tty: n_gsm: fix possible out-of-bounds in gsm0_receive()
In the Linux kernel, the following vulnerability has been resolved:
tty: n_gsm: fix possible out-of-bounds in gsm0_receive()
Assuming the following:
- side A configures the n_gsm in basic option mode
- side B sends the header of a basic option mode frame with data length 1
- side A switches to advanced option mode
- side B sends 2 data bytes which exceeds gsm->len
Reason: gsm->len is not used in advanced option mode.
- side A switches to basic option mode
- side B keeps sending until gsm0_receive() writes past gsm->buf
Reason: Neither gsm->state nor gsm->len have been reset after
reconfiguration.
Fix this by changing gsm->count to gs
In the Linux kernel, the following vulnerability has been resolved:
tcp: do not accept ACK of bytes we never sent
This patch is based on a detailed report and ideas from Yepeng Pan
and Christian Rossow.
ACK seq validation is currently following RFC 5961 5.2 guidelines:
The ACK value is considered acceptable only if
it is in the range of ((SND.UNA - MAX.SND.WND) <= SEG.ACK <=
SND.NXT). All incoming segments whose ACK value doesn't satisfy the
above condition MUST be discarded and an ACK sent back. It needs to
be noted that RFC 793 on page 72 (fifth check) says: "If the ACK is a
duplicate (SEG.ACK < SND.UNA), it can be i
In the Linux kernel, the following vulnerability has been resolved:
ppdev: Add an error check in register_device
In register_device, the return value of ida_simple_get is unchecked,
in witch ida_simple_get will use an invalid index value.
To address this issue, index should be checked after ida_simple_get. When
the index value is abnormal, a warning message should be printed, the port
should be dropped, and the value should be recorded.
drm/arm/malidp: fix a possible null pointer dereference
In the Linux kernel, the following vulnerability has been resolved:
drm/arm/malidp: fix a possible null pointer dereference
In malidp_mw_connector_reset, new memory is allocated with kzalloc, but
no check is performed. In order to prevent null pointer dereferencing,
ensure that mw_state is checked before calling
__drm_atomic_helper_connector_reset.
tty: n_gsm: require CAP_NET_ADMIN to attach N_GSM0710 ldisc
In the Linux kernel, the following vulnerability has been resolved:
tty: n_gsm: require CAP_NET_ADMIN to attach N_GSM0710 ldisc
Any unprivileged user can attach N_GSM0710 ldisc, but it requires
CAP_NET_ADMIN to create a GSM network anyway.
Require initial namespace CAP_NET_ADMIN to do that.
net: nexthop: fix null pointer dereference when IPv6 is not enabled
In the Linux kernel, the following vulnerability has been resolved:
net: nexthop: fix null pointer dereference when IPv6 is not enabled
When we try to add an IPv6 nexthop and IPv6 is not enabled
(!CONFIG_IPV6) we'll hit a NULL pointer dereference[1] in the error path
of nh_create_ipv6() due to calling ipv6_stub->fib6_nh_release. The bug
has been present since the beginning of IPv6 nexthop gateway support.
Commit 1aefd3de7bc6 ("ipv6: Add fib6_nh_init and release to stubs") tells
us that only fib6_nh_init has a dummy stub because fib6_nh_release should
not be called if fib6_nh_init returns an error, but the commit below added
a call to ipv6_s
staging: rtl8192e: Fix use after free in _rtl92e_pci_disconnect()
In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8192e: Fix use after free in _rtl92e_pci_disconnect()
The free_rtllib() function frees the "dev" pointer so there is use
after free on the next line. Re-arrange things to avoid that.
proc/vmcore: fix clearing user buffer by properly using clear_user()
In the Linux kernel, the following vulnerability has been resolved:
proc/vmcore: fix clearing user buffer by properly using clear_user()
To clear a user buffer we cannot simply use memset, we have to use
clear_user(). With a virtio-mem device that registers a vmcore_cb and
has some logically unplugged memory inside an added Linux memory block,
I can easily trigger a BUG by copying the vmcore via "cp":
systemd[1]: Starting Kdump Vmcore Save Service...
kdump[420]: Kdump is using the default log level(3).
kdump[453]: saving to /sysroot/var/crash/127.0.0.1-2021-11-11-14:59:22/
kdump[458]: saving vmcore-dmesg.txt to /sysroot/var/crash/
scsi: mpt3sas: Fix kernel panic during drive powercycle test
In the Linux kernel, the following vulnerability has been resolved:
scsi: mpt3sas: Fix kernel panic during drive powercycle test
While looping over shost's sdev list it is possible that one
of the drives is getting removed and its sas_target object is
freed but its sdev object remains intact.
Consequently, a kernel panic can occur while the driver is trying to access
the sas_address field of sas_target object without also checking the
sas_target object for NULL.
In the Linux kernel, the following vulnerability has been resolved:
net: vlan: fix underflow for the real_dev refcnt
Inject error before dev_hold(real_dev) in register_vlan_dev(),
and execute the following testcase:
ip link add dev dummy1 type dummy
ip link add name dummy1.100 link dummy1 type vlan id 100
ip link del dev dummy1
When the dummy netdevice is removed, we will get a WARNING as following:
=======================================================================
refcount_t: decrement hit 0; leaking memory.
WARNING: CPU: 2 PID: 0 at lib/refcount.c:31 refcount_warn_saturate+0xbf/0x1e0
and an endless loop of:
=====================
sata_fsl: fix UAF in sata_fsl_port_stop when rmmod sata_fsl
In the Linux kernel, the following vulnerability has been resolved:
sata_fsl: fix UAF in sata_fsl_port_stop when rmmod sata_fsl
When the `rmmod sata_fsl.ko` command is executed in the PPC64 GNU/Linux,
a bug is reported:
==================================================================
BUG: Unable to handle kernel data access on read at 0x80000800805b502c
Oops: Kernel access of bad area, sig: 11 [#1]
NIP [c0000000000388a4] .ioread32+0x4/0x20
LR [80000000000c6034] .sata_fsl_port_stop+0x44/0xe0 [sata_fsl]
Call Trace:
.free_irq+0x1c/0x4e0 (unreliable)
.ata_host_stop+0x74/0xd0 [libata]
.release_nodes+0x330/0x3f0
.device_release_dr
ethernet: hisilicon: hns: hns_dsaf_misc: fix a possible array overflow in hns_dsaf_ge_srst_by_port()
In the Linux kernel, the following vulnerability has been resolved:
ethernet: hisilicon: hns: hns_dsaf_misc: fix a possible array overflow in hns_dsaf_ge_srst_by_port()
The if statement:
if (port >= DSAF_GE_NUM)
return;
limits the value of port less than DSAF_GE_NUM (i.e., 8).
However, if the value of port is 6 or 7, an array overflow could occur:
port_rst_off = dsaf_dev->mac_cb[port]->port_rst_off;
because the length of dsaf_dev->mac_cb is DSAF_MAX_PORT_NUM (i.e., 6).
To fix this possible array overflow, we first check port and if it is
greater than or equal to DSAF_MAX_PORT_NUM, the function returns.
net: tulip: de4x5: fix the problem that the array 'lp->phy[8]' may be out of bound
In the Linux kernel, the following vulnerability has been resolved:
net: tulip: de4x5: fix the problem that the array 'lp->phy[8]' may be out of bound
In line 5001, if all id in the array 'lp->phy[8]' is not 0, when the
'for' end, the 'k' is 8.
At this time, the array 'lp->phy[8]' may be out of bound.
In the Linux kernel, the following vulnerability has been resolved:
ipv6: fix memory leak in fib6_rule_suppress
The kernel leaks memory when a `fib` rule is present in IPv6 nftables
firewall rules and a suppress_prefix rule is present in the IPv6 routing
rules (used by certain tools such as wg-quick). In such scenarios, every
incoming packet will leak an allocation in `ip6_dst_cache` slab cache.
After some hours of `bpftrace`-ing and source code reading, I tracked
down the issue to ca7a03c41753 ("ipv6: do not free rt if
FIB_LOOKUP_NOREF is set on suppress rule").
The problem with that change is that the generic `args->flags` always have
`
net: qlogic: qlcnic: Fix a NULL pointer dereference in qlcnic_83xx_add_rings()
In the Linux kernel, the following vulnerability has been resolved:
net: qlogic: qlcnic: Fix a NULL pointer dereference in qlcnic_83xx_add_rings()
In qlcnic_83xx_add_rings(), the indirect function of
ahw->hw_ops->alloc_mbx_args will be called to allocate memory for
cmd.req.arg, and there is a dereference of it in qlcnic_83xx_add_rings(),
which could lead to a NULL pointer dereference on failure of the
indirect function like qlcnic_83xx_alloc_mbx_args().
Fix this bug by adding a check of alloc_mbx_args(), this patch
imitates the logic of mbx_cmd()'s failure handling.
This bug was found by a static analyzer. The analysis employs
differentia
net/mlx4_en: Fix an use-after-free bug in mlx4_en_try_alloc_resources()
In the Linux kernel, the following vulnerability has been resolved:
net/mlx4_en: Fix an use-after-free bug in mlx4_en_try_alloc_resources()
In mlx4_en_try_alloc_resources(), mlx4_en_copy_priv() is called and
tmp->tx_cq will be freed on the error path of mlx4_en_copy_priv().
After that mlx4_en_alloc_resources() is called and there is a dereference
of &tmp->tx_cq[t][i] in mlx4_en_alloc_resources(), which could lead to
a use after free problem on failure of mlx4_en_copy_priv().
Fix this bug by adding a check of mlx4_en_copy_priv()
This bug was found by a static analyzer. The analysis employs
differential checking to identify inconsistent sec
rxrpc: Fix rxrpc_local leak in rxrpc_lookup_peer()
In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix rxrpc_local leak in rxrpc_lookup_peer()
Need to call rxrpc_put_local() for peer candidate before kfree() as it
holds a ref to rxrpc_local.
[DH: v2: Changed to abstract the peer freeing code out into a function]
serial: core: fix transmit-buffer reset and memleak
In the Linux kernel, the following vulnerability has been resolved:
serial: core: fix transmit-buffer reset and memleak
Commit 761ed4a94582 ("tty: serial_core: convert uart_close to use
tty_port_close") converted serial core to use tty_port_close() but
failed to notice that the transmit buffer still needs to be freed on
final close.
Not freeing the transmit buffer means that the buffer is no longer
cleared on next open so that any ioctl() waiting for the buffer to drain
might wait indefinitely (e.g. on termios changes) or that stale data can
end up being transmitted in case tx is restarted.
Furthermore, the buffer of any port that has bee
In the Linux kernel, the following vulnerability has been resolved:
HID: bigbenff: prevent null pointer dereference
When emulating the device through uhid, there is a chance we don't have
output reports and so report_field is null.
can: sja1000: fix use after free in ems_pcmcia_add_card()
In the Linux kernel, the following vulnerability has been resolved:
can: sja1000: fix use after free in ems_pcmcia_add_card()
If the last channel is not available then "dev" is freed. Fortunately,
we can just use "pdev->irq" instead.
Also we should check if at least one channel was set up.