Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
drm/meson: explicitly remove aggregate driver at module unload time
In the Linux kernel, the following vulnerability has been resolved:
drm/meson: explicitly remove aggregate driver at module unload time
Because component_master_del wasn't being called when unloading the
meson_drm module, the aggregate device would linger forever in the global
aggregate_devices list. That means when unloading and reloading the
meson_dw_hdmi module, component_add would call into
try_to_bring_up_aggregate_device and find the unbound meson_drm aggregate
device.
This would in turn dereference some of the aggregate_device's struct
entries which point to memory automatically freed by the devres API when
unbinding the aggregate d
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
drm: Fix potential null-ptr-deref due to drmm_mode_config_init()
In the Linux kernel, the following vulnerability has been resolved:
drm: Fix potential null-ptr-deref due to drmm_mode_config_init()
drmm_mode_config_init() will call drm_mode_create_standard_properties()
and won't check the ret value. When drm_mode_create_standard_properties()
failed due to alloc, property will be a NULL pointer and may causes the
null-ptr-deref. Fix the null-ptr-deref by adding the ret value check.
Found null-ptr-deref while testing insert module bochs:
general protection fault, probably for non-canonical address
0xdffffc000000000c: 0000 [#1] SMP KASAN PTI
KASAN: null-ptr-deref in range [0x0000000000000060-0x00000000
Nicht bewertetEPSS 0,26%Keine Korrektur veröffentlicht
drm/gma500: Fix null dereference in hdmi teardown
In the Linux kernel, the following vulnerability has been resolved:
drm/gma500: Fix null dereference in hdmi teardown
pci_set_drvdata sets the value of pdev->driver_data to NULL,
after which the driver_data obtained from the same dev is
dereferenced in oaktrail_hdmi_i2c_exit, and the i2c_dev is
extracted from it. To prevent this, swap these calls.
Found by Linux Verification Center (linuxtesting.org) with Svacer.
mm/hugetlb: fix folio is still mapped when deleted
In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb: fix folio is still mapped when deleted
Migration may be raced with fallocating hole. remove_inode_single_folio
will unmap the folio if the folio is still mapped. However, it's called
without folio lock. If the folio is migrated and the mapped pte has been
converted to migration entry, folio_mapped() returns false, and won't
unmap it. Due to extra refcount held by remove_inode_single_folio,
migration fails, restores migration entry to normal pte, and the folio is
mapped again. As a result, we triggered BUG in filemap_unaccount_folio.
The log is as follows:
Nicht bewertetEPSS 0,26%Keine Korrektur veröffentlicht
scsi: mvsas: Fix use-after-free bugs in mvs_work_queue
In the Linux kernel, the following vulnerability has been resolved:
scsi: mvsas: Fix use-after-free bugs in mvs_work_queue
During the detaching of Marvell's SAS/SATA controller, the original code
calls cancel_delayed_work() in mvs_free() to cancel the delayed work
item mwq->work_q. However, if mwq->work_q is already running, the
cancel_delayed_work() may fail to cancel it. This can lead to
use-after-free scenarios where mvs_free() frees the mvs_info while
mvs_work_queue() is still executing and attempts to access the
already-freed mvs_info.
A typical race condition is illustrated below:
CPU 0 (remove) | CPU 1 (delayed work call
scsi: target: target_core_configfs: Add length check to avoid buffer overflow
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: target_core_configfs: Add length check to avoid buffer overflow
A buffer overflow arises from the usage of snprintf to write into the
buffer "buf" in target_lu_gp_members_show function located in
/drivers/target/target_core_configfs.c. This buffer is allocated with
size LU_GROUP_NAME_BUF (256 bytes).
snprintf(...) formats multiple strings into buf with the HBA name
(hba->hba_group.cg_item), a slash character, a devicename (dev->
dev_group.cg_item) and a newline character, the total formatted string
length may exceed the buffer size of 256 bytes.
Since snprin
Nicht bewertetEPSS 0,23%Keine Korrektur veröffentlicht
media: b2c2: Fix use-after-free causing by irq_check_work in flexcop_pci_remove
In the Linux kernel, the following vulnerability has been resolved:
media: b2c2: Fix use-after-free causing by irq_check_work in flexcop_pci_remove
The original code uses cancel_delayed_work() in flexcop_pci_remove(), which
does not guarantee that the delayed work item irq_check_work has fully
completed if it was already running. This leads to use-after-free scenarios
where flexcop_pci_remove() may free the flexcop_device while irq_check_work
is still active and attempts to dereference the device.
A typical race condition is illustrated below:
CPU 0 (remove) | CPU 1 (delayed work callback)
flexcop_pci_remove()
media: i2c: tc358743: Fix use-after-free bugs caused by orphan timer in probe
In the Linux kernel, the following vulnerability has been resolved:
media: i2c: tc358743: Fix use-after-free bugs caused by orphan timer in probe
The state->timer is a cyclic timer that schedules work_i2c_poll and
delayed_work_enable_hotplug, while rearming itself. Using timer_delete()
fails to guarantee the timer isn't still running when destroyed, similarly
cancel_delayed_work() cannot ensure delayed_work_enable_hotplug has
terminated if already executing. During probe failure after timer
initialization, these may continue running as orphans and reference the
already-freed tc358743_state object through tc358743_irq_poll_timer.
The follow
media: tuner: xc5000: Fix use-after-free in xc5000_release
In the Linux kernel, the following vulnerability has been resolved:
media: tuner: xc5000: Fix use-after-free in xc5000_release
The original code uses cancel_delayed_work() in xc5000_release(), which
does not guarantee that the delayed work item timer_sleep has fully
completed if it was already running. This leads to use-after-free scenarios
where xc5000_release() may free the xc5000_priv while timer_sleep is still
active and attempts to dereference the xc5000_priv.
A typical race condition is illustrated below:
CPU 0 (release thread) | CPU 1 (delayed work callback)
xc5000_release() | xc5000_do_timer_s
In the Linux kernel, the following vulnerability has been resolved:
media: rc: fix races with imon_disconnect()
Syzbot reports a KASAN issue as below:
BUG: KASAN: use-after-free in __create_pipe include/linux/usb.h:1945 [inline]
BUG: KASAN: use-after-free in send_packet+0xa2d/0xbc0 drivers/media/rc/imon.c:627
Read of size 4 at addr ffff8880256fb000 by task syz-executor314/4465
CPU: 2 PID: 4465 Comm: syz-executor314 Not tainted 6.0.0-rc1-syzkaller #0
Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.14.0-2 04/01/2014
Call Trace:
<TASK>
__dump_stack lib/dump_stack.c:88 [inline]
dump_stack_lvl+0xcd/0x134 lib/dump_stack.c:106
print_a
can: hi311x: populate ndo_change_mtu() to prevent buffer overflow
In the Linux kernel, the following vulnerability has been resolved:
can: hi311x: populate ndo_change_mtu() to prevent buffer overflow
Sending an PF_PACKET allows to bypass the CAN framework logic and to
directly reach the xmit() function of a CAN driver. The only check
which is performed by the PF_PACKET framework is to make sure that
skb->len fits the interface's MTU.
Unfortunately, because the sun4i_can driver does not populate its
net_device_ops->ndo_change_mtu(), it is possible for an attacker to
configure an invalid MTU by doing, for example:
$ ip link set can0 mtu 9999
After doing so, the attacker could open a PF_PACKET socket us
can: sun4i_can: populate ndo_change_mtu() to prevent buffer overflow
In the Linux kernel, the following vulnerability has been resolved:
can: sun4i_can: populate ndo_change_mtu() to prevent buffer overflow
Sending an PF_PACKET allows to bypass the CAN framework logic and to
directly reach the xmit() function of a CAN driver. The only check
which is performed by the PF_PACKET framework is to make sure that
skb->len fits the interface's MTU.
Unfortunately, because the sun4i_can driver does not populate its
net_device_ops->ndo_change_mtu(), it is possible for an attacker to
configure an invalid MTU by doing, for example:
$ ip link set can0 mtu 9999
After doing so, the attacker could open a PF_PACKET socket
can: mcba_usb: populate ndo_change_mtu() to prevent buffer overflow
In the Linux kernel, the following vulnerability has been resolved:
can: mcba_usb: populate ndo_change_mtu() to prevent buffer overflow
Sending an PF_PACKET allows to bypass the CAN framework logic and to
directly reach the xmit() function of a CAN driver. The only check
which is performed by the PF_PACKET framework is to make sure that
skb->len fits the interface's MTU.
Unfortunately, because the mcba_usb driver does not populate its
net_device_ops->ndo_change_mtu(), it is possible for an attacker to
configure an invalid MTU by doing, for example:
$ ip link set can0 mtu 9999
After doing so, the attacker could open a PF_PACKET socket u
In the Linux kernel, the following vulnerability has been resolved:
i40e: add validation for ring_len param
The `ring_len` parameter provided by the virtual function (VF)
is assigned directly to the hardware memory context (HMC) without
any validation.
To address this, introduce an upper boundary check for both Tx and Rx
queue lengths. The maximum number of descriptors supported by the
hardware is 8k-32.
Additionally, enforce alignment constraints: Tx rings must be a multiple
of 8, and Rx rings must be a multiple of 32.
crypto: af_alg - Disallow concurrent writes in af_alg_sendmsg
In the Linux kernel, the following vulnerability has been resolved:
crypto: af_alg - Disallow concurrent writes in af_alg_sendmsg
Issuing two writes to the same af_alg socket is bogus as the
data will be interleaved in an unpredictable fashion. Furthermore,
concurrent writes may create inconsistencies in the internal
socket state.
Disallow this by adding a new ctx->write field that indiciates
exclusive ownership for writing.
tcp: Clear tcp_sk(sk)->fastopen_rsk in tcp_disconnect().
In the Linux kernel, the following vulnerability has been resolved:
tcp: Clear tcp_sk(sk)->fastopen_rsk in tcp_disconnect().
syzbot reported the splat below where a socket had tcp_sk(sk)->fastopen_rsk
in the TCP_ESTABLISHED state. [0]
syzbot reused the server-side TCP Fast Open socket as a new client before
the TFO socket completes 3WHS:
1. accept()
2. connect(AF_UNSPEC)
3. connect() to another destination
As of accept(), sk->sk_state is TCP_SYN_RECV, and tcp_disconnect() changes
it to TCP_CLOSE and makes connect() possible, which restarts timers.
Since tcp_disconnect() forgot to clear tcp_sk(sk)->fastopen_rsk, the
retransmit time
tty: serial: samsung_tty: Fix a memory leak in s3c24xx_serial_getclk() when iterating clk
In the Linux kernel, the following vulnerability has been resolved:
tty: serial: samsung_tty: Fix a memory leak in s3c24xx_serial_getclk() when iterating clk
When the best clk is searched, we iterate over all possible clk.
If we find a better match, the previous one, if any, needs to be freed.
If a better match has already been found, we still need to free the new
one, otherwise it leaks.
In the Linux kernel, the following vulnerability has been resolved:
tun: Fix memory leak for detached NAPI queue.
syzkaller reported [0] memory leaks of sk and skb related to the TUN
device with no repro, but we can reproduce it easily with:
struct ifreq ifr = {}
int fd_tun, fd_tmp;
char buf[4] = {};
fd_tun = openat(AT_FDCWD, "/dev/net/tun", O_WRONLY, 0);
ifr.ifr_flags = IFF_TUN | IFF_NAPI | IFF_MULTI_QUEUE;
ioctl(fd_tun, TUNSETIFF, &ifr);
ifr.ifr_flags = IFF_DETACH_QUEUE;
ioctl(fd_tun, TUNSETQUEUE, &ifr);
fd_tmp = socket(AF_PACKET, SOCK_PACKET, 0);
ifr.ifr_flags = IFF_UP;
ioctl(fd_tmp, SIOCSIFFLAGS, &ifr);
writ
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (xgene) Fix ioremap and memremap leak
Smatch reports:
drivers/hwmon/xgene-hwmon.c:757 xgene_hwmon_probe() warn:
'ctx->pcc_comm_addr' from ioremap() not released on line: 757.
This is because in drivers/hwmon/xgene-hwmon.c:701 xgene_hwmon_probe(),
ioremap and memremap is not released, which may cause a leak.
To fix this, ioremap and memremap is modified to devm_ioremap and
devm_memremap.
[groeck: Fixed formatting and subject]
bcache: Fix __bch_btree_node_alloc to make the failure behavior consistent
In the Linux kernel, the following vulnerability has been resolved:
bcache: Fix __bch_btree_node_alloc to make the failure behavior consistent
In some specific situations, the return value of __bch_btree_node_alloc
may be NULL. This may lead to a potential NULL pointer dereference in
caller function like a calling chain :
btree_split->bch_btree_node_alloc->__bch_btree_node_alloc.
Fix it by initializing the return value in __bch_btree_node_alloc.