PatchFirst · Aktuelle Sicherheitslücken
In den letzten 30 Tagen veröffentlichte Sicherheitslücken für linux-aws-fips: 759. Davon im KEV-Katalog: 0.
Sicherheitslücken: 7618
In the Linux kernel, the following vulnerability has been resolved: phy: sunplus: fix error handling in sp_uphy_init() Fix the error paths of sp_uphy_init() to undo exactly what each stage did: return directly if clk_prepare_enable() fails, release only the clock if reset_control_deassert() fails, and jump to err_reset if update_disc_vol() fails so the clock and reset are not leaked.
In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu/gfx6: Use PFP on the compute queues too On GFX6, the compute rings use the same CP path as the graphics ring. The only difference is that they don't support draw commands. (As opposed to GFX7 and newer which have a separate command parser that is called MEC for compute queues.) This means that we have to take into consideration that the PFP also exists on compute queues on GFX6: Use PFP for register writes on both graphics and compute queues. In the pipeline sync, use the PFP to wait for the previous fence (and not the ME) to prevent the PFP from starting to e
In the Linux kernel, the following vulnerability has been resolved: scsi: qla2xxx: Remove redundant VPD flash read in sysfs read path qla2x00_sysfs_read_vpd() called ha->isp_ops->read_optrom() a second time after releasing optrom_mutex. The repeated read is redundant and, unlike the first, runs without optrom_mutex held, exposing flash access to concurrent optrom operations. Drop the duplicate call.
In the Linux kernel, the following vulnerability has been resolved: firmware_loader: do not queue completed sysfs fallback requests fw_load_sysfs_fallback() calls device_add() before adding the fw_priv to pending_fw_head. device_add() publishes the fallback loading interface, so a userspace helper which discovers the device by scanning sysfs can write 0 to the loading attribute and complete the request before it is queued as pending. In that interleaving firmware_loading_store() calls fw_state_done() while pending_list still points to itself, so it cannot remove an entry from pending_fw_head. The subsequent unconditional list_add() then qu
In the Linux kernel, the following vulnerability has been resolved: hugetlbfs: release subpool on fill_super failure hugetlbfs_fill_super() allocates a hugepage subpool when size or min_size mount options are specified. hugepage_new_subpool() may also reserve huge pages for min_size. If root dentry creation fails after the subpool is created, the failure path frees the subpool with kfree(). This bypasses hugepage_put_subpool() and can leave min_size reservations charged. Use hugepage_put_subpool() on the failure path, matching the normal put_super path.
In the Linux kernel, the following vulnerability has been resolved: phy: qcom: qmp-usb-legacy: Fix possible NULL-deref on early runtime suspend There is a small window where the runtime suspend callback may run after pm_runtime_enable() and before pm_runtime_forbid(). In this case, a crash occurs because runtime suspend/resume dereferences qmp->phy pointer, which is not yet initialized: `if (!qmp->phy->init_count) {` This can also happen if user re-enables runtime-pm via the sysfs attribute before qmp phy is initialized. Similarly to other qcom phy drivers, introduce a qmp->phy_initialized variable that can be used to avoid relyin
In the Linux kernel, the following vulnerability has been resolved: phy: qcom: snps-femto-v2: Fix possible NULL-deref on early runtime suspend Runtime PM must be enabled before creating the PHY, since phy_create() only enables runtime PM on the PHY device if it is already enabled on this parent device. However, the runtime PM callbacks dereference the hsphy instance, which is not yet ready, leaving a window where a suspend callback may trigger a NULL pointer dereference. Take a runtime PM usage reference with pm_runtime_get_noresume() before enabling runtime PM and release it once the PHY has been created, so that no runtime suspend can ru
In the Linux kernel, the following vulnerability has been resolved: phy: qcom: qmp-usb: Fix possible NULL-deref on early runtime suspend There is a small window where the runtime suspend callback may run after pm_runtime_enable() and before pm_runtime_forbid(). In this case, a crash occurs because runtime suspend/resume dereferences qmp->phy pointer, which is not yet initialized: `if (!qmp->phy->init_count) {` This can also happen if user re-enables runtime-pm via the sysfs attribute before qmp phy is initialized. Similarly to other qcom phy drivers, introduce a qmp->phy_initialized variable that can be used to avoid relying on th
In the Linux kernel, the following vulnerability has been resolved: md/raid5: round bitmap stripes with sector division raid5_bitmap_sector_map() aligns the array range to full RAID5 stripe widths before converting it to component sectors. That width is chunk_sectors multiplied by the number of data disks, and it is not always a power of two. Reproduce with a 4-disk RAID5, 1024-sector chunks, and three data disks. The full-stripe width is 3072 sectors. For a one-sector write at array sector 3072, correct rounding gives array range [3072, 6144), which maps to component range [1024, 2048). The old round_down()/round_up() logic instead gives
In the Linux kernel, the following vulnerability has been resolved: md/raid1: don't set array_frozen in raid1_takeover() raid1_takeover() sets conf->array_frozen = 1 on the newly-allocated r1conf and nothing ever clears it, so every I/O to the array stalls permanently once _wait_barrier() sees it stuck at 1. This used to be harmless: level_store() called mddev_resume() right after pers->run(), which called raid1_quiesce(mddev, 0) and cleared array_frozen back to 0 regardless of what raid1_takeover() set. Commit b39f35ebe86d ("md: don't quiesce in mddev_suspend()") removed that quiesce(mddev, 0) call, so the pre-set now sticks. setup_conf(
In the Linux kernel, the following vulnerability has been resolved: coresight: etm4x: fix underflow for usage of (nrseqstate - 1) According to IHI006H Embedded Trace Macrocell Architecture Specification[0], TRCSEQEVR<n> is implemented only when TRCIDR5.NUMSEQSTATE is 0b100, in which case n ranges from 0 to 2; otherwise, TRCIDR5.NUMSEQSTATE is 0b000. IOW, the number of usage in the initialisation or setting TRCSEQEVR<n> with drvdata->nrseqstate - 1 in the loop could make underflow issue when TRCIDR5.NUMSEQSTATE is 0b000. Therefore, introduce nr_seq_ctrls field and untie it from nrseqstate. As part of this introduce ETM_MAX_SEQ_TRANSITIONS
In the Linux kernel, the following vulnerability has been resolved: coresight: etm4x: missing cscfg_csdev_disable_active_config() in perf enable In the perf enable path, there are missing cases where cscfg_csdev_disable_active_config() is not called: - Branch broadcast is selected but not supported by the hardware - etm4_enable_hw() fails This can lead to a leak of config_desc->active_cnt. Fix this by properly calling cscfg_csdev_disable_active_config() in these error paths.
In the Linux kernel, the following vulnerability has been resolved: scsi: sd: Fix special_vec mempool leak when scsi_alloc_sgtables() fails sd_set_special_bvec() allocates a special payload page for UNMAP and WRITE SAME commands. If scsi_alloc_sgtables() fails afterward in sd_setup_unmap_cmnd() or sd_setup_write_same{10,16}_cmnd(), the SCSI midlayer does not call uninit_command() because RQF_DONTPREP is not set yet, leaking the page. Call sd_uninit_command() on error, and clear RQF_SPECIAL_PAYLOAD after freeing the page.
In the Linux kernel, the following vulnerability has been resolved: btrfs: defrag: fix deadlock between defrag and delalloc space reservation While running fsstress with autodefrag and flushoncommit, hit a deadlock due to the fact that defrag reserves delalloc space while it's holding dirty and locked folios, besides the extent range lock. The stack traces are the following: [958.624] task:kworker/u50:3 state:D stack:0 pid:20365 tgid:20365 ppid:2 task_flags:0x4208060 flags:0x00080000 [958.626] Workqueue: events_unbound btrfs_async_reclaim_metadata_space [btrfs] [958.627] Call Trace: [958.628] <TASK> [958.628] __
In the Linux kernel, the following vulnerability has been resolved: btrfs: check if root is readonly when setting posix acl For a filesystem which has btrfs read-only property set to true, all write operations including acl and xattr should be denied. However, acl can still be set even if btrfs ro property is true. This happens because no function on the set_acl code path checks the root is readonly or not. It was checked in btrfs_setxattr_trans() but got removed in commit 353c2ea735e4 ("btrfs: remove redundant readonly root check in btrfs_setxattr_trans") That commit didn't check if all the callers properly check the root's read-only fla
In the Linux kernel, the following vulnerability has been resolved: btrfs: retry verity reads for not-uptodate Merkle folios btrfs_read_merkle_tree_page() can find a folio in the mapping that is not uptodate. After taking the folio lock, the current code treats that state as a read error and returns -EIO. That can make a previous transient read failure sticky. If the failed read left a not-uptodate folio in the mapping, later callers find that folio and fail instead of retrying the read. Keep the existing page-cache insertion and locking order, but retry the Merkle item read when a not-uptodate folio is found in the mapping. Also unloc
In the Linux kernel, the following vulnerability has been resolved: btrfs: zoned: flush active metadata block group at btree_writepages() start btree_writepages() writes the btree inode's dirty metadata in ascending logical address order. On a zoned filesystem only one metadata and one system block group is active for writing at a time, and check_bg_is_active() (via btrfs_check_meta_write_pointer()) pivots the active block group as writeback moves from one block group to the next. If the active block group sits at a higher logical address than another block group that also holds dirty metadata, the ascending walk reaches the lower one firs
In the Linux kernel, the following vulnerability has been resolved: btrfs: zoned: don't clobber the extent buffer when zeroing it out On a zoned filesystem a freed-but-still-dirty tree block is written out as zeros (EXTENT_BUFFER_ZONED_ZEROOUT) only to keep the zone write pointer advancing. btree_csum_one_bio() implemented this by memzeroing the extent buffer's own folios before submission. That destroys the in-memory buffer while it may still be referenced. In particular btrfs_free_tree_block() can run on it afterwards and reads the header to add a delayed reference; once the header has been zeroed it frees bytenr 0 and corrupts the exten
In the Linux kernel, the following vulnerability has been resolved: btrfs: qgroup: fix a wrong length calculation in qgroup_free_reserved_data() In that function, we round down the start position and round up the ending position. But during the calculation of @len, we use "round_up(start + len, sectorsize)", which is the rounded up end position, not the rounded up length. Which results a much larger length, and later we are still using "start + len", which is completely incorrect. Fix it by declaring a local @aligned_start and @aligned_len and use them instead.
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: virtio_bt: avoid OOB read of build info string The virtbt_setup_zephyr() sends the Zephyr vendor command 0xfc08 (Read Build Information) and hands the response to bt_dev_info() and hci_set_fw_info() as a "%s" string starting at skb->data + 1, without checking the length. A backend that answers with status only leaves that pointer past the end of the received data, so the walk reads adjacent slab memory until it meets a NUL. Those bytes reach the kernel log and the firmware-info debugfs file. To fix this, print the string with a bounded "%.*s" limited to skb->len
Gleichen Sie Ihren installierten Stack und seine Versionen mit den aktuellen Sicherheitsmeldungen ab.