Sicherheitslücken in linux-intel-iotg-5.15 · Seite 122

can: bcm: track a single source interface for ANYDEV timeout/throttle ops

In the Linux kernel, the following vulnerability has been resolved: can: bcm: track a single source interface for ANYDEV timeout/throttle ops An ANYDEV rx op (ifindex == 0) with an active RX timeout and/or throttle timer has no defined semantics when matching frames arrive from several interfaces: bcm_rx_handler() can run concurrently for the same op on different CPUs, racing hrtimer_cancel()/ bcm_rx_starttimer() against bcm_rx_timeout_handler() and causing spurious RX_TIMEOUT notifications and last_frames corruption. The same concurrency lets throttled multiplex frames from different interfaces clobber the single rx_ifindex/rx_stamp fields

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

can: bcm: validate frame length in bcm_rx_setup() for RTR replies

In the Linux kernel, the following vulnerability has been resolved: can: bcm: validate frame length in bcm_rx_setup() for RTR replies bcm_tx_setup() validates cf->len against the CAN/CAN FD DLC limits before installing frames for TX_SETUP, but bcm_rx_setup() never did the same for the RTR-reply frame configured via RX_SETUP with RX_RTR_FRAME.

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

can: bcm: add missing device refcount for CAN filter removal

In the Linux kernel, the following vulnerability has been resolved: can: bcm: add missing device refcount for CAN filter removal sashiko-bot remarked a problem with a concurrent device unregistration in isotp.c which also is present in the bcm.c code. A former fix for raw.c commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix") introduced a netdevice_tracker which solves the issue for bcm.c too. bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on dev_get_by_index(ifindex) to re-find the device for an rx_op before unregistering its filter. If a concurrent NETDEV_UNREGISTER has already unlisted the device from

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

bpf,fork: wipe ->bpf_storage before bailouts that access it

In the Linux kernel, the following vulnerability has been resolved: bpf,fork: wipe ->bpf_storage before bailouts that access it Currently, copy_process() can bail out to free_task() before p->bpf_storage has been initialized, with this call graph (shown here for the !CONFIG_MEMCG case): copy_process dup_task_struct arch_dup_task_struct [copies the entire task_struct, including ->bpf_storage member] [RLIMIT_NPROC check fails] delayed_free_task free_task bpf_task_storage_free rcu_dereference(task->bpf_storage) bpf_local_storage_destroy In this case, the nascent task's ->bpf_storage member that bpf_l

• Auf 5.15.0-1114.120~20.04.1 aktualisieren

net: sparx5: unregister blocking notifier on init failure

In the Linux kernel, the following vulnerability has been resolved: net: sparx5: unregister blocking notifier on init failure sparx5_register_notifier_blocks() registers the switchdev blocking notifier before allocating the ordered workqueue. If the workqueue allocation fails, the error path unregisters the switchdev and netdevice notifiers, but leaves the blocking notifier registered. Add a separate error label for the workqueue allocation failure path and unregister the switchdev blocking notifier there.

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

dm thin metadata: fix metadata snapshot consistency on commit failure

In the Linux kernel, the following vulnerability has been resolved: dm thin metadata: fix metadata snapshot consistency on commit failure __reserve_metadata_snap() and __release_metadata_snap() modify the superblock's held_root directly in the block_manager's buffer. If the subsequent metadata commit fails, the held_root gets flushed to disk through the abort_transaction path, resulting in inconsistent metadata. Reproducer 1: __reserve_metadata_snap() 1. Create a 2 MiB metadata device and make the region after the 14th block inaccessible, to trigger metadata commit failure in the subsequent reserve_metadata_snap operation. The 14th

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

dm era: fix out-of-bounds memory access for non-zero start sector

In the Linux kernel, the following vulnerability has been resolved: dm era: fix out-of-bounds memory access for non-zero start sector dm-era tracks writes in target-relative blocks, but era_map() calculates the writeset block before applying the target offset. Tables with a non-zero start sector can therefore pass an absolute mapped-device block to metadata_current_marked(). If the absolute block is beyond the current writeset size, writeset_marked() tests past the end of the in-core bitset. KASAN reports this as a vmalloc-out-of-bounds access. Apply the target offset before calculating the era block so writeset lookups use the target-r

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

dm-ioctl: fix a possible overflow in list_version_get_info

In the Linux kernel, the following vulnerability has been resolved: dm-ioctl: fix a possible overflow in list_version_get_info sizeof(tt->version) is 12 bytes, but the code writes 16 bytes into the output buffer - info->vers->version[0], info->vers->version[1], info->vers->version[2] and info->vers->next. This can cause buffer overflow. Fix this buffer overflow by replacing "sizeof(tt->version)" with "sizeof(struct dm_target_versions)".

dm-log: fix a bitset_size overflow on 32bit machines

In the Linux kernel, the following vulnerability has been resolved: dm-log: fix a bitset_size overflow on 32bit machines Commit c20e36b7631d ("dm log: fix out-of-bounds write due to region_count overflow") made sure that region_count could fit in an unsigned int. But the bitmap memory isn't allocated based on region_count. It uses bitset_size (a size_t variable). The first step of calculating bitset_size is to set it to region_count, rounded up to a multiple of BITS_PER_LONG. If region_size is less than BITS_PER_LONG smaller than UINT_MAX, it will get rounded up to 2^32. On a 32bit architecture, this will make bitset_size wrap around to 0 a

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

dm_early_create: fix freeing used table on dm_resume failure

In the Linux kernel, the following vulnerability has been resolved: dm_early_create: fix freeing used table on dm_resume failure If dm_resume fails, the kernel attempts to free table with dm_table_destroy, but the table was already instantiated with dm_swap_table. This commit skips the call to dm_table_destroy in this case.

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

dm-integrity: don't increment hash_offset twice

In the Linux kernel, the following vulnerability has been resolved: dm-integrity: don't increment hash_offset twice hash_offset is already incremented in the loop "for (i = 0; i < to_copy; i++, ts--)". Do not increment it again.

• Auf 5.15.0-1114.120~20.04.1 aktualisieren

dm-verity: fix buffer overflow in FEC calculation

In the Linux kernel, the following vulnerability has been resolved: dm-verity: fix buffer overflow in FEC calculation There's a buffer overflow in dm-verity-fec: if (neras && *neras <= v->fec->roots) fio->erasures[(*neras)++] = i; This allows *neras to reach roots + 1 (the post-increment pushes it past roots). This value is then passed as no_eras to decode_rs8(). Inside the RS decoder (lib/reed_solomon/decode_rs.c:113-121), the erasure locator polynomial loop writes lambda[j] where j can reach nroots + 1 — one element past the end of lambda[] (which is sized nroots + 1, valid indices 0..nroots). The out-of-bounds write lands on syn[0], c

dm-verity: make error counter atomic

In the Linux kernel, the following vulnerability has been resolved: dm-verity: make error counter atomic The error counter "v->corrupted_errs" was not atomic, thus it could be subject to race conditions. The call to dm_audit_log_target("max-corrupted-errors") may be skipped due to the races.

• Auf 5.15.0-1114.120~20.04.1 aktualisieren

scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path

In the Linux kernel, the following vulnerability has been resolved: scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path If phys_disk->in_reset is set, the function returns directly without undoing the resources acquired for the command. Add the missing error cleanup by unmapping the IOACCEL2 SG chain block when needed, unmapping the SCSI command, and dropping the outstanding IOACCEL command count before returning.

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup()

In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup() The memory allocated for mboxq using mempool_alloc() is not freed in some of the early exit error paths. Fix that by moving the mempool_free() call to an earlier point after last use.

• Auf 5.15.0-1114.120~20.04.1 aktualisieren

scsi: xen: scsiback: Free the command tag on the TMR submit-failure path

In the Linux kernel, the following vulnerability has been resolved: scsi: xen: scsiback: Free the command tag on the TMR submit-failure path scsiback_device_action() obtains a command tag in scsiback_get_pend_req() and submits a task-management request with target_submit_tmr(). When target_submit_tmr() fails it returns < 0 and scsiback jumps to the err: label, which sends a response but frees nothing, leaking the tag. Impact: a pvSCSI guest can leak the command tags of a LUN's session, stopping the LUN, by issuing VSCSIIF_ACT_SCSI_ABORT or RESET requests whenever target_submit_tmr() fails. transport_generic_free_cmd() cannot be used here.

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

scsi: xen: scsiback: Free unsubmitted command instead of double-putting it

In the Linux kernel, the following vulnerability has been resolved: scsi: xen: scsiback: Free unsubmitted command instead of double-putting it scsiback_get_pend_req() obtains a command tag and returns a vscsibk_pend whose embedded se_cmd has only been memset to 0, so its cmd_kref is 0; the se_cmd is initialised (kref_init() via target_init_cmd()) only later, in scsiback_cmd_exec(), on the successful VSCSIIF_ACT_SCSI_CDB path. The two error paths in scsiback_do_cmd_fn() taken before the command is submitted -- a failed scsiback_gnttab_data_map() and an unknown ring_req.act -- call transport_generic_free_cmd(&pending_req->se_cmd, 0), which kr

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

scsi: target: Bound PR-OUT TransportID parsing to the received buffer

In the Linux kernel, the following vulnerability has been resolved: scsi: target: Bound PR-OUT TransportID parsing to the received buffer core_scsi3_decode_spec_i_port() and core_scsi3_emulate_register_and_move() hand the raw PERSISTENT RESERVE OUT parameter buffer to target_parse_pr_out_transport_id() without telling it how many bytes are valid. For an iSCSI TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() locates the ",i,0x" ISID separator with an unbounded strstr() (and on the error path prints the name with a further unbounded "%s"). An initiator can submit a TransportID whose iSCSI name contains neither a ",i,0x" subs

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE

In the Linux kernel, the following vulnerability has been resolved: scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE core_scsi3_emulate_pro_register_and_move() maps the PERSISTENT RESERVE OUT parameter list with transport_kmap_data_sg() and parses the destination TransportID with target_parse_pr_out_transport_id(). For an iSCSI TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() returns the ISID in iport_ptr as a raw pointer into that mapped buffer. The function then unmaps the buffer with transport_kunmap_data_sg() before dereferencing iport_ptr in strcmp(), __core_scsi3_locate_pr_reg() and core_scsi3_al

• Auf 5.15.0-1112.118~20.04.1 aktualisieren

scsi: elx: efct: Fix refcount leak in efct_hw_io_abort()

In the Linux kernel, the following vulnerability has been resolved: scsi: elx: efct: Fix refcount leak in efct_hw_io_abort() When efct_hw_reqtag_alloc() fails in efct_hw_io_abort(), the error path returns -ENOSPC without releasing the reference obtained via kref_get_unless_zero() earlier in the function. All other error paths correctly drop the reference. This causes a permanent reference leak on the io_to_abort object. Additionally, the abort_in_progress flag is left set to true on this path, which means future abort attempts for the same I/O will immediately return -EINPROGRESS even though the abort was never submitted, effectively block

• Auf 5.15.0-1112.118~20.04.1 aktualisieren