mmc: vub300: defer reset until cmd_mutex is unlocked
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: defer reset until cmd_mutex is unlocked
vub300_cmndwork_thread() holds cmd_mutex while it sends a command and
waits for the command response. If the response wait times out,
__vub300_command_response() kills the command URBs and then synchronously
resets the USB device through usb_reset_device().
That reset path re-enters the driver through vub300_pre_reset(), which
also takes cmd_mutex. The worker therefore tries to acquire the same
mutex recursively while it is still holding it from the command path.
This issue was found by our static analysis tool and th
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
media: atomisp: gc2235: fix UAF and memory leak
In the Linux kernel, the following vulnerability has been resolved:
media: atomisp: gc2235: fix UAF and memory leak
gc2235_probe() handles its error paths incorrectly.
If media_entity_pads_init() fails, gc2235_remove() is called, which
tears down the subdev and frees dev, but then still falls through to
atomisp_register_i2c_module(). This results in use-after-free.
If atomisp_register_i2c_module() fails, the media entity and control
handler are left initialized and dev is leaked.
gc2235_remove() unconditionally calls media_entity_cleanup() and
v4l2_ctrl_handler_free(), but these are not initialized at every
error path in gc2235_probe().
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
In the Linux kernel, the following vulnerability has been resolved:
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
With a list_for_each() loop, if we don't find the item we are looking for
in the list, then the loop exits with the iterator, which is "dbell" in
this loop, pointing to invalid memory.
This code uses the "found" variable to determine if we have found the
doorbell we are looking for or not. However, the problem that the "found"
variable needs to be set to false at the start of each iteration,
otherwise after the first correct doorbell, then everything is marked as
found.
Reset the "found" to false at the start o
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: don't BUG_ON an invalid journal dinode
[BUG]
A fuzzed OCFS2 image can corrupt the current slot journal dinode while
mount is still in progress. The mount path first reports the invalid
journal block and then crashes in shutdown:
kernel BUG at fs/ocfs2/journal.c:1034!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_journal_toggle_dirty+0x2d6/0x340 fs/ocfs2/journal.c:1034
Call Trace:
ocfs2_journal_shutdown+0x414/0xc30 fs/ocfs2/journal.c:1116
ocfs2_mount_volume fs/ocfs2/super.c:1785 [inline]
ocfs2_fill_super+0x30a9/0x3cd0 fs/ocfs2/super.c:1083
get_t
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
In the Linux kernel, the following vulnerability has been resolved:
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
Use get_unaligned_be32() and put_unaligned_be32() to safely read and
write the timestamp fields. This prevents performance degradation due to
unaligned memory access or even a crash on strict alignment
architectures.
This follows the implementation of timestamp parsing in the networking
stack at tcp_parse_options() and synproxy_parse_options().
wifi: wcn36xx: fix OOB read from short trigger BA firmware response
In the Linux kernel, the following vulnerability has been resolved:
wifi: wcn36xx: fix OOB read from short trigger BA firmware response
The firmware response length is only checked against sizeof(*rsp) (20
bytes), but when candidate_cnt >= 1, a 22-byte candidate struct is read
at buf + 20 without verifying the response contains it. This causes an
out-of-bounds read of stale heap data, corrupting the BA session state.
Add validation that the response includes the candidate data.
ALSA: seq: oss: Serialize readq reset state with q->lock
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Serialize readq reset state with q->lock
snd_seq_oss_readq_clear() resets qlen, head, and tail without
q->lock even though the normal reader and producer paths serialize the
same ring state under that spinlock. A reset can therefore race
snd_seq_oss_readq_free() or snd_seq_oss_readq_put_event() and leave
stale records in the queue, drop freshly queued ones, or report the
wrong readiness after wakeup. KCSAN reports a data race between
snd_seq_oss_readq_clear() and snd_seq_oss_readq_free().
Take q->lock while clearing the ring and resetting input_time. Factor
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
In the Linux kernel, the following vulnerability has been resolved:
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
fsl_emb_pmu_del() unconditionally calls put_cpu_var(cpu_hw_events) at
the 'out:' label, but only calls the matching get_cpu_var() after the
'i < 0' early-return check. When event->hw.idx is negative the
function jumps to 'out:' without having taken get_cpu_var(), and the
trailing put_cpu_var() then issues an unmatched preempt_enable(),
underflowing preempt_count.
On a CONFIG_PREEMPT=y kernel preempt_count would underflow and
eventually present as a 'scheduling while atomic' BUG.
Move put_cpu_var() to pair with g
char: tlclk: fix use-after-free in tlclk_cleanup()
In the Linux kernel, the following vulnerability has been resolved:
char: tlclk: fix use-after-free in tlclk_cleanup()
This patch improves the module cleanup process in the tlclk driver to
prevent potential use-after-free and race conditions.
Currently, the file_operations structure does not specify the .owner
field, which could allow the module to be unloaded while user-space
processes are still interacting with the device. Additionally, the
tlclk_cleanup() function frees the alarm_events memory before ensuring
that blocked processes in the waitqueue are fully awakened and that the
switchover_timer has completed.
To address these cases,
apparmor: fix potential UAF in aa_replace_profiles
In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix potential UAF in aa_replace_profiles
The function aa_replace_profiles was accessing udata->size after calling
aa_put_loaddata(udata), causing a potential UAF.
Fixed this by saving the size to a local variable before dropping the
reference.
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
In the Linux kernel, the following vulnerability has been resolved:
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
It's pointless to call WARN_ON() in case of an allocation failure in
dev_change_net_namespace() and device_rename(), since it only leads to
useless splats caused by deliberate fault injections, so avoid it.
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
In the Linux kernel, the following vulnerability has been resolved:
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
When function tracing or Kprobes is enabled, entering an ACPI Low
Power Idle (LPI) state triggers the following RCU splat:
RCU not on for: acpi_idle_lpi_enter+0x4/0xd8
WARNING: CPU: 8 PID: 0 at include/linux/trace_recursion.h:162 function_trace_call+0x1e8/0x228
The acpi_idle_lpi_enter() function is invoked within the cpuidle
path after RCU has already been disabled for the current local CPU.
Consequently, ftrace's function_trace_call() expects RCU to be
actively watching before recording trace data, emitting
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In the Linux kernel, the following vulnerability has been resolved:
HID: picolcd: prevent NULL pointer dereference in picolcd_send_and_wait()
In picolcd_send_and_wait(), an integer overflow of the signed loop counter
'k' can theoretically lead to a NULL pointer dereference of 'raw_data'.
If the loop executes more than INT_MAX times, 'k' becomes negative,
making the condition 'k < size' true even when 'size' is 0.
Change the type of 'k' to 'unsigned int' to prevent the overflow and
eliminate the out-of-bounds access.
Found by Linux Verification Center (linuxtesting.org) with the Svace static
analysis tool.
[[email protected]: extended hash
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_irc: fix parse_dcc() off-by-one OOB read
parse_dcc() treats data_end as an inclusive end pointer, but its only
caller passes data_limit = ib_ptr + datalen, which points one past the
last valid byte.
The newline search loop iterates while tmp <= data_end, so when no
newline is present, *tmp is read at tmp == data_end, one byte beyond
the region filled by skb_header_pointer().
irc_buffer is kmalloc'd as MAX_SEARCH_SIZE + 1 bytes and datalen is
capped at MAX_SEARCH_SIZE, so the stray read does not fault. The byte
is uninitialized or stale; if it cont
batman-adv: gw: acquire ethernet header only after skb realloc
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: gw: acquire ethernet header only after skb realloc
The pskb_may_pull() called by batadv_get_vid() could reallocate the buffer
behind the skb. Variables which were pointing to the old buffer need to be
reassigned to avoid an use-after-free.
batman-adv: dat: ensure accessible eth_hdr proto field
In the Linux kernel, the following vulnerability has been resolved:
batman-adv: dat: ensure accessible eth_hdr proto field
When batadv_get_vid() accesses the proto field of the ethernet header, it
is not checking if the data itself is accessible. The caller is responsible
for it. But in contrast to other call sites, batadv_dat_get_vid() and its
caller didn't make sure this is true. This could have caused an
out-of-bounds access.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
mtd: maps: vmu-flash: fix NULL pointer dereference in initialization
In the Linux kernel, the following vulnerability has been resolved:
mtd: maps: vmu-flash: fix NULL pointer dereference in initialization
The mtd_info contains a struct device, which must be linked to its
parent. Without this, the initialization of the MTD fails with a NULL
pointer dereference.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
Input: ims-pcu - add response length checks
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - add response length checks
The driver processes response data from device buffers without verifying
that the device actually sent enough data. This can lead to
out-of-bounds reads or processing stale data.
Add checks for the expected response length before accessing the
buffers.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
Input: ims-pcu - fix potential infinite loop in CDC union descriptor parsing
In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix potential infinite loop in CDC union descriptor parsing
The driver parses CDC union descriptors in ims_pcu_get_cdc_union_desc()
by iterating through the extra descriptor data. However, it does not
verify that the bLength of each descriptor is at least 2. A malicious
device could provide a descriptor with bLength = 0, leading to an
infinite loop in the driver.
Add a check to ensure bLength is at least 2 before proceeding with
parsing.
hwmon: (asus_atk0110) Check package count before accessing element
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (asus_atk0110) Check package count before accessing element
atk_ec_present() walks the management group package returned by the GGRP
ACPI method and, for each sub-package, reads its first element:
id = &obj->package.elements[0];
if (id->type != ACPI_TYPE_INTEGER)
without checking that the sub-package is non-empty. ACPICA allocates the
element array with exactly package.count entries, so for a sub-package
with a zero count this reads past the allocation.
The sibling function atk_debugfs_ggrp_open() performs the same access but
skips empty packages with a package