In the Linux kernel, the following vulnerability has been resolved:
fanotify: fix use-after-free of file range info
fsnotify_pre_content() builds its file_range on the triggering task's
stack. fanotify_alloc_perm_event() saves a pointer to range.pos in the
heap-allocated permission event so copy_range_info_to_user() can report
the offset later.
The event reader can set the event state to FAN_EVENT_REPORTED and then
sleep while preparing the file descriptor. If a signal interrupts the
triggering task at that point, fanotify_get_response() changes the state
to FAN_EVENT_CANCELED and returns. This unwinds the file_range stack
frame while the
fbdev: omapfb: panel-dsi-cm: initialize lock before registering display
In the Linux kernel, the following vulnerability has been resolved:
fbdev: omapfb: panel-dsi-cm: initialize lock before registering display
dsicm_probe() registers the display before initializing ddata->lock.
Once omapdss_register_display() publishes the display, another consumer
can reach a dsicm callback that takes this mutex while it is still
uninitialized.
Initialize the mutex before registering the display so the published
callbacks always see a valid lock.
fbdev: ssd1307fb: defer I2C transfers from damage callbacks
In the Linux kernel, the following vulnerability has been resolved:
fbdev: ssd1307fb: defer I2C transfers from damage callbacks
The fbdev damage callbacks may run from fbcon while printk has disabled
preemption. They currently update the display synchronously, which enters
the sleeping I2C transfer path from atomic context.
A complete report from an RK3566 system follows:
[ 258.129004] watchdog: watchdog0: watchdog did not stop!
[ 258.129067] BUG: scheduling while atomic: systemd/1/0x00000003
[ 258.129076] Modules linked in: algif_hash algif_skcipher af_alg bnep
binfmt_misc lz4hc lz4 zram snd_soc_hdmi_codec brcmfmac_wcc hci_ua
fbdev: uvesafb: unregister connector callback on init failure
In the Linux kernel, the following vulnerability has been resolved:
fbdev: uvesafb: unregister connector callback on init failure
uvesafb_init() registers the v86d connector callback before registering
the platform driver. If platform_driver_register() fails, the function
returns the error directly and leaves the connector callback registered.
The later platform-device failure path already unregisters the callback.
Add the same cleanup before the final return when platform-driver
registration fails.
This issue was identified during our ongoing static-analysis research while
reviewing kernel code.
forcedeth: fix off-by-one when saving/restoring non-PCI config space
In the Linux kernel, the following vulnerability has been resolved:
forcedeth: fix off-by-one when saving/restoring non-PCI config space
nv_suspend() and nv_resume() walk the non-PCI configuration space with
for (i = 0; i <= np->register_size/sizeof(u32); i++)
which runs one iteration too many. saved_config_space is declared as
u32 saved_config_space[NV_PCI_REGSZ_MAX/4];
and NV_PCI_REGSZ_VER3 is equal to NV_PCI_REGSZ_MAX (0x604), so on a VER3
device register_size/sizeof(u32) is exactly the array length and the last
iteration addresses one element past the end.
The element it lands on is np->name_rx[0..3]: saved_config_space[] is
foll
fsnotify: Fix stale object mask after concurrent mark updates
In the Linux kernel, the following vulnerability has been resolved:
fsnotify: Fix stale object mask after concurrent mark updates
When a mark gets a new event bit, fanotify and inotify may avoid
recalculating the object mask if the cached aggregate already contains that
bit. This is racy with a recalculation triggered by a concurrent update to
another mark on the same connector.
The concurrent scan can read the mark before the new bit is added, while
the updater reads the old aggregate before that scan publishes its result.
The updater then skips recalculation and the scan publishes a mask without
the bit, leaving the object mask stale aft
In the Linux kernel, the following vulnerability has been resolved:
hsi: omap_ssi_core: fix missing DMA mask setup for SSI controller device
The OMAP SSI driver uses a synthetic HSI controller device allocated via
hsi_alloc_controller(), which does not go through the normal OF/platform
device initialization path.
As a result, the embedded struct device does not have a DMA mask
initialized by default.
After recent DMA API hardening changes, dma_map_sg() and related helpers
now require a valid dma_mask to be present, otherwise the driver may
crash or trigger warnings when attempting DMA mapping operations.
Fix this by explicitly initializi
hugetlb: only adjust reservation during unmapping if mapcount is 0
In the Linux kernel, the following vulnerability has been resolved:
hugetlb: only adjust reservation during unmapping if mapcount is 0
Since df7a6d1f6405, __unmap_hugepage_range can adjust reservations. In
the case of folio mapped in both a parent and a child, if the parent
unmaps the range first, the reservation adjustment will result in an
underflow of the reserved count. Once the child unmaps the range, the
count is restored. Change __unmap_hugepage_range() to check the mapcount
before adjusting the reservation.
accel/rocket: fix NULL dereference and integer overflow in rocket_job_push()
In the Linux kernel, the following vulnerability has been resolved:
accel/rocket: fix NULL dereference and integer overflow in rocket_job_push()
rocket_job_push() allocates a temporary array to hold all input and
output GEM object pointers:
bos = kvmalloc_array(job->in_bo_count + job->out_bo_count,
sizeof(void *), GFP_KERNEL);
memcpy(bos, job->in_bos, job->in_bo_count * sizeof(void *));
memcpy(&bos[job->in_bo_count], job->out_bos, ...);
Two bugs exist:
1. Missing NULL check: if kvmalloc_array() fails, bos is NULL and
the subsequent memcpy() dereferences it, causing a kernel NULL
pointer derefere
accel/rocket: initialize job domain before cleanup paths
In the Linux kernel, the following vulnerability has been resolved:
accel/rocket: initialize job domain before cleanup paths
rocket_ioctl_submit_job() releases rjob through rocket_job_put() on
allocation error paths. rocket_job_cleanup() unconditionally calls
rocket_iommu_domain_put(job->domain), but job->domain is assigned only
after task copying and BO lookups. A failure before that assignment can
therefore clean up a job with a NULL domain pointer.
Take the per-file domain reference before the first error path can release
rjob. Also clear rjob->tasks after freeing it in rocket_copy_tasks(), so
the common cleanup path cannot free the tas
accel/rocket: Fix error path handling in rocket_job_run()
In the Linux kernel, the following vulnerability has been resolved:
accel/rocket: Fix error path handling in rocket_job_run()
In rocket_job_run(), after taking an extra fence reference for
job->done_fence via dma_fence_get(), the error paths have three bugs:
- The dma_fence reference held by job->done_fence is never released,
causing a reference leak.
- pm_runtime_get_sync() increments the usage counter even on failure,
but the error path does not decrement it, leaking the runtime PM
reference and preventing the NPU from suspending.
- A valid but unsignaled fence is returned to the DRM scheduler,
which triggers WARN("Fence ... rele
acpi/apei/ghes: Use raw_spinlock_t for CXL CPER work locks
In the Linux kernel, the following vulnerability has been resolved:
acpi/apei/ghes: Use raw_spinlock_t for CXL CPER work locks
The CXL CPER work registration and unregistration helpers acquire
cxl_cper_work_lock and cxl_cper_prot_err_work_lock with a spinlock
guard(), which leaves local interrupts enabled. The corresponding post
paths (cxl_cper_post_event(), cxl_cper_post_prot_err()) execute in hard
IRQ context (they are called from the GHES error notification path) and
acquire the same locks with an irqsave guard().
If a CPU is holding one of these locks via a spinlock guard() when a GHES
interrupt arrives on the same CPU, the IRQ handler
ACPI: APEI: GHES: fix ARM section length accounting after header
In the Linux kernel, the following vulnerability has been resolved:
ACPI: APEI: GHES: fix ARM section length accounting after header
In ghes_handle_arm_hw_error(), after skipping the cper_sec_proc_arm
header with (err + 1), the remaining length was reduced by sizeof(err)
(pointer size) instead of sizeof(*err) (structure size).
That overestimates the bytes left for cper_arm_err_info records and can
let the parser read past the CPER section when err_info_num is large
enough relative to error_data_length.
Use sizeof(*err) so the length accounting matches the pointer advance
and the earlier sizeof(*err) size check.
ACPI: pfr_update: fix stack buffer overflow in query_capability()
In the Linux kernel, the following vulnerability has been resolved:
ACPI: pfr_update: fix stack buffer overflow in query_capability()
query_capability() copies four ACPI buffer objects returned by the
firmware _DSM into fixed-size u8[16] fields in struct
pfru_update_cap_info using memcpy with the firmware-supplied length:
memcpy(&cap_hdr->code_type,
elements[CAP_CODE_TYPE_IDX].buffer.pointer,
elements[CAP_CODE_TYPE_IDX].buffer.length);
The same pattern repeats for drv_type, platform_id, and oem_id.
If the firmware returns buffer.length > 16 for any of these fields,
memcpy writes past the destination array.
struct pfru
ata: libata-scsi: fix DSM TRIM for sector sizes larger than 2048 bytes
In the Linux kernel, the following vulnerability has been resolved:
ata: libata-scsi: fix DSM TRIM for sector sizes larger than 2048 bytes
ata_scsi_write_same_xlat() translates a SCSI WRITE SAME command with the
UNMAP bit set into an ATA DATA SET MANAGEMENT TRIM command. The TRIM
descriptor is built by ata_format_dsm_trim_descr() into the 2048-byte
ata_scsi_rbuf staging buffer, and the number of bytes copied is compared
against the logical sector size by the caller:
size = ata_format_dsm_trim_descr(scmd, trmax, block, n_block);
if (size != len) /* len == sdp->sector_size */
goto invalid_param_len;
ata_format_dsm_trim_descr() clamps
auxdisplay: charlcd: cancel backlight work on registration failure
In the Linux kernel, the following vulnerability has been resolved:
auxdisplay: charlcd: cancel backlight work on registration failure
With CONFIG_CHARLCD_BL_FLASH, charlcd_init() schedules bl_work before
charlcd_register() calls misc_register(). If registration fails, the
caller frees the charlcd object while delayed work still contains its
address.
Add charlcd_deinit() to cancel the delayed work and turn the backlight
off. Use it for both registration rollback and normal unregistration.
block: validate user space vectors during extraction
In the Linux kernel, the following vulnerability has been resolved:
block: validate user space vectors during extraction
The bio-based drivers don't necessarily check the alignment split, and
stacking block drivers don't always handle a misalignment detected after
submitting the bio. Validate user vectors against the device's
dma_alignment as the bio is built from the iov_iter, rejecting
misaligned early with -EINVAL.
Bluetooth: eir: Fix OOB read in eir_get_service_data()
In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: eir: Fix OOB read in eir_get_service_data()
eir_get_service_data() walks the advertising data for a Service Data
field with a matching UUID. On a mismatch it advances:
eir += dlen;
eir_len -= dlen;
eir_get_data() reports dlen as the field's data length, but the field
spans dlen + 2 bytes once its length and type bytes count, and more
when non-Service-Data fields were skipped to reach it. The pointer
lands correctly on the next field. eir_len does not, and the shortfall
compounds across fields until eir_get_data() reads the length and type
bytes of a
bnx2x: fix double free in bnx2x_init_firmware() error path
In the Linux kernel, the following vulnerability has been resolved:
bnx2x: fix double free in bnx2x_init_firmware() error path
bnx2x_init_firmware() frees bp->init_ops, bp->init_data and
bp->init_ops_offsets in its error path without setting them to NULL.
The cleanup function bnx2x_release_firmware() frees the same three
pointers unconditionally, so if init_firmware fails and
release_firmware is later called (e.g. from __bnx2x_remove or through
the function state machine), all three are freed a second time.
Set each pointer to NULL after kfree() in the error path so that the
subsequent kfree(NULL) in bnx2x_release_firmware() is a safe no-o
bpf, x86: Fix per-CPU address resolution into an extended register
In the Linux kernel, the following vulnerability has been resolved:
bpf, x86: Fix per-CPU address resolution into an extended register
The destination of the per-CPU address MOV is encoded in ModRM.reg,
which is extended by REX.R, but the REX prefix is built with
add_1mod(), which sets REX.B. REX.B extends ModRM.rm and SIB.base, and
this instruction addresses memory as disp32 with no base, so the bit
has no effect at all and the high register bit is simply lost.
Every is_ereg() destination therefore resolves to the wrong register,
picking whichever one shares the low three bits:
R5 -> RAX R7 -> RBP R8 -> RSI R9 -> RDI
With BPF