ALSA: caiaq: unregister the input device when probe fails
In the Linux kernel, the following vulnerability has been resolved:
ALSA: caiaq: unregister the input device when probe fails
setup_card() registers the input device, whose name and phys point into
struct snd_usb_caiaqdev, and then goes on to snd_card_register() and
snd_usb_caiaq_control_init(). If either fails, snd_probe() calls
snd_card_free(), which frees the device state but leaves the input
device registered: card_free() only clears the pointer, and the input
device is unregistered from snd_disconnect() alone. Reading its "uevent"
attribute afterwards dereferences freed memory:
BUG: KASAN: slab-use-after-free in string+0x4a9/0x4f0
In the Linux kernel, the following vulnerability has been resolved:
ALSA: line6: reject oversized playback packets
Each playback URB is handed a slice of out.buffer that is exactly
LINE6_ISO_PACKETS * max_packet_size_out bytes, sized from the OUT
endpoint, but the number of bytes written into that slice is never
compared against it.
submit_audio_out_urb() takes the frame count from prev_fsize, which
audio_in_callback() derived from the *IN* endpoint's received packet
length, and rescales it with the playback frame size; when prev_fsize is
still zero it synthesizes a length from the sample rate instead. On a
device declaring a large IN wMa
In the Linux kernel, the following vulnerability has been resolved:
iio: accel: kionix-kx022a: Fix array boundary check
The driver performs a sanity check for an array size, when converting a
register value to an array index. The check incorrectly accepts the
sizeof(array) as a last index, when last valid index should be
sizeof(array) - 1.
Fix the check by bailing out when index >= sizeof(array).
In the Linux kernel, the following vulnerability has been resolved:
mtd: core: call _get_device() with the master MTD
__get_mtd_device() calls the master's _get_device() callback with mtd,
which may be a partition. __put_mtd_device() passes the master.
This breaks gluebi partitions because gluebi_get_device() uses
container_of() and therefore requires the master MTD. Pass the master
to _get_device(), matching _put_device().
of/overlay: don't leak fragment references when changeset init fails
In the Linux kernel, the following vulnerability has been resolved:
of/overlay: don't leak fragment references when changeset init fails
init_overlay_changeset() stores the number of initialized fragments
in ovcs->count only on full success. When find_target() or the
__symbols__ lookup fails partway through, the target and overlay
references taken for the fragments initialized so far are never
dropped: free_overlay_changeset() bounds its cleanup loop by
ovcs->count, which is still 0.
Store the running count on the error path so free_overlay_changeset()
puts whatever was set up. The store is guarded by ovcs->fragments
because on the allocat
wifi: wfx: validate MIB read length before copying to caller
In the Linux kernel, the following vulnerability has been resolved:
wifi: wfx: validate MIB read length before copying to caller
wfx_hif_read_mib() copies reply->length bytes from the firmware
response into the caller-provided buffer without checking that
reply->length does not exceed val_len. A firmware response with
a length field larger than expected overruns the caller buffer and
reads past the end of the reply allocation.
Replace the dead -ENOMEM check with an active validation that
reply->length fits within val_len before the memcpy.
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: reject short WMI command responses
ath9k_wmi_rsp_callback() removes the validated WMI header and copies
the number of bytes expected by the waiting command into its response
buffer. A device response shorter than that expectation can therefore
be read beyond the skb payload.
Record -EMSGSIZE for a short response, complete the waiter, and return
the stored status from the command path. This also prevents callers from
consuming stale response bytes as a successful reply.
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k_htc: bound TX aggregation to MAX_TX_BUF_SIZE
__hif_usb_tx() dequeues up to MAX_TX_AGGR_NUM (20) frames into a
single tx_buf of MAX_TX_BUF_SIZE (32768) bytes, limiting the batch
by record count but never by cumulative byte length.
With large frames (MTU 2304), 20 aggregated frames of 2292 bytes
each exceed the allocation (20 * 2296 = 45920 bytes), so the
memcpy() in the loop writes up to 13152 bytes past tx_buf->buf
before usb_submit_urb().
Peek the queue head and stop before copying any record that would
cross MAX_TX_BUF_SIZE, then dispatch the current batch.
rtc: ac100: Fix clock provider use-after-free on probe failure
In the Linux kernel, the following vulnerability has been resolved:
rtc: ac100: Fix clock provider use-after-free on probe failure
ac100_rtc_register_clks() registers the RTC-32k clock with
clk_hw_register_fixed_rate() and the clock provider with
of_clk_add_hw_provider(). Neither is device managed, and both are
released only from ac100_rtc_remove(). The driver core does not call
remove() when probe() fails: really_probe() reaches probe_failed below
the device_remove() call and goes straight to releasing the device's
managed resources.
ac100_rtc_probe() ends with
return devm_rtc_register_device(chip->rtc);
so if that fails after the cloc
rtc: mpfs: fix unchecked devm_clk_get() error pointer in probe()
In the Linux kernel, the following vulnerability has been resolved:
rtc: mpfs: fix unchecked devm_clk_get() error pointer in probe()
devm_clk_get(&pdev->dev, "rtcref")'s return value was passed straight
into clk_get_rate() without checking it for an error first, unlike the
"rtc" clock a few lines above which is correctly checked with
IS_ERR(). clk_get_rate() only guards against a NULL clk, not an error
pointer:
if (!clk)
return 0;
...
rate = clk_core_get_rate_recalc(clk->core);
so if devm_clk_get() ever returns an error pointer here (for example
ERR_PTR(-EPROBE_DEFER), which is the normal, expected outcome if the
clkcfg clock-provide
In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: preserve hidden-group beacon IE ownership
A hidden-group probe-response entry borrows its beacon IEs from the
group's beacon entry. cfg80211_update_assoc_bss_entry() can pass such
an entry to cfg80211_update_known_bss() when merging scan entries
after a channel switch.
Copying the borrowed beacon_ies into the associated entry gives the
same allocation two owners. Releasing the group's beacon entry can
then leave the associated entry pointing to freed IEs, which are
freed again when that entry is released.
Skip beacon IE replacement when the source entry be
wifi: mac80211: prevent AP VLAN tx from other interfaces
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: prevent AP VLAN tx from other interfaces
Since the station lookup was factored out of ieee80211_build_hdr(),
ieee80211_lookup_ra_sta() uses sta_info_get_bss() for all AP and AP VLAN
frames, not only for control port frames. A unicast frame sent on one
interface thus matches a station of a different VLAN of the same BSS and
is transmitted to it.
Only match stations of the interface the frame is sent on, except for
control port frames, since those may be sent for VLAN stations directly
on the BSS interface.
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btintel: validate DDC record lengths
Parse DDC record lengths in unsigned storage so 0xFF does not wrap.
Reject records smaller than the mandatory three-byte header, records
exceeding U8_MAX, and records exceeding remaining firmware bytes before
issuing Intel_Write_DDC.
This issue was reported by Claude Mythos.
net/mctp: publish the mctp_dev only after it is initialised
In the Linux kernel, the following vulnerability has been resolved:
net/mctp: publish the mctp_dev only after it is initialised
mctp_add_dev() links the new mctp_dev into dev->mctp_ptr before mdev->dev
is assigned, so a reader that picks the device up in that window
dereferences a net_device pointer that is still NULL:
KASAN: null-ptr-deref in range [0x00000000000000b0-0x00000000000000b7]
Call Trace:
<TASK>
? __pfx_mctp_sendmsg (./include/linux/sockptr.h:49)
? __pfx_mctp_dst_output (net/mctp/route.c:41)
? selinux_socket_sendmsg (security/selinux/hooks.c:5278)
____sys_sendmsg (net/socket.c:775 (discriminator 1) net/socket.c:790
(discr
net/sched: cls_api: reclaim an empty proto on the error path
In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_api: reclaim an empty proto on the error path
Two racing tc filter add requests on the same chain/prio of an
unlocked classifier both run change() on the shared proto and both
can fail: the winner's tcf_chain_tp_delete_empty() attempt gives up
because the loser's handle is still in the idr, and the loser's
error path drops only its own reference without a second reclamation
attempt. The empty proto stays linked in the chain, holding the
chain reference, a block reference and the classifier module
reference until the chain or block is torn down.
Reclaim the p
Bluetooth: hci_sync: don't drain cmd_sync backlog on unregister
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: don't drain cmd_sync backlog on unregister
hci_unregister_dev() disables cmd_work and cmd_timer, then calls
hci_cmd_sync_clear(), whose cancel_work_sync() waits for
hci_cmd_sync_work() to return. That worker dequeues and runs every
entry on cmd_sync_work_list. With cmd_work disabled nothing reaches
the controller, so each queued HCI command waits the full
HCI_CMD_TIMEOUT (2s).
The backlog has no bound. Userspace can keep queuing MGMT commands
such as MGMT_OP_GET_CLOCK_INFO against a controller that doesn't
answer. Closing /dev/vhci then blocks in vhci_
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
In the Linux kernel, the following vulnerability has been resolved:
net: systemport: Fix buffer overflow in bcm_sysport_get_stats()
When running on SYSTEMPORT Lite, certain statistics are unsupported and
skipped during bcm_sysport_get_stats(). The variable 'j' tracks the
compacted index into the destination data buffer, whereas 'i' iterates
over all elements in bcm_sysport_gstrings_stats.
Because the buffer allocated by ethtool is sized only according to
bcm_sysport_get_sset_count(), storing values at data[i] instead of
data[j] writes past the allocated array bounds, leading to memory
corruption.
Fix this by writing to data[j] instead of
net/mlx5: Fix slab-out-of-bounds when handling team device events
In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: Fix slab-out-of-bounds when handling team device events
The mlx5_handle_changeupper_event() and mlx5_handle_changeinfodata_event()
functions check for LAG masters (which includes both bonding and team
devices) but only call bonding-specific APIs. When processing team device
events, calling bond_slave_get_rcu() and bond_is_slave_inactive() on
team_port structures causes KASAN to detect an out-of-bounds memory access
since team_port is smaller than bond slave.
Fix this by wrapping the bond-specific API calls with a check for bonding
devices. This allows the functio
In the Linux kernel, the following vulnerability has been resolved:
tipc: prevent GCM nonce reuse on peer key changes
TIPC can encrypt traffic between nodes using a different transmit key
for each node. In this mode, the AES-GCM nonce for a packet sent to a
known peer consists of a 32-bit prefix (a per-key salt XOR the peer's
address) followed by a 64-bit counter. That counter is stored in the
peer's RX crypto object. When the peer reports a change in which key
it uses to receive packets, TIPC resets this counter. The sender can
still be using the same TX key and salt, so subsequent packets reuse
earlier nonces. This nonce reuse breaks conf
net: restrict SO_RESERVE_MEM to TCP sockets and cap max value
In the Linux kernel, the following vulnerability has been resolved:
net: restrict SO_RESERVE_MEM to TCP sockets and cap max value
Commit 2bb2f5fb21b0 ("net: add new socket option SO_RESERVE_MEM") and
commit d00c8ee31729 ("net: fix possible NULL deref in sock_reserve_memory")
only checked sk_has_account(sk), which is true for both TCP and UDP
sockets.
However, SO_RESERVE_MEM and sk_unused_reserved_mem() are currently only
supported by TCP:
- On UDP sockets, sk->sk_forward_alloc is protected by
sk->sk_receive_queue.lock, whereas sock_reserve_memory() and
sock_release_reserved_memory() only acquire lock_sock(sk). Concurrent
UDP packet r