Sicherheitslücken in linux-nvidia-tegra · Seite 164

usb: gadget: f_tcm: synchronize delayed set_alt with teardown

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_tcm: synchronize delayed set_alt with teardown The f_tcm set_alt() path defers endpoint setup to a work item and completes the delayed status response from process context. The delayed work uses f_tcm private state and may complete the setup request after disconnect or function teardown has already moved on. Cancel and drain the delayed set_alt work when the function is unbound or freed. For disable paths, which are reached under the composite device lock, use a small state machine and a non-sleeping cancellation path instead of cancel_work_sync(). If the wo

usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer uvc_send_response() builds the UVC control response from a user-supplied struct uvc_request_data: req->length = min_t(unsigned int, uvc->event_length, data->length); ... memcpy(req->buf, data->data, req->length); req->length is clamped to uvc->event_length, which is taken from the host control request wLength (up to UVC_MAX_REQUEST_SIZE, 64), and to data->length, which comes from the UVCIOC_SEND_RESPONSE ioctl and is only checked for being negative. The source buffer data->data is only 60 bytes, so a

USB: serial: io_edgeport: cap received transmit credits

In the Linux kernel, the following vulnerability has been resolved: USB: serial: io_edgeport: cap received transmit credits The interrupt-status packet reports transmit credits returned by the device. edge_interrupt_callback() adds the 16-bit value to txCredits without checking maxTxCredits. edge_write() uses txCredits minus the software FIFO count as the amount of data that fits. Since the FIFO is allocated with maxTxCredits bytes, txCredits exceeding maxTxCredits can cause OOB write in ring buffer. Cap accumulated credits at maxTxCredits. Conforming devices should never hit the cap.

wifi: ath9k: hif_usb: don't dereference hif_dev after re-arming firmware request

In the Linux kernel, the following vulnerability has been resolved: wifi: ath9k: hif_usb: don't dereference hif_dev after re-arming firmware request ath9k_hif_request_firmware() re-arms an asynchronous firmware load via request_firmware_nowait(), passing hif_dev as the completion context, and then still dereferences hif_dev: dev_info(&hif_dev->udev->dev, "ath9k_htc: Firmware %s requested\n", hif_dev->fw_name); The re-armed callback ath9k_hif_usb_firmware_cb() runs on the "events" workqueue and, when the firmware is missing, walks the retry chain into ath9k_hif_usb_firmware_fail() -> complete_all(&hif_dev->fw_done). That releases the w

wifi: ath11k: fix NULL pointer dereference in ath11k_hal_srng_access_begin

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix NULL pointer dereference in ath11k_hal_srng_access_begin In ATH11K_QMI_EVENT_FW_READY, ATH11K_FLAG_REGISTERED is set unconditionally even when ath11k_core_qmi_firmware_ready() fails. This leaves the driver in an inconsistent state where initialization is considered complete although the firmware ready handling did not finish successfully. During the subsequent SSR, the driver enters the restart path based on this incorrect state and dereferences uninitialized srng members, resulting in a NULL pointer dereference. Call trace: ath11k_hal_srng_access_begin

hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within corsairpsu_probe(). If the probe operation fails after "io start" has been initiated, this race condition will result in a uaf vulnerability [1]. CPU0 CPU1 ==== ==== corsairpsu_probe() hid_device_io_start() ... unlock driver_input_lock hid_hw_stop() kfree(hidraw) __hid_input_report() ... acquire driver_input_l

hwmon: (corsair-cpro) Stop device IO before calling hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-cpro) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by calling hid_device_io_stop() before calling hid_hw_stop().

hwmon: (nzxt-smart2) Stop device IO before calling hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: hwmon: (nzxt-smart2) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by calling hid_device_io_stop() before calling hid_hw_stop().

watchdog: pretimeout: Fix UAF in watchdog_unregister_governor()

In the Linux kernel, the following vulnerability has been resolved: watchdog: pretimeout: Fix UAF in watchdog_unregister_governor() When a watchdog governor is unregistered, it updates existing watchdog devices that were using this governor by falling back to `default_gov`. If the governor being unregistered is currently set as `default_gov`, the `default_gov` is never cleared. This leads to 2 use-after-free issues: 1. New watchdog devices registered after this point will inherit the dangling `default_gov`. 2. Existing watchdog devices using the unregistered governor will have their `wdd->gov` reassigned to the dangling `default_gov

wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get()

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get() When the first entry in msdu_details has a zero buffer address, the code accesses msdu_details[i - 1] with i == 0, causing a buffer underflow. Fix similarly to ath12k_wifi7_hal_rx_msdu_list_get() by adding a separate check for i == 0 before the main condition to prevent the out-of-bounds access. Found by Linux Verification Center (linuxtesting.org) with SVACE.

firewire: net: Fix fragmented datagram reassembly

In the Linux kernel, the following vulnerability has been resolved: firewire: net: Fix fragmented datagram reassembly fwnet_frag_new() keeps a sorted list of received fragments for a partial datagram. When a new fragment is adjacent to an existing fragment, the code checks whether the new fragment also closes the gap to the next or previous list entry. Those neighbor lookups currently assume that the current fragment always has a real next or previous fragment. At a list edge, the next or previous entry is the list head, not a struct fwnet_fragment_info. The gap checks also compare against the old edge of the current fragment instead of t

• Auf 6.8.0-1036.39 aktualisieren

wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler The firmware-controlled num_msg field (u8, 0-255) drives the loop in ath6kl_wmi_tx_complete_event_rx() without validation against the buffer length. This allows out-of-bounds reads of up to 1020 bytes past the WMI event buffer when the firmware sends an inflated num_msg. Add a check that the buffer is large enough to hold the fixed struct and the num_msg variable-length entries.

• Auf 6.8.0-1036.39 aktualisieren

wifi: ath6kl: fix OOB read from firmware IE lengths in connect event

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware IE lengths in connect event The firmware-controlled beacon_ie_len, assoc_req_len, and assoc_resp_len fields in ath6kl_wmi_connect_event_rx() are not validated against the buffer length. Their sum (up to 765) can exceed the actual WMI event data, causing out-of-bounds reads during IE parsing and state corruption of wmi->is_wmm_enabled. Add a check that the total IE length fits within the buffer.

• Auf 6.8.0-1036.39 aktualisieren

wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read When the firmware sends a command response with a length mismatch, carl9170_cmd_callback() logs the mismatch and calls carl9170_restart() but then falls through to memcpy(ar->readbuf, buffer + 4, len - 4). Since len comes from the firmware and can exceed ar->readlen, this copies more data than the readbuf was allocated for. Bound the memcpy to min(len - 4, ar->readlen) so that the response is still completed -- avoiding repeated restarts from queued garbage -- while preventing an overread past the resp

wifi: carl9170: fix OOB read from off-by-two in TX status handler

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: fix OOB read from off-by-two in TX status handler The bounds check in carl9170_tx_process_status() uses `i > ((cmd->hdr.len / 2) + 1)` which is off by two, allowing 2 extra iterations past valid _tx_status entries when the firmware- controlled hdr.ext exceeds hdr.len/2. Fix by using the correct comparison `i >= (cmd->hdr.len / 2)`.

wifi: carl9170: fix buffer overflow in rx_stream failover path

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: fix buffer overflow in rx_stream failover path The failover continuation in carl9170_rx_stream() copies the full tlen from the second USB transfer instead of capping at rx_failover_missing bytes. When both transfers are near maximum size, the total exceeds the 65535-byte failover SKB, triggering skb_over_panic. Limit the copy size to the missing byte count. [Fix checkpatch CHECK:PARENTHESIS_ALIGNMENT]

ASoC: tas2781: bound firmware description string parsing

In the Linux kernel, the following vulnerability has been resolved: ASoC: tas2781: bound firmware description string parsing The TAS2781 firmware parser reads several variable-length description strings with strlen() before checking that the string terminator is present inside the firmware blob. A malformed firmware image without a NUL terminator can therefore make the parser walk past the end of the firmware buffer before the later size checks run. Add a small bounded string-length helper and use it for all description fields that are parsed from the firmware buffer. Keep the existing size checks for the fixed bytes that follow each strin

• Auf 6.8.0-1036.39 aktualisieren

ALSA: hda: cs35l41: validate and free ACPI mute object

In the Linux kernel, the following vulnerability has been resolved: ALSA: hda: cs35l41: validate and free ACPI mute object cs35l41_get_acpi_mute_state() evaluates a _DSM method to get the ACPI mute state and reads the first byte from the returned object. However, the returned ACPI object is owned by the caller and is never freed after use, so each successful query leaks the _DSM result object. The code also assumes that the returned object is a buffer with at least one byte. A malformed firmware response can return a different object type or an empty buffer, and the direct ret->buffer.pointer dereference can then access an invalid pointer

smb: client: validate DFS referral PathConsumed

In the Linux kernel, the following vulnerability has been resolved: smb: client: validate DFS referral PathConsumed parse_dfs_referrals() validates that the response contains the fixed referral entry array and, on for-next, the per-referral string offsets. However, the response also contains a PathConsumed value that is later used for DFS path parsing. If a malformed response provides a PathConsumed value larger than the search name, later DFS parsing can advance beyond the end of the path. Validate PathConsumed against the search name length before storing it in the parsed referral.

• Auf 6.8.0-1035.38 aktualisieren

hwmon: occ: validate poll response sensor blocks

In the Linux kernel, the following vulnerability has been resolved: hwmon: occ: validate poll response sensor blocks The OCC poll response parser walks a counted list of sensor data blocks. It used the static backing-array capacity as the parse boundary, but a transport response makes only data_length bytes current and valid. A truncated response can therefore make the parser consume a block header or block extent outside the current response. Use data_length as the parent boundary, prove the fixed poll header and each current block header before reading them, and prove the complete block before advancing. Keep parsed sensor metadata local

• Auf 6.8.0-1036.39 aktualisieren