perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
In the Linux kernel, the following vulnerability has been resolved:
perf tools: Use perf_env__get_cpu_topology() in machine__resolve()
machine__resolve() accesses env->cpu[al->cpu].socket_id after checking
al->cpu >= 0 and env->cpu != NULL, but without validating al->cpu
against env->nr_cpus_avail. Since al->cpu comes from the untrusted
perf.data sample, a crafted file with a large CPU index causes an
out-of-bounds heap read.
Use perf_env__get_cpu_topology() which validates both NULL and bounds.
Also bounds-check al->cpu before the cast to struct perf_cpu (int16_t):
without this, values like 65536 silently truncate to 0, bypassing the
acc
In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_nat: reject unsupported target families
xt_nat SNAT and DNAT target handlers assume IP-family conntrack state
is present and can dereference a NULL pointer when instantiated from an
unsupported family through nft_compat. A bridge-family compat rule can
therefore trigger a NULL-dereference in nf_nat_setup_info().
Reject non-IP families in xt_nat_checkentry() so unsupported targets
cannot be installed. Keep NFPROTO_INET allowed for valid inet NAT
compat users and leave the runtime fast path unchanged.
[ The crash was fixed via
9dbba7e694ec ("netfilter: nft_c
mmc: vub300: defer reset until cmd_mutex is unlocked
In the Linux kernel, the following vulnerability has been resolved:
mmc: vub300: defer reset until cmd_mutex is unlocked
vub300_cmndwork_thread() holds cmd_mutex while it sends a command and
waits for the command response. If the response wait times out,
__vub300_command_response() kills the command URBs and then synchronously
resets the USB device through usb_reset_device().
That reset path re-enters the driver through vub300_pre_reset(), which
also takes cmd_mutex. The worker therefore tries to acquire the same
mutex recursively while it is still holding it from the command path.
This issue was found by our static analysis tool and th
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
crypto: ccp - Treat zero-length cert chain as query for blob lengths
In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Treat zero-length cert chain as query for blob lengths
When handling a PDH export, treat a zero-length userspace cert chain buffer
as a request to query the length of the relevant blobs. Failure to account
for the zero-length buffer trips a BUG_ON() when running with
CONFIG_DEBUG_VIRTUAL=y due to trying to get the physical address of the
ZERO_SIZE_PTR (returned by kzalloc() on the bogus allocation).
kernel BUG at arch/x86/mm/physaddr.c:28 !
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
CPU: 30 UID: 0 PID: 28580 Comm: syz.2.18 Kdump: loaded
Tainted
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
media: atomisp: gc2235: fix UAF and memory leak
In the Linux kernel, the following vulnerability has been resolved:
media: atomisp: gc2235: fix UAF and memory leak
gc2235_probe() handles its error paths incorrectly.
If media_entity_pads_init() fails, gc2235_remove() is called, which
tears down the subdev and frees dev, but then still falls through to
atomisp_register_i2c_module(). This results in use-after-free.
If atomisp_register_i2c_module() fails, the media entity and control
handler are left initialized and dev is leaked.
gc2235_remove() unconditionally calls media_entity_cleanup() and
v4l2_ctrl_handler_free(), but these are not initialized at every
error path in gc2235_probe().
firmware: arm_scmi: Fix OOB in scmi_power_name_get()
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Fix OOB in scmi_power_name_get()
scmi_power_name_get() does not validate the domain number passed by the
external caller, which may lead to an out-of-bounds access.
Fix this by returning "unknown" for invalid domains, like
scmi_reset_name_get() does.
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
RDMA/hns: Fix warning in poll cq direct mode
In the Linux kernel, the following vulnerability has been resolved:
RDMA/hns: Fix warning in poll cq direct mode
CQs allocated by ib_alloc_cq() always have a comp_handler. Though
in direct mode this handler is never expected to be called, it
is still called when the driver is reset, triggering the following
WARN_ONCE():
Call trace:
ib_cq_completion_direct+0x38/0x60
hns_roce_cq_completion+0x54/0x90 (hns_roce_hw_v2]
hns_roce_handle_device_err+Ox1c8/0x340 [hns_roce_hw_v2]
hns_roce_hw_v2_uninit_instance.constprop.0+0x34/0x70 [hns_roce_hw_v2]
hns_roce_hw_v2_reset_notify+0xc4/0xe0 [hns_roce_hw_v2]
hclge_notify_roce_client+0x60/0xbc [hclge]
hclge
ipv6: guard against possible NULL deref in __in6_dev_stats_get()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: guard against possible NULL deref in __in6_dev_stats_get()
dev_get_by_index_rcu() could return NULL if the original physical
device is unregistered.
Found by Sashiko.
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
In the Linux kernel, the following vulnerability has been resolved:
rapidio/tsi721: prevent a bad dereference in tsi721_db_dpc()
With a list_for_each() loop, if we don't find the item we are looking for
in the list, then the loop exits with the iterator, which is "dbell" in
this loop, pointing to invalid memory.
This code uses the "found" variable to determine if we have found the
doorbell we are looking for or not. However, the problem that the "found"
variable needs to be set to false at the start of each iteration,
otherwise after the first correct doorbell, then everything is marked as
found.
Reset the "found" to false at the start o
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: don't BUG_ON an invalid journal dinode
[BUG]
A fuzzed OCFS2 image can corrupt the current slot journal dinode while
mount is still in progress. The mount path first reports the invalid
journal block and then crashes in shutdown:
kernel BUG at fs/ocfs2/journal.c:1034!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_journal_toggle_dirty+0x2d6/0x340 fs/ocfs2/journal.c:1034
Call Trace:
ocfs2_journal_shutdown+0x414/0xc30 fs/ocfs2/journal.c:1116
ocfs2_mount_volume fs/ocfs2/super.c:1785 [inline]
ocfs2_fill_super+0x30a9/0x3cd0 fs/ocfs2/super.c:1083
get_t
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
In the Linux kernel, the following vulnerability has been resolved:
netfilter: synproxy: fix unaligned memory access in timestamp adjustment
Use get_unaligned_be32() and put_unaligned_be32() to safely read and
write the timestamp fields. This prevents performance degradation due to
unaligned memory access or even a crash on strict alignment
architectures.
This follows the implementation of timestamp parsing in the networking
stack at tcp_parse_options() and synproxy_parse_options().
wifi: wcn36xx: fix OOB read from short trigger BA firmware response
In the Linux kernel, the following vulnerability has been resolved:
wifi: wcn36xx: fix OOB read from short trigger BA firmware response
The firmware response length is only checked against sizeof(*rsp) (20
bytes), but when candidate_cnt >= 1, a 22-byte candidate struct is read
at buf + 20 without verifying the response contains it. This causes an
out-of-bounds read of stale heap data, corrupting the BA session state.
Add validation that the response includes the candidate data.
net/sched: sch_fq_codel: Do not call qdisc_tree_reduce_backlog during peek before restoring qlen
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_fq_codel: Do not call qdisc_tree_reduce_backlog during peek before restoring qlen
Whenever fq_codel drops packets during peek, it calls
qdisc_tree_reduce_backlog. An issue arises because it calls
qdisc_tree_reduce_backlog before it reincrements the qlen. If qlen drops
to zero, but peek returns an skb, the parent's qlen_notify callback will be
executed even though fq_codel still has 1 packet on the queue and, thus,
will mistakenly deactivate the parent's class causing issues like a recent
report [1] and a wild memory access in qfq:
[ 29.371146][ T360] Oops
ALSA: seq: oss: Serialize readq reset state with q->lock
In the Linux kernel, the following vulnerability has been resolved:
ALSA: seq: oss: Serialize readq reset state with q->lock
snd_seq_oss_readq_clear() resets qlen, head, and tail without
q->lock even though the normal reader and producer paths serialize the
same ring state under that spinlock. A reset can therefore race
snd_seq_oss_readq_free() or snd_seq_oss_readq_put_event() and leave
stale records in the queue, drop freshly queued ones, or report the
wrong readiness after wakeup. KCSAN reports a data race between
snd_seq_oss_readq_clear() and snd_seq_oss_readq_free().
Take q->lock while clearing the ring and resetting input_time. Factor
Nicht bewertetEPSS 0,22%Keine Korrektur veröffentlicht
MIPS: mm: Fix out-of-bounds write in maar_res_walk()
In the Linux kernel, the following vulnerability has been resolved:
MIPS: mm: Fix out-of-bounds write in maar_res_walk()
maar_res_walk() uses wi->num_cfg as the index into the fixed-size
wi->cfg array, but checks whether the array is full only after it has
filled the selected entry. If walk_system_ram_range() reports more than
16 memory ranges, the overflow call writes one struct maar_config past
the end of the array before WARN_ON() prevents num_cfg from advancing.
Move the full-array check before taking the array slot and return non-zero
when the scratch array is full, so walk_system_ram_range() terminates the
walk instead of invoking th
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
In the Linux kernel, the following vulnerability has been resolved:
powerpc/perf: fix preempt count underflow in fsl_emb_pmu_del
fsl_emb_pmu_del() unconditionally calls put_cpu_var(cpu_hw_events) at
the 'out:' label, but only calls the matching get_cpu_var() after the
'i < 0' early-return check. When event->hw.idx is negative the
function jumps to 'out:' without having taken get_cpu_var(), and the
trailing put_cpu_var() then issues an unmatched preempt_enable(),
underflowing preempt_count.
On a CONFIG_PREEMPT=y kernel preempt_count would underflow and
eventually present as a 'scheduling while atomic' BUG.
Move put_cpu_var() to pair with g
char: tlclk: fix use-after-free in tlclk_cleanup()
In the Linux kernel, the following vulnerability has been resolved:
char: tlclk: fix use-after-free in tlclk_cleanup()
This patch improves the module cleanup process in the tlclk driver to
prevent potential use-after-free and race conditions.
Currently, the file_operations structure does not specify the .owner
field, which could allow the module to be unloaded while user-space
processes are still interacting with the device. Additionally, the
tlclk_cleanup() function frees the alarm_events memory before ensuring
that blocked processes in the waitqueue are fully awakened and that the
switchover_timer has completed.
To address these cases,
apparmor: fix potential UAF in aa_replace_profiles
In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix potential UAF in aa_replace_profiles
The function aa_replace_profiles was accessing udata->size after calling
aa_put_loaddata(udata), causing a potential UAF.
Fixed this by saving the size to a local variable before dropping the
reference.
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
In the Linux kernel, the following vulnerability has been resolved:
ieee802154: Avoid calling WARN_ON() on -ENOMEM in cfg802154_switch_netns()
It's pointless to call WARN_ON() in case of an allocation failure in
dev_change_net_namespace() and device_rename(), since it only leads to
useless splats caused by deliberate fault injections, so avoid it.
Found by Linux Verification Center (linuxtesting.org) with Syzkaller.
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
In the Linux kernel, the following vulnerability has been resolved:
ACPI: processor_idle: Mark LPI enter functions as __cpuidle
When function tracing or Kprobes is enabled, entering an ACPI Low
Power Idle (LPI) state triggers the following RCU splat:
RCU not on for: acpi_idle_lpi_enter+0x4/0xd8
WARNING: CPU: 8 PID: 0 at include/linux/trace_recursion.h:162 function_trace_call+0x1e8/0x228
The acpi_idle_lpi_enter() function is invoked within the cpuidle
path after RCU has already been disabled for the current local CPU.
Consequently, ftrace's function_trace_call() expects RCU to be
actively watching before recording trace data, emitting