wifi: mac80211: drain PS delivery work during station teardown
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: drain PS delivery work during station teardown
Removing an AP or mesh station can notify the driver and wake TXQs after
the station has already been removed from the driver, and can update
num_sta_ps and the power-save queues after station cleanup has purged
them.
sta_deliver_ps_frames() tests sta->dead only before it starts delivery. A
worker that passes that test can be delayed while teardown sets sta->dead
and removes the station from the driver; when it resumes it still runs the
full delivery.
The existing cancel_work_sync() sits near the end of
__clea
wifi: mac80211: account proxy paths against the mesh path limit
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: account proxy paths against the mesh path limit
Proxy-path churn can drive the interface path counter negative and let
later mesh path additions exceed MESH_MAX_MPATHS.
mesh_path_free_rcu() decrements the interface mpaths counter for entries
from both the mesh and proxy path tables, but mpp_path_add() never
reserves a slot in that counter. Removing or expiring a proxy path
therefore returns a slot that was never charged.
mesh_path_add() uses the same counter to enforce MESH_MAX_MPATHS, so once
it falls below the number of installed paths the limit no longe
wifi: mac80211: keep fallback association elements alive
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: keep fallback association elements alive
Associating to a non-transmitted MBSSID profile reads freed memory while
determining the operating channel and applying HT capabilities.
When an association response omits WMM, HT, or VHT information,
ieee80211_assoc_config_link() parses the cached BSS IEs and copies the
missing element pointers out of that fallback parse. For a
non-transmitted MBSSID profile those pointers refer to merged-profile
storage owned by the parse object, and the fallback block frees that
object at its end. The copied pointers are used afte
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
wifi: mac80211: minstrel_ht: validate fixed rate index
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: minstrel_ht: validate fixed rate index
The fixed_rate_idx debugfs file is a plain u32 attribute, so any value
can be written to it. minstrel_ht_update_stats() then copies the value
into mi->max_tp_rate[] and mi->max_prob_rate, and
minstrel_ht_set_rate() uses MI_RATE_GROUP()/MI_RATE_IDX() to index
minstrel_mcs_groups[] (42 entries) and mi->groups[].rates[] (10 entries)
with it.
Writing e.g. 65535 selects group 4095 and rate index 15, far outside
both arrays. The out-of-bounds entries are dereferenced and updated as
struct minstrel_rate_stats (retry counts,
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: reject invalid 320 MHz CSA bandwidth
The HT/VHT channel definition validator can receive a 320 MHz
bandwidth indication from a received CSA frame on a non-6 GHz link.
It warns for this unsupported width but continues with an uninitialized
vht_operation.chan_width, which is then read by
ieee80211_chandef_vht_oper(). With panic_on_warn enabled, this lets a
received frame panic the kernel.
Reject the channel definition before entering the VHT operation
conversion. This preserves the existing CSA fallback while avoiding
both the warning and the uninitialized re
wifi: mac80211: release mesh path quota on failed additions
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: release mesh path quota on failed additions
Repeated failed or duplicate mesh path additions can exhaust
MESH_MAX_MPATHS while the path table holds fewer paths, which stops new
paths to reachable destinations from being created.
mesh_path_add() reserves a slot before allocating and inserting a path.
If allocation fails, the function returns without releasing the slot. If
the rhashtable insertion reports an error or an existing destination, the
function discards its candidate but retains the reservation. No new path
is installed in any of these cases.
Relea
wifi: mac80211: set info->band for 802.3 encap offload frames
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: set info->band for 802.3 encap offload frames
Unlike the 802.11 TX paths, ieee80211_8023_xmit() does not set
info->band from the channel context on non-MLD interfaces. It stays at
0, so ieee80211_get_tx_rates() uses the wrong band for these frames.
Set it the same way as ieee80211_build_hdr(): drop the frame if there is
no channel context, and leave the band at 0 on MLD interfaces.
wifi: mac80211: fix mesh fast xmit path deletion UAF
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: fix mesh fast xmit path deletion UAF
mesh_fast_tx_cache() stores raw mesh_path pointers. Path deletion
flushes the cache and then frees the path with kfree_rcu(), but a
lookup that already holds the path can insert a new cache entry
after the flush. The cache then points at freed memory.
Set MESH_PATH_DELETED before flushing, and skip inserting a cache
entry if the path or MPP path is already deleted. Check this under
the cache walk lock so it is ordered with the flush. Use WRITE_ONCE()
for the deletion flag updates because the cache check reads flags
witho
wifi: mac80211: handle empty FILS association request payload
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: handle empty FILS association request payload
fils_encrypt_assoc_req() accepts a (Re)Association Request frame whose
last element is the FILS Session element. crypt_len is then zero and
aes_siv_encrypt() is called with an empty plaintext.
kmemdup() returns ZERO_SIZE_PTR for a zero-length allocation, so the
unconditional sg_init_one() puts an invalid page into the scatterlist.
With CONFIG_DEBUG_SG this triggers a kernel BUG in sg_set_buf();
without the debug check the bogus page is handed to the crypto backend.
AES-SIV is defined for empty plaintext and th
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
USB: serial: fix dynamic id driver deregistration race
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix dynamic id driver deregistration race
Only free the dynamic ids after having deregistered the driver and
removed the "new_id" attribute to avoid leaking any id added by a racing
write to the attribute.
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
USB: serial: fix driver deregistration order
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix driver deregistration order
USB serial driver modules register one driver for the USB bus and one or
more drivers for the ports on the USB serial bus.
When unloading a driver module, the USB driver must be deregistered
before the USB serial bus drivers so that I/O is stopped before
unbinding the ports to avoid use-after-free in completion handlers
accessing port data.
Note that the "new_id" attributes must first be removed to prevent new
ids from being added and triggering a probe of the USB driver after it
has been deregistered.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
USB: serial: fix ioctl hangup race
In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix ioctl hangup race
The tty ioctls can race with hangup and end up calling into a tty driver
for a device that is already gone or powered down.
Serialise the callbacks using the tty port mutex and add the missing
checks to make sure the port has not been hung up before accessing port
driver data or hardware.
This specifically avoids dereferencing a NULL-pointer if a device is
disconnected during lengthy break signalling.
Note that TIOCGICOUNT and TIOCMIWAIT do not access port driver data or
hardware and are therefore not affected by the race.
thunderbolt: Fix KASAN reported use-after-free when request is canceled
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Fix KASAN reported use-after-free when request is canceled
Alan reported that when doing stress testing sometimes KASAN notices
use-after-free during control channel operation (stripped down keeping
the relevant parts):
BUG: KASAN: slab-use-after-free in tb_cfg_request_sync+0x240/0x250 [thunderbolt]
Read of size 24 at addr ffff88811067f290 by task kworker/u40:2/1760
<TASK>
tb_cfg_request_sync+0x240/0x250 [thunderbolt]
tb_cfg_read_raw+0x367/0x510 [thunderbolt]
tb_cfg_read+0xec/0x240 [thunderbolt]
tb_port_get_link_generation+0x258/0x420 [thunderbolt]
thunderbolt: Hold a router reference for each allocated HopID
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Hold a router reference for each allocated HopID
tb_stop() drops the reference to all DP tunnels but does not deactivate
them, thus nothing cancels a dprx_work still in flight (which holds its
own tunnel reference) and the tunnel can outlive tb_switch_remove(). The
HopID releases in tb_path_free() then operate on freed IDAs and trigger
warnings like
ida_free called for id=8 which is not allocated.
This can be triggered by unbinding the driver while a DP tunnel is still
waiting for the DPRX capabilities read to finish. On the Apple NHI
unplugging the cable r
Nicht bewertetEPSS 0,15%Keine Korrektur veröffentlicht
thunderbolt: Make the DP tunnel activation callback mandatory
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Make the DP tunnel activation callback mandatory
tb_tunnel_alloc_dp() takes an optional callback which is run from
dprx_work once the DPRX capabilities read has completed. Without that
callback tb_dp_dprx_start() reads the capabilities synchronously and
never queues the work. It however always takes a tunnel reference which
is only dropped by dprx_work itself or by tb_dp_dprx_stop() when
cancel_delayed_work() actually canceled that work. That reference is
thus leaked for every tunnel without a callback.
The only tunnels without one are those from tb_tunnel_dis
thunderbolt: Tear down inactive DP tunnels when the domain is stopped
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Tear down inactive DP tunnels when the domain is stopped
tb_stop() only tears down DMA tunnels so a DP tunnel that is still
waiting for dprx_work to complete keeps that work queued while the
routers are removed and the control channel is stopped. The work only
stops once the DPRX timeout has passed and because it requeues itself
until then the flush_workqueue() in tb_domain_remove() won't wait for its
final run. The callback then runs against a domain that is already torn
down. A reference to that domain is kept so the completion waiting for
that domain to disa
thunderbolt: Fix domain reference leak when DPRX read is canceled
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Fix domain reference leak when DPRX read is canceled
tb_tunnel_one_dp() takes a domain reference which is only dropped once
tb_dp_tunnel_active() has run on the work queue. If that work is
cancelled that reference is leaked. Since
commit f5cc545f5969 ("thunderbolt: Wait for tb_domain_release() to
complete when driver is removed") instead of just leaking memory this
now also blocks in the completion wait forever when unbinding the
driver.
This can be triggered whenever a DP tunnel is torn down before the DPRX
read has completed, e.g. by unplugging within the ti
thunderbolt: Don't access a DP tunnel after its DPRX read was canceled
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Don't access a DP tunnel after its DPRX read was canceled
tb_dp_dprx_work() checks ->dprx_canceled before it takes tb->lock so it
misses a tb_dp_dprx_stop() that could not cancel the already running
work. It then polls the DPRX capabilities and runs the callback for a
tunnel that has already been torn down while the domain is suspending or
going away.
This can be hit by cancelling the DPRX read from outside the ordered
tb->wq: During suspend tb_disconnect_and_release_dp() does just this and
with a later patch tb_stop() will do it as well. The latter in combina
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Reject oversized XDomain properties responses
tb_xdp_properties_request() allocates room for 45 data dwords in its
252-byte response buffer. The XDomain length field is six bits wide,
however, and a malicious peer can set it to 63. After the fixed response
fields are subtracted, the driver treats this as 48 data dwords.
Commit 322e93448d90 ("thunderbolt: Clamp XDomain response data copy to
allocation size") only bounds the copy against data_len. If data_len is
at least 48, memcpy() reads 192 bytes from the 180-byte res->data array,
causing a 12-byte heap ou
smb: client: discard post-EOF pagecache when extending a file via zero range
In the Linux kernel, the following vulnerability has been resolved:
smb: client: discard post-EOF pagecache when extending a file via zero range
smb3_zero_range() removed the pagecache only for the range being zeroed,
so when it extends the file the folio straddling the old EOF - which may
hold data dirtied past EOF through an mmap - was never dropped and became
visible as file content once the file was extended.
Lower the discard boundary to the smaller of the zero-range offset and the
old EOF.