In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: cortina: Ack RX overrun interrupt correctly
The RX overrun interrupt is reported in interrupt status register 4, but
gmac_irq() acknowledges it using the RX descriptor error bit from status
register 0. For GMAC0 this writes the GMAC1 overrun bit, while for GMAC1
the shift leaves no bit in the 32-bit register.
Acknowledge the same per-port RX overrun bit that was detected.
net: psp: avoid conflicts with skb->decrypted and sk_validate_xmit_skb()
In the Linux kernel, the following vulnerability has been resolved:
net: psp: avoid conflicts with skb->decrypted and sk_validate_xmit_skb()
PSP conflicts with TLS ULP in its usage of both skb->decrypted and
sk->sk_validate_xmit_skb().
Make PSP mutually exclusive with TLS ULP, the only other user of either
of these. As other users of skb->decrypted come along, they can be added
to sk_has_decrypt_user(). It would make sense to also assert that
sk->sk_validate_xmit_skb() is also NULL in both of these setup paths for
similar future proofing, but the PSP listener/sk_clone() path is still
broken and it could be seen as a regression to not allow
x86/kprobes: Fix crash when probing CS CALL instructions
In the Linux kernel, the following vulnerability has been resolved:
x86/kprobes: Fix crash when probing CS CALL instructions
When using eBPF to probe CS CALL instructions within a function,
a crash can be triggered.
The eBPF tool probes offset 257 of the __hrtimer_run_queues()
function:
<__hrtimer_run_queues+249>: nopl 0x0(%rax,%rax,1)
<__hrtimer_run_queues+254>: mov %r14,%rdi
<__hrtimer_run_queues+257>: cs call <__x86_indirect_thunk_r12>
<__hrtimer_run_queues+263>: mov %eax,%r12d
<__hrtimer_run_queues+266>: xchg %ax,%ax
<__hrtimer_run_queues+268>: mov %r13,%rdi
Which triggers this crash:
BUG: unable to handle page
net: mvpp2: prevent buffer overflow in page_pool allocation
In the Linux kernel, the following vulnerability has been resolved:
net: mvpp2: prevent buffer overflow in page_pool allocation
The per‑processor buffering scheme is supported only if the
number of pools (nrxqs * 2) does not exceed MVPP2_BM_MAX_POOLS (8).
This is already checked in mvpp2_probe() during the initial
activation of percpu_pools.
However, mvpp2_change_mtu() may later call
mvpp2_bm_switch_buffers(priv, true) without this check, which can
lead to an out-of-bounds access in the priv->page_pool array in
mvpp2_bm_init(). The array is sized to hold MVPP2_PORT_MAX_RXQ
entries, and mvpp2_get_nrxqs() may return exactly that value. The
p
net: skbuff: do not leave stale header offsets after pskb_carve()
In the Linux kernel, the following vulnerability has been resolved:
net: skbuff: do not leave stale header offsets after pskb_carve()
pskb_carve_inside_header() and pskb_carve_inside_nonlinear() remove
the first bytes of a packet and reallocate skb->head.
All the headers that were present before the operation are gone,
but both functions call skb_headers_offset_update(skb, 0), which
is a no-op : skb->mac_header, skb->network_header,
skb->transport_header and skb->csum_start keep their old values and
now describe bytes which are no longer there.
Both helpers size the new head from the old skb_end_offset(), so the
stale offsets still land i
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: check ras and obj before dereference
nbio_v7_9_handle_ras_controller_intr_no_bifring() dereferences ras and obj
without checking either for NULL. Both amdgpu_ras_get_context() and
amdgpu_ras_find_obj() can return NULL, e.g. during the window between
adev->nbio.ras being set (early in amdgpu_ras_init(), by design, to
enable the fatal-error interrupt as soon as possible) and the PCIE_BIF
ras object actually being created in RAS late_init. Any interrupt in that
window crashes in hard-IRQ context.
This is analogous to commit d190b459b2a4 ("drm/amdgpu: the warning
d
btrfs: abort transaction on failure to update inode for hole punching and reflinking
In the Linux kernel, the following vulnerability has been resolved:
btrfs: abort transaction on failure to update inode for hole punching and reflinking
If we fail to update the inode we error out without aborting the
transaction, which can result in a persistent inconsistency if after
the failure the transaction is committed, as we have dropped file
extent items from a range and either punched a hole or insert a new file
extent item for that range (for reflinks).
So add the missing transaction abort.
perf: Fix null pointer access in is_include_guest_event()
In the Linux kernel, the following vulnerability has been resolved:
perf: Fix null pointer access in is_include_guest_event()
A typical module unload occurring event when there is an active perf
connection leads to freeing of the pmu pointer. The call log is something
like:
..
__pmu_detach_event
pmu_detach_event
pmu_detach_events
perf_pmu_unregister
..
__pmu_detach_event() sets event->pmu to null. When the perf connection
finally is closed, the following stack trace is observed:
Oops: general protection fault, kernel NULL pointer dereference
...
RIP: 0010:_free_event+0x3e/0x370
...
Call Trace:
...
perf_event_release_kernel+0x
9p: Fix v9fs_issue_write() to update i_size and remote_i_size
In the Linux kernel, the following vulnerability has been resolved:
9p: Fix v9fs_issue_write() to update i_size and remote_i_size
Fix v9fs_issue_write() to update i_size and remote_i_size to the new size
of the server file if we made it larger, using the start fpos and the count
returned by p9_client_write() to calculate the new minimum file size.
This assumes that if the 9P server makes a short write (say it hits
ENOSPC), a reduced count is returned.
ALSA: core: Fix potential UAF after asynchronous card release
In the Linux kernel, the following vulnerability has been resolved:
ALSA: core: Fix potential UAF after asynchronous card release
Usually a sound driver releases the resources assigned to the card via
snd_card_free(), and it synchronizes with the whole release procedure.
However, when the card is released asynchronously via
snd_card_free_when_closed() like USB-audio driver, the situation is
slightly different; although the snd_card_disconnect() call at the
disconnection guarantees that any newer accesses will be gated, the
in-flight tasks might be still accessing to the underlying card->dev
device even after the disconnection, which would c
ALSA: usb-audio: Clamp implicit feedback packet count to URB capacity
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Clamp implicit feedback packet count to URB capacity
data_ep_set_params() allocates each data URB for exactly u->packets
isochronous frames, so urb->iso_frame_desc[] has u->packets slots and
ctx->packets is the driver's only record of that limit. For an implicit
feedback sink, snd_usb_queue_pending_output_urbs() overwrites it with the
sync source's packet count, which is calculated independently from the
capture endpoint's parameters. When that count is larger,
prepare_playback_urb() and prepare_silent_urb() can write
iso_frame_desc[] past the allocation; t
ALSA: virtio: reset device before deleting virtqueues
In the Linux kernel, the following vulnerability has been resolved:
ALSA: virtio: reset device before deleting virtqueues
virtsnd_remove() and virtsnd_freeze() delete the virtqueues before
resetting the device. del_vqs() frees the vring backing, but does not
provide a generic device quiesce operation. In particular, modern
virtio-pci keeps enabled queues active until the device is reset.
Reset the device before deleting the virtqueues so it can no longer
access the vring memory when that memory is released. This also covers
probe failures after DRIVER_OK, which unwind through virtsnd_remove().
In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: rt712-sdca-dmic: fix uninitialized stream_config->type
stream_config is not initialized before being passed to
sdw_stream_add_slave(). The type field may contain garbage and is
later copied to stream->type by sdw_config_stream().
Zero-initialize stream_config so type defaults to SDW_STREAM_PCM.
While at it, use snd_sdw_params_to_config() helper instead of
open-coding the same logic.
ata: libahci: clear PxCLBU and PxFBU for AHCI_HFLAG_32BIT_ONLY
In the Linux kernel, the following vulnerability has been resolved:
ata: libahci: clear PxCLBU and PxFBU for AHCI_HFLAG_32BIT_ONLY
A user reported that commit 105c42566a55 ("ata: ahci: force 32-bit DMA for
JMicron JMB582/JMB585") made the JMicron JMB585 unusable on his board.
The failure is seen as soon as the ahci driver is probed, and booting with
iommu=off does not solve the problem.
Looking at the AHCI specification, PxCLBU and PxFBU are both read only '0'
for HBAs that do not support 64-bit addressing.
For HBAs that do support 64-bit addressing, the registers are read write,
with a reset value that is Implementation Specific.
When
cifs: Fix server use-after-free in cifs_chan_skip_or_disable()
In the Linux kernel, the following vulnerability has been resolved:
cifs: Fix server use-after-free in cifs_chan_skip_or_disable()
When a secondary channel is no longer supported by the server,
cifs_chan_skip_or_disable() drops the channel reference with
cifs_put_tcp_session() and then continues to use the server pointer by
calling cifs_signal_cifsd_for_reconnect() on it and reading its
primary_server pointer. cifs_put_tcp_session() can drop the last
reference of the channel and tear it down, so both the channel and the
primary server (whose reference is also dropped by
cifs_put_tcp_session()) can be freed before they are signaled for
recon
High · CVSS 7.8EPSS 0.18%Public exploitFix available
exec: Cleanup POSIX timers right after de_thread()
In the Linux kernel, the following vulnerability has been resolved:
exec: Cleanup POSIX timers right after de_thread()
A per-thread CPU timer holds a reference to the PID of the thread it is
attached to and, while it is armed, its node is queued in that thread's
posix_cputimers. The task is looked up by that PID.
When a non-leader thread exec()s, de_thread() changes which task owns
that PID. pid_task(timer->it.cpu.pid, PIDTYPE_PID) then returns NULL,
but the node is still queued on tsk, which is alive. timer_lock_sighand()
takes a failed lookup to mean that the node is already dequeued, so it
has nothing to undo.
begin_new_exec() calls po
fs/dax: check zero or empty entry before converting xarray entry
In the Linux kernel, the following vulnerability has been resolved:
fs/dax: check zero or empty entry before converting xarray entry
Calling dax_to_folio() with empty entry causes kernel panic below when
booting a VM with DAX enabled storage.
This patch checks empty entry before calling dax_to_folio() on
dax_associate_entry(), dax_disassociate_entry(), and dax_busy_page().
Commit 98c183a4fccf ("fs/dax: don't disassociate zero page entries") added
guards in the associate and disassociate paths, but the guards still come
after dax_to_folio(), and dax_busy_page() still has the same problem.
[ 0.737679] EXT4-fs (pmem0p1): mounted filesyst
posix-cpu-timers: Prevent freeing a timer which is queued on the expiry list
In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Prevent freeing a timer which is queued on the expiry list
Kijo analyzed another race in the POSIX CPU timer code:
Commit bf635681c906 converted cpu_timer::firing from a tristate value to a
boolean. This lost the distinction between "not owned by the firing list"
and "still owned, but delivery was canceled". The resulting race is:
expiry handler timer_settime() timer_delete()
-------------- --------------- --------------
collect timer onto
private firing list
firing = true
rds: ib: use rds_conn_drop() on protocol version mismatch
In the Linux kernel, the following vulnerability has been resolved:
rds: ib: use rds_conn_drop() on protocol version mismatch
rds_ib_cm_connect_complete() runs from the RDMA-CM event handler with
conn->c_cm_lock held. When the peer negotiates a protocol version
older than RDS_PROTOCOL_COMPAT_VERSION, the handler calls
rds_conn_destroy(), which is only safe in the rmmod path: it
synchronously tears the connection down and flush_work()es the
shutdown work cp_down_w.
That shutdown work (rds_conn_shutdown()) needs cp_cm_lock, which is
the very lock the event handler still holds, so the flush never
completes: the two workers wait on each other
High · CVSS 7.8EPSS 0.14%Public exploitFix available
signal: Prevent exec() race
In the Linux kernel, the following vulnerability has been resolved:
signal: Prevent exec() race
Hyunwoo debugged the following KASAN UAF splat:
BUG: KASAN: slab-use-after-free in __send_signal_locked+0xb27/0xba0
Write of size 8 at addr ffff888007ed80c8 by task poc/79
...
Call Trace:
__send_signal_locked+0xb27/0xba0
do_send_sig_info+0xa7/0x160
do_send_specific+0x76/0xa0
__x64_sys_tgkill+0x193/0x270
...
Allocated by task 80:
do_timer_create+0x1a4/0x1030
__x64_sys_timer_create+0x145/0x190
...
Freed by task 12:
kmem_cache_free_bulk+0x1f8/0x4a0
kvfree_rcu_bulk+0x14f/0x1c0
kfree_rcu_work+0x128/0x1a0
.