thunderbolt: Clamp XDomain response data copy to allocation size
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Clamp XDomain response data copy to allocation size
tb_xdp_properties_request() derives the per-packet copy length from
the response header without checking that it fits in the previously
allocated data buffer. A malicious peer can set its length field
larger than the declared data_length, causing memcpy to write past
the kcalloc allocation.
Clamp the per-packet copy length so that the cumulative offset
never exceeds data_len.
thunderbolt: Validate XDomain request packet size before type cast
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Validate XDomain request packet size before type cast
tb_xdp_handle_request() casts the received packet buffer to
protocol-specific structs without verifying that the allocation
is large enough for the target type. A peer can send a minimal
XDomain packet that passes the generic header length check but is
shorter than the struct accessed after the cast, causing out-of-
bounds reads from the kmemdup allocation.
Plumb the packet length through xdomain_request_work and validate
it against the expected struct size before each cast.
thunderbolt: Limit XDomain response copy to actual frame size
In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: Limit XDomain response copy to actual frame size
tb_xdomain_copy() copies req->response_size bytes from the received
packet buffer regardless of the actual frame size. When a short
response arrives, this reads past the valid frame data in the DMA
pool buffer into stale contents from previous transactions.
Use the minimum of frame size and expected response size for the
copy length.
In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Skip CSD when it has zeroed workgroups
A compute shader dispatch encodes its workgroup counts in the CFG0..CFG2
registers. Kicking off a dispatch with a zero count in any of the three
dimensions is invalid. First, the hardware will process 0 as 65536,
while the user-space driver exposes a maximum of 65535. Over that, a
submission with a zeroed workgroup dimension should be a no-op.
These zeroed counts can reach the dispatch path through an indirect CSD
job, whose workgroup counts are only known once the indirect buffer is
read and may legitimately be zero, but suc
drm/amd/display: Bound VBIOS record-chain walk loops
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Bound VBIOS record-chain walk loops
[Why & How]
All record-chain walk loops in bios_parser.c and bios_parser2.c use
for(;;) and only terminate on a 0xFF record_type sentinel or zero
record_size. A malformed VBIOS image missing the terminator record
causes unbounded iteration at probe time, potentially hundreds of
thousands of iterations with record_size=1. In the final iterations
near the BIOS image boundary, struct casts beyond the 2-byte header
validated by GET_IMAGE can also read out of bounds.
Cap all 14 record-chain walk loops to BIOS_MAX_NUM_RECORD (
drm/amd/display: Clamp HDMI HDCP2 rx_id_list read to buffer size
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Clamp HDMI HDCP2 rx_id_list read to buffer size
[Why & How]
During HDCP 2.x repeater authentication over HDMI, the driver reads the
sink's RxStatus register and extracts a 10-bit message size field (max
value 1023). This value is used as the read length for the ReceiverID
list without being clamped to the size of the destination buffer
rx_id_list[177]. A malicious HDMI repeater could advertise a message
size larger than the buffer, causing an out-of-bounds write during the
I2C read.
Clamp the read length in mod_hdcp_read_rx_id_list() to the size of the
rx_
drm/amd/display: Clamp VBIOS HDMI retimer register count to array size
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Clamp VBIOS HDMI retimer register count to array size
[Why & How]
The VBIOS integrated info tables (v1_11 and v2_1) contain HdmiRegNum and
Hdmi6GRegNum fields that are used as loop bounds when copying retimer I2C
register settings into fixed-size arrays (dp*_ext_hdmi_reg_settings[9]
and dp*_ext_hdmi_6g_reg_settings[3]). These u8 fields are not validated
before use, so a malformed VBIOS can specify values up to 255, causing an
out-of-bounds heap write during driver probe.
Clamp each register count to the destination array size using min_t()
before the copy
drm/amd/display: Fix NULL deref and buffer over-read in SDP debugfs
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Fix NULL deref and buffer over-read in SDP debugfs
[Why & How]
dp_sdp_message_debugfs_write() dereferences connector->base.state->crtc
without checking for NULL. A connector can be connected but not bound to
any CRTC (e.g. after hot-plug before the next atomic commit), causing a
kernel crash when writing to the sdp_message debugfs node.
The function also ignores the user-provided size argument and always
passes 36 bytes to copy_from_user(), reading past the user buffer when
size < 36.
Fix both issues by:
- Returning -ENODEV when connector->base.state or s
netfilter: nft_fib: fix stale stack leak via the OIFNAME register
In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: fix stale stack leak via the OIFNAME register
For NFT_FIB_RESULT_OIFNAME the destination register is declared with
len = IFNAMSIZ (four 32-bit registers), but on the lookup-fail,
RTN_LOCAL and oif-mismatch paths nft_fib{4,6}_eval() only writes one
register via "*dest = 0". The remaining three registers are left as
whatever was on the stack in nft_do_chain()'s struct nft_regs, and a
downstream expression that loads the register span can leak that
uninitialised kernel stack to userspace.
The NFTA_FIB_F_PRESENT existence check has the same shape: it is onl
In the Linux kernel, the following vulnerability has been resolved:
RDMA/umem: Fix truncation for block sizes >= 4G
When the iommu is used the linearization of the mapping can give a single
block that is very large split across multiple SG entries.
When __rdma_block_iter_next() reassembles the split SG entries it is
overflowing the 32 bit stack values and computed the wrong DMA addresses
for blocks after the truncation.
Use the right types to hold DMA addresses.
netfilter: require Ethernet MAC header before using eth_hdr()
In the Linux kernel, the following vulnerability has been resolved:
netfilter: require Ethernet MAC header before using eth_hdr()
`ip6t_eui64`, `xt_mac`, the `bitmap:ip,mac`, `hash:ip,mac`, and
`hash:mac` ipset types, and `nf_log_syslog` access `eth_hdr(skb)`
after either assuming that the skb is associated with an Ethernet
device or checking only that the `ETH_HLEN` bytes at
`skb_mac_header(skb)` lie between `skb->head` and `skb->data`.
Make these paths first verify that the skb is associated with an
Ethernet device, that the MAC header was set, and that it spans at
least a full Ethernet header before accessing `eth_hdr(skb)`.
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
In the Linux kernel, the following vulnerability has been resolved:
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
omfs_fill_super() rejects oversized s_sys_blocksize values (> PAGE_SIZE),
but it does not reject values smaller than OMFS_DIR_START (0x1b8 = 440).
Later, omfs_make_empty() uses
sbi->s_sys_blocksize - OMFS_DIR_START
as the length argument to memset(). Since s_sys_blocksize is u32,
a crafted filesystem image with s_sys_blocksize < OMFS_DIR_START causes
an unsigned underflow there, wrapping to a value near 2^32. That drives
a ~4 GiB memset() from bh->b_data + OMFS_DIR_START and overwrites kernel
memory far be
fs/mbcache: cancel shrink work before destroying the cache
In the Linux kernel, the following vulnerability has been resolved:
fs/mbcache: cancel shrink work before destroying the cache
mb_cache_destroy() calls shrinker_free() and then frees all cache
entries and the cache itself, but it does not cancel the pending
c_shrink_work work item first.
If mb_cache_entry_create() schedules c_shrink_work via schedule_work()
and the work item is still pending or running when mb_cache_destroy()
runs, mb_cache_shrink_worker() will access the cache after its memory
has been freed, causing a use-after-free.
This is only reachable by a privileged user (root or CAP_SYS_ADMIN)
who can trigger the last put of a mo
drbd: Balance RCU calls in drbd_adm_dump_devices()
In the Linux kernel, the following vulnerability has been resolved:
drbd: Balance RCU calls in drbd_adm_dump_devices()
Make drbd_adm_dump_devices() call rcu_read_lock() before
rcu_read_unlock() is called. This has been detected by the Clang
thread-safety analyzer.
btrfs: fix deadlock between reflink and transaction commit when using flushoncommit
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix deadlock between reflink and transaction commit when using flushoncommit
When using the flushoncommit mount option, we can have a deadlock between
a transaction commit and a reflink operation that copied an inline extent
to an offset beyond the current i_size of the destination node.
The deadlock happens like this:
1) Task A clones an inline extent from inode X to an offset of inode Y
that is beyond Y's current i_size. This means we copied the inline
extent's data to a folio of inode Y that is beyond its EOF, using a
call to copy_inline_to_page();
2)
In the Linux kernel, the following vulnerability has been resolved:
PCI: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
s390/cio: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
s390/cio: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
bus: fsl-mc: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
bus: fsl-mc: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
wifi: rtlwifi: pci: fix possible use-after-free caused by unfinished irq_prepare_bcn_tasklet
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: pci: fix possible use-after-free caused by unfinished irq_prepare_bcn_tasklet
The irq_prepare_bcn_tasklet is initialized in rtl_pci_init() and
scheduled when RTL_IMR_BCNINT interrupt is triggered by hardware.
But it is never killed in rtl_pci_deinit(). When the rtlwifi card
probe fails or is being detached, the ieee80211_hw is deallocated.
However, irq_prepare_bcn_tasklet may still be running or pending,
leading to use-after-free when the freed ieee80211_hw is accessed
in _rtl_pci_prepare_bcn_tasklet().
Similar to irq_tasklet, add tasklet_kill() in rtl_pci_d
bpf: test_run: Fix the null pointer dereference issue in bpf_lwt_xmit_push_encap
In the Linux kernel, the following vulnerability has been resolved:
bpf: test_run: Fix the null pointer dereference issue in bpf_lwt_xmit_push_encap
The bpf_lwt_xmit_push_encap helper needs to access skb_dst(skb)->dev to
calculate the needed headroom:
err = skb_cow_head(skb,
len + LL_RESERVED_SPACE(skb_dst(skb)->dev));
But skb->_skb_refdst may not be initialized when the skb is set up by
bpf_prog_test_run_skb function. Executing bpf_lwt_push_ip_encap function
in this scenario will trigger null pointer dereference, causing a kernel
crash as Yinhao reported:
[ 105.186365] BUG: kernel NULL pointer dereference, address: 0000000000000