PatchFirst · Aktuelle Sicherheitslücken
In den letzten 30 Tagen veröffentlichte Sicherheitslücken für linux-azure-fde: 759. Davon im KEV-Katalog: 0.
Sicherheitslücken: 7413
In the Linux kernel, the following vulnerability has been resolved: iommu/dma: Check atomic pool allocation result directly The non-blocking, non-coherent allocation path uses dma_alloc_from_pool(), which returns the allocated page and fills cpu_addr only on success. Do not rely on cpu_addr to detect allocation failure in this path. Check the returned page directly before using it for the IOMMU mapping.
In the Linux kernel, the following vulnerability has been resolved: swiotlb: Preserve allocation virtual address for dynamic pools swiotlb_alloc_tlb() can allocate from the DMA atomic pool when a decrypted pool is needed from atomic context. With CONFIG_DMA_DIRECT_REMAP, the atomic pool is backed by remapped virtual addresses, which are not the same as the direct-map addresses returned by phys_to_virt(). swiotlb_init_io_tlb_pool() currently reconstructs the pool virtual address from the physical start address. For atomic-pool backed allocations this stores the wrong address in pool->vaddr. Later, swiotlb_free_tlb() passes that address to d
In the Linux kernel, the following vulnerability has been resolved: i3c: dw: avoid shift-out-of-bounds when DAA assigns no devices On an empty bus ENTDAA assigns nothing, so cmd->rx_len (the count of addresses left unassigned) equals master->maxdevs. The GENMASK() index master->maxdevs - cmd->rx_len - 1 then becomes -1, which trips up UBSAN. This happens every time on boot on a Gigabyte/AMD server: UBSAN: shift-out-of-bounds in drivers/i3c/master/dw-i3c-master.c:905:12 shift exponent 64 is too large for 64-bit type 'long unsigned int' CPU: 7 UID: 0 PID: 963 Comm: (udev-worker) Not tainted 7.0.11-200.fc44.x86_64 #1 PREEMPT(lazy
In the Linux kernel, the following vulnerability has been resolved: md/raid1: create serial pool adding rdev to array with serialize_policy=1 The following bug has been observed with kernel 7.1.3 after adding a new rdev to an existing RAID1 array with serialize_policy enabled: Oops: 0002 [#1] CPU: 0 UID: 0 PID: 19639 Comm: ext4lazyinit Not tainted 7.1.3-1-default RIP: _raw_spin_lock_irqsave+0x27/0x50 CR2: 0000000000004960 Call Trace: wait_for_serialization+0xb9/0x260 [raid1] raid1_make_request+0x762/0xaff [raid1] md_handle_request+0x1c9/0x2e0 [md_mod] The raid1.c code calls wait_for_serialization() if the MD_SERIALIZE_P
In the Linux kernel, the following vulnerability has been resolved: misc: sgi-gru: remove interrupt-context page-table walks The GRU TLB miss handler walks a process's page tables without holding page-table locks or a reference to the mapped page. It also uses a kernel page-table accessor on user page tables and supports only PMD-level large mappings on x86-64. Remove the direct walker. Send interrupt faults directly to user polling mode so the existing call-OS fallback retries them in process context. Remove the mmap-lock failure statistic that can no longer be incremented.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt76x02: do not WARN on invalid rx descriptor length The MPDU length in the rx descriptor comes from the hardware. In monitor mode with the fcsfail filter enabled, the hardware passes up corrupted frames, and a corrupted frame can report a length larger than the received buffer. The bounds check correctly discards such frames, but its WARN_ON_ONCE wrapper means any over-the-air garbage frame taints the kernel, and panics it on the first such frame when panic_on_warn is set. Drop the WARN and discard the frame silently, matching what commit c2d4c8723dbf ("mt76x2
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt792x: fix use-after-free in mt76_rx_poll_complete A use-after-free issue occurs in mt76_rx_poll_complete due to a race condition. The STA has already been removed, but the rx_status still had a pointer to the wcid in the STA. Set the links' wcid pointers to be NULL for a MLD in mt7925_sta_pre_rcu_remove() BUG: KASAN: invalid-access in mt76_rx_poll_complete+0x280/0x470 Call trace: dump_backtrace+0xec/0x128 show_stack+0x18/0x28 dump_stack_lvl+0x40/0xc8 print_report+0x1b8/0x710 kasan_report+0xe0/0x144 do_bad_area+0x120/0x260 do_tag_check_fault+0x20/0x34 do_mem_
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7921: Add PCIe AER handler support to prevent system crash When an AER error occurs and the bus is hung, the register reads return 0xFFFFFFFF, causing the DMA queue state to be corrupted and resulting in an invalid memory access when accessing q->desc[] or q->entry[]. Unable to handle kernel paging request at virtual address ffffffc01099eac0 pc : mt76_dma_add_buf+0x124/0x188 [mt76] lr : mt76_dma_rx_fill+0x11c/0x1d8 [mt76] sp : ffffffc016d9bbf0 x29: ffffffc016d9bc10 x28: 0000000000000000 x27: 0000000000000000 x26: ffffffb7855e50b8 x25: ffffffb80d04f000 x24: 00
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt792x: Fix memory leak in SDIO TX path When tx_prepare_skb() returns an error in the SDIO TX path, the skb is not freed, leading to a memory leak. This can occur when zero-length frames (such as WNM NULL frames) are dropped to prevent potential hardware TX hangs. Fix this by properly releasing the skb with ieee80211_tx_status_ext() when tx_prepare_skb() fails.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: fix non-AQL packet accounting for MLO stations __mt76_tx_queue_skb() overrides the wcid passed by the driver with sta->drv_priv, so the wcid might incorrectly be changed after TX, causing wcid->non_aql_packets to be counted on the wrong wcid. For example, on the AP side, if a station's setup link is the 5G link and the station uses 2G to transmit a frame, the value of non_aql_packets is increased on the 5G wcid but decreased on the 2G wcid. Once the inflated counter exceeds MT_MAX_NON_AQL_PKT, the TX scheduler permanently refuses to service the station. Drop th
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: validate RX band_idx before dereferencing phys[] band_idx comes from a 2-bit descriptor field (0-3) and was used directly to index dev->mt76.phys[] (size __MT_MAX_BAND == 3) and dereference the result. A corrupt or reserved descriptor value could index out of bounds or hit a NULL phy on parts with fewer bands. Reject invalid band indices, mirroring mt7996_rx_get_wcid().
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: avoid nss underflow in mt7915_mcu_get_sta_nss If a peer's VHT/HE MCS map has no supported spatial stream (all fields 0x3), the loop exits with nss == 0 and the function returned (u8)-1 (255), which was then written into the firmware sta_rec_bf beamforming fields. Clamp the result to 0.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: bound TLV walk in mt7996_mcu_get_chip_config The response TLV loop advanced by tlv->len without a minimum, so a theoretical firmware response containing a zero-length TLV could spin forever, hanging the CPU during device probe. The u32 payload was also read without bounds checking. Reject a short fixed field, stop on a TLV whose length underruns the header or overruns the skb.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7915: unwind state on add_interface failure When mt76_wcid_alloc() fails, mt7915_add_interface() returned without clearing the vif_mask/omac_mask bits it had already set, without removing the firmware dev info added earlier, and without clearing a monitor_vif pointer to the vif mac80211 is about to free. mac80211 does not call remove_interface() for a failed add, so the indices and firmware dev entry leaked permanently and testmode could dereference the stale monitor_vif. Add a proper error unwind.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: hold dev->mt76.mutex while disabling tx worker in SER mt7996_mac_reset_work() parked the tx worker and disabled the RX/TX NAPIs before taking dev->mt76.mutex. mt76_worker_disable()/_enable() are plain kthread park/unpark, not refcounted, and __mt76_set_channel() toggles the same worker and the MT76_RESET bit under the mutex. An L1 SER racing a channel switch could therefore have the worker unparked and MT76_RESET cleared while the reset path resets the DMA rings, corrupting descriptors or tokens. Take the mutex before disabling the worker, as mt7915 does
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7996: reserve space for the CSA-abort countdown TLV When a CSA countdown is active, mt7996_mcu_beacon_cntdwn() emits two bss_bcn_cntdwn_tlv entries (the CSA countdown and the CCA-abort BCC), but MT7996_BEACON_UPDATE_SIZE only reserved one. With MBSSID enabled and a near-maximum beacon template the extra 8 bytes could push the offload command past MT7996_MAX_BSS_OFFLOAD_SIZE and trigger skb_over_panic(). Reserve room for both countdown TLVs.
In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: cancel reset and rc work on device unregister Both drivers cancelled dump_work on unregister but left reset_work and rc_work to be flushed only by destroy_workqueue() in mt76_free_device(), which runs after the hw is unregistered and the hardware stopped. A reset_work that fires in that window calls ieee80211_restart_hw() and re-arms mac_work on an unregistered hw, and rc_work touches station state being torn down. Cancel both up front, alongside dump_work.
In the Linux kernel, the following vulnerability has been resolved: ACPI: processor: Unregister cpufreq notifier on init failure acpi_processor_driver_init() registers the cpufreq policy notifier before registering the ACPI processor driver and setting up CPU hotplug state. If driver_register() or cpuhp_setup_state() fails, the error path only unregisters the ACPI processor driver and the idle driver. The cpufreq notifier remains registered even though initialization failed. Mirror the module exit path on the init failure path and unregister the cpufreq notifier when it has been registered.
In the Linux kernel, the following vulnerability has been resolved: drm/msm: don't tear down KMS twice when KMS init fails When priv->kms_init() (mdp4_kms_init() / mdp5_kms_init()) fails partway through, both display drivers already tear their KMS state down via mdp4_destroy() / mdp5_kms_destroy() before returning the error. The common error path in msm_drm_init() then runs msm_drm_uninit() -> msm_drm_kms_uninit(), which tries to destroy the very same KMS a second time, which causes a use-after-free crash. Bring MDP4/MDP5 in line with the DPU driver whose dpu_kms_init() doesn't perform error cleanup on the failure. Let the common path own
In the Linux kernel, the following vulnerability has been resolved: drm/msm/dsi: Drop dev_pm_opp_set_rate(0) dev_pm_opp_set_rate(0) removes the vote specified in required-opps but does not actually park the clock, making it run without the necessary power backing. Drop the explicit call to it. Every call site of ops->link_clk_disable() is followed by pm_runtime_put(), so the power vote will be rescinded if deemed safe. Patchwork: https://patchwork.freedesktop.org/patch/742783/
Gleichen Sie Ihren installierten Stack und seine Versionen mit den aktuellen Sicherheitsmeldungen ab.