In the Linux kernel, the following vulnerability has been resolved:
RDMA/umem: Fix truncation for block sizes >= 4G
When the iommu is used the linearization of the mapping can give a single
block that is very large split across multiple SG entries.
When __rdma_block_iter_next() reassembles the split SG entries it is
overflowing the 32 bit stack values and computed the wrong DMA addresses
for blocks after the truncation.
Use the right types to hold DMA addresses.
netfilter: require Ethernet MAC header before using eth_hdr()
In the Linux kernel, the following vulnerability has been resolved:
netfilter: require Ethernet MAC header before using eth_hdr()
`ip6t_eui64`, `xt_mac`, the `bitmap:ip,mac`, `hash:ip,mac`, and
`hash:mac` ipset types, and `nf_log_syslog` access `eth_hdr(skb)`
after either assuming that the skb is associated with an Ethernet
device or checking only that the `ETH_HLEN` bytes at
`skb_mac_header(skb)` lie between `skb->head` and `skb->data`.
Make these paths first verify that the skb is associated with an
Ethernet device, that the MAC header was set, and that it spans at
least a full Ethernet header before accessing `eth_hdr(skb)`.
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
In the Linux kernel, the following vulnerability has been resolved:
fs/omfs: reject s_sys_blocksize smaller than OMFS_DIR_START
omfs_fill_super() rejects oversized s_sys_blocksize values (> PAGE_SIZE),
but it does not reject values smaller than OMFS_DIR_START (0x1b8 = 440).
Later, omfs_make_empty() uses
sbi->s_sys_blocksize - OMFS_DIR_START
as the length argument to memset(). Since s_sys_blocksize is u32,
a crafted filesystem image with s_sys_blocksize < OMFS_DIR_START causes
an unsigned underflow there, wrapping to a value near 2^32. That drives
a ~4 GiB memset() from bh->b_data + OMFS_DIR_START and overwrites kernel
memory far be
fs/mbcache: cancel shrink work before destroying the cache
In the Linux kernel, the following vulnerability has been resolved:
fs/mbcache: cancel shrink work before destroying the cache
mb_cache_destroy() calls shrinker_free() and then frees all cache
entries and the cache itself, but it does not cancel the pending
c_shrink_work work item first.
If mb_cache_entry_create() schedules c_shrink_work via schedule_work()
and the work item is still pending or running when mb_cache_destroy()
runs, mb_cache_shrink_worker() will access the cache after its memory
has been freed, causing a use-after-free.
This is only reachable by a privileged user (root or CAP_SYS_ADMIN)
who can trigger the last put of a mo
drbd: Balance RCU calls in drbd_adm_dump_devices()
In the Linux kernel, the following vulnerability has been resolved:
drbd: Balance RCU calls in drbd_adm_dump_devices()
Make drbd_adm_dump_devices() call rcu_read_lock() before
rcu_read_unlock() is called. This has been detected by the Clang
thread-safety analyzer.
btrfs: fix deadlock between reflink and transaction commit when using flushoncommit
In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix deadlock between reflink and transaction commit when using flushoncommit
When using the flushoncommit mount option, we can have a deadlock between
a transaction commit and a reflink operation that copied an inline extent
to an offset beyond the current i_size of the destination node.
The deadlock happens like this:
1) Task A clones an inline extent from inode X to an offset of inode Y
that is beyond Y's current i_size. This means we copied the inline
extent's data to a folio of inode Y that is beyond its EOF, using a
call to copy_inline_to_page();
2)
In the Linux kernel, the following vulnerability has been resolved:
PCI: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
s390/cio: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
s390/cio: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
bus: fsl-mc: use generic driver_override infrastructure
In the Linux kernel, the following vulnerability has been resolved:
bus: fsl-mc: use generic driver_override infrastructure
When a driver is probed through __driver_attach(), the bus' match()
callback is called without the device lock held, thus accessing the
driver_override field without a lock, which can cause a UAF.
Fix this by using the driver-core driver_override infrastructure taking
care of proper locking internally.
Note that calling match() from __driver_attach() without the device lock
held is intentional. [1]
wifi: rtlwifi: pci: fix possible use-after-free caused by unfinished irq_prepare_bcn_tasklet
In the Linux kernel, the following vulnerability has been resolved:
wifi: rtlwifi: pci: fix possible use-after-free caused by unfinished irq_prepare_bcn_tasklet
The irq_prepare_bcn_tasklet is initialized in rtl_pci_init() and
scheduled when RTL_IMR_BCNINT interrupt is triggered by hardware.
But it is never killed in rtl_pci_deinit(). When the rtlwifi card
probe fails or is being detached, the ieee80211_hw is deallocated.
However, irq_prepare_bcn_tasklet may still be running or pending,
leading to use-after-free when the freed ieee80211_hw is accessed
in _rtl_pci_prepare_bcn_tasklet().
Similar to irq_tasklet, add tasklet_kill() in rtl_pci_d
bpf: test_run: Fix the null pointer dereference issue in bpf_lwt_xmit_push_encap
In the Linux kernel, the following vulnerability has been resolved:
bpf: test_run: Fix the null pointer dereference issue in bpf_lwt_xmit_push_encap
The bpf_lwt_xmit_push_encap helper needs to access skb_dst(skb)->dev to
calculate the needed headroom:
err = skb_cow_head(skb,
len + LL_RESERVED_SPACE(skb_dst(skb)->dev));
But skb->_skb_refdst may not be initialized when the skb is set up by
bpf_prog_test_run_skb function. Executing bpf_lwt_push_ip_encap function
in this scenario will trigger null pointer dereference, causing a kernel
crash as Yinhao reported:
[ 105.186365] BUG: kernel NULL pointer dereference, address: 0000000000000
powerpc/64s: Fix unmap race with PMD migration entries
In the Linux kernel, the following vulnerability has been resolved:
powerpc/64s: Fix unmap race with PMD migration entries
The following race is possible with migration swap entries or
device-private THP entries. e.g. when move_pages is called on a PMD THP
page, then there maybe an intermediate state, where PMD entry acts as
a migration swap entry (pmd_present() is true). Then if an munmap
happens at the same time, then this VM_BUG_ON() can happen in
pmdp_huge_get_and_clear_full().
This patch fixes that.
Thread A: move_pages() syscall
add_folio_for_migration()
mmap_read_lock(mm)
folio_isolate_lru(folio)
mmap_read_unlock(mm)
wifi: libertas: don't kill URBs in interrupt context
In the Linux kernel, the following vulnerability has been resolved:
wifi: libertas: don't kill URBs in interrupt context
Serialization for the TX path was enforced by calling
usb_kill_urb()/usb_kill_anchored_urbs(), to prevent transmission before
a previous URB was completed. usb_tx_block() can be called from
interrupt context (e.g. in the HCD giveback path), so we can't always
use it to kill in-flight URBs.
Prevent sleeping during interrupt context by checking the tx_submitted
anchor for existing URBs. We now return -EBUSY, to indicate there's
a pending request.
In the Linux kernel, the following vulnerability has been resolved:
bpf: Do not allow deleting local storage in NMI
Currently, local storage may deadlock when deferring freeing selem or
local storage through kfree_rcu(), call_rcu() or call_rcu_tasks_trace()
in NMI or reentrant. Since deleting selem in NMI is an unlikely use
case, partially mitigate it by returning error when calling from
bpf_xxx_storage_delete() helpers in NMI. Note that, it is still possible
to deadlock through reentrant. A full mitigation requires returning
error when irqs_disabled() is true, which, however is too heavy-handed
for bpf_xxx_storage_delete().
The long-term
bpf: Use RCU-safe iteration in dev_map_redirect_multi() SKB path
In the Linux kernel, the following vulnerability has been resolved:
bpf: Use RCU-safe iteration in dev_map_redirect_multi() SKB path
The DEVMAP_HASH branch in dev_map_redirect_multi() uses
hlist_for_each_entry_safe() to iterate hash buckets, but this function
runs under RCU protection (called from xdp_do_generic_redirect_map()
in softirq context). Concurrent writers (__dev_map_hash_update_elem,
dev_map_hash_delete_elem) modify the list using RCU primitives
(hlist_add_head_rcu, hlist_del_rcu).
hlist_for_each_entry_safe() performs plain pointer dereferences without
rcu_dereference(), missing the acquire barrier needed to pair with
writers' r
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: Fix error pointer dereference
The function brcmf_chip_add_core() can return an error pointer and is
not checked. Add checks for error pointer.
Detected by Smatch:
drivers/net/wireless/broadcom/brcm80211/brcmfmac/chip.c:1010 brcmf_chip_recognition() error:
'core' dereferencing possible ERR_PTR()
drivers/net/wireless/broadcom/brcm80211/brcmfmac/chip.c:1013 brcmf_chip_recognition() error:
'core' dereferencing possible ERR_PTR()
drivers/net/wireless/broadcom/brcm80211/brcmfmac/chip.c:1016 brcmf_chip_recognition() error:
'core' dereferencing possible ERR_PTR()
In the Linux kernel, the following vulnerability has been resolved:
net: pull headers in qdisc_pkt_len_segs_init()
Most ndo_start_xmit() methods expects headers of gso packets
to be already in skb->head.
net/core/tso.c users are particularly at risk, because tso_build_hdr()
does a memcpy(hdr, skb->data, hdr_len);
qdisc_pkt_len_segs_init() already does a dissection of gso packets.
Use pskb_may_pull() instead of skb_header_pointer() to make
sure drivers do not have to reimplement this.
Some malicious packets could be fed, detect them so that we can
drop them sooner with a new SKB_DROP_REASON_SKB_BAD_GSO drop_reason.
bpf: Fix ld_{abs,ind} failure path analysis in subprogs
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix ld_{abs,ind} failure path analysis in subprogs
Usage of ld_{abs,ind} instructions got extended into subprogs some time
ago via commit 09b28d76eac4 ("bpf: Add abnormal return checks."). These
are only allowed in subprograms when the latter are BTF annotated and
have scalar return types.
The code generator in bpf_gen_ld_abs() has an abnormal exit path (r0=0 +
exit) from legacy cBPF times. While the enforcement is on scalar return
types, the verifier must also simulate the path of abnormal exit if the
packet data load via ld_{abs,ind} failed.
This is currently not t
bpf: Fix use-after-free in offloaded map/prog info fill
In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix use-after-free in offloaded map/prog info fill
When querying info for an offloaded BPF map or program,
bpf_map_offload_info_fill_ns() and bpf_prog_offload_info_fill_ns()
obtain the network namespace with get_net(dev_net(offmap->netdev)).
However, the associated netdev's netns may be racing with teardown
during netns destruction. If the netns refcount has already reached 0,
get_net() performs a refcount_t increment on 0, triggering:
refcount_t: addition on 0; use-after-free.
Although rtnl_lock and bpf_devs_lock ensure the netdev pointer remains
valid, they canno
net: bcmgenet: fix off-by-one in bcmgenet_put_txcb
In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: fix off-by-one in bcmgenet_put_txcb
The write_ptr points to the next open tx_cb. We want to return the
tx_cb that gets rewinded, so we must rewind the pointer first then
return the tx_cb that it points to. That way the txcb can be correctly
cleaned up.