drm/hyperv: validate VMBus packet size in receive callback
In the Linux kernel, the following vulnerability has been resolved:
drm/hyperv: validate VMBus packet size in receive callback
hyperv_receive_sub() reads msg->vid_hdr.type and dispatches into one
of four message-type branches without knowing how many bytes the host
wrote into hv->recv_buf. The completion path then runs
memcpy(hv->init_buf, msg, VMBUS_MAX_PACKET_SIZE), so the consumer that
wakes on wait_for_completion_timeout() can read up to 16 KiB of
residue from a prior message as if it were the response payload.
Pass bytes_recvd into hyperv_receive_sub() and reject any packet that
does not cover the pipe + synthvid header. A single swit
drm/hyperv: validate resolution_count and fix WIN8 fallback
In the Linux kernel, the following vulnerability has been resolved:
drm/hyperv: validate resolution_count and fix WIN8 fallback
A SYNTHVID_RESOLUTION_RESPONSE with resolution_count > 64 walks past
the supported_resolution[SYNTHVID_MAX_RESOLUTION_COUNT] array in the
parse loop. Bound resolution_count against the array size, folded
into the existing zero-check.
When the WIN10 resolution probe fails, the caller in
hyperv_connect_vsp() left hv->screen_*_max / preferred_* unpopulated,
which sets mode_config.max_width / max_height to 0 and makes
drm_internal_framebuffer_create() reject every userspace framebuffer
with -EINVAL. The pre-WIN10 bran
userfaultfd: gate must_wait writability check on pte_present()
In the Linux kernel, the following vulnerability has been resolved:
userfaultfd: gate must_wait writability check on pte_present()
userfaultfd_must_wait() and userfaultfd_huge_must_wait() read the PTE
without taking the page table lock and then apply pte_write() /
huge_pte_write() to it. Those accessors decode bits from the present
encoding only; on a swap or migration entry they read the offset bits that
happen to share the same position and return an undefined result.
The intent of the check is "is this fault still WP-blocked?". A
non-marker swap entry means the page is in transit -- the userfault
context the original fault delivered a
KVM: x86: Unconditionally recompute CR8 intercept on PPR update
In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Unconditionally recompute CR8 intercept on PPR update
The TPR_THRESHOLD field in the VMCS is used by VMX to induce VM exits
when the guest's virtual TPR falls under the specified threshold,
allowing KVM to inject previously masked interrupts.
KVM handles these VM exits in handle_tpr_below_threshold().
Commit eb90f3417a0c ("KVM: vmx: speed up TPR below threshold vmexits")
optimized this function by calling apic_update_ppr() instead of raising
KVM_REQ_EVENT. apic_update_ppr() then raises KVM_REQ_EVENT if there is
a pending, deliverable interrupt.
However, if there
ACPI: CPPC: Suppress UBSAN warning caused by field misuse
In the Linux kernel, the following vulnerability has been resolved:
ACPI: CPPC: Suppress UBSAN warning caused by field misuse
The definition of reg->access_width changes depending on the
reg->space_id type. Type ACPI_ADR_SPACE_PLATFORM_COMM uses
access_width to indicate the PCC region, which can result in a UBSAN
if the value is greater than 4.
For example:
UBSAN: shift-out-of-bounds in drivers/acpi/cppc_acpi.c:1090:9
shift exponent 32 is too large for 32-bit type 'int'
CPU: 61 UID: 0 PID: 1220 Comm: (udev-worker) Not tainted 7.0.10-201.fc44.aarch64 #1 PREEMPT(lazy)
Hardware name: To be filled by O.E.M.
Call trace:
...(trimming)
In the Linux kernel, the following vulnerability has been resolved:
ACPI: NFIT: core: Fix acpi_nfit_init() error cleanup
If acpi_nfit_init() fails after adding the acpi_desc object to the
acpi_descs list, that object is never removed from that list because
the acpi_nfit_shutdown() devm action is not added for the NFIT device
in that case. Next, the acpi_nfit_init() failure causes
acpi_nfit_probe() to fail, the acpi_desc object is freed, and a
dangling pointer is left behind in the acpi_descs. Any subsequent
ACPI Machine Check Exception will trigger nfit_handle_mce() which
iterates over acpi_descs and so a use-after-free will occur.
Moreo
usb: gadget: function: rndis: add length check for header
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: function: rndis: add length check for header
Add a length check for the rndis header in rndis_rm_hdr, to ensure that
MessageType, MessageLength, DataOffset, and DataLength fields are
present before they are accessed.
iio: accel: bmc150: clamp the device-reported FIFO frame count
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: bmc150: clamp the device-reported FIFO frame count
__bmc150_accel_fifo_flush() copies the number of samples the device
reports in its hardware FIFO into an on-stack buffer
u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3];
which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The
frame count is read from the FIFO_STATUS register and only masked to its
7 valid bits:
count = val & 0x7F;
so it can be 0..127. The only other limit applied to it is the optional
caller-supplied sample budget:
if (samples && count > samples)
count = samples;
which does not
iio: accel: kxsd9: fix runtime PM imbalance on write_raw() error
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: kxsd9: fix runtime PM imbalance on write_raw() error
kxsd9_write_raw() takes a runtime PM reference with pm_runtime_get_sync()
but returns -EINVAL directly when a scale with a non-zero integer part is
requested, skipping the matching pm_runtime_put_autosuspend(). This leaks
a runtime PM usage-counter reference on every such write, after which the
device can no longer autosuspend.
Set the error code and fall through to the existing put instead of
returning early.
iio: adc: lpc32xx: Initialize completion before requesting IRQ
In the Linux kernel, the following vulnerability has been resolved:
iio: adc: lpc32xx: Initialize completion before requesting IRQ
In the report from Jaeyoung Chung:
"lpc32xx_adc_probe() in drivers/iio/adc/lpc32xx_adc.c registers its
interrupt handler with devm_request_irq() before it initializes
st->completion with init_completion(). If an interrupt arrives after
devm_request_irq() and before init_completion(), the handler calls
complete() on an uninitialized completion, causing a kernel panic.
The probe path, in lpc32xx_adc_probe():
iodev = devm_iio_device_alloc(&pdev->dev, sizeof(*st)); /* st kzalloc-zeroed */
...
retval =
iio: chemical: scd30: Cleanup initializations and fix sign-extension bug
In the Linux kernel, the following vulnerability has been resolved:
iio: chemical: scd30: Cleanup initializations and fix sign-extension bug
Include linux/bitfield.h for FIELD_GET().
Create new macros for bit manipulation in combination with manual bit
manipulation being replaced with FIELD_GET().
The current variable declaration and initializations are barely readable
and use comma separations across multiple lines. Refactor the
initializations so that mantissa and exp have separate declarations and
sign gets initialized later.
In addition (and due to the nature of the cleanup), fix a sign-extension
bug where, float32 would get bitwise
In the Linux kernel, the following vulnerability has been resolved:
iio: event: Fix event FIFO reset race
`iio_event_getfd()` creates the event file descriptor with
`anon_inode_getfd()`, which allocates a new fd, creates the anonymous
file and installs it in the process fd table before returning to the
caller.
The IIO code resets the event FIFO after `anon_inode_getfd()` has returned,
but before `IIO_GET_EVENT_FD_IOCTL` has copied the fd number to userspace.
But since fd tables are shared between threads, another thread can guess
the newly allocated fd number and issue a `read()` on it as soon as the fd
has been installed.
This means the
iio: gyro: bmg160: bail out when bandwidth/filter is not in table
In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: bmg160: bail out when bandwidth/filter is not in table
bmg160_get_filter() walks bmg160_samp_freq_table[] looking for the entry
matching the bw_bits value read from the chip:
for (i = 0; i < ARRAY_SIZE(bmg160_samp_freq_table); ++i) {
if (bmg160_samp_freq_table[i].bw_bits == bw_bits)
break;
}
*val = bmg160_samp_freq_table[i].filter;
If no entry matches, i ends up equal to the array size and the next line
reads one slot past the end. bmg160_set_filter() has the same shape, driven
by 'val' instead of bw_bits.
smatch flags both:
drivers/iio/gyro/bmg160_
iio: light: gp2ap002: fix runtime PM leak on read error
In the Linux kernel, the following vulnerability has been resolved:
iio: light: gp2ap002: fix runtime PM leak on read error
gp2ap002_read_raw() calls pm_runtime_get_sync() before reading the
lux value, but if gp2ap002_get_lux() fails, it returns directly. This
skips the pm_runtime_put_autosuspend() call at the "out" label,
permanently leaking a runtime PM reference and preventing the device
from autosuspending.
Replace the direct return with a "goto out" to ensure the reference
is properly dropped on the error path.
In the Linux kernel, the following vulnerability has been resolved:
ALSA: aoa: check snd_ctl_new1() return value
snd_ctl_new1() can return NULL when memory allocation fails. In
layout.c, the function does not check the return value before
dereferencing ctl->id.name or passing to aoa_snd_ctl_add(), which can
lead to a NULL pointer dereference.
Add NULL checks after snd_ctl_new1() calls and return early if any
fails.
ALSA: caiaq: fix out-of-bounds read in the Traktor Kontrol S4 input parser
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: fix out-of-bounds read in the Traktor Kontrol S4 input parser
snd_usb_caiaq_tks4_dispatch() decodes the Traktor Kontrol S4 input
stream in fixed 16-byte (TKS4_MSGBLOCK_SIZE) message blocks. On every
iteration it advances buf and subtracts the block size while looping on
"while (len)".
len is urb->actual_length. That value is supplied by the device and is
not guaranteed to be a multiple of 16. When a final short block leaves
len between 1 and 15, the loop runs once more, reads up to buf[15], and
then does "len -= TKS4_MSGBLOCK_SIZE". As len is unsigned this und
In the Linux kernel, the following vulnerability has been resolved:
ALSA: es1938: check snd_ctl_new1() return value
snd_ctl_new1() can return NULL when memory allocation fails.
snd_es1938_mixer() does not check the return value before dereferencing
the pointer, which can lead to a NULL pointer dereference.
Add a NULL check after snd_ctl_new1() and return -ENOMEM if it fails.
ALSA: firewire: isight: bound the sample count to the packet payload
In the Linux kernel, the following vulnerability has been resolved:
ALSA: firewire: isight: bound the sample count to the packet payload
isight_packet() takes the frame count from the device iso packet and
checks it only against the device claimed iso length.
count = be32_to_cpu(payload->sample_count);
if (likely(count <= (length - 16) / 4))
isight_samples(isight, payload->samples, count);
length is the iso header data_length. It can be up to 0xffff. So the
gate allows a count up to about 16379. isight_samples() then copies
count frames out of payload->samples into the PCM DMA buffer.
payload->samples holds only 2 * MAX_FRAMES_PER_PA
ALSA: usb-audio: avoid kobject path lookup in DualSense match
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: avoid kobject path lookup in DualSense match
The DualSense jack-detection input handler verifies that a matching input
device belongs to the same physical controller by building kobject path
strings for both the input device and the USB audio device, then comparing
the path prefix.
This was observed when a weak physical connection caused the controller
to rapidly disconnect and reconnect. During that repeated hotplug,
snd_dualsense_ih_match() can run while the controller's USB device is
being disconnected. kobject_get_path() walks ancestor kobjects and
der
vfio/pci: Release the VGA arbiter client on register_device() failure
In the Linux kernel, the following vulnerability has been resolved:
vfio/pci: Release the VGA arbiter client on register_device() failure
The re-order in the Fixes commit below displaced vfio_pci_vga_init() as
the last failure point of what is now vfio_pci_core_register_device()
without introducing an unwind for the VGA arbiter registration.
In current kernels this is mostly benign because vfio_pci_set_decode()
only uses pci_dev state, but the original failure path could leave a
callback with a freed vdev cookie. The stale registration also becomes
unsafe again once the callback follows drvdata to the vfio device.
Add the required VGA un