HID: logitech-hidpp: Fix FF device cleanup on init failure
In the Linux kernel, the following vulnerability has been resolved:
HID: logitech-hidpp: Fix FF device cleanup on init failure
hidpp_ff_init() creates the input force-feedback device with
input_ff_create(), then allocates the HID++ FF private data,
effect ID array, and workqueue.
If any of those allocations fail after input_ff_create() succeeds,
the function returns an error without destroying the FF device.
Add an unwind path that frees the private allocations made by
hidpp_ff_init() and calls input_ff_destroy() for failures after
input_ff_create() succeeds.
HID: synchronize input before cleaning up a failed probe
In the Linux kernel, the following vulnerability has been resolved:
HID: synchronize input before cleaning up a failed probe
hid_device_io_start() allows reports to run concurrently with probe. If
the probe subsequently fails, __hid_device_probe() releases driver
resources and clears hdev->driver without first excluding those report
callbacks.
For example, a report may enter hidraw_report_event() while the failure
path frees the associated hidraw object, leading to a use-after-free when
the report takes the object's list lock.
Stop input before performing failed-probe cleanup. This reacquires
driver_input_lock and waits for any report cal
In the Linux kernel, the following vulnerability has been resolved:
HID: steam: Reject short reads
Steam Controller FEATURE reports encode the size of the message in the
message itself. Previously we were trusting that the size reported matched
the size we actually read, leading to a potential issue with short reads.
Instead, we should actually verify the length of the read.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
phonet: pep: do not write beyond optlen in getsockopt
In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: do not write beyond optlen in getsockopt
pep_getsockopt() clamps the reported length to the caller's buffer with
min_t(), but then stores the value with put_user(val, (int __user *)
optval), which always writes sizeof(int) bytes. A getsockopt() call with
an optlen smaller than sizeof(int) thus reports the clamped length yet
writes a full int, one to three bytes past the user buffer.
Write the value with copy_to_user() bounded by len, so at most optlen
bytes are copied, matching the length reported back to userspace.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
ocfs2/cluster: keep heartbeat local node stable
In the Linux kernel, the following vulnerability has been resolved:
ocfs2/cluster: keep heartbeat local node stable
o2nm_node_local_store() handles local=0 by stopping o2net and setting
cl_local_node to O2NM_INVALID_NODE_NUM, but it leaves cl_has_local set.
That stale state makes o2nm_this_node() return 255, blocks a later local=1
attempt with -EBUSY, and can feed 255 to heartbeat users that call
o2nm_this_node() dynamically.
Clearing cl_has_local is required when the local node is reset. But
heartbeat threads can still be running at that point. They pin the local
node config item at startup, yet o2hb_do_disk_heartbeat() and thread
tear
ocfs2: validate inline xattrs during inode block validation
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate inline xattrs during inode block validation
Patch series "ocfs2: validate xattr entry bounds", v7.
This series validates OCFS2 xattr entry name/value bounds when xattr
metadata is read and validated, before getxattr() or listxattr() can walk
out-of-range entry arrays or offsets from corrupted metadata.
This patch (of 2):
ocfs2_validate_inode_block() verifies a dinode before OCFS2 users walk
metadata from it, but inline xattr metadata is still checked only in
operation-specific consumers. The existing ibody lookup helper validates
inline header placement
ocfs2: validate external xattr entries when reading metadata
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate external xattr entries when reading metadata
ocfs2_validate_xattr_block() checks the xattr block header before the
block reaches higher-level xattr users, but it does not verify that a
non-indexed block's xh_count and entry offsets fit inside the block.
Indexed buckets likewise reach list/get consumers after ECC without an
entry-bounds check.
Use the flat xattr entry validator for non-indexed external xattr blocks,
and use a bucket-specific validator for indexed buckets at metadata read
time. The bucket validator keeps the entry array bounded by the first
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
fat: release buffer head after rebuilding parent
In the Linux kernel, the following vulnerability has been resolved:
fat: release buffer head after rebuilding parent
fat_scan_logstart() leaves the matching directory entry's buffer head in
sinfo.bh for the caller to release, just like fat_scan().
fat_rebuild_parent() uses the directory entry to rebuild the parent inode
for the nostale_ro NFS export path, but does not release sinfo.bh after a
successful scan. Release it once fat_build_inode() has consumed the
directory entry data.
In the Linux kernel, the following vulnerability has been resolved:
drm/omap: dsi: Do not copy isr table
To be able to unregister stuff from isrs, the corresponding table was
copied. Nobody seems to unregister stuff that way, so it does not help.
But there are stack-allocated objects passed to these isrs giving chances
of UAF of these objects if irqs are unregistered while they are handled,
so better do not copy that table.
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
PCI/sysfs: Add lockdown checks to legacy I/O and memory handlers
In the Linux kernel, the following vulnerability has been resolved:
PCI/sysfs: Add lockdown checks to legacy I/O and memory handlers
Currently, the legacy I/O and memory sysfs handlers do not check
security_locked_down(LOCKDOWN_PCI_ACCESS), leaving the legacy_io and
legacy_mem files unprotected when the kernel is locked down.
Commit eb627e17727e ("PCI: Lock down BAR access when the kernel is locked
down") added the check to pci_write_config(), pci_mmap_resource(), and
pci_write_resource_io() to prevent userspace from programming DMA-capable
hardware that could be used to modify kernel code, but did not cover the
legacy handlers.
As a resu
Nicht bewertetEPSS 0,23%Keine Korrektur veröffentlicht
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
In the Linux kernel, the following vulnerability has been resolved:
remoteproc: fix OOB read via signed offset in rsc_table_for_each_entry()
table->offset[i] is a u32 from firmware, but was stored into a signed
int. A crafted offset like 0xFFFFFFF0 becomes -16, placing hdr 16 bytes
before the table buffer. The subsequent avail check was bypassed
because the negative int was promoted to a large size_t in the
expression "table_sz - offset - sizeof(*hdr)", yielding a large positive
avail and letting the out-of-bounds hdr->type read proceed undetected.
Store the offset as u32 and validate it with unsigned comparisons before
any pointer arith
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
In the Linux kernel, the following vulnerability has been resolved:
bpf, cgroup: Fix invalid storage access after __cgroup_bpf_attach failed
A potential invalid storage access issue can occur after replacing a
cgroup bpf prog.
This occurs in the following scenario:
1. prog1 with storage is attached to a cgroup in multi-attach mode.
2. prog1 is replaced with prog2 using BPF_F_REPLACE in multi-attach
mode, but fails midway (e.g. in bpf_trampoline_link_cgroup_shim or
update_effective_progs).
3. A new prog3 is attached to the cgroup in multi-attach mode.
The reason is that __cgroup_bpf_attach overwrites pl->storage with the
new storage
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
thermal: hwmon: Remove hwmon class device along with its parent
In the Linux kernel, the following vulnerability has been resolved:
thermal: hwmon: Remove hwmon class device along with its parent
The current code creates one hwmon device per thermal zone type and that
device is registered under the first thermal zone of the given type.
That turns out to be problematic when the thermal zone holding the
hwmon device is removed.
For example, say that there are two ACPI thermal zones on a system
/sys/devices/virtual/thermal/thermal_zone0/
/sys/devices/virtual/thermal/thermal_zone1/
The current code registers a hwmon class device for thermal_zone0 only:
/sys/devices/virtual/thermal/thermal_zone0/hwmo
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
RDMA/srp: fix heap information leak on a truncated SRP_CRED_REQ
In the Linux kernel, the following vulnerability has been resolved:
RDMA/srp: fix heap information leak on a truncated SRP_CRED_REQ
srp_recv_done() passes wc->byte_len to srp_process_rsp(). It passes
nothing to srp_process_cred_req() and srp_process_aer_req(), which read
fixed-size fields from the receive buffer without checking that those
fields were received.
The buffer size is max_ti_iu_len, which comes from the login response
and is not validated. A target that advertises 8 and then sends an
8-byte SRP_CRED_REQ makes the initiator read req->tag from beyond the
end of the buffer. req->tag is copied into the SRP_CRED_RSP and sent
back, s
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
ARM: 9485/1: mm: acquire mmap write lock around show_pte() for user faults
In the Linux kernel, the following vulnerability has been resolved:
ARM: 9485/1: mm: acquire mmap write lock around show_pte() for user faults
When CONFIG_DEBUG_USER=y, and cmdline "user_debug=31" is set,
a user fault may trigger show_pte() without any lock.
If another thread in the same process concurrently calls munmap(),
the page table pages may be freed while show_pte() is still traversing
them, causing a use-after-free in show_pte().
If CONFIG_ARM_LPAE=y, this may cause a kernel panic if the pages table
of PMD are freed when show_pte() is running.
Acquire mmap_write_lock() around show_pte() for user faults to fix the
contention.
For
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
ocfs2: synchronize heartbeat callbacks with o2net teardown
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: synchronize heartbeat callbacks with o2net teardown
Patch series "ocfs2: harden heartbeat teardown races".
This series fixes two OCFS2 heartbeat/o2net teardown races found by
KASAN.
This patch (of 2):
Heartbeat callbacks stay registered while configfs local-node teardown
enters o2net_stop_listening(). A node-down event can still run through
o2net_disconnect_node() and o2net_set_nn_state() while teardown is
destroying o2net_wq, so the later queue/flush operations can hit a dead
workqueue. KASAN has caught this as a slab-use-after-free in
__queue_work() with the
ocfs2: o2hb: quiesce negotiate handlers and timeout work
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: o2hb: quiesce negotiate handlers and timeout work
Heartbeat regions publish struct o2hb_region as the private data for the
NEGO_TIMEOUT and NEGO_APPROVE o2net handlers as soon as make_item()
creates the configfs region. The approve handler can call
o2hb_arm_timeout(), so a peer can touch the region timeout work before
dev_store() has finished building the heartbeat runtime, or after teardown
has started to shut that runtime back down.
The final configfs put also has to keep reg alive until the last in-flight
o2net callback drops its handler reference.
o2net_unregi
In the Linux kernel, the following vulnerability has been resolved:
bpf: Clear buf on error in __bpf_get_task_stack
Both bpf_get_task_stack and bpf_get_task_stack_sleepable helpers that
use __bpf_get_task_stack have buf defined as ARG_PTR_TO_UNINIT_MEM
argument and we should initialize the buf on every return path.
Adding missing buf memset for __bpf_get_task_stack fail paths. This
provides deterministic buffer contents, which is useful when the buffer
is used directly as a map key.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
drm/sun4i: tcon: Drop TCON TOP device reference
In the Linux kernel, the following vulnerability has been resolved:
drm/sun4i: tcon: Drop TCON TOP device reference
of_find_device_by_node() takes a device reference. Drop it after mux
configuration succeeds.
In the Linux kernel, the following vulnerability has been resolved:
drm/sun4i: crtc: Propagate layer initialization error
sun4i_crtc_init() returns plain NULL when layer initialization fails,
while all its other error paths return an error pointer. The only
caller, sun4i_tcon_bind(), checks the result with IS_ERR() and happily
continues with tcon->crtc set to NULL. sun4i_rgb_init() and
sun4i_lvds_init() then dereference it in drm_crtc_mask(), which
oopses.
Return the error pointer instead.