In the Linux kernel, the following vulnerability has been resolved:
iommu: Fix error unwind in iommu_group_alloc()
If either iommu_group_grate_file() fails then the
iommu_group is leaked.
Destroy it on these error paths.
Found by kselftest/iommu/iommufd_fail_nth
ubi: ubi_wl_put_peb: Fix infinite loop when wear-leveling work failed
In the Linux kernel, the following vulnerability has been resolved:
ubi: ubi_wl_put_peb: Fix infinite loop when wear-leveling work failed
Following process will trigger an infinite loop in ubi_wl_put_peb():
ubifs_bgt ubi_bgt
ubifs_leb_unmap
ubi_leb_unmap
ubi_eba_unmap_leb
ubi_wl_put_peb wear_leveling_worker
e1 = rb_entry(rb_first(&ubi->used)
e2 = get_peb_for_wl(ubi)
ubi_io_read_vid_hdr // return err (flash fault)
out_error:
ubi->move_from = ubi->move_to = NULL
wl_entry_destroy(ubi, e1)
ubi->lookuptbl[e->pnum] = NULL
retry:
e = ubi->lookuptbl[pnum];
kobject: Add sanity check for kset->kobj.ktype in kset_register()
In the Linux kernel, the following vulnerability has been resolved:
kobject: Add sanity check for kset->kobj.ktype in kset_register()
When I register a kset in the following way:
static struct kset my_kset;
kobject_set_name(&my_kset.kobj, "my_kset");
ret = kset_register(&my_kset);
A null pointer dereference exception is occurred:
[ 4453.568337] Unable to handle kernel NULL pointer dereference at \
virtual address 0000000000000028
... ...
[ 4453.810361] Call trace:
[ 4453.813062] kobject_get_ownership+0xc/0x34
[ 4453.817493] kobject_add_internal+0x98/0x274
[ 4453.822005] kset_register+0x5c/0xb4
[ 4453.825820] my_kobj_init+0x44
ipv6: Add lwtunnel encap size of all siblings in nexthop calculation
In the Linux kernel, the following vulnerability has been resolved:
ipv6: Add lwtunnel encap size of all siblings in nexthop calculation
In function rt6_nlmsg_size(), the length of nexthop is calculated
by multipling the nexthop length of fib6_info and the number of
siblings. However if the fib6_info has no lwtunnel but the siblings
have lwtunnels, the nexthop length is less than it should be, and
it will trigger a warning in inet6_rt_notify() as follows:
WARNING: CPU: 0 PID: 6082 at net/ipv6/route.c:6180 inet6_rt_notify+0x120/0x130
......
Call Trace:
<TASK>
fib6_add_rt2node+0x685/0xa30
fib6_add+0x96/0x1b0
ip6_route_add+0x50/0xd0
inet
iw_cxgb4: Fix potential NULL dereference in c4iw_fill_res_cm_id_entry()
In the Linux kernel, the following vulnerability has been resolved:
iw_cxgb4: Fix potential NULL dereference in c4iw_fill_res_cm_id_entry()
This condition needs to match the previous "if (epcp->state == LISTEN) {"
exactly to avoid a NULL dereference of either "listen_ep" or "ep". The
problem is that "epcp" has been re-assigned so just testing
"if (epcp->state == LISTEN) {" a second time is not sufficient.
In the Linux kernel, the following vulnerability has been resolved:
usb: xhci: tegra: fix sleep in atomic call
When we set the dual-role port to Host mode, we observed the following
splat:
[ 167.057718] BUG: sleeping function called from invalid context at
include/linux/sched/mm.h:229
[ 167.057872] Workqueue: events tegra_xusb_usb_phy_work
[ 167.057954] Call trace:
[ 167.057962] dump_backtrace+0x0/0x210
[ 167.057996] show_stack+0x30/0x50
[ 167.058020] dump_stack_lvl+0x64/0x84
[ 167.058065] dump_stack+0x14/0x34
[ 167.058100] __might_resched+0x144/0x180
[ 167.058140] __might_sleep+0x64/0xd0
[ 167.058171] slab_pre_alloc_hook.c
In the Linux kernel, the following vulnerability has been resolved:
x86/MCE/AMD: Use an u64 for bank_map
Thee maximum number of MCA banks is 64 (MAX_NR_BANKS), see
a0bc32b3cacf ("x86/mce: Increase maximum number of banks to 64").
However, the bank_map which contains a bitfield of which banks to
initialize is of type unsigned int and that overflows when those bit
numbers are >= 32, leading to UBSAN complaining correctly:
UBSAN: shift-out-of-bounds in arch/x86/kernel/cpu/mce/amd.c:1365:38
shift exponent 32 is too large for 32-bit type 'int'
Change the bank_map to a u64 and use the proper BIT_ULL() macro when
modifying bits in there.
In the Linux kernel, the following vulnerability has been resolved:
ext4: improve error handling from ext4_dirhash()
The ext4_dirhash() will *almost* never fail, especially when the hash
tree feature was first introduced. However, with the addition of
support of encrypted, casefolded file names, that function can most
certainly fail today.
So make sure the callers of ext4_dirhash() properly check for
failures, and reflect the errors back up to their callers.
In the Linux kernel, the following vulnerability has been resolved:
pwm: lpc32xx: Remove handling of PWM channels
Because LPC32xx PWM controllers have only a single output which is
registered as the only PWM device/channel per controller, it is known in
advance that pwm->hwpwm value is always 0. On basis of this fact
simplify the code by removing operations with pwm->hwpwm, there is no
controls which require channel number as input.
Even though I wasn't aware at the time when I forward ported that patch,
this fixes a null pointer dereference as lpc32xx->chip.pwms is NULL
before devm_pwmchip_add() is called.
drm/amdgpu/gfx: disable gfx9 cp_ecc_error_irq only when enabling legacy gfx ras
In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx: disable gfx9 cp_ecc_error_irq only when enabling legacy gfx ras
gfx9 cp_ecc_error_irq is only enabled when legacy gfx ras is assert.
So in gfx_v9_0_hw_fini, interrupt disablement for cp_ecc_error_irq
should be executed under such condition, otherwise, an amdgpu_irq_put
calltrace will occur.
[ 7283.170322] RIP: 0010:amdgpu_irq_put+0x45/0x70 [amdgpu]
[ 7283.170964] RSP: 0018:ffff9a5fc3967d00 EFLAGS: 00010246
[ 7283.170967] RAX: ffff98d88afd3040 RBX: ffff98d89da20000 RCX: 0000000000000000
[ 7283.170969] RDX: 0000000000000000 RSI: ffff98d89da2bef8 RDI: ffff98d8
In the Linux kernel, the following vulnerability has been resolved:
ionic: catch failure from devlink_alloc
Add a check for NULL on the alloc return. If devlink_alloc() fails and
we try to use devlink_priv() on the NULL return, the kernel gets very
unhappy and panics. With this fix, the driver load will still fail,
but at least it won't panic the kernel.
soundwire: qcom: fix storing port config out-of-bounds
In the Linux kernel, the following vulnerability has been resolved:
soundwire: qcom: fix storing port config out-of-bounds
The 'qcom_swrm_ctrl->pconfig' has size of QCOM_SDW_MAX_PORTS (14),
however we index it starting from 1, not 0, to match real port numbers.
This can lead to writing port config past 'pconfig' bounds and
overwriting next member of 'qcom_swrm_ctrl' struct. Reported also by
smatch:
drivers/soundwire/qcom.c:1269 qcom_swrm_get_port_config() error: buffer overflow 'ctrl->pconfig' 14 <= 14
scsi: iscsi_tcp: Check that sock is valid before iscsi_set_param()
In the Linux kernel, the following vulnerability has been resolved:
scsi: iscsi_tcp: Check that sock is valid before iscsi_set_param()
The validity of sock should be checked before assignment to avoid incorrect
values. Commit 57569c37f0ad ("scsi: iscsi: iscsi_tcp: Fix null-ptr-deref
while calling getpeername()") introduced this change which may lead to
inconsistent values of tcp_sw_conn->sendpage and conn->datadgst_en.
Fix the issue by moving the position of the assignment.
In the Linux kernel, the following vulnerability has been resolved:
ibmvnic: Do not reset dql stats on NON_FATAL err
All ibmvnic resets, make a call to netdev_tx_reset_queue() when
re-opening the device. netdev_tx_reset_queue() resets the num_queued
and num_completed byte counters. These stats are used in Byte Queue
Limit (BQL) algorithms. The difference between these two stats tracks
the number of bytes currently sitting on the physical NIC. ibmvnic
increases the number of queued bytes though calls to
netdev_tx_sent_queue() in the drivers xmit function. When, VIOS reports
that it is done transmitting bytes, the ibmvnic device increases the
In the Linux kernel, the following vulnerability has been resolved:
hsr: Fix uninit-value access in fill_frame_info()
Syzbot reports the following uninit-value access problem.
=====================================================
BUG: KMSAN: uninit-value in fill_frame_info net/hsr/hsr_forward.c:601 [inline]
BUG: KMSAN: uninit-value in hsr_forward_skb+0x9bd/0x30f0 net/hsr/hsr_forward.c:616
fill_frame_info net/hsr/hsr_forward.c:601 [inline]
hsr_forward_skb+0x9bd/0x30f0 net/hsr/hsr_forward.c:616
hsr_dev_xmit+0x192/0x330 net/hsr/hsr_device.c:223
__netdev_start_xmit include/linux/netdevice.h:4889 [inline]
netdev_start_xmit include/linux/ne
io_uring: wait interruptibly for request completions on exit
In the Linux kernel, the following vulnerability has been resolved:
io_uring: wait interruptibly for request completions on exit
WHen the ring exits, cleanup is done and the final cancelation and
waiting on completions is done by io_ring_exit_work. That function is
invoked by kworker, which doesn't take any signals. Because of that, it
doesn't really matter if we wait for completions in TASK_INTERRUPTIBLE
or TASK_UNINTERRUPTIBLE state. However, it does matter to the hung task
detection checker!
Normally we expect cancelations and completions to happen rather
quickly. Some test cases, however, will exit the ring and park the
owning task sto
media: cx23885: Fix a null-ptr-deref bug in buffer_prepare() and buffer_finish()
In the Linux kernel, the following vulnerability has been resolved:
media: cx23885: Fix a null-ptr-deref bug in buffer_prepare() and buffer_finish()
When the driver calls cx23885_risc_buffer() to prepare the buffer, the
function call dma_alloc_coherent may fail, resulting in a empty buffer
risc->cpu. Later when we free the buffer or access the buffer, null ptr
deref is triggered.
This bug is similar to the following one:
https://git.linuxtv.org/media_stage.git/commit/?id=2b064d91440b33fba5b452f2d1b31f13ae911d71.
We believe the bug can be also dynamically triggered from user side.
Similarly, we fix this by checking the return value of cx23
In the Linux kernel, the following vulnerability has been resolved:
FS: JFS: Fix null-ptr-deref Read in txBegin
Syzkaller reported an issue where txBegin may be called
on a superblock in a read-only mounted filesystem which leads
to NULL pointer deref. This could be solved by checking if
the filesystem is read-only before calling txBegin, and returning
with appropiate error code.
scsi: qla4xxx: Add length check when parsing nlattrs
In the Linux kernel, the following vulnerability has been resolved:
scsi: qla4xxx: Add length check when parsing nlattrs
There are three places that qla4xxx parses nlattrs:
- qla4xxx_set_chap_entry()
- qla4xxx_iface_set_param()
- qla4xxx_sysfs_ddb_set_param()
and each of them directly converts the nlattr to specific pointer of
structure without length checking. This could be dangerous as those
attributes are not validated and a malformed nlattr (e.g., length 0) could
result in an OOB read that leaks heap dirty data.
Add the nla_len check before accessing the nlattr data and return EINVAL if
the length check fails.