s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix wrong domain value verification with EP11 CPRBs
There is a wrong upper limit check for the domain value when an EP11
CPRB is processed for sending to a crypto card. This check is only
active on custom device nodes but may lead to access heap memory
behind perms->adm when an administrative CPRB is sent.
Add correct limit (AP_DOMAINS = 256) checking to fix this.
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix missing mem scrub at clear key import in cca_clr2cipherkey()
The helper function _ip_cprb_helper() uses internal buffer memory for
building and processing CPRBs. After use this buffer was never
scrubbed which could lead to leaving for example clear key material in
memory which could be exposed via tricky reuse of this same memory.
Extend the _ip_cprb_helper() function with another parameter 'scrub'
used to steer scrubbing of this buffer. So now the caller has the
opportunity to decide if scrubbing is needed or not.
Extend the clear key to secure key token
In the Linux kernel, the following vulnerability has been resolved:
can: j1939: transport: j1939_session_fresh_new(): initialize receive buffer
Zero the allocated buffer in j1939_session_fresh_new() to ensure it
contains no residual data.
While there is a potential performance impact if users allocate maximum
sized ETP buffers, most real-world use cases are not noticeably affected
since the maximum known buffer size is typically around 65K.
[mkl: add Message-ID]
can: softing: fw_parse(): validate firmware record spans
In the Linux kernel, the following vulnerability has been resolved:
can: softing: fw_parse(): validate firmware record spans
fw_parse() reads a fixed record header, a firmware-provided payload,
and a trailing checksum without knowing the end of the firmware blob. A
truncated record can therefore make those reads exceed the blob.
The same record also supplies addresses and lengths for writes into
DPRAM. The generic loader uses wrap-prone mixed signed arithmetic for its
bounds check, while the application loader does not bound the staging
copy at all.
Pass the firmware end to the parser and validate the full source record.
Use a signed wide
drm/amd/display: check if dml21_add_phantom_plane() is successful
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: check if dml21_add_phantom_plane() is successful
Verify that the phantom plane was allocated to avoid a later
segfault.
(cherry picked from commit 5adb54abe5a8e82cbff7f8806db30a5f4924329f)
In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: use proper context for logging
The same as the rest of the code, get_ss_info_from_atombios() uses
calc_pll_cs->ctx->logger for logging. But calc_pll_cs->ctx is
initialized only later in calc_pll_max_vco_construct(). Therefore, any
output using DC_LOG_SYNC() leads to a NULL pointer deference in
get_ss_info_from_atombios().
According to Sashiko, the very same problem exists in
dce112_get_pix_clk_dividers() and dcn3_get_pix_clk_dividers() too.
To avoid accessing the NULL context, use clk_src->base.ctx->logger
everywhere. That context in base is initialized e
drm/amdkfd: Fix missing authorization check in KFD_IOC_DBG_TRAP_DISABLE
In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Fix missing authorization check in KFD_IOC_DBG_TRAP_DISABLE
Prevent unauthorized termination of active GPU debug sessions.
Previously, users with /dev/kfd access could terminate another process's
debug session without proper ownership or ptrace authorization.
(cherry picked from commit 4db4c5ffd5585b72622ecf6ffedf2da258ee23f5)
drm/vmwgfx: fix guest_memory_dirty bitfield clobbered as size
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: fix guest_memory_dirty bitfield clobbered as size
Two sites in vmwgfx_resource.c assign boolean literals to
res->guest_memory_size, which is an unsigned long allocation-size
field; the intended target is the adjacent res->guest_memory_dirty
bitfield. After the assignments the field holds 0 or 1 instead of
the resource's MOB allocation size:
- vmw_resource_release() writes 0 (false), and
- vmw_resource_unbind_list() writes 1 (true).
Subsequent revalidation paths read guest_memory_size when computing
the dirty page range (vmw_bo_dirty_transfer_to_re
drm/vmwgfx: validate external BO copy bounds for both stride paths
In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: validate external BO copy bounds for both stride paths
vmw_external_bo_copy() trusts caller-supplied offsets, strides, and
heights and operates on imported dma-buf vmaps:
- The equal-stride memcpy() bound was clamped after subtracting the
offsets from dst_size and src_size; an offset larger than the BO
size wraps the unsigned subtraction to a huge value and the
resulting memcpy() runs off the end of the vmap. dst_stride *
height is also a u32 multiplication that can overflow.
- The non-equal-stride row-by-row path had no bound at all. The
dmaengine: idxd: fix double free of wq, engine, and group structs
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: fix double free of wq, engine, and group structs
The release callbacks for wq, engine, and group devices
(idxd_conf_wq_release, idxd_conf_engine_release,
idxd_conf_group_release) each call kfree() on the enclosing struct.
The setup error paths and cleanup functions also call kfree()
explicitly after put_device(), producing a double free whenever
put_device() drops the reference count to zero and fires the release.
In the setup functions, device_initialize() is called before
device_add(), so the reference count is exactly 1 at the error sites.
put_device()
hwmon: (ltc4282) Fix reading the minimum alarm voltage
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (ltc4282) Fix reading the minimum alarm voltage
Coverity reports an out-of-bounds access when reading the minimum alarm
voltage for the VGPIO channel. Add the missing return statement to fix
the problem.
In the Linux kernel, the following vulnerability has been resolved:
hwmon: (sht3x) Fix unaligned accesses
Sashiko reports:
In sht3x_update_client(), the 16-bit temperature and humidity values are
extracted from a stack-allocated byte array using be16_to_cpup(). The
pointers passed to this function are calculated as buf and buf + 3. Since
the difference between the two pointers is an odd number of bytes, at
least one of them is guaranteed to be at an unaligned offset.
This will trigger an alignment fault on strict-alignment architectures
such as ARMv5 or SPARC, resulting in a kernel panic.
Fix the problem by using get_unaligned_be16() ins
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: mtk_eth_soc: pass eth to mtk_handle_irq_rx in poll_controller
mtk_handle_irq_rx expects a struct mtk_eth * (matching the request_irq
cookie), but mtk_poll_controller incorrectly passed the net_device *.
Calling ndo_poll_controller with CONFIG_NET_POLL_CONTROLLER enabled
would then crash.
idpf: bound interrupt-vector register fill to the allocated array
In the Linux kernel, the following vulnerability has been resolved:
idpf: bound interrupt-vector register fill to the allocated array
idpf_get_reg_intr_vecs() fills the caller-allocated reg_vals[] array from
the VIRTCHNL2_OP_ALLOC_VECTORS reply in adapter->req_vec_chunks, bounding
its inner loop only by the per-chunk num_vectors. The array is sized
separately: idpf_intr_reg_init() allocates
kzalloc_objs(struct idpf_vec_regs, total_vecs) from
caps.num_allocated_vectors and only checks the returned count after the
fill. The sum of per-chunk num_vectors is never reconciled against
total_vecs, so a reply with a small num_allocated_vectors but c
Bluetooth: hci_sync: hold conn in hci_connect_acl/le_sync() callbacks
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hold conn in hci_connect_acl/le_sync() callbacks
There is theoretical UAF if the conn is freed while the hci_sync task
is running.
Hold refcount to avoid that.
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iblock: Fix wrong PR ops NULL check for PREEMPT/RELEASE
In the iblock_execute_pr_out() function, PRO_PREEMPT,
PRO_PREEMPT_AND_ABORT, and PRO_RELEASE all perform callback capability
checks through ops->pr_clear. The error check allows unimplemented hooks
to pass through the gate, resulting dereferencing a NULL function
pointer.
Check whether the hooks that need to be called are supported.
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
In the Linux kernel, the following vulnerability has been resolved:
tracing/mmiotrace: Add NULL check for mmio_trace_array in logging functions
mmio_trace_rw() and mmio_trace_mapping() retrieve mmio_trace_array into
tr and pass it to __trace_mmiotrace_rw() and __trace_mmiotrace_map().
If these functions are invoked while mmio_trace_array is NULL (e.g. before
initialization or after disabled), accessing tr->array_buffer.buffer will
result in a NULL pointer dereference crash.
Fix this by adding an explicit NULL check for tr at the beginning of
__trace_mmiotrace_rw() and __trace_mmiotrace_map().
mm: migrate_device: fix pte_pfn/pte_dirty called on non-present PTE
In the Linux kernel, the following vulnerability has been resolved:
mm: migrate_device: fix pte_pfn/pte_dirty called on non-present PTE
pte_pfn() and pte_dirty() have undefined behaviour when called on a
non-present PTE. In migrate_vma_collect_pmd(), these functions may be
invoked on non-present entries (e.g., device-private entries), leading
to potential crashes from pte_pfn() or incorrect dirty folio accounting
from pte_dirty(). Fix both by guarding with pte_present() checks.
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Fix NULL dereference on AIBV allocation failure
The airq_iv_create() can return NULL on failure, but the return value was
never checked. If it fails, zdev->aibv will be NULL and fail when
dereferenced in kvm_zpci_set_airq(). Add a NULL check and free the
previously allocated AISB bit and zdev->aisb on failure.
vxlan: re-fetch eth header after route_shortcircuit()
In the Linux kernel, the following vulnerability has been resolved:
vxlan: re-fetch eth header after route_shortcircuit()
Before route_shortcircuit(), the eth header pointer is cached from eth_hdr(skb).
Inside route_shortcircuit(), pskb_may_pull() can be called, which may
reallocate skb->head.
In this case, returning to vxlan_xmit() leaves the cached eth pointer pointing to
freed memory, leading to a use-after-free when dereferencing eth->h_dest.
Fix this by updating eth = eth_hdr(skb) after calling route_shortcircuit().