xhci: Handle TD clearing for multiple streams case
In the Linux kernel, the following vulnerability has been resolved:
xhci: Handle TD clearing for multiple streams case
When multiple streams are in use, multiple TDs might be in flight when
an endpoint is stopped. We need to issue a Set TR Dequeue Pointer for
each, to ensure everything is reset properly and the caches cleared.
Change the logic so that any N>1 TDs found active for different streams
are deferred until after the first one is processed, calling
xhci_invalidate_cancelled_tds() again from xhci_handle_cmd_set_deq() to
queue another command until we are done with all of them. Also change
the error/"should never happen" paths to ens
drm/exynos: hdmi: report safe 640x480 mode as a fallback when no EDID found
In the Linux kernel, the following vulnerability has been resolved:
drm/exynos: hdmi: report safe 640x480 mode as a fallback when no EDID found
When reading EDID fails and driver reports no modes available, the DRM
core adds an artificial 1024x786 mode to the connector. Unfortunately
some variants of the Exynos HDMI (like the one in Exynos4 SoCs) are not
able to drive such mode, so report a safe 640x480 mode instead of nothing
in case of the EDID reading failure.
This fixes the following issue observed on Trats2 board since commit
13d5b040363c ("drm/exynos: do not return negative values from .get_modes()"):
[drm] Exynos DRM: using 11c0000
wifi: mac80211: Fix deadlock in ieee80211_sta_ps_deliver_wakeup()
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: Fix deadlock in ieee80211_sta_ps_deliver_wakeup()
The ieee80211_sta_ps_deliver_wakeup() function takes sta->ps_lock to
synchronizes with ieee80211_tx_h_unicast_ps_buf() which is called from
softirq context. However using only spin_lock() to get sta->ps_lock in
ieee80211_sta_ps_deliver_wakeup() does not prevent softirq to execute
on this same CPU, to run ieee80211_tx_h_unicast_ps_buf() and try to
take this same lock ending in deadlock. Below is an example of rcu stall
that arises in such situation.
rcu: INFO: rcu_sched self-detected stall on CPU
rcu: 2-
USB: class: cdc-wdm: Fix CPU lockup caused by excessive log messages
In the Linux kernel, the following vulnerability has been resolved:
USB: class: cdc-wdm: Fix CPU lockup caused by excessive log messages
The syzbot fuzzer found that the interrupt-URB completion callback in
the cdc-wdm driver was taking too long, and the driver's immediate
resubmission of interrupt URBs with -EPROTO status combined with the
dummy-hcd emulation to cause a CPU lockup:
cdc_wdm 1-1:1.0: nonzero urb status received: -71
cdc_wdm 1-1:1.0: wdm_int_callback - 0 bytes
watchdog: BUG: soft lockup - CPU#0 stuck for 26s! [syz-executor782:6625]
CPU#0 Utilization every 4s during lockup:
#1: 98% system, 0% softirq, 3% hardirq, 0% i
In the Linux kernel, the following vulnerability has been resolved:
jfs: xattr: fix buffer overflow for invalid xattr
When an xattr size is not what is expected, it is printed out to the
kernel log in hex format as a form of debugging. But when that xattr
size is bigger than the expected size, printing it out can cause an
access off the end of the buffer.
Fix this all up by properly restricting the size of the debug hex dump
in the kernel log.
vmci: prevent speculation leaks by sanitizing event in event_deliver()
In the Linux kernel, the following vulnerability has been resolved:
vmci: prevent speculation leaks by sanitizing event in event_deliver()
Coverity spotted that event_msg is controlled by user-space,
event_msg->event_data.event is passed to event_deliver() and used
as an index without sanitization.
This change ensures that the event index is sanitized to mitigate any
possibility of speculative information leaks.
This bug was discovered and resolved using Coverity Static Analysis
Security Testing (SAST) by Synopsys, Inc.
Only compile tested, no access to HW.
bonding: Fix out-of-bounds read in bond_option_arp_ip_targets_set()
In the Linux kernel, the following vulnerability has been resolved:
bonding: Fix out-of-bounds read in bond_option_arp_ip_targets_set()
In function bond_option_arp_ip_targets_set(), if newval->string is an
empty string, newval->string+1 will point to the byte after the
string, causing an out-of-bound read.
BUG: KASAN: slab-out-of-bounds in strlen+0x7d/0xa0 lib/string.c:418
Read of size 1 at addr ffff8881119c4781 by task syz-executor665/8107
CPU: 1 PID: 8107 Comm: syz-executor665 Not tainted 6.7.0-rc7 #1
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014
Call Trace:
<TASK>
__dump_stack lib/dump_stack.c:88 [inl
mmc: davinci: Don't strip remove function when driver is builtin
In the Linux kernel, the following vulnerability has been resolved:
mmc: davinci: Don't strip remove function when driver is builtin
Using __exit for the remove function results in the remove callback being
discarded with CONFIG_MMC_DAVINCI=y. When such a device gets unbound (e.g.
using sysfs or hotplug), the driver is just removed without the cleanup
being performed. This results in resource leaks. Fix it by compiling in the
remove callback unconditionally.
This also fixes a W=1 modpost warning:
WARNING: modpost: drivers/mmc/host/davinci_mmc: section mismatch in
reference: davinci_mmcsd_driver+0x10 (section: .data) ->
davinci_mmcsd_remov
In the Linux kernel, the following vulnerability has been resolved:
kdb: Fix buffer overflow during tab-complete
Currently, when the user attempts symbol completion with the Tab key, kdb
will use strncpy() to insert the completed symbol into the command buffer.
Unfortunately it passes the size of the source buffer rather than the
destination to strncpy() with predictably horrible results. Most obviously
if the command buffer is already full but cp, the cursor position, is in
the middle of the buffer, then we will write past the end of the supplied
buffer.
Fix this by replacing the dubious strncpy() calls with memmove()/memcpy()
calls plus
The IPv6 implementation in the Linux kernel before 6.3 has a net/ipv6/route.c max_size threshold that can be consumed easily, e.g., leading to a denial of service (network is unreachable errors) when IPv6 packets are sent in a loop via a raw socket.
In the Linux kernel before 4.8, usb_parse_endpoint in drivers/usb/core/config.c does not validate the wMaxPacketSize field of an endpoint descriptor. NOTE: This vulnerability only affects products that are no longer supported by the supplier.
nilfs2: fix nilfs_empty_dir() misjudgment and long loop on I/O errors
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix nilfs_empty_dir() misjudgment and long loop on I/O errors
The error handling in nilfs_empty_dir() when a directory folio/page read
fails is incorrect, as in the old ext2 implementation, and if the
folio/page cannot be read or nilfs_check_folio() fails, it will falsely
determine the directory as empty and corrupt the file system.
In addition, since nilfs_empty_dir() does not immediately return on a
failed folio/page read, but continues to loop, this can cause a long loop
with I/O if i_size of the directory's inode is also corrupted, causing the
log writer thread
f2fs: fix to do sanity check on i_xattr_nid in sanity_check_inode()
In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix to do sanity check on i_xattr_nid in sanity_check_inode()
syzbot reports a kernel bug as below:
F2FS-fs (loop0): Mounted with checkpoint version = 48b305e4
==================================================================
BUG: KASAN: slab-out-of-bounds in f2fs_test_bit fs/f2fs/f2fs.h:2933 [inline]
BUG: KASAN: slab-out-of-bounds in current_nat_addr fs/f2fs/node.h:213 [inline]
BUG: KASAN: slab-out-of-bounds in f2fs_get_node_info+0xece/0x1200 fs/f2fs/node.c:600
Read of size 1 at addr ffff88807a58c76c by task syz-executor280/5076
CPU: 1 PID: 5076 Comm: syz-executor
In the Linux kernel, the following vulnerability has been resolved:
net/9p: fix uninit-value in p9_client_rpc()
Syzbot with the help of KMSAN reported the following error:
BUG: KMSAN: uninit-value in trace_9p_client_res include/trace/events/9p.h:146 [inline]
BUG: KMSAN: uninit-value in p9_client_rpc+0x1314/0x1340 net/9p/client.c:754
trace_9p_client_res include/trace/events/9p.h:146 [inline]
p9_client_rpc+0x1314/0x1340 net/9p/client.c:754
p9_client_create+0x1551/0x1ff0 net/9p/client.c:1031
v9fs_session_init+0x1b9/0x28e0 fs/9p/v9fs.c:410
v9fs_mount+0xe2/0x12b0 fs/9p/vfs_super.c:122
legacy_get_tree+0x114/0x290 fs/fs_context.c:662
vfs_g
nilfs2: fix potential kernel bug due to lack of writeback flag waiting
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix potential kernel bug due to lack of writeback flag waiting
Destructive writes to a block device on which nilfs2 is mounted can cause
a kernel bug in the folio/page writeback start routine or writeback end
routine (__folio_start_writeback in the log below):
kernel BUG at mm/page-writeback.c:3070!
Oops: invalid opcode: 0000 [#1] PREEMPT SMP KASAN PTI
...
RIP: 0010:__folio_start_writeback+0xbaa/0x10e0
Code: 25 ff 0f 00 00 0f 84 18 01 00 00 e8 40 ca c6 ff e9 17 f6 ff ff
e8 36 ca c6 ff 4c 89 f7 48 c7 c6 80 c0 12 84 e8 e7 b3 0f 00 90 <0f>
0b e8 1f ca c6 ff 4
um: Add winch to winch_handlers before registering winch IRQ
In the Linux kernel, the following vulnerability has been resolved:
um: Add winch to winch_handlers before registering winch IRQ
Registering a winch IRQ is racy, an interrupt may occur before the winch is
added to the winch_handlers list.
If that happens, register_winch_irq() adds to that list a winch that is
scheduled to be (or has already been) freed, causing a panic later in
winch_cleanup().
Avoid the race by adding the winch to the winch_handlers list before
registering the IRQ, and rolling back if um_request_irq() fails.
enic: Validate length of nl attributes in enic_set_vf_port
In the Linux kernel, the following vulnerability has been resolved:
enic: Validate length of nl attributes in enic_set_vf_port
enic_set_vf_port assumes that the nl attribute IFLA_PORT_PROFILE
is of length PORT_PROFILE_MAX and that the nl attributes
IFLA_PORT_INSTANCE_UUID, IFLA_PORT_HOST_UUID are of length PORT_UUID_MAX.
These attributes are validated (in the function do_setlink in rtnetlink.c)
using the nla_policy ifla_port_policy. The policy defines IFLA_PORT_PROFILE
as NLA_STRING, IFLA_PORT_INSTANCE_UUID as NLA_BINARY and
IFLA_PORT_HOST_UUID as NLA_STRING. That means that the length validation
using the policy is for the max size of the
serial: max3100: Lock port->lock when calling uart_handle_cts_change()
In the Linux kernel, the following vulnerability has been resolved:
serial: max3100: Lock port->lock when calling uart_handle_cts_change()
uart_handle_cts_change() has to be called with port lock taken,
Since we run it in a separate work, the lock may not be taken at
the time of running. Make sure that it's taken by explicitly doing
that. Without it we got a splat:
WARNING: CPU: 0 PID: 10 at drivers/tty/serial/serial_core.c:3491 uart_handle_cts_change+0xa6/0xb0
...
Workqueue: max3100-0 max3100_work [max3100]
RIP: 0010:uart_handle_cts_change+0xa6/0xb0
...
max3100_handlerx+0xc5/0x110 [max3100]
max3100_work+0x12a/0x340 [max310
serial: max3100: Update uart_driver_registered on driver removal
In the Linux kernel, the following vulnerability has been resolved:
serial: max3100: Update uart_driver_registered on driver removal
The removal of the last MAX3100 device triggers the removal of
the driver. However, code doesn't update the respective global
variable and after insmod — rmmod — insmod cycle the kernel
oopses:
max3100 spi-PRP0001:01: max3100_probe: adding port 0
BUG: kernel NULL pointer dereference, address: 0000000000000408
...
RIP: 0010:serial_core_register_port+0xa0/0x840
...
max3100_probe+0x1b6/0x280 [max3100]
spi_probe+0x8d/0xb0
Update the actual state so next time UART driver will be registered
again.