linux-gcp vulnerabilities · Page 134

binfmt_misc: set have_execfd only once the interpreter is opened

In the Linux kernel, the following vulnerability has been resolved: binfmt_misc: set have_execfd only once the interpreter is opened load_misc_binary() raises bprm->have_execfd as soon as it sees the 'O' (or 'C') flag. This happens well before it opens the interpreter. If that open fails the flag stays set on the bprm. binfmt_misc is at the head of the format list so an interpreter open failure that returns -ENOEXEC lets the search fall through to a later format. This means it runs the matched binary directly having never staged an interpreter. So bprm->executable is NULL while have_execfd falsely claims a descriptor is present. Consequent

• Update to 5.15.0-1118.128

cdrom: fix stack out-of-bounds read in CDROMVOLCTRL

In the Linux kernel, the following vulnerability has been resolved: cdrom: fix stack out-of-bounds read in CDROMVOLCTRL mmc_ioctl_cdrom_volume() first reads the audio control mode page into a 32-byte stack buffer with cgc->buflen set to 24. If the device reports a block descriptor, the function increases cgc->buflen to include that descriptor and reads the page again. For CDROMVOLCTRL, the function then builds a MODE SELECT parameter list by moving cgc->buffer forward by offset - 8 bytes. This drops the block descriptor from the outgoing payload and leaves a new 8-byte mode parameter header in front of the audio control page. However, c

• Update to 5.15.0-1118.128

firmware: stratix10-svc: fix memory leaks and list corruption bugs

In the Linux kernel, the following vulnerability has been resolved: firmware: stratix10-svc: fix memory leaks and list corruption bugs Fix a memory leak when gen_pool_alloc() fails by freeing pmem on the error path. Switch pmem allocation from devm_kzalloc() to kzalloc() with explicit kfree() in the free path to match its list-managed lifetime. Remove the erroneous list_del(&svc_data_mem) which corrupted the list head on failed lookups.

• Update to 5.15.0-1118.128

comedi: comedi_parport: deal with premature interrupt

In the Linux kernel, the following vulnerability has been resolved: comedi: comedi_parport: deal with premature interrupt Syzbot reported a general protection fault in `comedi_get_is_subdevice_running()`, which was called from the interrupt handler `parport_interrupt()` in the "comedi_parport" driver, but it does not currently have a C reproducer for the problem. It's probably due to a premature interrupt for one of two reasons: 1. The driver sets up the interrupt handler before the comedi subdevices used by the interrupt handler have been allocated, but does not disable the interrupt in the parallel port's CTRL register first. 2. T

• Update to 5.15.0-1118.128

intel_th: fix MSC output device reference leak

In the Linux kernel, the following vulnerability has been resolved: intel_th: fix MSC output device reference leak intel_th_output_open() looks up the output device with bus_find_device_by_devt(), which returns the device with a reference that must be dropped after use. commit 95fc36a234da ("intel_th: fix device leak on output open()") attempted to drop the reference from intel_th_output_release(). However, a successful open replaces file->f_op with the output driver file operations before returning, so close runs the output driver release callback instead. For MSC outputs, close runs intel_th_msc_release(), which only removes the per-fil

• Update to 5.15.0-1118.128

tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev

In the Linux kernel, the following vulnerability has been resolved: tracing: Fix mmiotrace possible NULL dereferencing of hiter->dev If the mmio_pipe_open() fails to find a PCI device, the hiter->dev will be assigned to NULL. The mmiotrace read() function dereferences the hiter->dev if hiter exists. Change the test of the read to not only check hiter being NULL, but also the hiter->dev before dereferencing it.

• Update to 5.15.0-1118.128

tracing: Fix resource leak on mmiotrace trace_pipe close

In the Linux kernel, the following vulnerability has been resolved: tracing: Fix resource leak on mmiotrace trace_pipe close The mmiotrace tracer was added May 12th 2008. At that time, resources created in pipe_open() could not be freed because there was not pipe_close function pointer of the tracer. The pipe_close function pointer was added in December 7th, 2009, but the mmiotrace tracer was not updated. mmio_pipe_open() allocates a header_iter and takes a pci_dev reference when trace_pipe is opened. mmio_close() frees them, but it was only wired to the tracer's .close callback. tracing_release_pipe() invokes .pipe_close, not .close, whe

• Update to 5.15.0-1118.128

sctp: avoid auth_enable sysctl UAF during netns teardown

In the Linux kernel, the following vulnerability has been resolved: sctp: avoid auth_enable sysctl UAF during netns teardown proc_sctp_do_auth() updates the SCTP control socket after changing net.sctp.auth_enable. The handler gets the per-net SCTP state from ctl->data, so an already opened sysctl file can still target a network namespace while that namespace is being torn down. SCTP previously registered its per-net sysctls from sctp_defaults_init(), while the control socket is created later from sctp_ctrlsock_init(). This exposed a window during initialization where auth_enable was writable before net->sctp.ctl_sock existed, and a teardow

• Update to 5.15.0-1120.130

sctp: close UDP tunnel sockets during netns teardown

In the Linux kernel, the following vulnerability has been resolved: sctp: close UDP tunnel sockets during netns teardown proc_sctp_do_udp_port() starts per-net SCTP UDP tunneling sockets when net.sctp.udp_port is set, and stops/restarts them when the sysctl value changes. The netns exit path does not stop these sockets, so a namespace can be torn down while its SCTP UDP tunnel sockets are still installed. Close the UDP tunnel sockets from sctp_ctrlsock_exit() after unregistering the per-net sysctl table. This prevents new sysctl writes from racing in while the sockets are being released, and closes the sockets before the control socket is

ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps()

In the Linux kernel, the following vulnerability has been resolved: ceph: fix pre-auth out-of-bounds read on snaptrace in ceph_handle_caps() ceph_handle_caps() reads snap_trace_len from the wire-format ceph_mds_caps header and uses it unconditionally to build a fake end pointer (snaptrace + snaptrace_len) that is later handed to ceph_update_snap_trace() in the CEPH_CAP_OP_IMPORT case: snaptrace = h + 1; snaptrace_len = le32_to_cpu(h->snap_trace_len); p = snaptrace + snaptrace_len; ... case CEPH_CAP_OP_IMPORT: if (snaptrace_len) { ... if (ceph_update_snap_trace(mdsc, snaptr

• Update to 5.15.0-1118.128

libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE

In the Linux kernel, the following vulnerability has been resolved: libceph: bound pg_{temp,upmap,upmap_items} length to CEPH_PG_MAX_SIZE __decode_pg_temp() decodes an user-controlled length but only rejects values large enough to overflow the allocation; it does not bound it to CEPH_PG_MAX_SIZE. The helper backs both pg_temp and pg_upmap decoding, and apply_upmap()/get_temp_osds() later copy the decoded list into the fixed-size on-stack array struct ceph_osds.osds[CEPH_PG_MAX_SIZE]. A monitor that sends an OSDMap with a pg_temp/pg_upmap entry longer than 32 thus causes a stack out-of-bounds write. An OSD set for a single PG can never exce

• Update to 5.15.0-1120.130

libceph: Fix multiplication overflow in decode_new_up_state_weight()

In the Linux kernel, the following vulnerability has been resolved: libceph: Fix multiplication overflow in decode_new_up_state_weight() If a message of type CEPH_MSG_OSD_MAP contains a (maliciously) corrupted osdmap, out-of-bounds memory accesses may occur in decode_new_up_state_weight(). This happens because the bounds check for the new_state part is based on calculating its length depending on a len value read from the incoming message. This calculation may overflow leading to an incorrect bounds check. Subsequently, out-of-bounds reads may occur when decoding this part. This patch switches the multiplication to use check_mul_overflow()

• Update to 5.15.0-1118.128

libceph: guard missing CRUSH type name lookup

In the Linux kernel, the following vulnerability has been resolved: libceph: guard missing CRUSH type name lookup Localized read selection can walk a parent bucket whose name exists in the CRUSH map while its type has no matching entry in type_names. get_immediate_parent() then dereferences a NULL type_cn and passes an invalid pointer into strcmp(), causing a null-ptr-deref. Skip such malformed parent buckets unless both the bucket name and type name metadata are present. This keeps malformed hierarchy data from crashing locality lookup and safely falls back to "not local". [ idryomov: add WARN_ON_ONCE ]

• Update to 5.15.0-1118.128

libceph: refresh auth->authorizer_buf{,_len} after authorizer update

In the Linux kernel, the following vulnerability has been resolved: libceph: refresh auth->authorizer_buf{,_len} after authorizer update ceph_x_create_authorizer() caches au->buf->vec.iov_base and au->buf->vec.iov_len in struct ceph_auth_handshake. These cached values are then used by the messenger connect code when sending the authorizer. ceph_x_update_authorizer() can rebuild the authorizer when a newer service ticket is available. If the rebuilt authorizer no longer fits in the existing buffer, ceph_x_build_authorizer() drops its reference to au->buf and allocates a new one. If this is the final reference, ceph_buffer_put() frees the

• Update to 5.15.0-1118.128

libceph: Reject monmaps advertising zero monitors

In the Linux kernel, the following vulnerability has been resolved: libceph: Reject monmaps advertising zero monitors A message of type CEPH_MSG_MON_MAP contains a monmap that is sent from a monitor to the client. This monmap contains information about the existing monitors in the cluster. Currently, a monmap indicating that there are zero monitors in the cluster is treated as valid. However, it is impossible to have zero monitors in the cluster and still receive a valid monmap from a monitor. Therefore, such a monmap must be corrupted and should be treated as invalid. Furthermore, a monmap with a monitor count of zero can subsequently cras

• Update to 5.15.0-1118.128

libceph: reject zero bucket types in crush_decode

In the Linux kernel, the following vulnerability has been resolved: libceph: reject zero bucket types in crush_decode CRUSH bucket type 0 is reserved for devices. The mapper relies on that invariant and uses type 0 to identify leaf devices. If crush_decode() accepts a bucket with type 0, a malformed CRUSH map can make the mapper treat a negative bucket ID as a device and pass it to is_out(), which then indexes the OSD weight array with a negative value. Reject zero bucket types while decoding the CRUSH map so the invalid state never reaches the mapper.

• Update to 5.15.0-1118.128

libceph: remove debugfs files before client teardown

In the Linux kernel, the following vulnerability has been resolved: libceph: remove debugfs files before client teardown ceph_destroy_client() tears down the monitor client before removing the per-client debugfs files. A concurrent read of the monmap debugfs file can enter monmap_show() after ceph_monc_stop() has freed monc->monmap, triggering a use-after-free. Remove the debugfs files before stopping the OSD and monitor clients. debugfs_remove() drains active handlers and prevents new accesses, so the debugfs callbacks can no longer race the rest of client teardown.

• Update to 5.15.0-1118.128

binfmt_elf_fdpic: only honour the first PT_INTERP

In the Linux kernel, the following vulnerability has been resolved: binfmt_elf_fdpic: only honour the first PT_INTERP The program header scan handles PT_INTERP from a switch nested in the scan loop, so its break leaves the switch and not the loop. A binary carrying more than one PT_INTERP runs the case again and overwrites both interpreter_name and interpreter. The previous name allocation leaks and so does the previous interpreter reference, along with the write denial open_exec() took on it. The denial is never released, so the file stays unwritable for as long as the system runs. An unprivileged caller reaches this with a crafted binary

• Update to 5.15.0-1118.128

ftrace: Add global mutex to serialize trace_parser access

In the Linux kernel, the following vulnerability has been resolved: ftrace: Add global mutex to serialize trace_parser access In ftrace, the trace_parser structure is allocated and initialized when a trace file is opened, and is subsequently used across write and release handlers to parse user input. The affected handler paths and their specific functions are: - Open paths: ftrace_regex_open(), ftrace_graph_open() - Write paths: ftrace_regex_write(), ftrace_graph_write() - Release paths: ftrace_regex_release(), ftrace_graph_release() If userspace opens a trace file descriptor and shares it across multiple threads, concurrent write c

• Update to 5.15.0-1120.130

phonet: pep: fix use-after-free in pep_get_sb()

In the Linux kernel, the following vulnerability has been resolved: phonet: pep: fix use-after-free in pep_get_sb() pep_get_sb() doesn't consider that pskb_may_pull() might have relocated the skb data, and continue to access the older pointer, causing UAF. Reproduced under KASAN: BUG: KASAN: slab-use-after-free in pep_get_sb+0x234/0x3b0 Read of size 1 at addr ff11000105510f50 by task repro/157 pep_get_sb+0x234/0x3b0 pipe_handler_do_rcv+0x5f7/0xa10 pep_do_rcv+0x203/0x410 __sk_receive_skb+0x471/0x4a0 phonet_rcv+0x5b3/0x6c0 __netif_receive_skb+0xcc/0x1d0 Refetch the header with skb_header_pointer() after pskb_may_pull(

• Update to 5.15.0-1118.128