xhci: fix lost bounce buffers on TDs spanning several ring segments
In the Linux kernel, the following vulnerability has been resolved:
xhci: fix lost bounce buffers on TDs spanning several ring segments
When a TD reaches a link TRB with data that is not aligned to the
endpoint's wMaxPacketSize, xhci_align_td() stages the unalignable tail
through the bounce buffer of the ring segment holding that link TRB.
xhci_unmap_td_bounce_buffer() later unmaps it and, for IN transfers,
copies the data back into the URB's buffer.
The enqueue path records the segment that was bounced in td->bounce_seg,
under the assumption that a TD never spans more than two ring segments.
That assumption does not hold: a TD large enoug
tracing: Have show_event_filters/triggers files take trace array ref
In the Linux kernel, the following vulnerability has been resolved:
tracing: Have show_event_filters/triggers files take trace array ref
The newly added files show_event_filters and show_event_triggers that show
all filters or triggers that are set within the trace array do not take a
reference for the trace array it is showing. Without taking a reference,
the trace_array may be freed via "rmdir" while a task is reading one of
theses files. Those files iterate all the events within an instance
(trace_array) and nothing prevents that instance from being freed while
its data is being read. This causes a use-after-free crash.
Have the open of
tracing: Take trace_array reference when opening options file
In the Linux kernel, the following vulnerability has been resolved:
tracing: Take trace_array reference when opening options file
The options files do not take the trace_array reference for the options
they represent. This could cause a use-after-free kernel crash if one of
these files is opened by one task and another task removes the instance
that the option is for. Because it doesn't take a reference upon opening,
it will not stop the removal which will free the options descriptor that
is being used.
As the options are somewhat dynamic in their creation at boot up, each
file represents a flag in the trace_array. The trace_array has an a
spi: Fix DMA mapping ownership on partial map failure
In the Linux kernel, the following vulnerability has been resolved:
spi: Fix DMA mapping ownership on partial map failure
If RX mapping fails after TX mapping succeeds, __spi_map_msg() unmaps
TX but leaves tx_sg_mapped set. If TX mapping fails on a later
transfer, mappings created for earlier transfers remain active.
In both cases, cur_{tx,rx}_dma_dev have not yet been updated because they
are assigned only after every transfer has been mapped. The subsequent
spi_unmap_msg() may therefore unmap the TX mapping again or release
earlier mappings using a NULL or stale device. Using a NULL device can
trigger an oops. An empty SG table does not
scsi: target: iscsi: Reserve a terminator byte for the login payload
In the Linux kernel, the following vulnerability has been resolved:
scsi: target: iscsi: Reserve a terminator byte for the login payload
iscsi_target_check_login_request() rejects a login PDU whose
DataSegmentLength exceeds MAX_KEY_VALUE_PAIRS, but the test is '>' and
login->req_buf is allocated with exactly MAX_KEY_VALUE_PAIRS
bytes. Since iscsit_get_login_rx() receives payload_length + padding
bytes, where
padding = ((-payload_length) & 3);
any payload_length from 8189 to 8192 fills the whole 8192 byte
buffer. The write stays in bounds, but no byte is left for a NUL
terminator.
The buffer is subsequently consumed as a C string. In the
scsi: bsg: Cap io_uring sense copy to max_response_len
In the Linux kernel, the following vulnerability has been resolved:
scsi: bsg: Cap io_uring sense copy to max_response_len
Completion copied scmd->sense_len to the user response buffer without
honoring max_response_len. After a valid sense, the midlayer sets
sense_len to the real length (up to SCSI_SENSE_BUFFERSIZE), so a smaller
user buffer was overrun.
scsi: bsg: Fix TOCTOU in io_uring passthrough command setup
In the Linux kernel, the following vulnerability has been resolved:
scsi: bsg: Fix TOCTOU in io_uring passthrough command setup
scsi_bsg_uring_cmd() reads bsg_uring_cmd from the shared mmap'd SQE.
Userspace can change a field after we check it and before we use it.
request_len is the sharp case: it can grow past sizeof(scmd->cmnd) after
the bound check and overflow scmd->cmnd in copy_from_user().
READ_ONCE() the SQE fields we check or use into locals before use.
scsi: megaraid_sas: Limit NVMe request size to the PRP chain frame
In the Linux kernel, the following vulnerability has been resolved:
scsi: megaraid_sas: Limit NVMe request size to the PRP chain frame
megasas_make_prp_nvme() builds a command's PRP list in cmd->sg_frame, a
DMA pool buffer of instance->max_chain_frame_sz bytes, spending one
entry per NVMe page of the transfer plus one per page of the buffer for
the chain pointer. The loop runs until the transfer is described and
never checks the buffer bound.
max_hw_sectors comes straight from the MDTS the firmware reports for the
drive. On drives with a large MDTS the only thing keeping the list
inside the buffer was the block layer default of 1280 KiB, w
scsi: pm8001: Use rollback index when freeing MSI-X vectors
In the Linux kernel, the following vulnerability has been resolved:
scsi: pm8001: Use rollback index when freeing MSI-X vectors
pm8001_request_msix() unwinds previously registered handlers with
free_irq() when request_irq() fails. The rollback loop uses the failing
index i for every iteration instead of the already registered vector
index j.
That passes the wrong IRQ/dev_id pair to free_irq() and leaves the
earlier handlers installed. Use j for both pci_irq_vector() and the
matching irq_vector entry in the rollback loop.
In the Linux kernel, the following vulnerability has been resolved:
samples/damon/mtier: handle damon_stop() failure
damon_sample_mtier_stop() assumes its damon_stop() call will always
successfully stops the two DAMON contexts. Hence it deallocates the two
DAMON contexts after the damon_stop() call. However, if a given context
is already stopped, damon_stop() fails and returns an error while letting
the DAMON contexts that have not yet stopped keep running. This kind of
unexpected early DAMON context stops could happen due to memory allocation
failures in kdamond_fn(). Because damon_sample_mtier_stop() just
deallocates all DAMON context
In the Linux kernel, the following vulnerability has been resolved:
samples/damon/wsse: handle damon_start() failure
Patch series "samples/damon: handle damon_{start,stop}() failures".
All DAMON sample modules are not correctly handling failures from
damon_start(). Among those, mtier also has an additional problem for
handling of damon_stop() failures. wsse and prcl also have a problem in
their damon_call() failure handling. As a result, memory leaks, next
DAMON operation disruptions, and use-after-free can happen. Fix those.
Note that only the damon_start() failure caused issues can reliably be
reproduced. Reproducing those issues r
mm/damon/core: handle region split failure in apply_min_nr_regions()
In the Linux kernel, the following vulnerability has been resolved:
mm/damon/core: handle region split failure in apply_min_nr_regions()
damon_apply_min_nr_regions() repeatedly split each region until its size
becomes small enough to meet the user-defined low limit of the number of
regions. The loop assumes the split operation (damon_split_region_at())
will always succeed and create the new region. But the operation could
silently fail for memory allocation failures, for example.
If such failure happens and the region was the last region, the linked
list-based next region fetching returns invalid pointer. As a result,
invalid memory der
futex: Prevent rcuwait use-after-free during requeue PI
In the Linux kernel, the following vulnerability has been resolved:
futex: Prevent rcuwait use-after-free during requeue PI
On PREEMPT_RT, FUTEX_CMP_REQUEUE_PI can trigger a KASAN report
(slab-out-of-bounds) in futex_requeue_pi_complete() invocation of
rcuwait_wake_up().
The futex_q used by futex_wait_requeue_pi() is allocated on the waiter's
stack. An early wakeup can race with a PI requeue as follows:
waiter requeue task
------ ------------
futex_wait_requeue_pi()
futex_do_wait()
schedule()
futex_requeue
ftrace: Take trace_array reference before accessing its ftrace_ops
In the Linux kernel, the following vulnerability has been resolved:
ftrace: Take trace_array reference before accessing its ftrace_ops
The trace instance files set_ftrace_filter and set_ftrace_notrace was
updated to work with specific trace instances (trace_arrays). The issue is
that when these files are opened, there is a small race window where it
will use the ftrace_ops from the inode->private pointer to get a reference
to the trace_array and then take its reference. The problem is that the
ftrace_ops itself could be freed. If the rmdir on the instance happens at
the same time the set_ftrace_filter file is opened, the rmdir could have
al
HID: bpf: serialize device reference release in struct_ops destroy path
In the Linux kernel, the following vulnerability has been resolved:
HID: bpf: serialize device reference release in struct_ops destroy path
__hid_bpf_ops_destroy_device() and hid_bpf_unreg() can race on the
same registration reference, double-putting struct hid_device and
freeing it while hid_destroy_device() still uses it. Serialize the
remove/NULL decision under hdev->bpf.prog_list_lock so exactly one
path releases each registration reference: unreg re-checks ops->hdev
under the lock and returns without putting when the destroy path
already cleared it; all put_device() calls happen after the lock is
dropped, which is safe because a concu
HID: rmi: fix OOB access with undersized RMI reports
In the Linux kernel, the following vulnerability has been resolved:
HID: rmi: fix OOB access with undersized RMI reports
The hid-rmi driver sizes its writeReport/readReport buffer purely from
the report descriptor supplied by the device, with no minimum bound:
data->input_report_size = hid_report_len(input_report);
data->output_report_size = hid_report_len(output_report);
alloc_size = data->output_report_size + data->input_report_size;
data->writeReport = devm_kzalloc(&hdev->dev, alloc_size, GFP_KERNEL);
data->readReport = data->writeReport + data->output_report_size;
but then reads and writes fixed offsets into it. A device declar
HID: wacom: validate report length in wacom_intuos_pro2_bt_irq
In the Linux kernel, the following vulnerability has been resolved:
HID: wacom: validate report length in wacom_intuos_pro2_bt_irq
wacom_intuos_pro2_bt_irq() receives the wire report length in `len`
but never consults it before parsing. After the report-id gate it
unconditionally calls wacom_intuos_pro2_bt_pen() and then, selected by
features.type, a fixed chain of sub-parsers, none of which receive
`len`:
wacom_intuos_pro2_bt_pen(wacom);
if (type == INTUOSP2_BT || type == INTUOSP2S_BT) {
wacom_intuos_pro2_bt_touch(wacom);
wacom_intuos_pro2_bt_pad(wacom);
wacom_intuos_pro2_bt_battery(wacom);
} else {
wacom_intuos_gen3_bt_pad(wac
In the Linux kernel, the following vulnerability has been resolved:
dm: fix race when loading and unloading a table
If the userspace calls two concurrent table load ioctls and one of them
succeeds and the other fails, there is a race condition because
dm_setup_md_queue walks &md->table_devices without any lock. If the walk
races with dm_table_destroy -> free_devices -> dm_put_table_device, there
is access to invalid memory.
Fix this race by extending the lock over the list walk.
In the Linux kernel, the following vulnerability has been resolved:
dm: fix resume-vs-remove race
If the user issues the resume ioctl and the remove ioctl at the same
time, it may be possible that the device is resumed after it is suspended
in __dm_destroy. The result is that the table is destroyed without
calling the postsuspend method.
Dm targets expect that they may be removed only after the postsuspend
method method was called. If we break this expectation, it can cause
misbehavior in various targets. For example - in the dm-integrity target,
the reboot notifier is not unregistered, leading to use-after-free.
Fix this bug by refusing
dma-buf: dma-heap: don't publish fd before copy_to_user() succeeds
In the Linux kernel, the following vulnerability has been resolved:
dma-buf: dma-heap: don't publish fd before copy_to_user() succeeds
DMA_HEAP_IOCTL_ALLOC allocates a dma-buf and installs an fd into the
caller's fd table via dma_buf_fd() -> fd_install() before
dma_heap_ioctl() copies the result back to userspace. If the trailing
copy_to_user() fails, userspace never learns the fd number, but the
fd (and the underlying dma-buf reference) are already visible to
other threads in the same process and are leaked for the lifetime of
the process.
The obvious "close it on the failure path" fix is unsafe: once
fd_install() has run, another thread