In the Linux kernel, the following vulnerability has been resolved:
ALSA: ua101: reject mismatched capture/playback packet sizes
detect_usb_format() cross-checks bSubframeSize, bBitResolution and
tSamFreq between the capture and playback interfaces, but never relates
the two endpoints' wMaxPacketSize and bNrChannels. Each playback URB
gets a buffer of ua->playback.max_packet_bytes, while the number of
bytes written into it is derived from the capture stream:
capture_urb_complete() computes frames from the received capture packet
and capture.frame_bytes, and start_usb_playback() and playback_work()
multiply that by playback.frame_bytes.
A
Nicht bewertetEPSS 0,18%Keine Korrektur veröffentlicht
EDAC/altera: Drop __init from ECC setup paths for re-probe safety
In the Linux kernel, the following vulnerability has been resolved:
EDAC/altera: Drop __init from ECC setup paths for re-probe safety
Sashiko reports:
"Does suppressing sysfs unbinding fully prevent the execution of freed __init
memory? If altr_sysmgr_regmap_lookup_by_phandle() returns -EPROBE_DEFER, the
probe is deferred until after __init memory is freed."
The a10 EDAC .setup callbacks (sdmmc, ethernet, nand, dma, usb, qspi) and
their helpers (altr_init_a10_ecc_device_type, altr_init_a10_ecc_block) were
marked __init. These run from the probe path, which may execute after init
memory is freed -- e.g. a probe deferred via -EPROBE_DEFER t
Bluetooth: RFCOMM: Fix initial port reference race
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix initial port reference race
For RFCOMM_RELEASE_ONHUP devices, rfcomm_tty_install() and
__rfcomm_release_dev() both use RFCOMM_TTY_OWNED to decide who drops the
initial tty_port reference. The release path tests the bit separately
from the install path setting it, so both can drop that reference.
The synchronous hangup does not prevent this race: port->tty is not
assigned until tty_port_open(), after installation. The following
interleaving is possible:
1. Install and release each obtain a reference with rfcomm_dev_get().
2. Release observes RFCO
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: Serialize SMP remote OOB data access
build_pairing_cmd() looks up remote OOB data and copies its contents
without holding hdev->lock, which serializes the list's writers. After
SMP finds an entry, a concurrent management Remove Remote OOB Data
command can unlink and free it before SMP reads its present flag or
copies its random and confirmation values. Removal can also invalidate
an entry while the lookup is still traversing the list.
KASAN reported:
BUG: KASAN: slab-use-after-free in build_pairing_cmd+0x948/0x9b0
Call Trace:
build_pairing_cmd+0x948/0x9b
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: Fix inquiry cache use-after-free
The sync command worker holds hdev->req_lock, but inquiry-cache updates
and flushes use hdev->lock. Both hci_acl_create_conn_sync() and
hci_stop_discovery_sync() look up entries and read their fields without
taking hdev->lock.
After either lookup returns, a concurrent HCIINQUIRY ioctl can acquire
hdev->lock and flush the cache, freeing the entry. The worker then reads
the freed entry while preparing a create-connection or remote-name-cancel
command. The list traversal also races with cache updates and removal.
KASAN re
Bluetooth: hci_conn: Lock parent access during enhanced SCO setup
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_conn: Lock parent access during enhanced SCO setup
Bluetooth: hci_conn: Lock parent access during enhanced SCO setup
hci_enhanced_setup_sync() runs on the request workqueue without the
hci_dev_lock held by its caller when setup was queued. Its CVSD
capability check and find_next_esco_param() dereference conn->parent
while the receive workqueue can unlink and release that parent.
The following interleaving can cause a use-after-free:
hci_enhanced_setup_sync() hci_disconn_complete_evt()
load conn->parent
hci_dev_loc
Bluetooth: hci_core: Serialize ACL scheduling with channel deletion
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_core: Serialize ACL scheduling with channel deletion
hci_chan_sent() selects a channel under RCU but drops the read lock before
accessing chan->conn and returning the channel. The ACL and LE schedulers
then use its packet queue and update its transmit counters without any
protection against channel deletion.
After TX selects a channel and releases RCU, a disconnect command timeout
on the separate request workqueue can run hci_conn_failed() and
l2cap_conn_del(). hci_chan_del() can then unlink the channel, complete
synchronize_rcu(), purge its queue and free i
Bluetooth: hci_core: Serialize SCO and ISO scheduling with teardown
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_core: Serialize SCO and ISO scheduling with teardown
hci_low_sent() selects a connection under RCU but drops the read lock
before calculating its quota and returning it to the scheduler. The
connection is then used without lifetime protection by hci_sched_iso()
and hci_sched_sco().
After the TX worker drops the RCU read lock, hci_abort_conn_sync() on
hdev->req_workqueue can remove the connection from the hash, complete
synchronize_rcu(), purge its queues and release it. The TX worker on
hdev->workqueue can then access the freed connection in hci_quote_sent()
Bluetooth: hci_core: Serialize fragmented ISO packet queueing
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_core: Serialize fragmented ISO packet queueing
The fragmented path in hci_queue_iso() calls __skb_queue_tail() without
holding conn->data_q.lock. The socket lock serializes senders, but the
transmit worker can concurrently remove packets from this queue using
skb_dequeue().
After an insertion saves the old tail pointer, hci_sched_iso() can dequeue
that packet and pass it to the driver. The driver can free the packet
before the insertion resumes and writes to the old tail's next pointer,
causing a use-after-free. Concurrent updates can also corrupt the queue.
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
Bluetooth: btintel: fix buffer over-read in btintel_hw_error()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: fix buffer over-read in btintel_hw_error()
The "Exception info %s" print uses skb->data + 1, but the 12-byte
payload is not guaranteed to be NUL-terminated and can be read past
its end.
Bound the print with "%.*s" and skb->len - 1.
nvme-multipath: fix underflow in ANA log bounds checks
In the Linux kernel, the following vulnerability has been resolved:
nvme-multipath: fix underflow in ANA log bounds checks
The number of ANA groups advertised through Identify Controller sizes the
ANA log buffer. The ANA log header and group descriptors independently
supply the number of groups and namespace IDs to parse.
Both bounds checks subtract an untrusted object size from ana_log_size
before comparing the current offset. If the object is larger than the
buffer, the size_t subtraction underflows and lets the parser read beyond
ana_log_buf.
Check the current offset before the first subtraction and compare each
object size with the re
nvmet-auth: fix out-of-bounds write in nvmet_auth_challenge()
In the Linux kernel, the following vulnerability has been resolved:
nvmet-auth: fix out-of-bounds write in nvmet_auth_challenge()
nvmet_auth_challenge() receives its output buffer as a void pointer.
sizeof(*d) therefore evaluates to one with GCC and undercounts the fixed
challenge header by 15 bytes. A short AUTH_RECEIVE buffer can pass the
check before the challenge is copied past the end of its allocation.
Use the typed challenge pointer when calculating the response size.
BUG: KASAN: slab-out-of-bounds in nvmet_execute_auth_receive (drivers/nvme/target/fabrics-cmd-auth.c:442 drivers/nvme/target/fabrics-cmd-auth.c:569)
Write of siz
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
mtd: block2mtd: Fix divide error when erase_size is zero
In the Linux kernel, the following vulnerability has been resolved:
mtd: block2mtd: Fix divide error when erase_size is zero
The erase size is parsed from the "block2mtd" module parameter and can
be set to zero. add_device() then evaluates
if (size % erase_size)
with a zero divisor, which triggers a divide error:
divide error: 0000 [#1] PREEMPT SMP PTI
RIP: 0010:add_device drivers/mtd/devices/block2mtd.c:296 [inline]
RIP: 0010:block2mtd_setup2+0x592/0xda0 drivers/mtd/devices/block2mtd.c:459
Call Trace:
block2mtd_setup+0x27/0xe0 drivers/mtd/devices/block2mtd.c:476
param_attr_store+0x214/0x310 kernel/params.c:589
module_attr_store+
Nicht bewertetEPSS 0,2%Keine Korrektur veröffentlicht
mtd: rawnand: cadence: Initialize IRQ state before requesting IRQ
In the Linux kernel, the following vulnerability has been resolved:
mtd: rawnand: cadence: Initialize IRQ state before requesting IRQ
The Cadence NAND interrupt handler uses both the IRQ lock and completion
object. Registering the IRQ before initializing them leaves a window in
which a pending interrupt can access uninitialized synchronization state.
Initialize them before registering the handler.
KVM: nVMX: Force MSR bitmap refresh if runtime eVMCS controls are modified
In the Linux kernel, the following vulnerability has been resolved:
KVM: nVMX: Force MSR bitmap refresh if runtime eVMCS controls are modified
Force a refresh of the vmcs02 MSR bitmap during nested VM-Enter if the
runtime eVMCS controls (pin, primary, secondary, etc.) are being updated.
If L1 isn't intercepting TPR writes, runs L2 with TPR virtualization, and
then runs the same L2 with TPR virtualization disabled, KVM will fail to
refresh msr_bitmap02 and leave TPR in passthrough mode even though TPR
virtualization is disabled. I.e. failure to refresh the bitmap lets L2 (or
L1 by proxy) read and write L0's TPR.
KVM: SVM: Use the active VMCB's MSR bitmap when checking if MSR is intercepted
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Use the active VMCB's MSR bitmap when checking if MSR is intercepted
Use the MSR permission bitmap of the active VMCB instead of assuming that
KVM is always using vmcb02's bitmap when L2 is active, as KVM uses msrpm02
if and only if L1 wants to intercept MSR accesses, i.e. if and only if KVM
needs to merge msprm01 with msrpm12.
Don't bother tracking the virtual address of the bitmap that's being used,
as __va() is cheap on x86, and caching the virtual address would introduce
yet another source of potentially stale information.
KVM: SVM: Preserve TLB control (i.e. pending TLB flush) on failed VMRUN
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Preserve TLB control (i.e. pending TLB flush) on failed VMRUN
Don't reset the VMCB's TLB control back to "do nothing" on a failed VMRUN,
as empirical testing shows that the CPU performs the requested TLB flush if
and only if VMRUN is successful, i.e. clearing TLB control on a failed
VMRUN effectively drops a TLB flush.
Explicitly track the need to flush all ASIDs on a per-CPU basis, as the
ASID reuse condition is tied to the pCPU, not to the vCPU. As a bonus,
this also obviates the need to avoid clobbering FLUSH_ALL_ASID with
TLB_CONTROL_FLUSH_ASID, e.g. in svm_
KVM: SVM: Update control fields on #VMEXIT if and only if VMRUN succeeded
In the Linux kernel, the following vulnerability has been resolved:
KVM: SVM: Update control fields on #VMEXIT if and only if VMRUN succeeded
Leave control.erap_ctl and control.clean as-is in the VMCS if VMRUN fails,
because as per AMD:
there's no explicit architectural guarantee about the behavior in the
presence of VMRUN failures. So the best thing to do would be to assume
that if VMRUN fails, the actions requested in the control fields may not
have been performed.
wifi: cw1200: fix TX padding OOB read leaking heap data to device
In the Linux kernel, the following vulnerability has been resolved:
wifi: cw1200: fix TX padding OOB read leaking heap data to device
The TX path rounds the transfer size up to the bus alignment
(align_size(), up to 511 bytes for SDIO, 1 byte for SPI) but sends
the padded length straight from the frame buffer, which has no room
reserved for the padding. cw1200_data_write() therefore reads past
the end of the frame and the bus transfer carries those bytes to the
device. A bogus device can collect up to 511 bytes of kernel heap
data per TX frame.
The RX path does not have this problem: it allocates the skb with
the aligned length (alloc_le
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
wifi: iwlegacy: 3945: free EEPROM data on remove
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlegacy: 3945: free EEPROM data on remove
il3945_pci_probe() calls il_eeprom_init(), which allocates memory for
the EEPROM data. The probe failure paths release this allocation with
il_eeprom_free(), but the remove path does not free it after a
successful probe.
As a result, the EEPROM data is leaked when the PCI device is removed.
Free the EEPROM data in il3945_pci_remove() before releasing the
mac80211 hardware structure.
This issue was found by manual code inspection.