PatchFirst · Latest vulnerabilities
Vulnerabilities published for linux in the last 30 days: 670. Listed in the KEV catalogue: 0.
Vulnerabilities: 15186
In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu: Bound GPIO I2C table entry count from VBIOS Reject undersized tables and cap the derived entry count to AMDGPU_MAX_I2C_BUS so we do not overrun adev->i2c_bus[] or walk an absurd number of entries on corrupt size fields.
In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: don't call ieee80211_handle_reconfig_failure when not needed In case reconfiguration of NAN fails, we call ieee80211_handle_reconfig_failure, that marks all interfaces as not in the driver. Then, at the error path of the reconfig, cfg80211_shutdown_all_interfaces is called to destroy all the interfaces. If we have any other interface but the NAN one, for example a BSS station, then when its state (links, stations) will be removed, we won't tell the driver about this, because we will think that the interfaces are not in the driver, and then drivers might rem
In the Linux kernel, the following vulnerability has been resolved: net/rds: Don't sleep inside rds_ib_conn_path_shutdown New rds rdma self tests exposed a hang when tearing down the ib network configs. This is caused by the shutdown worker thread sleeping on the wait_event call, which blocks other work items in the queue. Fix this by changing wait_event to wait_event timeout, and looping until the wait check succeeds.
In the Linux kernel, the following vulnerability has been resolved: affs: handle set_blocksize failures affs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting we will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: bfs: handle set_blocksize failures bfs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: qnx4: handle set_blocksize failures qnx4 uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: jfs: handle set_blocksize failures jfs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting we will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: hpfs: handle set_blocksize failures hpfs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: omfs: handle set_blocksize failures omfs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting we will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.
In the Linux kernel, the following vulnerability has been resolved: usbip: vhci_hcd: fix NULL deref in status_show_vhci platform_get_drvdata() can return NULL if a VHCI host controller's probe failed (e.g. due to USB bus number exhaustion). status_show_vhci() checked for a NULL pdev but not for a NULL hcd returned by platform_get_drvdata(). Passing NULL to hcd_to_vhci_hcd() does not return NULL - it returns a pointer offset of 0x260, causing a NULL pointer dereference when that value is subsequently dereferenced. Add a NULL check on hcd before calling hcd_to_vhci_hcd(). Move status_show_not_ready() above status_show_vhci() to make it calla
In the Linux kernel, the following vulnerability has been resolved: usb: core: hcd: fix possible deadlock in rh control transfers >From within the SCSI error handler memory allocations must not trigger IO. Handling errors in UAS and the storage driver may involve resetting a device. The thread doing the reset itself relies on VM magic. However, that is insufficient, as resetting a device involves resuming it. Resumption as well as resetting involves conrol transfers to the parent of the device to be reset. That may be a root hub. Hence usbcore must heed the flags passed to usb_submit_urb() processing control transfers to root hubs. The pro
In the Linux kernel, the following vulnerability has been resolved: usb: gadget: goku_udc: avoid NULL deref of dev->driver in INT_USBRESET log goku_irq() handles a number of bus events under a single ep0 path. It already guards the gadget driver suspend/resume callbacks against a NULL ->driver: if (dev->gadget.speed != USB_SPEED_UNKNOWN && dev->driver && dev->driver->resume) { spin_unlock(&dev->lock); dev->driver->resume(&dev->gadget); ... } but the very next branch unconditionally dereferences dev->driver when an INT_USBRESET arrives: if (stat & INT_USBRESET) { ACK(INT_USBRESET); INFO(dev, "USB reset done, gadget %s\n
In the Linux kernel, the following vulnerability has been resolved: serial: 8250: fix possible ISR soft lockup There are rare cases in which the host gets stuck in the ISR because it is flooded with messages during the startup phase. The reason for the soft lockup in the ISR is the missing FIFO error IRQ (FIFOE) handling. Not handling it and reporting IRQ_HANDLED triggers the IRQ immediately again. Fix this by adding a check for the FIFOE status and clearing the FIFO if no data is ready (DR). This behavior was observed on an AM62L device which uses the OMAP 8250 driver. Fix it for all 8250 drivers, since the OMAP driver's special IRQ set
In the Linux kernel, the following vulnerability has been resolved: tty: serial: 8250: protect against NULL uart->port.dev in register serial8250_register_8250_port() conditionally copies uart->port.dev from up->port.dev only when up->port.dev is non-NULL: if (up->port.dev) { uart->port.dev = up->port.dev; ... } So if both the existing uart slot and up have a NULL ->dev, uart->port.dev remains NULL. The very next ACPI companion check then dereferences it unconditionally: if (!has_acpi_companion(uart->port.dev)) { has_acpi_companion() reads dev->fwnode without a NULL guard (include/linux/acpi.h), so this NULL-derefs the kernel for
In the Linux kernel, the following vulnerability has been resolved: driver core: Avoid warning when removing a device while its supplier is unbinding During driver removal, the following warning can appear: WARNING: CPU: 1 PID: 139 at drivers/base/core.c:1497 __device_links_no_driver+0xcc/0xfc ... Call trace: __device_links_no_driver+0xcc/0xfc (P) device_links_driver_cleanup+0xa8/0xf0 device_release_driver_internal+0x208/0x23c device_links_unbind_consumers+0xe0/0x108 device_release_driver_internal+0xec/0x23c device_links_unbind_consumers+0xe0/0x108 device_release_driver_internal+0xec/0x23c de
In the Linux kernel, the following vulnerability has been resolved: virt: acrn: Fix irqfd use-after-free during eventfd shutdown acrn_irqfd_deassign() and the eventfd EPOLLHUP wakeup can race and free the same struct hsm_irqfd: CPU0 CPU1 ---- ---- eventfd_release() wake_up_poll(EPOLLHUP) hsm_irqfd_wakeup() queue_work(&irqfd->shutdown) acrn_irqfd_deassign() hsm_irqfd_shutdown() list_del_init()
In the Linux kernel, the following vulnerability has been resolved: RDMA/counter: Fix num_counters leak on bind_qp failure in alloc_and_bind() When __rdma_counter_bind_qp() fails in alloc_and_bind(), the error path jumps to err_mode which frees the counter without decrementing port_counter->num_counters. The only place that decrements is rdma_counter_free(), which is unreachable since the counter was never successfully bound. This leak accumulates across repeated failures, permanently preventing the port from switching to AUTO mode (-EBUSY in __counter_set_mode()) and blocking the MANUAL→NONE auto-revert in rdma_counter_free(). When the mo
In the Linux kernel, the following vulnerability has been resolved: rds: filter RDS_INFO_* getsockopt by caller's netns The RDS_INFO_* family of getsockopt(2) options reads several file-scope global lists that are not per-netns: rds_sock_info / rds6_sock_info, rds_sock_inc_info / rds6_sock_inc_info -> rds_sock_list rds_tcp_tc_info / rds6_tcp_tc_info -> rds_tcp_tc_list rds_conn_info / rds6_conn_info, rds_conn_message_info_cmn (for the *_SEND_MESSAGES and *_RETRANS_MESSAGES variants), rds_for_each_conn_info (for RDS_INFO_IB_CONNECTIONS) -> rds_conn_hash[] The ha
In the Linux kernel, the following vulnerability has been resolved: thermal/drivers/tegra/soctherma: Switch to devm cooling device registration Use devm_thermal_of_cooling_device_register() to simplify resource management and avoid manual cleanup in error paths. As a side effect this change has the benefit of solving an existing issue. Before, the function tegra_soctherm_remove() only called debugfs_remove_recursive() and never called thermal_cooling_device_unregister() for any of the cooling devices registered here. After the driver removal, the thermal framework's cdev list would still hold references to thermal_cooling_device objects w
In the Linux kernel, the following vulnerability has been resolved: ipv6: addrconf: fix temp address generation after prefix deprecation When a router temporarily deprecates an IPv6 prefix (either by sending a Router Advertisement with Preferred Lifetime = 0 or by letting the lifetime expire) and later restores it, the kernel permanently loses its ability to generate temporary privacy addresses (RFC 8981) for that prefix. This happens because the address worker attempts to generate a replacement temporary address when the current one nears expiration. As the base prefix is deprecated already, the generation fails after marking the temporar
Check your installed stack and versions against the current vulnerability feeds.