In the Linux kernel, the following vulnerability has been resolved:
net: lock the socket in sock_gettstamp()
sk->sk_flags must only be changed while holding the socket lock,
because sock_set_flag() and sock_reset_flag() use non atomic
operations (__set_bit() and __clear_bit()).
sock_gettstamp() is one of the last places where a bit of sk->sk_flags
is changed from a syscall without owning the socket lock, through
sock_enable_timestamp(sk, SOCK_TIMESTAMP).
sk_set_memalloc() and sk_clear_memalloc() also change sk->sk_flags
without the socket lock, but their callers (nbd, iscsi_tcp, nvme-tcp,
sunrpc, wireguard) need a careful audit, this will
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Ack RX overrun interrupt correctly
The RX overrun interrupt is reported in interrupt status register 4, but
gmac_irq() acknowledges it using the RX descriptor error bit from status
register 0. For GMAC0 this writes the GMAC1 overrun bit, while for GMAC1
the shift leaves no bit in the 32-bit register.
Acknowledge the same per-port RX overrun bit that was detected.
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
x86/kprobes: Fix crash when probing CS CALL instructions
In the Linux kernel, the following vulnerability has been resolved:
x86/kprobes: Fix crash when probing CS CALL instructions
When using eBPF to probe CS CALL instructions within a function,
a crash can be triggered.
The eBPF tool probes offset 257 of the __hrtimer_run_queues()
function:
<__hrtimer_run_queues+249>: nopl 0x0(%rax,%rax,1)
<__hrtimer_run_queues+254>: mov %r14,%rdi
<__hrtimer_run_queues+257>: cs call <__x86_indirect_thunk_r12>
<__hrtimer_run_queues+263>: mov %eax,%r12d
<__hrtimer_run_queues+266>: xchg %ax,%ax
<__hrtimer_run_queues+268>: mov %r13,%rdi
Which triggers this crash:
BUG: unable to handle page
net: mvpp2: prevent buffer overflow in page_pool allocation
In the Linux kernel, the following vulnerability has been resolved:
net: mvpp2: prevent buffer overflow in page_pool allocation
The per‑processor buffering scheme is supported only if the
number of pools (nrxqs * 2) does not exceed MVPP2_BM_MAX_POOLS (8).
This is already checked in mvpp2_probe() during the initial
activation of percpu_pools.
However, mvpp2_change_mtu() may later call
mvpp2_bm_switch_buffers(priv, true) without this check, which can
lead to an out-of-bounds access in the priv->page_pool array in
mvpp2_bm_init(). The array is sized to hold MVPP2_PORT_MAX_RXQ
entries, and mvpp2_get_nrxqs() may return exactly that value. The
p
Nicht bewertetEPSS 0,17%Keine Korrektur veröffentlicht
net: skbuff: do not leave stale header offsets after pskb_carve()
In the Linux kernel, the following vulnerability has been resolved:
net: skbuff: do not leave stale header offsets after pskb_carve()
pskb_carve_inside_header() and pskb_carve_inside_nonlinear() remove
the first bytes of a packet and reallocate skb->head.
All the headers that were present before the operation are gone,
but both functions call skb_headers_offset_update(skb, 0), which
is a no-op : skb->mac_header, skb->network_header,
skb->transport_header and skb->csum_start keep their old values and
now describe bytes which are no longer there.
Both helpers size the new head from the old skb_end_offset(), so the
stale offsets still land i
btrfs: abort transaction on failure to update inode for hole punching and reflinking
In the Linux kernel, the following vulnerability has been resolved:
btrfs: abort transaction on failure to update inode for hole punching and reflinking
If we fail to update the inode we error out without aborting the
transaction, which can result in a persistent inconsistency if after
the failure the transaction is committed, as we have dropped file
extent items from a range and either punched a hole or insert a new file
extent item for that range (for reflinks).
So add the missing transaction abort.
ALSA: core: Fix potential UAF after asynchronous card release
In the Linux kernel, the following vulnerability has been resolved:
ALSA: core: Fix potential UAF after asynchronous card release
Usually a sound driver releases the resources assigned to the card via
snd_card_free(), and it synchronizes with the whole release procedure.
However, when the card is released asynchronously via
snd_card_free_when_closed() like USB-audio driver, the situation is
slightly different; although the snd_card_disconnect() call at the
disconnection guarantees that any newer accesses will be gated, the
in-flight tasks might be still accessing to the underlying card->dev
device even after the disconnection, which would c
ALSA: usb-audio: Clamp implicit feedback packet count to URB capacity
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Clamp implicit feedback packet count to URB capacity
data_ep_set_params() allocates each data URB for exactly u->packets
isochronous frames, so urb->iso_frame_desc[] has u->packets slots and
ctx->packets is the driver's only record of that limit. For an implicit
feedback sink, snd_usb_queue_pending_output_urbs() overwrites it with the
sync source's packet count, which is calculated independently from the
capture endpoint's parameters. When that count is larger,
prepare_playback_urb() and prepare_silent_urb() can write
iso_frame_desc[] past the allocation; t
ALSA: virtio: reset device before deleting virtqueues
In the Linux kernel, the following vulnerability has been resolved:
ALSA: virtio: reset device before deleting virtqueues
virtsnd_remove() and virtsnd_freeze() delete the virtqueues before
resetting the device. del_vqs() frees the vring backing, but does not
provide a generic device quiesce operation. In particular, modern
virtio-pci keeps enabled queues active until the device is reset.
Reset the device before deleting the virtqueues so it can no longer
access the vring memory when that memory is released. This also covers
probe failures after DRIVER_OK, which unwind through virtsnd_remove().
ata: libahci: clear PxCLBU and PxFBU for AHCI_HFLAG_32BIT_ONLY
In the Linux kernel, the following vulnerability has been resolved:
ata: libahci: clear PxCLBU and PxFBU for AHCI_HFLAG_32BIT_ONLY
A user reported that commit 105c42566a55 ("ata: ahci: force 32-bit DMA for
JMicron JMB582/JMB585") made the JMicron JMB585 unusable on his board.
The failure is seen as soon as the ahci driver is probed, and booting with
iommu=off does not solve the problem.
Looking at the AHCI specification, PxCLBU and PxFBU are both read only '0'
for HBAs that do not support 64-bit addressing.
For HBAs that do support 64-bit addressing, the registers are read write,
with a reset value that is Implementation Specific.
When
exec: Cleanup POSIX timers right after de_thread()
In the Linux kernel, the following vulnerability has been resolved:
exec: Cleanup POSIX timers right after de_thread()
A per-thread CPU timer holds a reference to the PID of the thread it is
attached to and, while it is armed, its node is queued in that thread's
posix_cputimers. The task is looked up by that PID.
When a non-leader thread exec()s, de_thread() changes which task owns
that PID. pid_task(timer->it.cpu.pid, PIDTYPE_PID) then returns NULL,
but the node is still queued on tsk, which is alive. timer_lock_sighand()
takes a failed lookup to mean that the node is already dequeued, so it
has nothing to undo.
begin_new_exec() calls po
rds: ib: use rds_conn_drop() on protocol version mismatch
In the Linux kernel, the following vulnerability has been resolved:
rds: ib: use rds_conn_drop() on protocol version mismatch
rds_ib_cm_connect_complete() runs from the RDMA-CM event handler with
conn->c_cm_lock held. When the peer negotiates a protocol version
older than RDS_PROTOCOL_COMPAT_VERSION, the handler calls
rds_conn_destroy(), which is only safe in the rmmod path: it
synchronously tears the connection down and flush_work()es the
shutdown work cp_down_w.
That shutdown work (rds_conn_shutdown()) needs cp_cm_lock, which is
the very lock the event handler still holds, so the flush never
completes: the two workers wait on each other
In the Linux kernel, the following vulnerability has been resolved:
tcp: exclude old ACKs from tcp fast path
Exclude old ACKs before SND.UNA from the tcp fast path
as well as ACKs after SND.NXT.
Such ACKs will fall through to the slow path, where tcp_ack()
performs the appropriate validation and challenge ACK handling
according to RFC5961 and Commit 3d501dd326fb1c7 ("tcp: do not
accept ACK of bytes we never sent").
This prevents old ACKs from being accepted
or modifying connection state as part of the fast path before
appropriate ACK validation is applied.
In particular, this prevents payload carried by a segment with
an excessively old A
swiotlb: use the adjusted address for the highmem page lookup
In the Linux kernel, the following vulnerability has been resolved:
swiotlb: use the adjusted address for the highmem page lookup
swiotlb_bounce() reads the page frame number from the slot's recorded
orig_addr, then advances orig_addr by tlb_offset to reach the address
the caller asked about. The highmem branch mixes the two: the offset
within the page comes from the adjusted address, the page from the value
before it.
Once the adjustment crosses a page boundary the pair no longer describes
one location, and the whole copy lands one page below the intended one
for a positive tlb_offset, one above for a negative one. DMA_FROM_DEVICE
writes
RDMA/ucma: Serialize join and leave on copy_to_user failure
In the Linux kernel, the following vulnerability has been resolved:
RDMA/ucma: Serialize join and leave on copy_to_user failure
rdma_join_multicast() queues RoCE work that later reads the ucma_multicast
through event->param.ud.private_data, then list_add()s the CMA multicast
at the head of id_priv->mc_list. rdma_leave_multicast() matches only by
sockaddr and destroys the first hit.
ucma_process_join() used to drop ctx->mutex after a successful join and
retake it only if copy_to_user() failed. Two concurrent JOIN_MCAST calls
with the same address can therefore insert a second CMA entry before the
first thread's leave. leave then cancels the
RDMA/core: fix refcount bug in iwpm_get_nlmsg_request()
In the Linux kernel, the following vulnerability has been resolved:
RDMA/core: fix refcount bug in iwpm_get_nlmsg_request()
iwpm_get_nlmsg_request() initializes refcount _after_ list_add_tail()
making it accessible to global list where another CPU can kref_get()
on nlmsg_request causing a refcount "addition on 0" bug. Fix this
by initializing kref _before_ list_add_tail() so refcount for
nlmsg_request can be incremented/decremented normally. In addition,
also initialize every field before list_add_tail().
In the Linux kernel, the following vulnerability has been resolved:
openvswitch: avoid reallocating confirmed conntrack labels
ovs_ct_get_conn_labels() adds the labels extension when a conntrack
entry does not have one. Confirmed conntracks can be read locklessly,
so adding an extension may reallocate and free the extension block
while another CPU accesses it.
Only add the extension for unconfirmed conntracks. A confirmed
conntrack without labels now fails the caller's label operation instead
of reallocating its extension storage.
arm64: hibernate: pass HVC_SET_VECTORS args to the resume hvc
In the Linux kernel, the following vulnerability has been resolved:
arm64: hibernate: pass HVC_SET_VECTORS args to the resume hvc
swsusp_arch_suspend_exit() reinstalls the restored kernel's hyp stub
vectors with an hvc, but never passes the arguments. x0 is not set to
HVC_SET_VECTORS and x1 is not set to the vector address, so the stub
dispatch falls through and returns without writing vbar_el2. EL2 is
left pointing at the trans_pgd copy of the vectors, a page that
swsusp_free() releases right after resume.
Set the arguments up the same way __hyp_set_vectors() does.
Without this fix, Vladimir was able to trigger a hang when resuming from
Nicht bewertetEPSS 0,21%Keine Korrektur veröffentlicht
arm64: percpu: Fix LSE operations on {8,16}-bit types
In the Linux kernel, the following vulnerability has been resolved:
arm64: percpu: Fix LSE operations on {8,16}-bit types
The assembly for __percpu_##name##_case_##sz() and
__percpu_##name##_return_case_##sz() doesn't use the 'sfx' macro
argument to form the LSE instruction. Without 'sfx', a W register
argument will imply a 32-bit memory location, and consequently
{8,16}-bit ops will erroneously read and write 32 bits of memory when
the LSE instruction is used.
Fix this by appending 'sfx' to 'op_lse' to LSE instruction. It is not
necessary (and not valid) to append 'sfx' to 'op_llsc', as 'op_llsc' is
a register-register operation which doe
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_codec: validate vendor codec count length
The Read Local Supported Codecs parsers consume the variable-sized
standard codec array before parsing the vendor codec count. Although the
initial reply-size check includes a vendor count byte in the fixed layout,
it does not guarantee that the byte remains after the standard codec array.
If a controller reply ends immediately after that array, calculating the
vendor codec array size reads vnd_codecs->num beyond the skb data. Use
skb_pull_data() to validate and consume each codec header before using its
count in b