on system_freezable_wq:
pending_status_wq for the deferred ep0 status stage and aligned_buf_wq
for realigned request buffers. Both handlers use the cdns3_device the
works are embedded in, and cdns3_pending_setup_status_handler() also
calls the ep0 request completion.
cdns3_gadget_exit() does not wait for these works. It frees all
endpoints and aligned buffers and drops the last reference to the
gadget device, which frees priv_dev, so a work queued before the exit
can run after the fre
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
usb: cdns3: Fix NULL pointer dereference in cdns3_pci_probe
In the Linux kernel, the following vulnerability has been resolved:
usb: cdns3: Fix NULL pointer dereference in cdns3_pci_probe
The Cadence USBSS controller is a two-function PCI device. The first
probed function allocates the driver data and stores it with
pci_set_drvdata(), while the second function reuses it via
pci_get_drvdata() when pci_is_enabled() reports that the first
function has already been probed.
When the second function is probed while the first one has been
enabled but has not yet set its driver data, pci_get_drvdata()
returns NULL, and the subsequent wrap->devfn assignment dereferences
a NULL pointer and crashes the kernel
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
tty: vcc: zero-initialize control packet in vcc_send_ctl()
In the Linux kernel, the following vulnerability has been resolved:
tty: vcc: zero-initialize control packet in vcc_send_ctl()
The stack-allocated struct vio_vcc pkt was partially initialized,
leaving the tag.stype_env field uninitialized before being sent via
ldc_write(), potentially leaking kernel stack data to the LDC peer.
tty: vcc: hold port lock when clearing tty pointer in vcc_cleanup
In the Linux kernel, the following vulnerability has been resolved:
tty: vcc: hold port lock when clearing tty pointer in vcc_cleanup
vcc_cleanup() sets port->tty to NULL without holding port->lock, racing
with vcc_event() LDC callbacks that read port->tty under port->lock and
then use tty->port. This can cause a use-after-free when the callback
dereferences tty->port after cleanup has already destroyed and freed it.
tty: tty_port: restore TTY_IO_ERROR on activation failure
In the Linux kernel, the following vulnerability has been resolved:
tty: tty_port: restore TTY_IO_ERROR on activation failure
Make sure to restore the TTY_IO_ERROR flag if activation fails to
prevent I/O attempts on a port that is gone or powered down.
This specifically avoids issues like kernel panic due to unclocked
accesses or NULL-pointer dereferences when accessing powered down or
deregistered ports when a TTY ioctl races with hangup and open.
Note that the flag is set again in tty_port_close() but not restoring it
on activation failure leaves a window where drivers fail to handle the
ioctl-hangup race.
In the Linux kernel, the following vulnerability has been resolved:
tty: port: fix tty_port_tty_vhangup() race
Drivers rely on tty_port_tty_vhangup() to synchronously hang up their
ports before tearing down resources as part of deregistration (e.g. on
physical disconnect).
If tty_port_tty_vhangup() races with another hangup it may however
return before the port has been shut down. This is in turn can lead to
use-after-free and NULL-pointer dereferences in racing ioctls (including
a synchronous hangup) and in processing of racing asynchronous hangups
(carrier loss).
Add the missing serialisation to tty_port_tty_vhangup() and
tty_port_hangu
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
tty: abort break signalling on hangup
In the Linux kernel, the following vulnerability has been resolved:
tty: abort break signalling on hangup
The break ioctls can race with hangup and end up calling into a tty
driver for a device that is already gone or powered down.
Drivers must handle this race, but TCSBRK and TCSBRKP should still be
aborted to avoid calling back into the driver after a user-controlled
timeout (possibly even after the tty has been reopened).
Note that drivers should disable any break state on shutdown so just
return on hangup (calling break_ctl() again is racy and will most likely
fail for drivers handling the race).