iommu/vt-d: Flush dev-IOTLB only when PCIe device is accessible in scalable mode
In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Flush dev-IOTLB only when PCIe device is accessible in scalable mode
Commit 4fc82cd907ac ("iommu/vt-d: Don't issue ATS Invalidation
request when device is disconnected") relies on
pci_dev_is_disconnected() to skip ATS invalidation for
safely-removed devices, but it does not cover link-down caused
by faults, which can still hard-lock the system.
For example, if a VM fails to connect to the PCIe device,
"virsh destroy" is executed to release resources and isolate
the fault, but a hard-lockup occurs while releasing the group fd.
Call Trace:
qi_submit_sync
qi_fl
In the Linux kernel, the following vulnerability has been resolved:
ALSA: mixer: oss: Add card disconnect checkpoints
ALSA OSS mixer layer calls the kcontrol ops rather individually, and
pending calls might be not always caught at disconnecting the device.
For avoiding the potential UAF scenarios, add sanity checks of the
card disconnection at each entry point of OSS mixer accesses. The
rwsem is taken just before that check, hence the rest context should
be covered by that properly.
pstore: ram_core: fix incorrect success return when vmap() fails
In the Linux kernel, the following vulnerability has been resolved:
pstore: ram_core: fix incorrect success return when vmap() fails
In persistent_ram_vmap(), vmap() may return NULL on failure.
If offset is non-zero, adding offset_in_page(start) causes the function
to return a non-NULL pointer even though the mapping failed.
persistent_ram_buffer_map() therefore incorrectly returns success.
Subsequent access to prz->buffer may dereference an invalid address
and cause crashes.
Add proper NULL checking for vmap() failures.
fbcon: check return value of con2fb_acquire_newinfo()
In the Linux kernel, the following vulnerability has been resolved:
fbcon: check return value of con2fb_acquire_newinfo()
If fbcon_open() fails when called from con2fb_acquire_newinfo() then
info->fbcon_par pointer remains NULL which is later dereferenced.
Add check for return value of the function con2fb_acquire_newinfo() to
avoid it.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
rpmsg: core: fix race in driver_override_show() and use core helper
In the Linux kernel, the following vulnerability has been resolved:
rpmsg: core: fix race in driver_override_show() and use core helper
The driver_override_show function reads the driver_override string
without holding the device_lock. However, the store function modifies
and frees the string while holding the device_lock. This creates a race
condition where the string can be freed by the store function while
being read by the show function, leading to a use-after-free.
To fix this, replace the rpmsg_string_attr macro with explicit show and
store functions. The new driver_override_store uses the standard
driver_set_override helper. Since t
wifi: rtw88: Use devm_kmemdup() in rtw_set_supported_band()
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: Use devm_kmemdup() in rtw_set_supported_band()
Simplify the code by using device managed memory allocations.
This also fixes a memory leak in rtw_register_hw(). The supported bands
were not freed in the error path.
Copied from commit 145df52a8671 ("wifi: rtw89: Convert
rtw89_core_set_supported_band to use devm_*").
Bluetooth: hci_sync: annotate data-races around hdev->req_status
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: annotate data-races around hdev->req_status
__hci_cmd_sync_sk() sets hdev->req_status under hdev->req_lock:
hdev->req_status = HCI_REQ_PEND;
However, several other functions read or write hdev->req_status without
holding any lock:
- hci_send_cmd_sync() reads req_status in hci_cmd_work (workqueue)
- hci_cmd_sync_complete() reads/writes from HCI event completion
- hci_cmd_sync_cancel() / hci_cmd_sync_cancel_sync() read/write
- hci_abort_conn() reads in connection abort path
Since __hci_cmd_sync_sk() runs on hdev->req_workqueue while
hci_se
btrfs: fix zero size inode with non-zero size after log replay
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix zero size inode with non-zero size after log replay
When logging that an inode exists, as part of logging a new name or
logging new dir entries for a directory, we always set the generation of
the logged inode item to 0. This is to signal during log replay (in
overwrite_item()), that we should not set the i_size since we only logged
that an inode exists, so the i_size of the inode in the subvolume tree
must be preserved (as when we log new names or that an inode exists, we
don't log extents).
This works fine except when we have already logged an inode in full mo
btrfs: tracepoints: get correct superblock from dentry in event btrfs_sync_file()
In the Linux kernel, the following vulnerability has been resolved:
btrfs: tracepoints: get correct superblock from dentry in event btrfs_sync_file()
If overlay is used on top of btrfs, dentry->d_sb translates to overlay's
super block and fsid assignment will lead to a crash.
Use file_inode(file)->i_sb to always get btrfs_sb.
netfilter: ctnetlink: ensure safe access to master conntrack
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ctnetlink: ensure safe access to master conntrack
Holding reference on the expectation is not sufficient, the master
conntrack object can just go away, making exp->master invalid.
To access exp->master safely:
- Grab the nf_conntrack_expect_lock, this gets serialized with
clean_from_lists() which also holds this lock when the master
conntrack goes away.
- Hold reference on master conntrack via nf_conntrack_find_get().
Not so easy since the master tuple to look up for the master conntrack
is not available in the existing problematic paths.
This patch g
In the Linux kernel, the following vulnerability has been resolved:
srcu: Use irq_work to start GP in tiny SRCU
Tiny SRCU's srcu_gp_start_if_needed() directly calls schedule_work(),
which acquires the workqueue pool->lock.
This causes a lockdep splat when call_srcu() is called with a scheduler
lock held, due to:
call_srcu() [holding pi_lock]
srcu_gp_start_if_needed()
schedule_work() -> pool->lock
workqueue_init() / create_worker() [holding pool->lock]
wake_up_process() -> try_to_wake_up() -> pi_lock
Also add irq_work_sync() to cleanup_srcu_struct() to prevent a
use-after-free if a queued irq_work fires after cleanup be
wifi: wl1251: validate packet IDs before indexing tx_frames
In the Linux kernel, the following vulnerability has been resolved:
wifi: wl1251: validate packet IDs before indexing tx_frames
wl1251_tx_packet_cb() uses the firmware completion ID directly to index
the fixed 16-entry wl->tx_frames[] array. The ID is a raw u8 from the
completion block, and the callback does not currently verify that it
fits the array before dereferencing it.
Reject completion IDs that fall outside wl->tx_frames[] and keep the
existing NULL check in the same guard. This keeps the fix local to the
trust boundary and avoids touching the rest of the completion flow.
HID: roccat: fix use-after-free in roccat_report_event
In the Linux kernel, the following vulnerability has been resolved:
HID: roccat: fix use-after-free in roccat_report_event
roccat_report_event() iterates over the device->readers list without
holding the readers_lock. This allows a concurrent roccat_release() to
remove and free a reader while it's still being accessed, leading to a
use-after-free.
Protect the readers list traversal with the readers_lock mutex.
wifi: brcmfmac: validate bsscfg indices in IF events
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: validate bsscfg indices in IF events
brcmf_fweh_handle_if_event() validates the firmware-provided interface
index before it touches drvr->iflist[], but it still uses the raw
bsscfgidx field as an array index without a matching range check.
Reject IF events whose bsscfg index does not fit in drvr->iflist[]
before indexing the interface array.
[add missing wifi prefix]
xfrm: account XFRMA_IF_ID in aevent size calculation
In the Linux kernel, the following vulnerability has been resolved:
xfrm: account XFRMA_IF_ID in aevent size calculation
xfrm_get_ae() allocates the reply skb with xfrm_aevent_msgsize(), then
build_aevent() appends attributes including XFRMA_IF_ID when x->if_id is
set.
xfrm_aevent_msgsize() does not include space for XFRMA_IF_ID. For states
with if_id, build_aevent() can fail with -EMSGSIZE and hit BUG_ON(err < 0)
in xfrm_get_ae(), turning a malformed netlink interaction into a kernel
panic.
Account XFRMA_IF_ID in the size calculation unconditionally and replace
the BUG_ON with normal error unwinding.
drm/vc4: Fix memory leak of BO array in hang state
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: Fix memory leak of BO array in hang state
The hang state's BO array is allocated separately with kzalloc() in
vc4_save_hang_state() but never freed in vc4_free_hang_state(). Add the
missing kfree() for the BO array before freeing the hang state struct.
drm/vc4: Fix a memory leak in hang state error path
In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: Fix a memory leak in hang state error path
When vc4_save_hang_state() encounters an early return condition, it
returns without freeing the previously allocated `kernel_state`,
leaking memory.
Add the missing kfree() calls by consolidating the early return paths
into a single place.
In the Linux kernel, the following vulnerability has been resolved:
net: lapbether: handle NETDEV_PRE_TYPE_CHANGE
lapbeth_data_transmit() expects the underlying device type
to be ARPHRD_ETHER.
Returning NOTIFY_BAD from lapbeth_device_event() makes sure
bonding driver can not break this expectation.
xsk: tighten UMEM headroom validation to account for tailroom and min frame
In the Linux kernel, the following vulnerability has been resolved:
xsk: tighten UMEM headroom validation to account for tailroom and min frame
The current headroom validation in xdp_umem_reg() could leave us with
insufficient space dedicated to even receive minimum-sized ethernet
frame. Furthermore if multi-buffer would come to play then
skb_shared_info stored at the end of XSK frame would be corrupted.
HW typically works with 128-aligned sizes so let us provide this value
as bare minimum.
Multi-buffer setting is known later in the configuration process so
besides accounting for 128 bytes, let us also take care of tailroom space
upfront.
xfrm: Wait for RCU readers during policy netns exit
In the Linux kernel, the following vulnerability has been resolved:
xfrm: Wait for RCU readers during policy netns exit
xfrm_policy_fini() frees the policy_bydst hash tables after flushing the
policy work items and deleting all policies, but it does not wait for
concurrent RCU readers to leave their read-side critical sections first.
The policy_bydst tables are published via rcu_assign_pointer() and are
looked up through rcu_dereference_check(), so netns teardown must also
wait for an RCU grace period before freeing the table memory.
Fix this by adding synchronize_rcu() before freeing the policy hash tables.