In the Linux kernel, the following vulnerability has been resolved:
can: j1939: transport: j1939_session_fresh_new(): initialize receive buffer
Zero the allocated buffer in j1939_session_fresh_new() to ensure it
contains no residual data.
While there is a potential performance impact if users allocate maximum
sized ETP buffers, most real-world use cases are not noticeably affected
since the maximum known buffer size is typically around 65K.
[mkl: add Message-ID]
can: softing: fw_parse(): validate firmware record spans
In the Linux kernel, the following vulnerability has been resolved:
can: softing: fw_parse(): validate firmware record spans
fw_parse() reads a fixed record header, a firmware-provided payload,
and a trailing checksum without knowing the end of the firmware blob. A
truncated record can therefore make those reads exceed the blob.
The same record also supplies addresses and lengths for writes into
DPRAM. The generic loader uses wrap-prone mixed signed arithmetic for its
bounds check, while the application loader does not bound the staging
copy at all.
Pass the firmware end to the parser and validate the full source record.
Use a signed wide
Nicht bewertetEPSS 0,16%Keine Korrektur veröffentlicht
drm/amd/display: use proper context for logging
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized e
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
dmaengine: idxd: fix double free of wq, engine, and group structs
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: fix double free of wq, engine, and group structs
The release callbacks for wq, engine, and group devices
(idxd_conf_wq_release, idxd_conf_engine_release,
idxd_conf_group_release) each call kfree() on the enclosing struct.
The setup error paths and cleanup functions also call kfree()
explicitly after put_device(), producing a double free whenever
put_device() drops the reference count to zero and fires the release.
In the setup functions, device_initialize() is called before
device_add(), so the reference count is exactly 1 at the error sites.
put_device()
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (sht3x) Fix unaligned accesses
Sashiko reports:
In sht3x_update_client(), the 16-bit temperature and humidity values are
extracted from a stack-allocated byte array using be16_to_cpup(). The
pointers passed to this function are calculated as buf and buf + 3. Since
the difference between the two pointers is an odd number of bytes, at
least one of them is guaranteed to be at an unaligned offset.
This will trigger an alignment fault on strict-alignment architectures
such as ARMv5 or SPARC, resulting in a kernel panic.
Fix the problem by using get_unaligned_be16() ins
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
mtk_handle_irq_rx expects a struct mtk_eth * (matching the request_irq
cookie), but mtk_poll_controller incorrectly passed the net_device *.
Calling ndo_poll_controller with CONFIG_NET_POLL_CONTROLLER enabled
would then crash.
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
In the Linux kernel, the following vulnerability has been resolved:
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
mmio_trace_rw() and mmio_trace_mapping() retrieve mmio_trace_array into
tr and pass it to __trace_mmiotrace_rw() and __trace_mmiotrace_map().
If these functions are invoked while mmio_trace_array is NULL (e.g. before
initialization or after disabled), accessing tr->array_buffer.buffer will
result in a NULL pointer dereference crash.
Fix this by adding an explicit NULL check for tr at the beginning of
__trace_mmiotrace_rw() and __trace_mmiotrace_map().
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
The airq_iv_create() can return NULL on failure, but the return value was
never checked. If it fails, zdev->aibv will be NULL and fail when
dereferenced in kvm_zpci_set_airq(). Add a NULL check and free the
previously allocated AISB bit and zdev->aisb on failure.
vxlan: re-fetch eth header after route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit().
i2c: amd-mp2: Unregister callback on adapter add failure
In the Linux kernel, the following vulnerability has been resolved:
i2c: amd-mp2: Unregister callback on adapter add failure
amd_mp2_register_cb() stores the platform I2C context in the MP2 PCI
driver's callback table before the adapter is registered. If
i2c_add_adapter() fails, probe returns and devres frees the context,
but the PCI driver can still dereference the stale pointer from its IRQ
and system-sleep callbacks.
Unregister the callback before returning the adapter registration error.
In the Linux kernel, the following vulnerability has been resolved:
s390/dasd: Fix potential NULL pointer dereference
dasd_release_space() checks the implementation of the is_ese()
discipline function before calling it to determine if a given device is
an ESE DASD.
The current usage of the logical AND operator will lead to a NULL
pointer dereference as the function is called even if the function
pointer is NULL.
Fix this by using the logical OR operator.
i2c: imx: Fix slave registration race and error handling
In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: Fix slave registration race and error handling
In i2c_imx_reg_slave(), the slave pointer was assigned before
pm_runtime_resume_and_get(). If pm_runtime_resume_and_get() failed,
the error path returned without clearing i2c_imx->slave, leaving it
non-NULL and causing all subsequent registration attempts to fail
with -EBUSY.
Additionally, because this driver uses a shared IRQ, the interrupt
handler i2c_imx_isr() can execute concurrently and, after acquiring
slave_lock, dereference i2c_imx->slave. The previous fix attempt
added a lockless i2c_imx->slave = NULL on t
driver core: use READ_ONCE() for dev->driver in dev_has_sync_state()
In the Linux kernel, the following vulnerability has been resolved:
driver core: use READ_ONCE() for dev->driver in dev_has_sync_state()
dev_has_sync_state() reads dev->driver twice without holding
device_lock() -- once for the NULL check and once to dereference
->sync_state. Some callers only hold device_links_write_lock, which
doesn't prevent a concurrent unbind from clearing dev->driver via
device_unbind_cleanup().
Fix it by reading dev->driver exactly once with READ_ONCE(), pairing
with the WRITE_ONCE() in device_set_driver().
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
Drivers: hv: vmbus: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
Drivers: hv: vmbus: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
In the Linux kernel, the following vulnerability has been resolved:
perf sched: Fix register_pid() overflow, strcpy, and BUG_ON
register_pid() has several issues when processing untrusted perf.data:
1. Integer overflow: (pid + 1) * sizeof(struct task_desc *) can wrap
to a small value on 32-bit systems when pid is large (e.g.
0x40000000), causing realloc to return a tiny buffer followed by
out-of-bounds writes in the initialization loop.
2. Heap buffer overflow: strcpy(task->comm, comm) copies the
untrusted comm string into a fixed 20-byte COMM_LEN buffer with
no length check.
3. BUG_ON on allocation failure: perf.data is u
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
In the Linux kernel, the following vulnerability has been resolved:
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
machine__resolve() accesses env->cpu[al->cpu].socket_id after checking
al->cpu >= 0 and env->cpu != NULL, but without validating al->cpu
against env->nr_cpus_avail. Since al->cpu comes from the untrusted
perf.data sample, a crafted file with a large CPU index causes an
out-of-bounds heap read.
Use perf_env__get_cpu_topology() which validates both NULL and bounds.
Also bounds-check al->cpu before the cast to struct perf_cpu (int16_t):
without this, values like 65536 silently truncate to 0, bypassing the
acc
In the Linux kernel, the following vulnerability has been resolved:
bpf: Disable xfrm_decode_session hook attachment
BPF LSM programs can currently attach to xfrm_decode_session(). That
hook may return an error, but security_skb_classify_flow() calls it
from a void path and triggers BUG_ON() if an error is returned.
Disable BPF attachment to the hook to prevent a BPF LSM program from
turning packet classification into a full panic.
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_nat: reject unsupported target families
xt_nat SNAT and DNAT target handlers assume IP-family conntrack state
is present and can dereference a NULL pointer when instantiated from an
unsupported family through nft_compat. A bridge-family compat rule can
therefore trigger a NULL-dereference in nf_nat_setup_info().
Reject non-IP families in xt_nat_checkentry() so unsupported targets
cannot be installed. Keep NFPROTO_INET allowed for valid inet NAT
compat users and leave the runtime fast path unchanged.
[ The crash was fixed via
9dbba7e694ec ("netfilter: nft_c
mmc: vub300: defer reset until cmd_mutex is unlocked
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: defer reset until cmd_mutex is unlocked
vub300_cmndwork_thread() holds cmd_mutex while it sends a command and
waits for the command response. If the response wait times out,
__vub300_command_response() kills the command URBs and then synchronously
resets the USB device through usb_reset_device().
That reset path re-enters the driver through vub300_pre_reset(), which
also takes cmd_mutex. The worker therefore tries to acquire the same
mutex recursively while it is still holding it from the command path.
This issue was found by our static analysis tool and th
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
soc: xilinx: Shutdown and free rx mailbox channel
In the Linux kernel, the following vulnerability has been resolved:
soc: xilinx: Shutdown and free rx mailbox channel
A mbox rx channel is requested using mbox_request_channel_byname() in
probe. In remove callback, the rx mailbox channel is cleaned up when the
rx_chan is NULL due to incorrect condition check. The mailbox channel is
not shutdown and it can receive messages even after the device removal.
This leads to use after free. Also the channel resources are not freed.
Fix this by checking the rx_chan correctly.