Sicherheitslücken in linux-nvidia-tegra-5.15 · Seite 125

wifi: rt2x00: avoid full teardown before work setup in probe

In the Linux kernel, the following vulnerability has been resolved: wifi: rt2x00: avoid full teardown before work setup in probe rt2x00lib_probe_dev() uses the full rt2x00lib_remove_dev() teardown for all probe failures. However, drv_data allocation and workqueue allocation can fail before intf_work, autowakeup_work and sleep_work have been initialized. Do not enter the full remove path until the probe has reached the point where those work items are set up. Return directly for drv_data allocation failure, and use a small early cleanup path for workqueue allocation failure. This issue was found by our static analysis tool and then confirm

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

wifi: mac80211: fix memory leak in ieee80211_register_hw()

In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: fix memory leak in ieee80211_register_hw() If kmemdup() fails while copying supported band structures, the error path jumps to fail_rate. This skips rate_control_deinitialize() and leaks the initialized local->rate_ctrl. Fix this by adding a fail_band label that shares the rate-control cleanup path before falling through to the remaining teardown. The bug was first flagged by an experimental analysis tool we are developing for kernel memory-management bugs while analyzing v6.13-rc1. The tool is still under development and is not yet publicly available. Man

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

Bluetooth: btrtl: validate firmware patch bounds

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: btrtl: validate firmware patch bounds rtlbt_parse_firmware() copies patch_length - 4 bytes before appending the firmware version. A malformed firmware patch shorter than the version field can make this subtraction underflow and turn the copy into an oversized read and write during Bluetooth setup. The existing patch_offset + patch_length check can also wrap on 32-bit architectures. Validate the patch length and range without arithmetic overflow before allocating or copying the patch.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

memstick: ms_block: reject a card that reports too many blocks

In the Linux kernel, the following vulnerability has been resolved: memstick: ms_block: reject a card that reports too many blocks msb_ftl_initialize() computes the zone count from the card block count with no bound: msb->zone_count = msb->block_count / MS_BLOCKS_IN_ZONE; ... for (i = 0; i < msb->zone_count; i++) msb->free_block_count[i] = MS_BLOCKS_IN_ZONE; msb->block_count is a card value. msb_read_boot_blocks() reads number_of_blocks from the card boot page and byte swaps it. free_block_count is a fixed int[MS_MAX_ZONES]. MS_MAX_ZONES is 16, so the valid indices are 0 to 15. The init loop above indexes it by zone_count. msb_mark_b

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

ipvs: fix more places with wrong ipv6 transport offsets

In the Linux kernel, the following vulnerability has been resolved: ipvs: fix more places with wrong ipv6 transport offsets Sashiko reports for more incorrect IPv6 transport offsets. The app code for TCP was assuming IPv4 network header even after the ipvsh argument was provided. This can cause problems with apps over IPv6. As for the only official app in the kernel tree (FTP) this problem is harmless because we use Netfilter to mangle the FTP ports and we do not adjust the TCP seq numbers. Also, provide correct offset of the ICMPV6 header in ip_vs_out_icmp_v6() for correct checksum checks when the IPv6 packet has extension headers.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

ipvs: reload ip header after head reallocation

In the Linux kernel, the following vulnerability has been resolved: ipvs: reload ip header after head reallocation __ip_vs_get_out_rt() calls skb_ensure_writable() which may reallocate skb->head.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

reset: sunxi: fix memory region leak on ioremap failure

In the Linux kernel, the following vulnerability has been resolved: reset: sunxi: fix memory region leak on ioremap failure In sunxi_reset_init(), when ioremap() fails, the memory region obtained via request_mem_region() is not released, leading to a resource leak. Add an err_mem_region label to properly release the memory region before freeing the data structure.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access()

In the Linux kernel, the following vulnerability has been resolved: powerpc/spufs: fix out-of-bounds access in spufs_mem_mmap_access() spufs_mem_mmap_access() computes the local store offset as address - vma->vm_start, but bounds-checks it against vma->vm_end instead of the local store size. On 64-bit, offset is always well below vma->vm_end, so the clamp never fires and len stays unbounded against the LS_SIZE buffer returned by ctx->ops->get_ls(). Reject offsets at or beyond LS_SIZE and clamp len to the remaining space, mirroring the guard already used by spufs_mem_mmap_fault() and spufs_ps_fault().

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

wifi: mac80211: validate extension-frame layout before RX

In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: validate extension-frame layout before RX Extension frames only have the extension header at the regular 802.11 header offset. The generic RX path can still reach helpers and interface dispatch code that read regular header address fields before unsupported extension subtypes are dropped. mac80211 currently only handles S1G beacon extension frames. Drop other extension subtypes before they can reach regular-header RX processing. For S1G beacons, linearize the SKB with the management-frame path and require the fixed S1G beacon header, including optional fixe

wifi: mwifiex: fix permanently busy scans after multiple roam iterations

In the Linux kernel, the following vulnerability has been resolved: wifi: mwifiex: fix permanently busy scans after multiple roam iterations In order for the firmware to sleep, the driver has to confirm a previously received sleep request. The normal sequence of evets goes like this: EVENT_SLEEP -> adapter->ps_state = PS_STATE_PRE_SLEEP -> sleep-confirm -> SLEEP -> EVENT_AWAKE -> AWAKE. Before sending the sleep-confirm command, the driver must make sure there are no commands either running or waiting to be completed. mwifiex_ret_802_11_associate() unconditionally sets ps_state = PS_STATE_AWAKE when it processes the association command resp

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

mtd: mchp23k256: use SPI match data for chip caps

In the Linux kernel, the following vulnerability has been resolved: mtd: mchp23k256: use SPI match data for chip caps The driver stores chip capacity information in both the OF match table and the SPI id table. Probe currently uses of_device_get_match_data(), so a non-OF SPI modalias match falls back to mchp23k256_caps even when the SPI id table selected a different part. Use spi_get_device_match_data() so SPI id-table driver_data is consumed when OF match data is absent. This keeps the existing default fallback while avoiding the wrong MTD geometry for id-table-only matches.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout

In the Linux kernel, the following vulnerability has been resolved: mtd: rawnand: lpc32xx_slc: fail DMA transfer on completion timeout lpc32xx_xmit_dma() waits for the DMA completion callback but ignores wait_for_completion_timeout(). A timed out DMA transfer is therefore unmapped and reported as successful to the NAND read/write path. Return -ETIMEDOUT when the completion wait expires. Terminate the DMA channel before unmapping the scatterlist so the timed out transfer cannot continue to access the buffer after the error is returned.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

device property: initialize the remaining fields of fwnode_handle in fwnode_init()

In the Linux kernel, the following vulnerability has been resolved: device property: initialize the remaining fields of fwnode_handle in fwnode_init() If a firmware node is allocated on the stack (for instance: temporary software node whose life-time we control) or on the heap - but using a non-zeroing allocation function - and initialized using fwnode_init(), its secondary pointer will contain uninitialized memory which likely will be neither NULL nor IS_ERR() and so may end up being dereferenced (for example: in dev_to_swnode()). Set fwnode->secondary to NULL on initialization. While at it: initialize the remaining fields of struct fwnode

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

f2fs: fix potential deadlock in f2fs_balance_fs()

In the Linux kernel, the following vulnerability has been resolved: f2fs: fix potential deadlock in f2fs_balance_fs() When the f2fs filesystem space is nearly exhausted, we encounter deadlock issues as below: INFO: task A:1890 blocked for more than 120 seconds. Tainted: G O 6.12.41-g3fe07ddf05ab #1 "echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message. task:A state:D stack:0 pid:1890 tgid:1626 ppid:1153 flags:0x00000204 Call trace: __switch_to+0xf4/0x158 __schedule+0x27c/0x908 schedule+0x3c/0x118 io_schedule+0x44/0x68 folio_wait_bit_common+0x174/0x370 folio_wait_bit+0x20/0x38 folio

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs()

In the Linux kernel, the following vulnerability has been resolved: f2fs: fix potential deadlock in gc_merge path of f2fs_balance_fs() When we mount device w/ gc_merge mount option, we may suffer below potential deadlock: Kworker GC trehad Truncator - f2fs_write_cache_pages - f2fs_write_single_data_page - f2fs_do_write_data_page - folio_start_writeback --- set writeback flag on folio - f2fs_outplace_write_data : cached folio in internal bio cache - f2fs_balance_fs - wake_up(gc_thread) : wake up gc thread to run foreground GC - finish_wait(fggc_wq) : wait on the waitqueue --- wait on GC thread to finish the

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

ksmbd: use opener credentials for FSCTL mutations

In the Linux kernel, the following vulnerability has been resolved: ksmbd: use opener credentials for FSCTL mutations SET_SPARSE, SET_ZERO_DATA and SET_COMPRESSION operate on an open SMB handle but call VFS xattr, fallocate or fileattr helpers with the current ksmbd worker credentials. Those helpers can revalidate inode permissions, ownership and LSM policy independently of the SMB handle access mask. Run each operation with the credentials captured in the target file when the handle was opened. Keep credential handling local to these single-file FSCTLs rather than applying session credentials to the complete IOCTL handler, which also cont

usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect()

In the Linux kernel, the following vulnerability has been resolved: usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect() ueagle-atm uses the asynchronous request_firmware_nowait() in .probe(), but does not wait for its completion, not even in .disconnect(); so, if the device is unplugged meanwhile, its teardown runs concurrently with that. Even though this inconsistency is worth addressing on its own, it has also triggered several bug reports in syzbot over the years (some auto-closed) where the firmware sysfs fallback mechanism (CONFIG_FW_LOADER_USER_HELPER) creates a firmware subdirectory in the device directory during its r

• Auf 5.15.0-1070.72~20.04.1 aktualisieren

KVM: s390: pci: Fix handling of AIF enable without AISB

In the Linux kernel, the following vulnerability has been resolved: KVM: s390: pci: Fix handling of AIF enable without AISB When a guest seeks to register IRQs without a summary bit specified, ensure that the associated GAITE then stores 0 for the guest AISB location instead of virt_to_phys(page_address(NULL)).

s390/zcrypt: Fix buffer over-read in cca_cipher2protkey

In the Linux kernel, the following vulnerability has been resolved: s390/zcrypt: Fix buffer over-read in cca_cipher2protkey Add validation of both the actual key buffer size and token length fields in all the cca_check_sec*token() functions. Additionally check in cca_gencipherkey() for possible underflow with returned key size. The CCA token structures contain user-controlled len fields that were used in operations without proper validation against both the actual buffer size and minimum token structure size. An attacker could set this field larger than the actual buffer size, leading to reading beyond buffer boundaries. This may result in

s390/zcrypt: Validate length for CCA AES cipher key requests

In the Linux kernel, the following vulnerability has been resolved: s390/zcrypt: Validate length for CCA AES cipher key requests cca_cipher2protkey() derives the copy length for the CPRB parameter block directly from the length field in the key token. Reject the request early if the token length exceeds the available space in the parameter block.

• Auf 5.15.0-1070.72~20.04.1 aktualisieren