ipv6: addrconf: bail out of dad_failure when state is no longer POSTDAD
In the Linux kernel, the following vulnerability has been resolved:
ipv6: addrconf: bail out of dad_failure when state is no longer POSTDAD
addrconf_dad_failure() transitions ifp->state from DAD to POSTDAD
via addrconf_dad_end(), which drops ifp->lock on return. The lock
is re-acquired after net_info_ratelimited(). A concurrent
ipv6_del_addr() can take the lock in that window, set ifp->state
to DEAD and run list_del_rcu(&ifp->if_list).
addrconf_dad_failure() then overwrites DEAD with ERRDAD at errdad:
and schedules a new dad_work. The work calls ipv6_del_addr()
again, hitting the already-poisoned list entry:
general protection fault:
IB/mlx5: Fix transport-domain rollback and initialize lb mutex earlier
In the Linux kernel, the following vulnerability has been resolved:
IB/mlx5: Fix transport-domain rollback and initialize lb mutex earlier
mlx5_ib_alloc_transport_domain() allocates a transport domain and then
may fail in mlx5_ib_enable_lb(). In that case, the allocated TD is leaked.
Fix this by deallocating the TD when mlx5_ib_enable_lb() returns an
error. Also return 0 explicitly in the no-loopback-capability success
branch, and move dev->lb.mutex initialization to mlx5_ib_stage_init_init().
In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Fix devx subscribe-event unwind NULL dereference
MLX5_IB_METHOD_DEVX_SUBSCRIBE_EVENT() links event_sub into sub_list
before initializing the fields used by the shared error path.
If eventfd_ctx_fdget() then fails, the unwind path dereferences
event_sub->ev_file in uverbs_uobject_put() and calls
subscribe_event_xa_dealloc() with an unset xa_key_level1.
subscribe_event_xa_alloc() creates the XA entry exactly once for a given
key_level1, on the first occurrence of that key. The unwind path must
therefore call subscribe_event_xa_dealloc() exactly once for it as wel
RDMA/srpt: fix integer overflow in immediate data length check
In the Linux kernel, the following vulnerability has been resolved:
RDMA/srpt: fix integer overflow in immediate data length check
imm_buf->len is a user-controlled uint32_t received from the network.
Adding it to imm_data_offset without overflow checking allows a
malicious initiator to send len=0xFFFFFFFF, causing req_size to wrap
around to a small value, bypassing the bounds check, and subsequently
passing a ~4GB length to sg_init_one().
Use check_add_overflow() to detect wrapping before the comparison.
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
tracing: Bound synthetic-field strings with seq_buf
In the Linux kernel, the following vulnerability has been resolved:
tracing: Bound synthetic-field strings with seq_buf
The synthetic field helpers build a prefixed synthetic variable name and
a generated hist command in fixed MAX_FILTER_STR_VAL buffers. The
current code appends those strings with raw strcat(), so long key lists,
field names, or saved filters can run past the end of the staging
buffers.
Build both strings with seq_buf and propagate -E2BIG if either the
synthetic variable name or the generated command exceeds
MAX_FILTER_STR_VAL. This keeps the existing tracing-side limit while
using the helper intended for bounded command c
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
RDMA/hns: Fix log flood after cmd_mbox failure
In the Linux kernel, the following vulnerability has been resolved:
RDMA/hns: Fix log flood after cmd_mbox failure
hns_roce_cmd_mbox() is the command interface between driver and
hardware. When hardware is abnormal, the unlimited error printings
after hns_roce_cmd_mbox() failure will cause log flood and even
system crash.
Replace ibdev_err() and ibdev_warn() with their ratelimited versions
in the error handling path after hns_roce_cmd_mbox() (and its wrappers
hns_roce_create_hw_ctx/hns_roce_destroy_hw_ctx) fails.
ALSA: seq: oss: Fix UAF at handling events with embedded SysEx data
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Fix UAF at handling events with embedded SysEx data
The OSS sequencer processes the input MIDI bytes into a sequencer
event to be dispatched later (in snd_seq_oss_midi_putc() called from
snd_seq_oss_process_event()). When it's a SysEx data, the event
record contains data.ext.ptr pointer to the original SysEx bytes, and
the referred data is copied into the pool afterwards at dispatching.
The problem is that, if the sequencer port gets closed concurrently
before the dispatch, the OSS sequencer core also releases the
resources (in snd_seq_oss_midi_check_exit_p
ALSA: seq: midi: Serialize output teardown with event_input
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: midi: Serialize output teardown with event_input
event_process_midi() borrows msynth->output_rfile.output and then
passes the substream to dump_midi() and snd_rawmidi_kernel_write()
without synchronizing with the output open/close transition.
midisynth_use() also publishes output_rfile before
snd_rawmidi_output_params() has finished.
The last midisynth_unuse() can therefore release the same rawmidi file
and free substream->runtime before snd_rawmidi_kernel_write1() takes
its runtime buffer reference. That leaves the event_input path using a
stale substream or ru
nvmet-tcp: fix page fragment cache leak in error path
In the Linux kernel, the following vulnerability has been resolved:
nvmet-tcp: fix page fragment cache leak in error path
In nvmet_tcp_alloc_queue(), when a connection is closed during the
allocation process (e.g., nvmet_tcp_set_queue_sock() returns -ENOTCONN),
the error handling jumps to out_destroy_sq and then to out_ida_remove
without draining the page fragment cache.
Although nvmet_tcp_free_cmd() is called in some error paths to release
individual page fragments, the underlying page cache reference held by
queue->pf_cache is never released. The first allocation using pf_cache
is the call to nvmet_tcp_alloc_cmd() for queue->connect, whi
nvme-multipath: fix flex array size in struct nvme_ns_head
In the Linux kernel, the following vulnerability has been resolved:
nvme-multipath: fix flex array size in struct nvme_ns_head
struct nvme_ns_head contains a flexible array member, current_path[],
which is indexed using the NUMA node ID:
head->current_path[numa_node_id()]
The structure is currently allocated as:
size = sizeof(struct nvme_ns_head) +
(num_possible_nodes() * sizeof(struct nvme_ns *));
head = kzalloc(size, GFP_KERNEL);
This allocation assumes that NUMA node IDs are sequential and densely
packed from 0 .. num_possible_nodes() - 1. While this assumption holds
on many systems, it is not always true on some architectures s
Nicht bewertetEPSS 0,19%Keine Korrektur veröffentlicht
net/sched: cls_bpf: prevent unbounded recursion in offload rollback
In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_bpf: prevent unbounded recursion in offload rollback
Quan Sun reported [1] a stack overflow in cls_bpf_offload_cmd().
Reproducer on netdevsim: add a skip_sw cls_bpf filter, set the
bpf_tc_accept debugfs knob to 0, then `tc filter replace`. The replace
calls tc_setup_cb_replace() which fails. cls_bpf_offload_cmd() then
swaps prog/oldprog and recursively calls itself to roll back. But
bpf_tc_accept=0 makes the rollback fail too, which triggers yet another
rollback frame with the same arguments, and so on until the stack is
exhausted.
bpf_tc_accept is just a c
In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Fix TOCTOU heap overflow in get_srq_wqe
get_srq_wqe() reads wqe->dma.num_sge from the shared receive queue
buffer, which is mapped into userspace. It validates num_sge against
max_sge, but then re-reads the same field to calculate the memcpy
size. A concurrent userspace thread can modify num_sge between
validation and use, causing a heap buffer overflow when copying the
WQE into qp->resp.srq_wqe.
Read num_sge into a local variable and use it for both the bounds
check and the size calculation.
RDMA/rxe: Copy WQE to local buffer in non-SRQ receive path
In the Linux kernel, the following vulnerability has been resolved:
RDMA/rxe: Copy WQE to local buffer in non-SRQ receive path
For non-SRQ QPs, the responder reads WQE fields directly from the
shared queue buffer mapped into userspace. This allows a malicious
user to modify fields like num_sge or sge entries while the kernel
is processing the WQE, leading to out-of-bounds reads in
rxe_resp_check_length() and copy_data().
Introduce get_recv_wqe() that validates num_sge and copies the WQE
to a kernel-local buffer before processing, matching the approach
already used for SRQ WQEs in get_srq_wqe(). The srq_wqe buffer is
reused since SRQ and no
md/raid10: reset read_slot when reusing r10bio for discard
In the Linux kernel, the following vulnerability has been resolved:
md/raid10: reset read_slot when reusing r10bio for discard
put_all_bios() always drops devs[i].bio, but it only drops
devs[i].repl_bio when r10_bio->read_slot < 0. If discard reuses an
r10bio that was previously used for a read, read_slot can still be
non-negative, and discard cleanup can skip bio_put() on repl_bio.
Reset read_slot to -1 when preparing an r10bio for discard so the
replacement bio is always released correctly.
md/raid1,raid10: fix error-path detection with md_cloned_bio()
In the Linux kernel, the following vulnerability has been resolved:
md/raid1,raid10: fix error-path detection with md_cloned_bio()
Detect the error path using md_cloned_bio() instead of relying
on r1_bio in raid1 or r10_bio->read_slot in raid10, which may be
NULL or -1 after splitting and resubmitting a failed bio.
As a result, the error path may not be recognized and memory
allocations can incorrectly use GFP_NOIO instead of
(GFP_NOIO | __GFP_HIGH), which can lead to a deadlock under
memory pressure.
nvdimm/btt: Handle preemption in BTT lane acquisition
In the Linux kernel, the following vulnerability has been resolved:
nvdimm/btt: Handle preemption in BTT lane acquisition
BTT lanes serialize access to per-lane metadata and workspace state
during BTT I/O. The btt-check unit test reports data mismatches during
BTT writes due to a race in lane acquisition that can lead to silent
data corruption.
The existing lane model uses a spinlock together with a per-CPU
recursion count. That recursion model stopped being valid after BTT
lanes became preemptible: another task can run on the same CPU,
observe a non-zero recursion count, bypass locking, and use the same
lane concurrently.
BTT lanes are a
configfs_lookup(): don't leave ->s_dentry dangling on failure
In the Linux kernel, the following vulnerability has been resolved:
configfs_lookup(): don't leave ->s_dentry dangling on failure
Normally ->s_dentry is cleared when dentry it's pointing to becomes
negative (on eviction, realistically). However, that only happens
if dentry gets to be positive in the first place; in case of inode
allocation failure dentry never becomes positive, so ->d_iput()
is not called at all.
We do part of what normally would've been done by configfs_d_iput()
(dropping the reference to configfs_dirent) manually, but we do
not clear ->s_dentry there. Sloppy as it is, it does not matter in
case of configfs_create_{dir,
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
ocfs2: rebase copied fsdlm LVB pointers in locking_state
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: rebase copied fsdlm LVB pointers in locking_state
The locking_state debugfs iterator snapshots struct ocfs2_lock_res by
value under ocfs2_dlm_tracking_lock and later formats that copy in
ocfs2_dlm_seq_show(). That is fine for the inline fields, but the
userspace fsdlm stack stores the LVB through lksb_fsdlm.sb_lvbptr. Once
the iterator drops the tracking lock, a copied non-NULL sb_lvbptr still
points into the original lockres owner, so teardown can free that
container before the debugfs dump walks the raw LVB bytes.
Rebase the copied sb_lvbptr to the copied l_lksb
ocfs2: validate fast symlink target during inode read
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate fast symlink target during inode read
ocfs2_validate_inode_block() already rejects several inconsistent
self-contained dinodes before they are exposed to the rest of the
filesystem. Fast symlinks need the same treatment.
A zero-cluster symlink is treated as a fast symlink and later read through
page_get_link() and ocfs2_fast_symlink_read_folio(). That path uses
strnlen() on the inline payload and then copies len + 1 bytes into the
folio. If a corrupt dinode stores an i_size that does not fit the inline
area or omits the terminating NUL at i_size, that co
ocfs2: reject FITRIM ranges shorter than a cluster
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: reject FITRIM ranges shorter than a cluster
ocfs2_trim_mainbm() trims the global bitmap in cluster units, but its
too-short range validation only checks sb->s_blocksize.
On filesystems with a cluster size larger than the block size, a FITRIM
range that is at least one block but shorter than one cluster is accepted
and shifted down to len == 0. The later start + len - 1 and len -= ...
arithmetic then underflows and can drive trimming past the requested
range.
Reject ranges shorter than s_clustersize instead. That preserves the
existing -EINVAL behavior for reques