PatchFirst · Aktuelle Sicherheitslücken
In den letzten 30 Tagen veröffentlichte Sicherheitslücken für linux-azure-5.15: 649. Davon im KEV-Katalog: 0.
Sicherheitslücken: 6542
In the Linux kernel, the following vulnerability has been resolved: tty: serial: pch_uart: add check for dma_alloc_coherent() Add a check for dma_alloc_coherent() failure to prevent a potential NULL pointer dereference in dma_handle_rx(). Properly release DMA channels and the PCI device reference using a goto ladder if the allocation fails.
In the Linux kernel, the following vulnerability has been resolved: drm/msm/dsi: don't dump registers past the mapped region On DSI 6G platforms the IO address space is internally adjusted by io_offset. Later this adjusted address might be used for memory dumping. However the size that is used for memory dumping isn't adjusted to account for the io_offset, leading to the potential access to the unmapped region. Lower ctrl_size by the io_offset value to prevent access past the mapped area. msm_disp_snapshot_add_block+0x1d4/0x3c8 [msm] (P) msm_dsi_host_snapshot+0x4c/0x78 [msm] msm_dsi_snapshot+0x28/0x50 [msm] msm_disp_snapshot_capture_st
In the Linux kernel, the following vulnerability has been resolved: octeontx2-af: CGX: add bounds check to cgx_speed_mbps index cgx_speed_mbps has 13 elements but RESP_LINKSTAT_SPEED can yield values 0-15. If it returns a value >= 13, this causes an out-of-bounds array access. Add a bounds check and default to speed 0 if the index is out of range.
In the Linux kernel, the following vulnerability has been resolved: octeontx2-pf: avoid double free of pool->stack on AQ init failure otx2_pool_aq_init() frees pool->stack when mailbox sync or retry allocation fails, but leaves the pointer unchanged. Later, otx2_sq_aura_pool_init() unwinds the partial setup through otx2_aura_pool_free(), which frees pool->stack again. The CN20K-specific cn20k_pool_aq_init() implementation has the same bug in its corresponding error path. Set pool->stack to NULL immediately after the local free so the shared cleanup path does not free the same stack again while cleaning up partially initialized pool state.
In the Linux kernel, the following vulnerability has been resolved: spi: ti-qspi: fix use-after-free after DMA setup failure The driver falls back to PIO mode if DMA setup fails during probe. Make sure to clear the DMA channel pointer also if buffer allocation fails to avoid passing a pointer to the released channel to the DMA engine (or trying to free the channel a second time on late probe errors or driver unbind). This issue was flagged by Sashiko when reviewing a devres allocation conversion patch.
In the Linux kernel, the following vulnerability has been resolved: device property: set fwnode->secondary to NULL in fwnode_init() If a firmware node is allocated on the stack (for instance: temporary software node whose life-time we control) or on the heap - but using a non-zeroing allocation function - and initialized using fwnode_init(), its secondary pointer will contain uninitalized memory which likely will be neither NULL nor IS_ERR() and so may end up being dereferenced (for example: in dev_to_swnode()). Set fwnode->secondary to NULL on initialization.
In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Validate payload length and link_index in dc_process_dmub_aux_transfer_async [Why&How] dc_process_dmub_aux_transfer_async() copies payload->length bytes into a 16-byte stack buffer (dpaux.data[16]) guarded only by an ASSERT(), which is a no-op in release builds. If a caller ever passes length > 16 this results in a stack buffer overflow via memcpy. Additionally, link_index is used to dereference dc->links[] without bounds checking against dc->link_count, risking an out-of-bounds access. Replace the ASSERT with a hard runtime check that returns false when
In the Linux kernel, the following vulnerability has been resolved: batman-adv: bla: fix report_work leak on backbone_gw purge batadv_bla_purge_backbone_gw() removes stale backbone gateway entries, but fails to properly handle their associated report_work: - If report_work is running, the purge must wait for it to finish before freeing the backbone_gw, otherwise the worker may access freed memory (e.g. bat_priv). - If report_work is pending, the purge must cancel it and release the reference held for that pending work item. The previous implementation called hlist_for_each_entry_safe() inside a spin_lock_bh() section, but cancel_wor
In the Linux kernel, the following vulnerability has been resolved: hwmon: (lm90) Add lock protection to lm90_alert Sashiko reports: lm90_alert() executes in the smbus alert context and calls lm90_update_confreg() to disable the hardware alert line, without acquiring hwmon_lock. Concurrently, sysfs write operations (such as lm90_write_convrate) hold the hwmon_lock, temporarily modify data->config, and then restore it. If an alert interrupt occurs concurrently with a sysfs write, the sysfs path will overwrite the alert handler's modifications to data->config and the hardware register. This unintentionally re-enables the hardware alert li
In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: xsk: Fix unlocked writing to ICOSQ During napi poll, when the affinity changes and there's still XSK work to be done, we trigger an ICOSQ interrupt on the new CPU. However, this triggering on the ICOSQ is done unprotected. There are 2 such races: A) mlx5e_trigger_irq() is called while mlx5e_xsk_alloc_rx_mpwqe() is running from a different CPU due to affinity change. This can happen because IRQ triggering is done after napi_complete_done(). At this point the NAPI can be scheduled on a different CPU. Like this: CPU A (old affinity, NAPI tail) CPU B (new aff
In the Linux kernel, the following vulnerability has been resolved: xfs: resample the data fork mapping after cycling ILOCK xfs_reflink_fill_{cow_hole,delalloc} are both presented with an inode, a data fork mapping, and a cow fork mapping. Unfortunately, these two helpers cycle the ILOCK to grab a transaction, which means that the mappings are stale as soon as we reacquire the ILOCK. Currently we refresh the cow fork mapping by re-calling xfs_find_trim_cow_extent, but we don't refresh the data fork mapping beforehand, which means that the xfs_bmap_trim_cow in that function queries the refcount btree about the wrong physical blocks and ret
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock l2cap_conn_del() takes conn->lock and then calls cancel_work_sync() for pending_rx_work. process_pending_rx() takes the same mutex, so teardown can deadlock against the worker it is flushing. This issue was found by our static analysis tool and then manually reviewed against the current tree. The grounded PoC kept the l2cap_conn_ready() -> queue_work(..., &conn->pending_rx_work) submit path, the l2cap_conn_del() -> cancel_work_sync(&conn->pending_rx_work) teardown path, and the process_pending_rx() -> mute
In the Linux kernel, the following vulnerability has been resolved: bpf: Reject BPF_MAP_TYPE_INODE_STORAGE creation if BPF LSM is uninitialized When CONFIG_BPF_LSM=y is set, BPF inode storage maps (BPF_MAP_TYPE_INODE_STORAGE) are compiled into the kernel. However, if the BPF LSM is not explicitly enabled at boot time (e.g. omitted from the "lsm=" boot parameter), lsm_prepare() is never executed for the BPF LSM. Consequently, the BPF inode security blob offset (bpf_lsm_blob_sizes.lbs_inode) is never initialized and remains at its default compiled size of 8 bytes instead of being updated to a valid offset past the reserved struct rcu_head (t
In the Linux kernel, the following vulnerability has been resolved: i2c: stub: Reject I2C block transfers with invalid length The I2C_SMBUS_I2C_BLOCK_DATA case in stub_xfer() uses data->block[0] as the transfer length. The existing check only clamps it to avoid overrunning the chip->words[256] register array, but does not validate it against I2C_SMBUS_BLOCK_MAX (32), which is the limit of the union i2c_smbus_data.block buffer (34 bytes total). The driver is a development/test tool (CONFIG_I2C_STUB=m, not built by default) that must be loaded with a chip_addr= parameter. A local user with access to /dev/i2c-* can issue an I2C_SMBUS ioctl wi
In the Linux kernel, the following vulnerability has been resolved: net: team: fix NULL pointer dereference in team_xmit during mode change __team_change_mode() clears team->ops with memset() before restoring safe dummy handlers via team_adjust_ops(). A concurrent team_xmit() running under RCU on another CPU can read team->ops.transmit during this window and call a NULL function pointer, crashing the kernel. The race requires a mode change (CAP_NET_ADMIN) concurrent with transmit on the team device. BUG: kernel NULL pointer dereference, address: 0000000000000000 Oops: 0010 [#1] SMP KASAN NOPTI RIP: 0010:0x0 Call Trace: team_xmit (dr
In the Linux kernel, the following vulnerability has been resolved: netfilter: ipset: fix race between dump and ip_set_list resize The release path of ip_set_dump_do() and ip_set_dump_done() read inst->ip_set_list via ip_set_ref_netlink(), a plain rcu_dereference_raw() of the array pointer. These run from netlink_recvmsg() without the nfnl mutex and without an RCU read-side critical section. A concurrent ip_set_create() can grow the array: it publishes the new array, calls synchronize_net() and then kvfree()s the old one. Since the dump paths read the array outside any RCU reader, synchronize_net() does not wait for them and the old array
In the Linux kernel, the following vulnerability has been resolved: net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink() rmnet_dellink() removes the endpoint from the hash table with hlist_del_init_rcu() and then immediately frees it with kfree(). However, RCU readers on the receive path (rmnet_rx_handler -> __rmnet_map_ingress_handler) may still hold a reference to the endpoint and dereference ep->egress_dev after the memory has been freed. The endpoint is a kmalloc-32 object, and the stale read at offset 8 corresponds to the egress_dev pointer. BUG: unable to handle page fault for address: ffffffffde942eef Oops: 0002
In the Linux kernel, the following vulnerability has been resolved: xfs: fail recovery on a committed log item with no regions If the first op of a transaction is a bare transaction header (len == sizeof(struct xfs_trans_header)), xlog_recover_add_to_trans() adds an item but no region, leaving it on r_itemq with ri_cnt == 0 and ri_buf == NULL. The header can be split across op records, so later ops may still add regions; the item is only invalid if the transaction commits with none. The runtime commit path never emits such a transaction, so this only happens on a crafted log. It came from an AI-assisted code audit of the recovery parser.
In the Linux kernel, the following vulnerability has been resolved: sysfs: don't remove existing directory on update failure When sysfs_update_group() is called for a named group and create_files() fails (e.g. -ENOMEM), internal_create_group() calls kernfs_remove(kn) on the group directory. In the update path, kn was obtained via kernfs_find_and_get() and refers to a directory that already existed before this call. Removing it silently destroys a sysfs group that the caller did not create. Only remove the directory if we created it ourselves. On update failure the directory remains as it is left empty by remove_files() inside create_fil
In the Linux kernel, the following vulnerability has been resolved: net: wwan: iosm: fix potential memory leaks in ipc_imem_init() The memory allocated in ipc_protocol_init() is not freed on the error paths that follow in ipc_imem_init(). Fix that by calling the corresponding release function ipc_protocol_deinit() in the error path.
Gleichen Sie Ihren installierten Stack und seine Versionen mit den aktuellen Sicherheitsmeldungen ab.