dm: fix mempool NULL pointer race when completing IO
In the Linux kernel, the following vulnerability has been resolved:
dm: fix mempool NULL pointer race when completing IO
dm_io_dec_pending() calls end_io_acct() first and will then dec md
in-flight pending count. But if a task is swapping DM table at same
time this can result in a crash due to mempool->elements being NULL:
task1 task2
do_resume
->do_suspend
->dm_wait_for_completion
bio_endio
->clone_endio
->dm_io_dec_pending
->end_io_acct
->wakeup task1
->dm_swap_table
->__bind
->__bind_mempools
->bioset_exit
->mempool_exit
xhci: Fix command ring pointer corruption while aborting a command
In the Linux kernel, the following vulnerability has been resolved:
xhci: Fix command ring pointer corruption while aborting a command
The command ring pointer is located at [6:63] bits of the command
ring control register (CRCR). All the control bits like command stop,
abort are located at [0:3] bits. While aborting a command, we read the
CRCR and set the abort bit and write to the CRCR. The read will always
give command ring pointer as all zeros. So we essentially write only
the control bits. Since we split the 64 bit write into two 32 bit writes,
there is a possibility of xHC command ring stopped before the upper
dword (all zeros) is wri
drm/radeon: fix a possible null pointer dereference
In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: fix a possible null pointer dereference
In radeon_fp_native_mode(), the return value of drm_mode_duplicate()
is assigned to mode, which will lead to a NULL pointer dereference
on failure of drm_mode_duplicate(). Add a check to avoid npd.
The failure status of drm_cvt_mode() on the other path is checked too.
IB/hfi1: Restore allocated resources on failed copyout
In the Linux kernel, the following vulnerability has been resolved:
IB/hfi1: Restore allocated resources on failed copyout
Fix a resource leak if an error occurs.
IB/IPoIB: Fix legacy IPoIB due to wrong number of queues
In the Linux kernel, the following vulnerability has been resolved:
IB/IPoIB: Fix legacy IPoIB due to wrong number of queues
The cited commit creates child PKEY interfaces over netlink will
multiple tx and rx queues, but some devices doesn't support more than 1
tx and 1 rx queues. This causes to a crash when traffic is sent over the
PKEY interface due to the parent having a single queue but the child
having multiple queues.
This patch fixes the number of queues to 1 for legacy IPoIB at the
earliest possible point in time.
BUG: kernel NULL pointer dereference, address: 000000000000036b
PGD 0 P4D 0
Oops: 0000 [#1] SMP
CPU: 4 PID: 209665 Com
In the Linux kernel, the following vulnerability has been resolved:
ice: Do not use WQ_MEM_RECLAIM flag for workqueue
When both ice and the irdma driver are loaded, a warning in
check_flush_dependency is being triggered. This is due to ice driver
workqueue being allocated with the WQ_MEM_RECLAIM flag and the irdma one
is not.
According to kernel documentation, this flag should be set if the
workqueue will be involved in the kernel's memory reclamation flow.
Since it is not, there is no need for the ice driver's WQ to have this
flag set so remove it.
Example trace:
[ +0.000004] workqueue: WQ_MEM_RECLAIM ice:ice_service_task [ice] is flus
In the Linux kernel, the following vulnerability has been resolved:
net: USB: Fix wrong-direction WARNING in plusb.c
The syzbot fuzzer detected a bug in the plusb network driver: A
zero-length control-OUT transfer was treated as a read instead of a
write. In modern kernels this error provokes a WARNING:
usb 1-1: BOGUS control dir, pipe 80000280 doesn't match bRequestType c0
WARNING: CPU: 0 PID: 4645 at drivers/usb/core/urb.c:411
usb_submit_urb+0x14a7/0x1880 drivers/usb/core/urb.c:411
Modules linked in:
CPU: 1 PID: 4645 Comm: dhcpcd Not tainted
6.2.0-rc6-syzkaller-00050-g9f266ccaa2f5 #0
Hardware name: Google Google Compute Engine/Google Co
mmc: sdio: fix possible resource leaks in some error paths
In the Linux kernel, the following vulnerability has been resolved:
mmc: sdio: fix possible resource leaks in some error paths
If sdio_add_func() or sdio_init_func() fails, sdio_remove_func() can
not release the resources, because the sdio function is not presented
in these two cases, it won't call of_node_put() or put_device().
To fix these leaks, make sdio_func_present() only control whether
device_del() needs to be called or not, then always call of_node_put()
and put_device().
In error case in sdio_init_func(), the reference of 'card->dev' is
not get, to avoid redundant put in sdio_free_func_cis(), move the
get_device() to sdio_alloc_
mmc: mmc_spi: fix error handling in mmc_spi_probe()
In the Linux kernel, the following vulnerability has been resolved:
mmc: mmc_spi: fix error handling in mmc_spi_probe()
If mmc_add_host() fails, it doesn't need to call mmc_remove_host(),
or it will cause null-ptr-deref, because of deleting a not added
device in mmc_remove_host().
To fix this, goto label 'fail_glue_init', if mmc_add_host() fails,
and change the label 'fail_add_host' to 'fail_gpiod_request'.
sched/psi: Fix use-after-free in ep_remove_wait_queue()
In the Linux kernel, the following vulnerability has been resolved:
sched/psi: Fix use-after-free in ep_remove_wait_queue()
If a non-root cgroup gets removed when there is a thread that registered
trigger and is polling on a pressure file within the cgroup, the polling
waitqueue gets freed in the following path:
do_rmdir
cgroup_rmdir
kernfs_drain_open_files
cgroup_file_release
cgroup_pressure_release
psi_trigger_destroy
However, the polling thread still has a reference to the pressure file and
will access the freed waitqueue when the file is closed or upon exit:
fput
ep_eventpoll_release
ep_fr
nilfs2: fix underflow in second superblock position calculations
In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix underflow in second superblock position calculations
Macro NILFS_SB2_OFFSET_BYTES, which computes the position of the second
superblock, underflows when the argument device size is less than 4096
bytes. Therefore, when using this macro, it is necessary to check in
advance that the device size is not less than a lower limit, or at least
that underflow does not occur.
The current nilfs2 implementation lacks this check, causing out-of-bound
block access when mounting devices smaller than 4096 bytes:
I/O error, dev loop0, sector 36028797018963960 op 0x0:(READ) f
net/usb: kalmia: Don't pass act_len in usb_bulk_msg error path
In the Linux kernel, the following vulnerability has been resolved:
net/usb: kalmia: Don't pass act_len in usb_bulk_msg error path
syzbot reported that act_len in kalmia_send_init_packet() is
uninitialized when passing it to the first usb_bulk_msg error path. Jiri
Pirko noted that it's pointless to pass it in the error path, and that
the value that would be printed in the second error path would be the
value of act_len from the first call to usb_bulk_msg.[1]
With this in mind, let's just not pass act_len to the usb_bulk_msg error
paths.
1: https://lore.kernel.org/lkml/Y9pY61y1nwTuzMOa@nanopsycho/
In the Linux kernel, the following vulnerability has been resolved:
pinctrl: single: fix potential NULL dereference
Added checking of pointer "function" in pcs_set_mux().
pinmux_generic_get_function() can return NULL and the pointer
"function" was dereferenced without checking against NULL.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix gart.bo pin_count leak
gmc_v{9,10}_0_gart_disable() isn't called matched with
correspoding gart_enbale function in SRIOV case. This will
lead to gart.bo pin_count leak on driver unload.
bpf, s390: Fix potential memory leak about jit_data
In the Linux kernel, the following vulnerability has been resolved:
bpf, s390: Fix potential memory leak about jit_data
Make sure to free jit_data through kfree() in the error path.
i2c: acpi: fix resource leak in reconfiguration device addition
In the Linux kernel, the following vulnerability has been resolved:
i2c: acpi: fix resource leak in reconfiguration device addition
acpi_i2c_find_adapter_by_handle() calls bus_find_device() which takes a
reference on the adapter which is never released which will result in a
reference count leak and render the adapter unremovable. Make sure to
put the adapter after creating the client in the same manner that we do
for OF.
[wsa: fixed title]
i40e: Fix freeing of uninitialized misc IRQ vector
In the Linux kernel, the following vulnerability has been resolved:
i40e: Fix freeing of uninitialized misc IRQ vector
When VSI set up failed in i40e_probe() as part of PF switch set up
driver was trying to free misc IRQ vectors in
i40e_clear_interrupt_scheme and produced a kernel Oops:
Trying to free already-free IRQ 266
WARNING: CPU: 0 PID: 5 at kernel/irq/manage.c:1731 __free_irq+0x9a/0x300
Workqueue: events work_for_cpu_fn
RIP: 0010:__free_irq+0x9a/0x300
Call Trace:
? synchronize_irq+0x3a/0xa0
free_irq+0x2e/0x60
i40e_clear_interrupt_scheme+0x53/0x190 [i40e]
i40e_probe.part.108+0x134b/0x1a40 [i40e]
? kmem_c
In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau/debugfs: fix file release memory leak
When using single_open() for opening, single_release() should be
called, otherwise the 'op' allocated in single_open() will be leaked.
net/sched: sch_taprio: properly cancel timer from taprio_destroy()
In the Linux kernel, the following vulnerability has been resolved:
net/sched: sch_taprio: properly cancel timer from taprio_destroy()
There is a comment in qdisc_create() about us not calling ops->reset()
in some cases.
err_out4:
/*
* Any broken qdiscs that would require a ops->reset() here?
* The qdisc was never in action so it shouldn't be necessary.
*/
As taprio sets a timer before actually receiving a packet, we need
to cancel it from ops->destroy, just in case ops->reset has not
been called.
syzbot reported:
ODEBUG: free active (active state 0) object type: hrtimer hint: advance_sched+0x0/0x9a0 arch/x86/include/asm/atomic64