In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: Fix advertising data UAFs
hci_find_adv_instance() returns an adv_info pointer that is valid only
while hdev->lock is held. The advertising command-sync paths perform
instance lookups without that lock and, in some cases, retain the pointer
while waiting for a controller response.
An advertising termination event can therefore interleave as follows:
hci_cmd_sync_work hci_rx_work
hci_find_adv_instance()
__hci_cmd_sync_status()
wait for controller reply hci_dev_lock()
hci_remove_adv_ins
Bluetooth: HIDP: reject frames without a transaction header
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: reject frames without a transaction header
hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0]
before checking that the L2CAP SDU contains a transaction header. A
connected HIDP peer can send an empty basic-mode SDU and make both paths
use an uninitialized byte from skb tailroom.
KMSAN reports the use in hidp_session_run(), with the uninitialized value
originating in __alloc_skb() through vhci_write(). The control path
produces two reports and the interrupt path produces one.
The byte can also be controlled by a malformed lower-layer packe
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: validate numbered report payloads
When hidp_get_raw_report() waits for a numbered report,
hidp_process_data() compares the expected report number with skb->data[0].
A connected HIDP peer can reply with only a DATA transaction header,
leaving the skb empty after the header is removed.
KMSAN reports an uninitialized-value use in hidp_session_run(), with the
value originating in __alloc_skb() through vhci_write(). The transaction
header checks remove the empty-frame reports, but this report remains until
the payload check is added.
The comparison can also co
In the Linux kernel, the following vulnerability has been resolved:
afs: Fix UAF when sending a message
In afs_make_call(), there's a race with async call reception and
destruction. If a call is dispatched that doesn't have call->write_iter
set (used to specify the data content for FS.StoreData), then the first
rxrpc_kernel_send_data() will not set MSG_MORE in the msghdr.
Once rxrpc_send_data() queues the last request packet, the response could
come in at any time and cause the call to be completed and put. However,
afs_make_call() will look at the call again to see it ->write_iter should
be handled - something it's only allowed to do if
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
ALSA: 6fire: Fix UAF at error handling during probe
In the Linux kernel, the following vulnerability has been resolved:
ALSA: 6fire: Fix UAF at error handling during probe
Although 6fire driver had a few fixes for dealing with the early error
handling during the probe phase, it forgot a pending URB before
freeing the resources, which may lead to a UAF.
This patch addresses it by doing the almost same cleanup procedure
like the normal disconnect phase at the error path.
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
ALSA: ump: fix double free of out_cvts on rawmidi error
In the Linux kernel, the following vulnerability has been resolved:
ALSA: ump: fix double free of out_cvts on rawmidi error
snd_ump_attach_legacy_rawmidi() allocates the legacy conversion array
ump->out_cvts and, on the snd_rawmidi_new() error path, frees it with
kfree() but leaves ump->out_cvts pointing at the freed memory. When the
endpoint is later torn down, snd_ump_endpoint_free() frees ump->out_cvts
a second time, resulting in a double free.
The host snd-usb-audio driver attaches the legacy rawmidi for any USB
MIDI 2.0 (UMP) device, so a device that makes snd_rawmidi_new() fail
reaches this path on enumeration.
Clear ump->out_cvts
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
ALSA: usb-audio: fix use-after-free in ump_to_endpoint()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix use-after-free in ump_to_endpoint()
create_midi2_ump() registers a card-owned snd_ump_endpoint and stores a
back-pointer to its per-interface snd_usb_midi2_ump object in
ump->private_data, but it never installs an ump->private_free hook and
never clears that pointer.
If a later step of snd_usb_midi_v2_create() fails, its error path calls
free_all_midi2_umps(), which kfree()s the snd_usb_midi2_ump object while
the already-registered endpoint keeps pointing at it. The created
/dev/snd/umpC*D* node stays exposed, so the first operation of any UMP
open, u
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
ALSA: usb-audio: fix stack info leak in RME Digiface status
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix stack info leak in RME Digiface status
snd_rme_digiface_read_status() reads a four-word status block from the
device into an uninitialised on-stack __le32 buf[4] and, whenever the
vendor control-IN transfer does not return a negative error, copies all
four words into the caller's status[].
snd_usb_ctl_msg() copies the full requested size back into the caller's
buffer regardless of how many bytes the data stage actually delivered:
buf = kmemdup(data, size, GFP_KERNEL);
err = usb_control_msg(dev, pipe, request, requesttype,
value, index, buf,
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()
snd_usbmidi_akai_output() computes its fill-loop bound
buf_end = ep->max_transfer - MAX_AKAI_SYSEX_LEN - 1;
as a signed int, so a small device-advertised bulk-OUT max_transfer
makes buf_end negative. The loop guard then compares the u32
urb->transfer_buffer_length against that negative int: the usual
arithmetic conversion turns buf_end into a large unsigned value, so the
guard stays true and each iteration keeps appending SysEx framing and
payload bytes past the end of the URB transfer buffer, which is only
max
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set
When a USB audio endpoint requests full packet transfers via the fill_max
descriptor flag, data_ep_set_params() promotes ep->curpacksize to
ep->maxpacksize. However, maxsize is left at the original sample-rate
derived value.
Since u->buffer_size is allocated as maxsize * packets, the resulting
DMA buffer is far too small for the requested transfer length. When the
USB host controller streams up to curpacksize bytes per packet, it writes
past the end of the buffer via DMA, corrupting kernel heap memory
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Clamp frame size in implicit-feedback mode
snd_usb_handle_sync_urb() scales received sync packet sizes by the sender's
stride and stores the result directly in out_packet->packet_size[i]. If a
connected USB device sends an oversized sync packet, this frame count can
exceed ep->maxframesize.
The un-clamped frame count then propagates to the playback endpoint queue,
potentially driving packet transfers beyond the endpoint's hardware frame
limits.
Cap the calculated frame count against ep->maxframesize in
snd_usb_handle_sync_urb() to prevent oversized packet
In the Linux kernel, the following vulnerability has been resolved:
fou: Fix use-after-free in fou_create()
fou_create() publishes struct fou through sk_user_data before adding the
new FOU port to the per-netns list. If fou_add_to_port_list() fails,
the error path frees fou while it is still reachable through
sk_user_data. A concurrent receive can then dereference the freed
object in fou_from_sock().
This ordering issue was previously noted in the linked discussion.
The failure is reachable when local port 0 is requested. Each socket
binds to a different ephemeral port, but fou_cfg_cmp() compares the
requested port 0 and reports -EALRE
In the Linux kernel, the following vulnerability has been resolved:
igbvf: Fix leak in TX DMA error cleanup
If an error is encountered while mapping TX buffers, the driver should
unmap any buffers already mapped for that skb.
Because count is incremented before each frag mapping, it will always
match the correct number of unmappings needed when dma_error is reached.
Decrementing count before the while loop in dma_error causes an
off-by-one error. If any mapping was successful before an unsuccessful
mapping, exactly one DMA mapping (the head) would leak.
This bug was introduced by a 2010 fix for an endless loop in dma_error.
All other affe
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
ksmbd: reject repeated SMB2 NEGOTIATE requests
In the Linux kernel, the following vulnerability has been resolved:
ksmbd: reject repeated SMB2 NEGOTIATE requests
Unauthenticated client can send multiple successful SMB2 NEGOTIATE
requests on one connection before SESSION_SETUP. While the connection is
in KSMBD_SESS_NEED_SETUP, smb2_handle_negotiate() accepts another
SMB3.1.1 NEGOTIATE and overwrites conn->preauth_info with a new allocation.
Only the final allocation is freed when the connection is released, leaking
one object for every additional successful request.
A repeated SMB2 NEGOTIATE after a dialect has been selected is a protocol
violation. MS-SMB2 section 3.3.5.4 requires the
net/smc: fix socket use-after-free during link group termination
In the Linux kernel, the following vulnerability has been resolved:
net/smc: fix socket use-after-free during link group termination
__smc_lgr_terminate() drops conns_lock after finding a connection in
lgr->conns_all, but before taking a reference on its socket. The connection
is embedded in the socket, and its registration reference protects it only
while the connection remains in the tree.
A concurrent close can unregister the connection and drop that reference,
freeing the socket before the termination worker reaches sock_hold().
The race is reachable when close overlaps link group termination.
Local stress testing reproduced the use-a
netfilter: ipset: do not update comments from kernel-side hash adds
In the Linux kernel, the following vulnerability has been resolved:
netfilter: ipset: do not update comments from kernel-side hash adds
mtype_resize() copies comment pointers with memcpy(), not the comment
objects themselves. During the window after an entry has been copied but
before the table swap and backlog replay, the old table is still
published for packet-side updates while the replacement-table entry
already holds the same ip_set_comment_rcu pointer.
If xt_SET --add-set ... --exist hits that old entry in this window,
mtype_add() calls ip_set_init_comment() even though packet-side adds
carry no comment payload. That call frees the s
tipc: avoid use-after-free in poll trace queue dumps
In the Linux kernel, the following vulnerability has been resolved:
tipc: avoid use-after-free in poll trace queue dumps
TIPC socket tracepoints dump queue state through tipc_sk_dump(). Most
queue-dump callsites already serialize that walk under the socket lock or
sk->sk_lock.slock, but tipc_poll() calls trace_tipc_sk_poll(...,
TIPC_DUMP_ALL, ...) without holding either lock.
That lets the poll trace path reach tipc_list_dump() and backlog head/tail
dumping while another context dequeues and frees an skb, leaving the trace
helper dereferencing a stale queue entry.
Stop the unlocked poll trace site from requesting queue dumps. Other queue
wifi: mwifiex: use the subframe length when parsing A-MSDU TDLS frames
In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: use the subframe length when parsing A-MSDU TDLS frames
mwifiex_11n_dispatch_amsdu_pkt() splits an A-MSDU with
ieee80211_amsdu_to_8023s() and walks the resulting subframes. For each
subframe it passes the subframe data pointer to
mwifiex_process_tdls_action_frame(), but pairs it with skb->len, the
length of the A-MSDU parent, instead of rx_skb->len:
rx_skb = __skb_dequeue(&list);
rx_hdr = (struct rx_packet_hdr *)rx_skb->data;
if (ISSUPP_TDLS_ENABLED(priv->adapter->fw_cap_info) &&
ntohs(rx_hdr->eth803_hdr.h_proto) == ETH_P_TDLS) {
mwifiex_process_td
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
binfmt_misc: restore write access when removing an entry
In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: restore write access when removing an entry
Registering an entry with the MISC_FMT_OPEN_FILE flag opens the
interpreter via open_exec() which denies write access to it for as
long as the entry exists. Removing the entry closes the interpreter
file via filp_close() but never restores write access, leaving the
inode's i_writecount permanently negative. Opening the interpreter
for writing keeps failing with ETXTBSY long after the entry is gone
until the inode is evicted from the inode cache.
Commit 90f601b497d7 ("binfmt_misc: restore write access before
closing f
binfmt_misc: reject a flag character as the field delimiter
In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: reject a flag character as the field delimiter
The registration string starts with a user chosen delimiter that
separates the individual fields. So that the field parsers terminate
even on a truncated string create_entry() pads the buffer with that
same delimiter:
memset(buf + count, del, 8);
Most fields are scanned for the delimiter with strchr()/scanarg() and
happily stop on the padding. The flags field is different: instead of
scanning for the delimiter check_special_flags() consumes the flag
characters 'P', 'O', 'C' and 'F' and stops at the first byte th